Optika LAB-1 Manual de usuario

Optika stereo-microscope LAB-1 / LAB-2

Instruction Manual

Optika LAB-1 & LAB-2

Optika stereo-microscope LAB-1 / LAB-2

INTRODUCTION

Ryeco Stereomicroscopes series STEREO, LAB 1 and LAB 2 are high level stereomicroscopes with

objectives 2x-4x (LAB 1) or zoom 1x4x (LAB-2). The magnification is from 5x to 12Ox by using

additional lens (optional).These stereomicroscopes are the good choose for the professional user.

Unpacking and assembling of the microscope

The components for series stereo Ryeco LAB-1 and LAB-2 are shipped detached for protection. open the

Styrofoam packing with care and do not leave any components attached to the packing being removed. Do not

discard any of the packing materials until all components have been located. lf damage occurs during transit,

contact both the carrier and your supplier immediately.

When handing the components, especially all the optical parts, avoid touching any lens surface with naked hand or

fingers. Any fingerprints or grease stains will negatively affect the image quality (see Ryf Cleaning Sets).

After unpacking the stand, put it on a good stable table. Loosen the lock screw of the focusing carrier, adjust the

height of the focusing carrier and lock the lock screw again. Make sure that the support collar is secured firmly

below the focusing carrier along the vertical post This is important as this collar functions to avoid the accidental

falling of the microscope along the column.

Optika stereo-microscope LAB-1 / LAB-2

Alignment and operation

Interpupillary distance

Move the two eyepiece tubes until only one circular field can be seen through the two eyepieces. lf two

circles appear the interpupillary distance is too big, and f 2 overlapped circles appear the interpupillary

distance is too small.

Focusing the microscope

Try to focus the sample at the highest magnification with the focusing knob. lf it cannot be done, adjust the

height of the microscope along the vertical post Remember to lock the lock screw and support collar after

aligning the height of the microscope.

Turn the zoom to the highest magnification. By turning the focusing knob, focus the sample until the

image is clear and sharp.

Turn the zoom (or change the objective by rotation) down to the lowest magnification. Adjust the diopter

focusing knob of the right eyepiece until the mage of the right eyepiece s clear and sharp.

Magnification

Select the desired magnification by adjusting the zoom knob. Change the eyepieces and,/or add an

appropriate magnifying objective lens if necessary

Total magnification used can be calculated by the following equation:

Total magnification = Eyepiece magnification x Zoom magnification x Normal working distance for the

standard configuration is 90mm.

Knowing your microscope

For LAB series stereomicroscope the binocular is built together with the stereo body to form a single piece

named "Stereo-head'.

The Stereo body is the key part of the microscope which includes the Greenough stereo-zoom system

1x4x. or objective 2x 4x. This system includes two telescopic zoom optics working for the left and the right

eyepiece tube separately.

With this system, the user can enjoy excellent depth of field and stereo effect. With the help of the

precision optics from Ryf, perfect parfocality can be maintained throughout the who e zoom range.

Zoom knob in LAB-2 is located bilaterally on both sides of the microscope and is printed with scale

showing the zoom magnification used. Adjust this knob for changing the magnification oft he image. if the

microscope is properly aligned, the image focus should always be maintained when zoom magnification is

changed [parfocal].

The stereo body is mounted onto the circular mount of the focusing carrier and is locked by the lock screw

on the left hand side of the carrier. During the operation of the microscope, the Lock screw should a ways

be locked to maintain stability.

Optika stereo-microscope LAB-1 / LAB-2

Cleaning and care of the microscope

Changing the bulb

Before changing the bulb, make sure that the power switch is off and the Power cord has been

disconnected from the main supply.

For Incident light, unscrew the lamp collector piece out, remove the old light bulb from the socket, and

carefully plug the new bulb in, screw the collector piece back after changing the bulb.

For transmitted light, remove the stage glass plate by pushing down its rear side, and move the old bulb

from the socket and carefully plug the new bulb in.

