StarTech.com SATDOCK22U3S Manual de usuario
Manual Revision: 07/12/2011
For the most up-to-date information, please visit: www.startech.com
DE: Bedienungsanleitung - de.startech.com
FR: Guide de l'utilisateur - fr.startech.com
ES: Guía del usuario - es.startech.com
IT: Guida per l'uso - it.startech.com
NL: Gebruiksaanwijzing - nl.startech.com
PT: Guia do usuário - pt.startech.com
SATDOCK22U3S / SATDOCK2U3GB / SATDOCK2U3EU
SuperSpeed USB 3.0 to Dual 2.5/3.5in SATA
Hard Drive Docking Station
*actual product may vary from photos
Instruction Manual
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Use of Trademarks, Registered Trademarks, and other Protected Names and
Symbols
This manual may make reference to trademarks, registered trademarks, and other
protected names and/or symbols of third-party companies not related in any way to
StarTech.com. Where they occur these references are for illustrative purposes only and do not
represent an endorsement of a product or service by StarTech.com, or an endorsement of the
product(s) to which this manual applies by the third-party company in question. Regardless
of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby
acknowledges that all trademarks, registered trademarks, service marks, and other protected
names and/or symbols contained in this manual and related documents are the property of
their respective holders.
Instruction Manual i
Table of Contents
Introduction ............................................................................................1
Packaging Contents ................................................................................................................................. 1
System Requirements .............................................................................................................................. 1
Front View .................................................................................................................................................... 2
Rear View ...................................................................................................................................................... 2
Installation ..............................................................................................3
Hardware Installation .............................................................................................................................. 3
Driver Installation ...................................................................................................................................... 3
Using the Storage Device ......................................................................4
Specications ..........................................................................................6
Technical Support ..................................................................................7
Warranty Information ............................................................................7
Instruction Manual 1
Introduction
The SATDOCK22U3S USB 3.0 to SATA Dual Hard Drive Docking Station enables two
SATA 2.5in or 3.5in hard drives (HDD) or solid state drives (SSD) to be connected
simultaneously to a computer through USB.
Using a single USB connection, this docking station can provide data transfer rates of
up to 5 Gbps with SuperSpeed USB 3.0, while remaining backward compatible with
USB 2.0 systems (data transfer rates up to 480 Mbps).
Extend the value of this hard drive docking station further with the addition of our
SATA to IDE Hard Drive Adapter (SAT2IDEADP), allowing easy insertion of any 2.5 or
3.5in. IDE hard drive into a SATA hard drive dock.
Packaging Contents
• 1 x SATA Hard Drive Dock
• 1 x USB 3.0 Cable
• 1 x Power Adapter
• 1 x Instruction Manual
System Requirements
• USB enabled computer system with available USB port
• Microsoft® Windows® 2000/XP/Server 2003/Vista/Server 2008 R2/7 (32/64-bit), or
Apple® Mac OS® X, or Linux®
*If used with the Apple Mac OS operating system, this device will function in USB 2.0 mode only as USB
3.0 is not currently supported by Apple.
Instruction Manual 2
Front View
Rear View
Instruction Manual 3
Installation
WARNING! Hard drives and storage enclosures require careful handling,
especially when being transported. If you are not careful with your hard disk,
lost data may result. Always handle your hard drive and storage device with
caution. Be sure that you are properly grounded by wearing an anti-static
strap when handling computer components or discharge yourself of any
static electricity build-up by touching a large grounded metal surface (such
as the computer case) for several seconds.
Hardware Installation
1. Connect the external power adapter from the hard drive dock to a power outlet.
2. Insert one or two 2.5” or 3.5” hard drive(s) into the top loading drive bay(s). Make
sure that the SATA connectors on the hard drive are facing the same corner of the
drive bay that has the 2.5in cutout in the door. The label on the hard drive should
face the front of the hard drive dock.
3. Connect the included USB cable from the hard drive dock to an available USB port
on the computer system. The computer can be on or o.
NOTE: A USB 2.0 A-B cable could be used as a substitute on the hard drive dock but
will be restricted to USB 2.0 speeds even on a USB 3.0 system.
4. Press the power button on the top of the hard drive dock for each drive bay. The
Power/Activity LED for the drive bays will light up. Solid blue indicates a drive
was found, while solid red indicates an error or no drive was found. Flashing red
indicates read/write activity on the drive.
5. To remove the hard drive, make sure it is currently not being accessed by the
computer then unmount or uninstall the disk drive from the operating system
(see documentation for your operating system). Press the power button for the
unmounted drive to turn o the hard drive dock and wait for the drive to power
down. Press the drive ejection button on the top of the hard drive dock to release
the drive, then pull the drive from the bay.
NOTE: Each drive can be independently powered on/o without aecting the other.
