Dancover Titanium Tent Manual de usuario

12-12-2016

6x12x3,5x5,5m

Manual

for

Titanium Tent

Safety Advice

Attention

In some countries approval is needed to set up a marquee/tent larger than 75 m2. It is your

responsibility to comply with local rules and regulations and to ensure that the marquee/tent is

assembled correctly.

In case of bad weather conditions, it is your responsibility to ensure the marquee/tent is safely

secured and that the marquee/tent does not cause damage to others.

Do not use open re, welding equipment or other sources which can ignite, inside or close to the

tent.

The marquee/tent must be safely secured. We recommend you secure your marquee/tent with

straps and pegs as soon as it is assembled.

Make sure to check if the marquee/tent is covered by your home contents insurance.

Marquees/tents must be evacuated under extreme weather conditions.

In the event of snow, always remove snow from the roof of the marquee/tent regularly to prevent

snow from building on the roof, as heavy snow can cause the marquee/tent to collapse.

In the event of rain, there is a risk of rain puddles building up on top of the roof of the marquee/

tent. Heavy rain puddles can cause the roof to collapse. It is your responsibility to ensure rain

puddles do not build up. As a precaution, make sure the roof of the marquee/tent is stretched

out properly and adequately over the side frames of the marquee/tent and remove rain water

regularly.

Do not unpack or repack your marquee/tent in freezing temperatures. In case of temperatures

below zero, always unpack and repack your marquee/tent indoors to avoid the risk of cracking

parts.

The marquee/tent must be totally dry before you repack and store it to avoid mildew.

Note: Marquees are intended for events and other arrangements and are as such only meant for

short term temporary assembly and the following disassembly. Dancover warranty applies only

to the normal use of the Product, normal wear and tear excepted, in accordance with written

use instructions or manual. The warranty does not apply to damage caused by accident, abuse,

misuse, or modication of the Product.

Warranty Information

Please visit dancovershop.com for information on warranty.

Please always check our website for the latest safety advice and manual.

Assembly Procedures

ground condition is suitable.

roof tubes to them accordingly.

3. Make each group of frame straight and assemble the roof purlins and horizontal walls in turn.

Make sure that all screws are tightened enough.

4. Assemble the cross tubes in front and back wall including the tensioning tube for covers at the

bottom.

roof cover onto the bottom tensioning tubes at the both side of frame as per Figure 5.

6. Then please put the rope in the sleeves at the two ends of roof cover into rings on the base

the bottom of the covers to the bottom tensioning tubes.

8. Please connect and tighten ropes between roof cover and front & back cover.

Your assembly is complete.

Assembly Illustration

For “user friendly” assembly we have

identified each individual component

with our partcode number as indicated

in the part list.

Please refer to the part code number

and drawings to ensure problem free

assembly.

Part No. Description Qty(pcs)

1 Curved Roof Tube (top) at two ends &tube size:1148mm 2

2 Curved Roof Tube (top) in the middle &tube size:1148mm 10

3 Straight Roof Tube at two ends &tube size:1787mm 4

4 Straight Roof Tube in the middle &tube size:1787mm 10

5 Curved Roof Tube (side) at two ends &short tube:660mm,long tube:1400mm 4

6 Curved Roof Tube (side) in the middle &short tube:660mm,long tube:1400 mm 10

7 Sidewall(in the middle) with base flange &tube size:2100mm 10

8 Sidewall(at two ends) with base flange &tube size:2100mm 4

9A-1 Upper Standing Legs in front panel &tube size:2124mm 2

9A-2 Upper Standing Legs in back panel &tube size:2124mm 2

9A-3 Upper Standing Legs in back panel(middle leg) &tube size:1398mm 1

9A-4 Middle Standing Legs in back panel(middle leg) &tube size:1900mm 1

9B Lower Standing Legs with base flange in front and back panel &tube size:2100mm 4

9C Lower Standing Legs with base flange in back panel( middle leg) &tube size: 2100mm 1

