CYP EL-5300 Manual de usuario
OPERATION MANUAL
EL-5300
PC/Video/HD to v1.3 HDMI
Switcher
1. Introduction 1
2. Features 1
3. Package Contents 1
4. Operation Controls and Functions 2
4.1 Front Panel Diagram 2
4.2 Rear Panel Diagram 3
4.3 Connection Diagram 4
4.4 Remote Control 5
5 RS232 Control Protocal 5
5.1 RS232 Transmission Format 6
6 Input Signal Secications 7
6.1 Output Signal Specications 7
7Specications 8
Table of Contents
Finden Sie ab Seite 11.
1. Introduction
The EL-5300 is a high quality video converter to convert Analogue and
Digital signals to v1.3 HDMI output. The EL-5300 is compatible to v1.3 HDMI
specications, a cutting edge technology which denes the transfer Deep Colour
(10-bit and 12- bit) video. Simply select from the front panel or remote control to
choose the input sources.
2. Features
• v1.3 HDMI, HDCP 1.1 and DVI 1.0 compliant.
• Supports ‘Deep Colour’ (10, 12, & 16 bit).
• Supports analogue/digital video & audio inputs, outputting to v1.3 HDMI
specications.
• HDCP keysets allows each HDMI input to work independently when connecting
to a HDMI display.
• Supports a wide range of PC and HDTV resolutions from VGA to SXGA@60Hz
and 480i to 1080p, including 1080p 24fps.
• 3D comb lter.
• 3D noise reduction (DNR).
• Format converter from 480i/576i to 480p/576p (de-interlace).
• Supports 150ms audio delay. Note: This feature will not function when input is
from HDMI source.
• IR remote control.
• RS-232 control.
3. Package Contents
• EL-5300
• 5V DC power supply adaptor.
• Operation Manual.
Page 1
Page 2
4. Operation Controls and Functions
1. Power switch and power LED indicator: Press the switch to power on the
unit and the power LED will illuminate.
2. IR sensor.
3. Input source selection: Press the input button to switch to your desired input
sources, the LED will illuminate to indicate which input source is selected.
4. Audio delay: Press to delay audio sources for 150ms, the LED will illuminate
when powered on.
5. De-interlace from 480i/576i to 480p/576p.
4.1 Front Panel
POWER HDMI 1 HDMI 2 HDMI 3 PC COMP 1 COMP 2 SVIDEO-1 SVIDEO-2 VIDEO-1 VIDEO-2 AUDIO
DELAY
3D Video Comb Filter/12bit
480I480P
576I576P
12 43 5
Page 3
4.2 Rear Panel
POWER
DC 5V
VIDEO 1 YPb/CbPr/Cr
HDMI IN
/ BYPASS HDMI OUT
AUDIO 1 AUDIO 1
Pr/Cr Pb/Cb Y
R LLR
AUDIO 2
SVIDEO 1
SVIDEO 2
COMPONENT 1 IN
RS-232COMPONENT 2 IN AUDIO
-
IN
-
PC
VIDEO 2
AUDIO 2
3 2 1
1 3 4 5 762
1. Power: Plug the 5V DC power supply into this unit and connect the
adaptor to AC wall outlet.
2. CV/SV inputs: Connect each of the input ports to the CV/SV and R/L
output ports of your source equipments such as DVD player or set-top-
box. The CV1/SV1/Audio1 and CV2/SV2/Audio2 are individual inputs for
source equipment.
3. Component inputs: Connect each of the input component ports to
the component and R/L output ports of your source equipments such
as DVD player or set-top-box. The Component1/Component Audio1
and Component2/Component Audio2 are individual inputs for source
equipment.
4. HDMI inputs: Connect each of the input ports to the HDMI or DVI output
ports of your source equipment such as DVD player or set-top-box.
5. PC input: Connect PC/audio input port to the PC/audio output port of
your source equipment such as Notebook or PC.
6. RS232: 9-pin D-Sub connector for connecting to your PC or other control
console for remote control.
7. HDMI output: Connect the output port to the HDMI display.
4.3. Connection Diagram
Page 4
Page 5
4.4. Remote Control
CR-62
POWERAudio Delay
COMP
SVIDEO
VIDEO
HDMI
PC
480I480P
576I576P
21
21
21
21 1
3
1. Audio Delay: Press to delay audio output for 150ms.
2. Format selection: To switch between Interlace and
Progressive format (de-interlace).
3. Power: Press the button to turn on/off the unit.
4. Component 1/2: Press to select Composite 1 or 2
inputs.
5. PC: Press for PC input.
6. S-Video1/2: Press to select S-Video 1 or 2 inputs.
7. Video1/2: Press to select Video 1 or 2 inputs.
8. HDMI 1/2/3: Press to select HDMI 1, 2 or 3 inputs.
3
5
21
4
6
7
8
5. RS-232 Remote Control Protocol
* The connection between this unit and remote controller with RS-232 modem cable (not
supplied).
