Danfoss TP7001 series Manual de usuario

TP7001

User Instructions

Accepting the Factory Pre-settings Weekdays (Mon-Fri) Weekend (Sat-Sun)

Event Time Temp °C Event Time Temp °C

1 06:30 20 1 07:30 20

2 08:30 15 2 09:30 20

3 11:30 20 3 11:30 20

4 13:30 15 4 13:30 20

5 16:30 21 5 16:30 21

6 22:30 15 6 22:30 15

Before programming the thermostat, press the recessed

RESET button to reset, using a non-metallic object (Fig.2)

Fig.1

Fig.2

Press and hold V & - until display changes (Fig.3)

Selecting the temperature display (°C or °F)

Selecting the clock display (am/pm or 24 hr)

Setting the Clock & Day

Fig.3

Press and hold Λ & + until display changes (Fig.4)

Fig.4

The date and time are set in the factory and therefore it

will not normally be necessary to do this on site. Changes

between summer and winter time are handled automatically

by the unit.

Setting the date: Press and hold Λ & PROG buttons for 3

seconds, to display date. (Fig.5)

The YEAR number will ash, use Λor Vto correct the year

(Fig.6)

Use - or +to move to MONTH, then use Λor V to correct

month (Fig.7)

Use - or +to move to DATE, in month then use Λor V to

correct day (Fig.8) The day of the week is set automatically

from the date.

Setting the correct time

After setting the date press PROG to display the time.

Use -or +buttons to set the correct time. (Fig.9) When time

is correct press PROG to return to RUN mode.

our TP7001 comes ready programmed with a set of

operating times and temperatures. (Fig.1)

To accept these settings close the front cover and after

2 minutes these will be accepted automatically.

If you

prefer, you can change any of these settings using the

following instructions.

Fig.5

Fig.6 Fig.7 Fig.8 Fig.9

Thermostat mode either 7-day, 5/2 day or 24 hour

To check which mode your unit is set to press PROG until

Event 1 ashes in display.

• In 7-day mode only one day of the week is shown in

the display.

• In 5/2 day mode either weekdays or weekend days are

shown in the display

• In 24 hour mode no days of the week are shown in

the display.

Press PROG to return to RUN mode.

Danfoss Ltd

Ampthill Road

Bedford, MK42 9ER

Tel: 01234 364621

Fax: 01234 219705

Email: [email protected]

Website: www.heating.danfoss.co.uk

CURRENT TEMPERATURE

PROGRAMMED TEMPERATURE

TIME

Days of Week (Numbers or Text)

DISPLAY

Programming in 5/2 day mode

a) Press PROG button until Event 1 ashes, then press the DAY button

until display shows weekdays (Fig.13)

b) Follow steps b as above (on 7 day mode) to programme times and

temperatures for weekdays (Fig.14)

c) Press the DAY button to programme events for weekend (day 6-7)

or press the COPY button to repeat weekday programme.

To return to RUN mode, press and release the PROG button. The

display will change to show the current time, the set temperature and

actual temperature (Fig.15)

Fig.13 Fig.14 Fig.15

Programming in 24 hour mode

a) Press PROG button until Event 1 ashes (Fig.16)

b) Amend the time and temperature as follows:

1. Use the +or - buttons to change the time

2. Use the V or Λ buttons to change the temperature in 0.5°C steps

3. Press the NEXT button to move to the next event (Fig.17)

4. Repeat the steps above for the remaining events

c) When all events are programmed press the PROG button to return

to RUN mode (Fig.18)

Fig.16 Fig.17 Fig.18

Programming in 7 day mode

a) Press PROG unit Event 1 ashes (Fig. 10)

b) Change the time and temperature as follows:

1. Use the +or -buttons to change time

2. use the s or tbuttons to change the temperature

3. Press NEXT to set up next Event for the day

4. Repeat steps 1-3 for the remaining events (Fig.11)

c) When all events are correct, press DAY to programme events for the

next day. If you wish to repeat the times and temperature to another

day of the week then the COPY function can be used.