10 Roof purlin and horizon wall at both sides &tube size:1912mm 102

11A Cross tube(at two ends) in front and back panel &tube size:1138mm 12

11A-1 Cross tube(middle) in back panel &tube size:1662mm 6

11B Cross tube(middle) in front and back panel &tube size:1703.5mm 2

12A Tensioning cross tube in top roof &tube size :2180mm 6

12B Door dropping tube &1850mm 2

13 Slant supporting tube &2095mm 12

14 Roof cover 1

15 Front cover 1

16 Back cover 1

17 Stake peg &Dia 16x700mm 38

18 Rope for fixing cover

19 Bolts with nuts M14x30 228

M14x70 48

M12x50 4

M14x50 24

20 Inner join for cross tubes tubes &tube size:178mm 1

21 Inner join for part 11B and part 12B &tube size:400mm 1

Part List (W6xL12xSidewall3.5xH5.5M) with 3.5x3.5M machining door

12-12-2016

P a r t No.D i agr a m Q t y Par t N o . Diagram

9A-1

9 A - 2

1 0

11A1 2

9 C

11A-1

11B2

12A

12B2

1 3 1 2

Roof/Front/Ba c k cove r

14.15.16

1 7

R o p e forfixing c o ver

1 8

1 9

2 0

M 1 4 X30

M 1 4 X70

M 1 2 X50

M14X50

2 1 1

Q t y

W6XL12XS3.5XH5.5M(with3.5X3.5machiningdoor)

1 0

102

3 8

228

4 8

2 4

1 0

9A-3

9 B

9A-4

12-12-2016

12M

6x12x3.5x5.5M

Schematic drawing of placement for base flange

10 19

11A

11B

12A 2

9A-2 11A-1

9A-3

6x12x3.5x5.5M

Frame Sketch

M14x50 bolt with nut

19 19

1-2

3-4

5-6

7－8

11B 20

6x12x3.5x5.5M

slant supporting tube

M12x50 bolt with nut

M14x70 bolt with nut

Frame installation procedure

And connection hint

11A

Frame connection hint

M14x30 bolt with nut

Tabla de contenidos

Otros manuales de Carpa de Dancover

Dancover

Dancover PE Series Manual de usuario

Dancover

Dancover TentZing Manual de usuario

Dancover

Dancover ProShed MS572012 Manual de usuario

Dancover

Dancover CA119011 Manual de usuario

Dancover

Dancover TentZing CT168300 Manual de usuario

Dancover

Dancover Semi PRO 9x12m Manual de usuario

Dancover

Dancover ProShed Manual de usuario

Dancover

Dancover PRO EventZone 9m Series Manual de usuario

Dancover

Dancover 2m Series Manual de usuario

Dancover

Dancover Pagoda Tent EventZone Manual de usuario

Dancover

Dancover CombiTent SEMI PRO 6m Series Manual de usuario

Dancover

Dancover 5.4m Series Manual de usuario

Dancover

Dancover ST145080 Manual de usuario

Dancover

Dancover Multipavillon 6x9m Manual de usuario

Dancover

Dancover Storage Tent PRO Manual de usuario

Dancover

Dancover TentZing CT168040 Manual de usuario

Dancover

Dancover Multipavillon 3x6m Manual de usuario

Dancover

Dancover PVC 4m Series Manual de usuario

Dancover

Dancover 5m PE Series Manual de usuario

Dancover

Dancover Semi PRO 4x8m Manual de usuario

Dancover

Dancover Semi PRO 5x10m Manual de usuario

Dancover

Dancover Proshed Garage Manual de usuario

Dancover

Dancover Pole Tent Semi PRO 6x6m Manual de usuario

Dancover

Dancover Arched PE Manual de usuario

Manuales populares de Carpa de otras marcas

OZTENT

OZTENT JV SIGNATURE EDITION Manual de usuario

GigaTent

GigaTent Summer Chalet Mini Tent Manual de usuario

Coleman

Coleman 2000007827 Manual

ShelterLogic

ShelterLogic 107153 Manual de usuario

Outsunny

Outsunny 84C-230 Manual de usuario

Napier

Napier SPORTZ COVE 61 Series Manual de usuario

EuroTrail

EuroTrail ATLANTIS PRO Manual de usuario

Reimo

Reimo Marina Manual de usuario

TiiTENT

TiiTENT TB300 Manual de usuario

Coleman

Coleman 2000033134 Guía de instalación

Ozark Trail

Ozark Trail W784.1 Guía de inicio rápido

SlingFin

SlingFin CrossBow 2 Manual de usuario

Coleman

Coleman 9600-141 Manual de usuario

Palram

Palram Arizona 5000 Wave - WINGS Manual de usuario

COVERPRO

COVERPRO 56184 Instrucciones de montaje

Vango

Vango Zenith 100 Manual de usuario

Costway

Costway PATIOJOY OP70818 Manual de usuario

Clarke

Clarke PUC 88 Manual de usuario