SolarEdge Storedge Manual de usuario

Installation Guide

StorEdge Three Phase Inverter

with SetApp Configuration

For Europe and APAC

Version 1.1

Disclaimers

Important Notice

No part of this document may be reproduced, stored in a retrieval system or

transmitted, in any form or by any means, electronic, mechanical, photographic,

magnetic or otherwise, without the prior written permission of SolarEdge Inc.

The material furnished in this document is believed to be accurate and reliable.

However, SolarEdge assumes no responsibility for the use of this material. SolarEdge

reserves the right to make changes to the material at any time and without notice. You

may refer to the SolarEdge web site (www.solaredge.com) for the most updated version.

All company and brand products and service names are trademarks or registered

trademarks of their respective holders.

Patent marking notice: see http://www.solaredge.com/patent

The general terms and conditions of delivery of SolarEdge shall apply.

The content of these documents is continually reviewed and amended, where

necessary. However, discrepancies cannot be excluded. No guarantee is made for the

completeness of these documents.

The images contained in this document are for illustrative purposes only and may vary

depending on product models.

Emission Compliance

This equipment has been tested and found to comply with the limits applied by the

local regulations.

These limits are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, you are encouraged to try to correct

the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Disclaimers 1

StorEdge Three Phase Inverter Installation Guide MAN-01-00648-1.1

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for

compliance may void the user’s authority to operate the equipment.

StorEdge Three Phase Inverter Installation Guide MAN-01-00648-1.1

2 Emission Compliance

Contents

Disclaimers 1

Important Notice 1

Emission Compliance 1

Revision History 5

HANDLING AND SAFETY INSTRUCTIONS 6

Safety Symbols Information 6

IMPORTANTSAFETYINSTRUCTIONS 6

Chapter 1: Overview 10

The StorEdge Solution Components 10

Installation Equipment List 11

Inverter Transport and Storage 12

Chapter 2: Installing the Power Optimisers 13

Safety 13

Installation Guidelines 14

Step 1: Mounting the Power Optimisers 16

Step 2: Connecting a PV Module to a Power Optimizer 16

Step 3: Connecting Power Optimizers in Strings 17

Step 4: Verifying Proper Power Optimiser Connection 18

Chapter 3: Installing the Inverter 19

Inverter Package Contents 19

Identifying the Inverter 19

Inverter Interfaces 20

Mounting the Inverter 24

Selecting a Residual Current Device (RCD) 26

Chapter 4: Installing the Battery 28

Chapter 5: Connecting the Inverter 29

Connecting the ACGrid 29

Connecting the Strings to the Inverter 30

Connecting the Energy Meter 31

Connecting the Battery 33

Chapter 6: Activating, Commissioning and Configuring the System 37

Step 1: Activating the Installation 37

Step 2: Commissioning and Configuring the Installation 38

Step 3: Verifying Proper Activation and Commissioning 42

Configuring Communication with the Energy Meter 42

Configuring Communication with the Battery 43

Running a Battery Self-test 43

Disclaimers 3

StorEdge Three Phase Inverter Installation Guide MAN-01-00648-1.1

Configuring StorEdge Applications 44

Viewing System Status 44

Chapter 7: Setting Up Communication to the Monitoring Platform 52

Communication Options 52

Verifying the Connection 53

Reporting and Monitoring Installation Data 54

Appendix A: Errors and Troubleshooting 57

Identifying Errors 57

Troubleshooting Communication 58

StorEdge Three Phase Inverter Troubleshooting 59

Power Optimiser Troubleshooting 60

Appendix B: Mechanical Specifications 62

Appendix C: SafeDC™ 63

StorEdge Three Phase Inverter - Technical Specifications 64

Support Contact Information 67

StorEdge Three Phase Inverter Installation Guide MAN-01-00648-1.1

4 Emission Compliance

Revision History

Version 1.1 (November 2019)

Editorial changes

Version 1.0 (August 2019)

First version of this guide

Revision History 5

StorEdge Three Phase Inverter Installation Guide MAN-01-00648-1.1

HANDLING AND SAFETY INSTRUCTIONS

During installation, testing and inspection, adherence to all the handling and safety

instructions is mandatory. Failure to do so may result in injury or loss of life and

damage to the equipment.