To return to RUN mode, press and release the PROG button. The

display will change to show the current time, the set temperature and

actual temperature (Fig.12)

Fig.10 Fig.11 Fig.12

Flame: shows when heating output is on

Battery: ashes when battery voltage is low

Hourglass: shows during programming delays or when

Delayed Start is active

Padlock: indicates keyboard lock

Suitcase: Holiday Mode

House and Thermometers:

Indoor and Outdoor Temperature

Clock and Hand: Timed and Manual Modes

Alarm: Alarm active

Frost Shield: Frost Mode

Λ Up Arrow: Temperature override up

Auto Mode (6 events per day)

Auto Mode (4 events per day)

Auto Mode (2 events per day) or All Day Mode

V Down Arrow: Temperature override down

OFF: Thermostat (O ) Mode

+ HRS: Extend function

KEY TO SYMBOLS

Otros manuales para TP7001 series

Tabla de contenidos

Otros manuales de Termostato de Danfoss

Danfoss

Danfoss TP4 Instrucciones de funcionamiento

Danfoss

Danfoss TP9 Manual de usuario

Danfoss

Danfoss KPU 61 Manual de usuario

Danfoss

Danfoss TP5001 series Manual de usuario

Danfoss

Danfoss ECL Comfort 210 Manual de usuario

Danfoss

Danfoss TP5001 series Manual de usuario

Danfoss

Danfoss DBR Manual de usuario

Danfoss

Danfoss TP4 Instrucciones de funcionamiento

Danfoss

Danfoss REP24 Manual de usuario

Danfoss

Danfoss ECtemp Touch Manual de usuario

Danfoss

Danfoss EFIT 540 Manual de usuario

Danfoss

Danfoss ECA 30 Manual de usuario

Danfoss

Danfoss FH-CWD Manual de usuario

Danfoss

Danfoss KP 61 Manual de usuario

Danfoss

Danfoss FH-CWP Manual de usuario

Danfoss

Danfoss RESD Series Manual de usuario

Danfoss

Danfoss RT 14E Manual de usuario

Danfoss

Danfoss FP715Si Manual de usuario

Danfoss

Danfoss RAS-D2 Combi Manual de usuario

Danfoss

Danfoss TP75 Manual de usuario

Danfoss

Danfoss living connect Manual de usuario

Danfoss

Danfoss ECL Comfort 310, A361 Manual de usuario

Danfoss

Danfoss ECtemp 532 Manual de usuario

Danfoss

Danfoss RAS-D2 Combi Manual de usuario

Manuales populares de Termostato de otras marcas

EWELLY

EWELLY EW-181 Manual de usuario

Prolon

Prolon T1100 Instrucciones de instalación

Computherm

Computherm Q20 Manual de usuario

Heatmiser

Heatmiser neoStat Manual de usuario

Aube Technologies

Aube Technologies TH111GFCI-NP 240 VCA Manual de usuario

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Manual de usuario

Saswell

Saswell SAS920XWHB-7-S-RF Guía

Aircalo

Aircalo TFP1-ET85P2 Manual de usuario

Honeywell

Honeywell CM721 Manual de usuario

Carrier

Carrier DEBONAIR 33CS Manual de usuario

Lennox

Lennox iHarmony Zone Thermostat Instrucciones de montaje

Gemtech

Gemtech GT7000 Manual de instrucciones

Rollei

Rollei Smartes 45000 Manual de usuario

Sinope

Sinope TH1300RF Manual de usuario

Honeywell

Honeywell RLV4305 Manual de usuario

Honeywell

Honeywell Prestige 2.0 THX9421 Manual de usuario

NuTone

NuTone NTBZ48 Instrucciones de funcionamiento originales

Stelpro

Stelpro MAESTRO ASMT402AD Manual de usuario