Never touch the glass surface of the bulb with naked hand, any grease stain brought onto the bulb by the

naked hand will negatively affect the heat dissipation, and thus, greatly shorten the life span of the bulb.

Clean the bulb surface with Ryf Lens Cleaner or alcohol and tissue if the user has touched the bulb

surface accidentally.

Cleaning

lf dust is found on the optical surface, try to remove by air blower or better with canned air (Ryf cleaning

Set).

For fingerprint, grease stain or dust which cannot be removed by the air blower possible methods are

recommended:

•To breathe lightly on the glass surface and wipe with a clean piece of cloth, lens paper or cotton

swab.

•Please notice that small cotton fiber may be left onto the lens surface if cotton swab is used.

•Use a cotton swab or lens paper dip with a small amount of absolute alcohol (or better with Ryf

cleaning Set) and clean the lens surface carefully. No other aggressive solvents should be used.

•In no circumstances should the user clean any lens surface with dry cotton swab, cloth or lens

paper. This will scratch the lens surface causing irreparable damage.

•Water is not recommended fop cleaning of lens as it will leave some water stain on the lens

surface and if water residue is left on the lens, fungus can grow causing irreparable damage.

Optional accessories

ST-001 WF5x/22mm eyepiece pair

ST-002 WF10x/20mm eyepiece pair

ST-003 WF15x/15mm eyepiece pair

ST-004 WF20x/13mm eyepiece pair

ST-005 WF10x/20 mm micrometric eyepiece

ST-023 Additional 0,5x lens

ST-024 Additional 1,5x lens

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Microscopio de Optika

Optika

Optika B-150 Series Manual de usuario

Optika

Optika SZM Manual de usuario

Optika

Optika STEREO Manual de instrucciones

Optika

Optika B-290 Manual de usuario

Optika

Optika ECOVISION Series Manual de usuario

Optika

Optika B-150 ALC Series Manual de usuario

Optika

Optika STEREO Series Manual de usuario

Optika

Optika B-350 Manual de usuario

Optika

Optika B-180 Manual de usuario

Optika

Optika B-50 Manual de usuario

Optika

Optika B-60 Series Manual de usuario

Optika

Optika XDS-3FL Manual de usuario

Optika

Optika IM-2 Manual de usuario

Optika

Optika DM-5UP Manual de usuario

Optika

Optika ECOVISION M-100FL Manual de usuario

Optika

Optika B-150POL Manual de usuario

Optika

Optika B-1000 Series Manual de usuario

Optika

Optika B-510 Series Manual de usuario

Optika

Optika B-1000 POL Manual de usuario

Optika

Optika B-600 Manual de instalación

Optika

Optika B-1000 POL Manual de usuario

Optika

Optika B-500TiFL Manual de usuario

Optika

Optika B-510 Series Manual de usuario

Optika

Optika B-190 Manual de usuario

Manuales populares de Microscopio de otras marcas

Thermo Scientific

Thermo Scientific Nicolet iN10 Guía

National

National DC3-163 Manual de usuario

KERN Optics

KERN Optics OPE-1 Manual de usuario

OPTIKA MICROSCOPES

OPTIKA MICROSCOPES B-150D Manual de usuario

Prior

Prior Lux POL Manual de usuario

Opitec

Opitec Smartscoop 115615 Manual de usuario

KERN

KERN OPO-1 Manual de usuario

Topcon

Topcon SP-1P Manual de usuario

Motic

Motic PA43 Manual de usuario

Leica

Leica DVM5000 Guía del usuario

MshOt

MshOt MZ62 Manual de usuario

KERN Optics

KERN Optics OZR-5 Manual de usuario

VWR

VWR VisiScope 384 Series Manual de usuario

Nikon

Nikon ECLIPSE E200 POL Manual de usuario

Leica

Leica DI C800 Manual

ThermoFisher Scientific

ThermoFisher Scientific Continuµm Manual de usuario

ThermoFisher Scientific

ThermoFisher Scientific Continuµm Manual de usuario

Olympus

Olympus SZ61 Manual de usuario