Safety Symbols Information

The following safety symbols are used in this document. Familiarize yourself with the

symbols and their meaning before installing or operating the system.

WARNING!

Denotes a hazard. It calls attention to a procedure that, if not correctly

performed or adhered to, could result in injury or loss of life. Do not proceed

beyond a warning note until the indicated conditions are fully understood and

met.

CAUTION!

Denotes a hazard. It calls attention to a procedure that, if not correctly

performed or adhered to, could result in damage or destruction of the

product. Do not proceed beyond a caution sign until the indicated conditions

are fully understood and met.

NOTE

Denotes additional information about the current subject.

IMPORTANTSAFETYFEATURE

Denotes information about safety issues.

Disposal requirements under the Waste Electrical and Electronic Equipment (WEEE)

regulations:

NOTE

Discard this product according to local regulations or send it back to SolarEdge.

IMPORTANTSAFETYINSTRUCTIONS

SAVETHESEINSTRUCTIONS

WARNING!

The inverter cover must be opened only after shutting off the inverter

P/ON/OFF switch located at the bottom on the inverter .This disables the DC

voltage inside the inverter. Wait five minutes before opening the cover.

Otherwise, there is a risk of electric shock from energy stored in the capacitors.

StorEdge Three Phase Inverter Installation Guide MAN-01-00648-1.1

6 HANDLING AND SAFETY INSTRUCTIONS



WARNING!

Before operating the inverter, ensure that the inverter AC power cable and wall

outlet are grounded properly. This product must be connected to a grounded,

metal, permanent wiring system, or an equipment-grounding conductor must

be run with the circuit conductors and connected to the equipment grounding

terminal or lead on the product.

WARNING!

Opening the inverter and repairing or testing under power must be performed

only by qualified service personnel familiar with this inverter.

WARNING!

Do not touch the PV panels or any rail system connected when the inverter

switch is ON, unless grounded.

WARNING!

SafeDC complies with IEC60947-3 when installing the system with a worst case

SafeDC voltage (under fault conditions) < 120V.

The worst case voltage is defined as: Voc,max+ (String Length-1)*1V, where:

Voc,max = Maximum Voc (at lowest temperature) of the PV models in the

string (for a string with multiple models, use the max value)

String Length = number of power optimizers in the string

CAUTION!

This unit must be operated according to the technical specification datasheet

provided with the unit.

CAUTION!

HEAVY OBJECT. To avoid muscle strain or back injury, use proper lifting

techniques, and if required - a lifting aid.

NOTE

The inverter is IP65 rated . Unused conduit openings and glands should be

sealed with appropriate seals.

HANDLING AND SAFETY INSTRUCTIONS 7

StorEdge Three Phase Inverter Installation Guide MAN-01-00648-1.1

NOTE

Use PV models rated according to IEC 61730 class A.

NOTE

The symbol appears at grounding points on the SolarEdge equipment. This

symbol is also used in this manual.

NOTE

A SolarEdge inverter may be installed in a site with a generator. SolarEdge

requires installing a physical or electronic interlock, which will signal to the

inverter when the grid has been disconnected. Interlock procurement,

installation, maintenance and support are the responsibility of the installer.

Damage to the inverter due to incorrect interlock installation or use of an

interlock that is incompatible with the SolarEdge system will render the

SolarEdge warranty invalid.

For more information, refer to

https://www.solaredge.com/sites/default/files/se-inverter-

support-of-voltage-sources.pdf.

NOTE

The following warning symbols appear on the inverter warning label:

Risk of electric shock

Risk of electric shock from energy stored in the capacitor. Do not

remove cover until 5 minutes after disconnecting all sources of

supply.

