Riva RC4100-IN Manual de usuario
1
IMPORTANT!
The explanation and specification at this manual are mainly on the basis of
RC4100-2212-36 which uses Sony 36X Optical Zoom module.
www.rivatech.de
RC4100-IN/ RC4100-OUT
Installation Guide
(RC4100-Out is an Outdoor PTZ Camera, Adding an Outdoor Housing to Indoor
PTZ RC4100-IN)
4
www.rivatech.de
INFORMATION TO USER
CAUTION
RISK OF ELECTRIC SHOCK,
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SEERIVCE PERSONEL.
This symbol is intended to alert the user to the presence of un-
insulated “dangerous voltage” within the product’s enclosure that
may be of sufficient magnitude to constitute a risk of electric
shock to persons.
This symbol is intended to alert the user to the presence of
important operating and maintenance (servicing) instructions in
the literature accompanying the appliance.
!
!
5
www.rivatech.de
Table of Contents
1. FEATURES…………………………………………………………………………7
2. PACKAGE CONTENTS ………………………………………………………….8
3. PART NAMES…………………………………………………………………….9
4. INSTALLATION…………………………………………………………………..12
4.1. Setting the Image Attribute........................................................... 13
4.2.Operating the OSD Menu............................................................... 13
5. CONNECTIONS………………………………………………………………….14
5.1.Connectors ................................................................................. 14
6.
CONFIGURATION………………………………………………………………..20
6.1.Set up network environment .......................................................... 20
6.2.View video on web page ................................................................ 20
6.2.1. View video using IPAdmin Tool ................................................. 20
6.2.2. View video using IP address .................................................... 22
6.3. Reset........................................................................................ 22
6.4. Factory Default ........................................................................... 22
APPENDIX (A): SPECIFICATIONS………………………………………………..23
Summary.......................................................................................... 23
Electrical Characteristics..................................................................... 25
Environment Condition ........................................................................ 26
APPENDIX (B): DIMENSIONS…………………………………………………….27
Dome .............................................................................................. 27
Outdoor Housing................................................................................ 28
6
www.rivatech.de
APPENDIX (C): ACCESSORIES…………………………………………………...29
Outdoor part ..................................................................................... 29
Assembling outdoor housing ................................................................ 30
APPENDIX (D): HEXADECIMAL-DECIMAL CONVERSION TABLE…………..33
REVISION HISTORY…………………………………………………………………34
7
www.rivatech.de
1.FEATURES
Camera
Indoor / Outdoor PTZ Dome IP Camera
IP66 vandal proof (supported only with Outdoor Housing)
Sony 1/4” Exview HAD CCD
x36 Optical Zoom, x12 Digital Zoom
True Day & Night (IR Cut Filter) +DSS
Streaming
Dual streaming mode (such as different codec/resolution/bit rate and so on.)
De-interlacing on DSP
Burnt-in text supported
Unicast/Multicast supported
Video/Audio
Video compression: H.264/MPEG/MJPEG, 25/30FPS@D1(PAL/NTSC)
Audio compression: G.711(µLaw, aLaw)/PCM
Analog video out for external monitors
Video Motion Detection supported
Two-way mono audio supported
Network
RTSP/ HTTP protocol supported
10/100 Base-T Ethernet
Additional Features
RS-485 supported
OSD supported
SDK (Software Development Kit) provided
4ch DI / 2ch DO supported
VCA (Video Content Analysis)
Built-in Auto-Tracking license
VCA Presence (Included as basic)
VCA Surveillance (Optional)
8
www.rivatech.de
2. PACKAGE CONTENTS
Unpack carefully and handle the equipment with care. The packaging contains:
Camera
Ceiling Mount Bracket
Ceiling Cover
Screws
Wrench
Terminal block
(2Pin, 3Pin , 5Pin ,6Pin)
Safety Wire
Cable Ties
Quick Installation Guide
The above contents are subject to change without prior notice.
Note
i
9
www.rivatech.de
3.PART NAMES
Lock Screw
Bubble
Lock Holder
Dip Switch
Camera Lens
Ceiling Mount Bracket for indoor
10
www.rivatech.de
ALARM AUX
GND 1 2 1 2
D+
3 4 GND
D- GND
AC24VRS 485
GND
ON VIDEO
OUT
LINE OUT
MIC/
100 BaseT LINE IN
①
②
③
④
⑤
⑥
⑧
⑨
⑦
* Models herein and their
appearance are subject to change
without any prior notice.
11
www.rivatech.de
1LAN Connector (Ethernet)
This is a RJ45 LAN connector for 10/100 Base-T Ethernet.
This LED lights up as orange and turns green when the encoder is powered on.
LED operation setting:
For the factory default setting, LED 2 blinks for the heartbeat and LED 1 turns on for
video signal. To change its setting, refer to the section
4.5.11. LED Setting
of the
NVC Web Page User’s Manual.
2RS-485
The camera supports RS-485 Serial Communication Port.
33 pin connector for power
The camera needs an AC24V for power supply. Refer to the section “5.1.Connectors”
for more specific information.
4External video
It is an analog video output port.
55 pin connector for D/O
The camera provides 2 channel D/O. Refer to the section “5.1.Connectors”for more
specific information.
66 pin connector for D/I
The camera provides 4 channel D/I. Refer to the section “5.1.Connectors”for more
specific information.
7Audio Output
The camera has a mono audio output.
8Audio Input
The camera has a mono audio input.
9Reset
Reset switch is used for restarting or resetting the camera as Factory Default (FD).
Refer to the section “6.3. Reset”for more specific information.
LED1 LED2
12
www.rivatech.de
4.INSTALLATION
Before you install the camera, you
should set the DIP switches to configure
the camera ID, communication protocol.
Please refer to the page15. DIP Switch
1. Find the places which are strong
enough to support the camera, about
2kg.
2. Make a hole, Ø 147mm, on the
ceiling.
3. Hook the safety wire to suspension
and the safety wire hold on the bracket.
4. Install the ceiling mount bracket by
driving 4 screws, Ø 4mm tapping
screws.
5. You can make wires simple by cable
ties.
SAFETY WIRE
CABLE TIE
LOCK HOLDER 2
MOUNT HOLDER
147.0 mm
COVER HOLE
LOCK HOLDER 1
SAFETY WIRE HOLE
MOUNTING HOLE
CELING BRACKET
SCREW(Ø4.0)
A
B
C
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Cámara de seguridad de Riva
Riva
Riva RC8102HD-6111T Manual de usuario
Riva
Riva RC5510 Manual de usuario
Riva
Riva RC4602HD-6416 Manual de usuario
Riva
Riva RC4202HD Manual de usuario
Riva
Riva RC3102HD-5211 Manual de usuario
Riva
Riva RC3302HD-5344 Manual de usuario
Riva
Riva RC5510 Manual de usuario
Riva
Riva RC3502HD-5311IR Manual de usuario
Riva
Riva RC4602SV01-2017-A Manual de usuario
Riva
Riva IPX5502HD-6415-05 Manual de usuario
Riva
Riva RC3402HD-6311IR Manual de usuario
Riva
Riva RC3512HD-6311IR Manual de usuario
Riva
Riva RC4202HD Manual de usuario
Riva
Riva RC6702SV-7311 Manual de usuario
Riva
Riva RC6602HD-5311 Manual de usuario
Riva
Riva RC4602SV-7416A-30 Manual de usuario
Riva
Riva RC4100-1212-27 Manual de usuario
Riva
Riva RC3500M Manual de usuario
Riva
Riva RC100 Manual de usuario
Riva
Riva RC3502HD-5311 Manual de usuario