Driver Installation
No driver installation is required for the supported operating systems, as this hard
drive dock is natively supported, so the drivers are already installed.
Instruction Manual 4
Using the Storage Device
Windows 2000/XP/Vista/7
If you are using a brand new hard drive that does not contain any data, then you will
rst need to prepare the hard drive for use. From the main desktop, right-click on
“My Computer” (“Computer” in Vista/7), then select Manage. In the new Computer
Management window, select Disk Management from the left window panel.
Locate the Disk that says it is “Unallocated” (check hard drive capacity to conrm it’s the
correct hard drive) and then right-click in the section that says “Unallocated” and select
“New Partition”.
Instruction Manual 5
The New Partition Wizard will appear. Follow the instructions in the wizard to
complete setting up the drive. Once complete, the Disk should show up as “Healthy”
with a drive letter assigned (i.e. E:). This drive letter should now appear within My
Computer.
If you are installing a hard drive that already has data on it, then after plugging it in, the
drive should automatically show up with a drive letter assigned within My Computer.
Instruction Manual 6
Specications
Drive Bays 2
Host Interface SuperSpeed USB 3.0
Chipset ID VIA VL810 + ASMedia ASM1051
External Connectors 1 x USB 3.0 type B female
1 x DC Power female
LEDs 2 x Power/Activity
Maximum Data Transfer Rate USB 3.0: 5 Gbps
Compatible Hard Drives 2.5in/3.5in SATA hard drives
Power Supply 12VDC, 2000mA, center positive,
type M plug
Operating Temperature 5°C ~ 80°C (41°F ~ 176°F)
Storage Temperature -40°C ~ 70°C (-40°F ~ 158°F
Humidity 8% ~ 90% RH
Dimensions 142.0mm x 130.0mm x 70.0mm
Weight 532g
Compatible Operating Systems
Windows 2000/XP/Server 2003/Vista/
Server 2008 R2/7 (32/64-bit),
Mac OS X, Linux
Instruction Manual 7
Technical Support
StarTech.com’s lifetime technical support is an integral part of our commitment to
provide industry-leading solutions. If you ever need help with your product, visit
www.startech.com/support and access our comprehensive selection of online tools,
documentation, and downloads.
For the latest drivers/software, please visit www.startech.com/downloads
Warranty Information
This product is backed by a two year warranty.
In addition, StarTech.com warrants its products against defects in materials
and workmanship for the periods noted, following the initial date of purchase.
During this period, the products may be returned for repair, or replacement with
equivalent products at our discretion. The warranty covers parts and labor costs only.
StarTech.com does not warrant its products from defects or damages arising from
misuse, abuse, alteration, or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their
ocers, directors, employees or agents) for any damages (whether direct or indirect,
special, punitive, incidental, consequential, or otherwise), loss of prots, loss of business,
or any pecuniary loss, arising out of or related to the use of the product exceed the
actual price paid for the product. Some states do not allow the exclusion or limitation
of incidental or consequential damages. If such laws apply, the limitations or exclusions
contained in this statement may not apply to you.
Este manual sirve para los siguientes modelos
2
Tabla de contenidos
Otros manuales de Estación de acoplamiento de StarTech.com
StarTech.com
StarTech.com DK31C2DHSPD Manual de usuario
StarTech.com
StarTech.com DKT31CHDVCM Manual de usuario
StarTech.com
StarTech.com USB3SMDOCKV Manual de usuario
StarTech.com
StarTech.com SDOCK2U33HFB Manual de usuario
StarTech.com
StarTech.com USB3SMDOCKV Manual de usuario
StarTech.com
StarTech.com SDOCK2U313R Manual de usuario
StarTech.com
StarTech.com TB2DOCK4KDHC Manual de usuario
StarTech.com
StarTech.com Thunderbolt 3 Series Manual de usuario
StarTech.com
StarTech.com UNIDOCK3U Manual de usuario
StarTech.com
StarTech.com 8STSDOCK1EU3P2 Manual de usuario
StarTech.com
StarTech.com DK30CHHPD Manual de usuario
StarTech.com
StarTech.com USB3DOCKH2DP Manual de usuario
StarTech.com
StarTech.com SATDOCKCRH Manual de usuario
StarTech.com
StarTech.com USBA2DPGB Manual de usuario
StarTech.com
StarTech.com DK30C2DPPDUE Manual de usuario
StarTech.com
StarTech.com USB6N1DOCK Manual
StarTech.com
StarTech.com DK30ADD Manual de usuario
StarTech.com
StarTech.com USB3SDOCKHDV Manual de usuario
StarTech.com
StarTech.com TB3DK2DPM2 Manual de usuario
StarTech.com
StarTech.com SDOCK1EU3P Manual de usuario