Hot surface – To reduce the risk of burns, do not touch.

WARNING!!

Before operating the system, ensure that the been grounded properly.

WARNING!

When handling the battery, adhere to all manufacturer safety instructions.

CAUTION!

This unit must be operated under the specified operating conditions as

described in the technical specifications supplied with the unit.

StorEdge Three Phase Inverter Installation Guide MAN-01-00648-1.1

8 IMPORTANTSAFETYINSTRUCTIONS

NOTE

The battery used with the inverter must conform to all local certification

requirements.

NOTE

For battery decommissioning and disposal, follow the manufacturer

requirements and instructions.

HANDLING AND SAFETY INSTRUCTIONS 9

StorEdge Three Phase Inverter Installation Guide MAN-01-00648-1.1

Otros manuales para storedge

Tabla de contenidos

Otros manuales de Inversor de SolarEdge

SolarEdge

SolarEdge Home Hub Inverter Three Phase Manual de usuario

SolarEdge

SolarEdge SE3000 Manual de usuario

SolarEdge

SolarEdge SE K-AU I Series Manual de usuario

SolarEdge

SolarEdge SE K Series Manual de usuario

SolarEdge

SolarEdge SE2200 Manual de usuario

SolarEdge

SolarEdge SE K Series Manual de usuario

SolarEdge

SolarEdge SE66.6KUS Manual de usuario

SolarEdge

SolarEdge StorEdge SE5K-RWS Manual de usuario

SolarEdge

SolarEdge SE15K Manual de usuario

SolarEdge

SolarEdge Power Harvesting System Manual de usuario

SolarEdge

SolarEdge EV Series Manual de usuario

SolarEdge

SolarEdge StorEdge SE7600A-USS Manual de usuario

SolarEdge

SolarEdge StorEdge Solution with Backup Manual de usuario

SolarEdge

SolarEdge SE2500H Manual de usuario

SolarEdge

SolarEdge SE8000H-AU Manual de usuario

SolarEdge

SolarEdge StorEdge SE10K-RWS Manual de usuario

SolarEdge

SolarEdge StorEdge Interface SESTI-S4 Manual de usuario

SolarEdge

SolarEdge UL1741-SA Manual de usuario

SolarEdge

SolarEdge BI-EU1P Manual de usuario

SolarEdge

SolarEdge SE3K-RWB Manual de usuario

SolarEdge

SolarEdge SE3000US Manual de usuario

SolarEdge

SolarEdge Solar Inverter Manual de usuario

SolarEdge

SolarEdge 330kW Manual de usuario

SolarEdge

SolarEdge storedge Manual de usuario

Manuales populares de Inversor de otras marcas

Fourgroup

Fourgroup Easy Manual de usuario

Velleman

Velleman PI300M Manual de usuario

Sungrow

Sungrow SG350HX-US Manual de usuario

WilTec

WilTec 61897 Manual de usuario

SMA

SMA SUNNY BOY STORAGE 2.5 Manual de usuario

Simplicity

Simplicity LANDLORD 316 Manual de usuario

Santak

Santak SMAX 3000 Manual de usuario

ATON

ATON RA.Store-3 Manual de usuario

ZIEHL-ABEGG

ZIEHL-ABEGG FXET4AMQ Manual de usuario

Tektronix

Tektronix CFG250 Manual de usuario

Champion

Champion 200989 Manual de usuario

Vanner

Vanner 20-500 Series Manual de usuario

GE GEP Manual de usuario

Astrel Group

Astrel Group Power Reducer Guía rápida

MULTIQUIP

MULTIQUIP GDP-5H Guía

GoWISE

GoWISE PS1007 Manual de usuario

Promate

Promate PM13500D ES Manual de usuario

Mastervolt

Mastervolt WHISPER 3.5M3000 RPM Manual de usuario