System Remote Controller
Pin Denition Pin Denition
1 NC 1 NC
2 TxD 2 RxD
3 RxD 3 TxD
4 NC 4 NC
5 GND 5 GND
6 NC 6 NC
7 NC 7 NC
8 NC 8 NC
9 NC 9 NC
Pins denition of modem cable
* RS-232 transmission format:
Baud Rate : 9600 bps
Data Bit : 8 bits
Parity : None
Stop Bit : 1 bit
5.1 RS-232 transmission format:
Command Code Response Description
R POWER > POWER ON~OFF SHOW POWER STATUS
R SOURCE > SOURCE HDMI~CV SHOW SOURCE STATUS
R AUDIODELAY > AUDIODELAY OFF~ON SHOW AUDIO DELAY STATUS
R SD_ITOP >480i/576i TO 480p/576p
OFF~ON
SHOW 480i/576i TO 480p/576p
STATUS
R FW_VER > FIRMWARE VERSION : Vx.xx SHOW FIRMWARE VERSION
(a) Set Command
Command Code Response Description
S POWER 0 > POWER OFF POWER OFF
S POWER 1 > POWER ON POWER ON
S SOURCE 0 > SOURCE HDMI1 HDMI1 INPUT
S SOURCE 1 > SOURCE HDMI2 HDMI2 INPUT
S SOURCE 2 > SOURCE HDMI3 HDMI3 INPUT
S SOURCE 3 > SOURCE PC PC INPUT
S SOURCE 4 > SOURCE COMP1 COMPONENT1 INPUT
S SOURCE 5 > SOURCE COMP2 COMPONENT2 INPUT
S SOURCE 6 > SOURCE SV1 SV1 INPUT
S SOURCE 7 > SOURCE SV2 SV2 INPUT
S SOURCE 8 > SOURCE CV1 CV1 INPUT
S SOURCE 9 > SOURCE CV2 CV2 INPUT
S AUDIODELAY 0 > AUDIODELAY OFF OFF : NO DELAY
S AUDIODELAY 1 > AUDIODELAY ON ON : DELAY 150ms
S SD_ITOP 0 > 480i/576i TO 480p/576p
OFF OFF : NO 480i/576i TO 480p/576p
S SD_ITOP 1 >480i/576i TO 480p/576p
ON ON : 480i/576i TO 480p/576p
S RESET 1 > RESET ON RESET ACTION
Page 6
PC Resolutions Vert Rate
VGA
SVGA
XGA
SXGA
640x480
800x600
1024x768
1280x1024
60/72/75/85Hz
56/60/72/75/85Hz
60/70/75/85Hz
60Hz
HDTV Resolutions Vert Rate
480p
480i
576p
576i
720p
1080i
1080p
1080p 24fps
720x480
720x480
720x576
720x576
1280x720
1920x1080i
1920x1080p
1920x1080p
60Hz
60Hz
50Hz
50Hz
50, 60Hz
50, 60Hz
50,60Hz
24Hz
PC Resolutions Vert Rate
VGA
SVGA
XGA
SXGA
640x480
800x600
1024x768
1280x1024
60/72/75/85Hz
56/60/72/75/85Hz
60/70/75/85Hz
60Hz
HDTV Resolutions Vert Rate
480p
576p
720p
1080i
1080p
720x480
720x576
1280x720
1920x1080i
1920x1080p
60Hz
60Hz
50, 60Hz
50, 60Hz
50, 60Hz
Page 7
6. Input Signal Specications
6.1 Output Signal Specications
Note: Output resolution is limited to the HDTV/Monitor's specications.
HDMI Input Port 3 x HDMI female ports (Type A connector)
Component Input 2 x YUV with L/R RCA
HDMI Output Port 1 x HDMI female ports (Type A connector)
Analogue Input Port 2 x CV/SV with L/R RCA
PC input Port VGA with 1 x 3.5mm stereo mini jack
Power Supply 5V/2.6A DC (US/EU standards, CE/FCC/UL certied)
Dimensions (mm) 280(W) x 147(D) x 44(H)
Weight (g) 1380
Chassis Material Aluminium
Silk Skin Colour Black
Operating Temperature Operating from 0°C ~ 48°C
7. Specications
Page 8
Otros manuales para EL-5300
1
Tabla de contenidos
Idiomas:
Otros manuales de Cambiar de CYP
CYP
CYP EL-42SA Manual de usuario
CYP
CYP EL-41PIP Manual de usuario
CYP
CYP CH-21 Manual de usuario
CYP
CYP CSC-5300 Manual de usuario
CYP
CYP CH-2537TXWPUS Manual de instalación
CYP
CYP EL-31SY Manual de usuario
CYP
CYP EL-21SY Manual de usuario
CYP
CYP EL-41AT Manual de usuario
CYP
CYP CSDI-42 Manual de usuario
CYP
CYP PU-1H2HBTE Manual de usuario
CYP
CYP CMLUX-4H4CAT Manual de usuario
CYP
CYP CPLUS-401V Manual de usuario
CYP
CYP CPLUS-V4H1HP Manual de usuario
CYP
CYP PU-8H8HBT Manual de usuario
CYP
CYP EL-41X Manual de usuario
CYP
CYP EL-21SY Manual de usuario
CYP
CYP PU-22HC Manual de usuario
CYP
CYP CLUX-4S2 Manual de usuario
CYP
CYP CLUX-21N Manual de usuario
CYP
CYP CLUX-41N Manual de usuario
