Metra Electronics 99-5816 Manual de usuario

INSTALLATION INSTRUCTIONS FOR PART 99-5816

99-5816

APPLICATIONS

FORD Focus

2008-2011

KIT FEATU ES

• DIN adio Provision with Pocket

• ISO Mount adio Provision with Pocket

• Double DIN adio Provision

• Stacked ISO Mount Units Provision

• Painted To Match Factory Dash

• A) adio Housing • B) ISO Brackets • C) ISO Trim Plate • D) Double DIN Brackets

• E) Double DIN Trim Plate • F) Pocket • G) (2) Top Clips and (4) Middle adio Housing Clips

Wiring & Antenna Connections (sold seperately)

XSVI-5520-NAV - Ford Interface

AFSI-02 - if equipped w/ sync

70-5522 - Ford Sub Harness

KIT COMPONENTS

TOOLS EQUI ED:

Small Flat Blade Screwdriver/ Panel emoval Tool

• Phillips Screwdriver • Socket Set • Cutting Tool

1-800-221-0932

www.metraonline.com

BDE

(2) TOP CLIPS (4) MIDDLE CLIPS

SIDE VIEW SIDE VIEW

Dash Disassembly

Ford Focus 2008-2011 . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

.. 1,2

Kit Assembly

- Kit Preparation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

- DIN Mount Ra io Provision with Pocket . . . . . . . . . . . . . . . . . . . . . . . .4

- ISO Mount Ra io Provision with Pocket. . . . . . . . . . . . . . . . . . . . . . . .5

- Double DIN /Stacke ISO Mount Units Ra io Provision . . . . . . . . . . . . .6

Final Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7

TABLE OF CONTENTS

99-5816

Note:

Refer also to the instructions included with the aftermarket radio.

KNOWLEDGE IS POWER

Enhance your installation and fabrication skills by

enrolling in the most recognized and respected

mobile electronics school in our industry.

Log onto www.installerinstitute.com or call

800-354-6782 for more information and take steps

toward a better tomorrow.

FORD FOCUS 2008-2011

95-5816 DASH DISASSEMBLY

Disconnect the negative battery termi-

nal to prevent an accidental short cir-

cuit.

Unclip and remove the trim panel sur-

rounding the shifter and including the

cup holders.

(Figure A)

emove (2) 9/32” screws facing up

above the gauge cluster then unclip

and remove the trim panel surrounding

the gauge cluster.

(Figure C)

Unclip and remove the trim panel

above the glove box.

(Figure D)

Contin e on page 2.

emove (2) 9/32” screws from the bot-

tom edge of the factory radio trim

panel.

(Figure B)

PASS

AIRBAG

OFF

PASS

AIRBAG

OFF

PASS

AIRBAG

OFF

95-5816 DASH DISASSEMBLY

Contin e to kit preparation.

Unclip and remove the vent panel at

the top of the factory radio trim panel.

(Figure E)

emove (4) T-20 Torx screws securing

the climate controls to the factory

radio trim panel assembly and

remove the controls from the assem-

bly. ( etain the screws and climate

controls for re-use during kit prepara-

tion.)

(Figure G)

emove (4) T-20 Torx screws securing

the accessory socket panel to the

factory radio trim panel assembly and

remove the socket panel from the

assembly. (Retain the screws and

accessory socket panel for re- se

d ring kit preparation.)

(Figure G)

Unclip and remove the passenger air

bag light and the switch panel blank

plates. ( etain the air bag light and

blank plates for re-use during kit

preparation.)

(Figure G)

Unclip the factory radio trim panel

assembly. Unplug and remove the

assembly. Note: Some early models

had a gro nd strap attached to the

radio chassis and the s b dash with

an 8 MM bolt. Yo will need to nbolt

this strap to remove the factory radio

trim panel assembly.

emove (2) 9/32” screws behind the

vent panel removed in step 6.

(Figure F)

FORD FOCUS 2008-2011

1234 5

7 8 9 0

99-5816 KIT ASSEMBLY

KIT PREPARATION

Secure the climate control into the

radio housing using the factory hard-

ware. (

Figure A)

Secure the accessory socket panel to

the radio housing using the factory

hardware. (

Figure B)

Clip the passenger air bag light and

the switch panel blank plates in to

the radio housing. (

Figure C)

Attach Top and Middle adio Housing

Clips to the back of the radio housing.

(

Figure D,E)

NOTE: When the clips are properly

attached they sho ld be on a 90

degree angle with the radio ho sing.

(4) MIDDLE CLIPS

SIDE VIEW

(2) TOP CLIPS

SIDE VIEW FRONT VIEW FRONT VIEW

99-5816 KIT ASSEMBLY

DIN MOUNT RADIO PROVISION ITH POCKET

Slide the DIN cage into the radio hous-

ing and secure by bending the metal

locking tabs outward.

(Figure A)

Slide the aftermarket radio into the DIN

cage and until it snaps into place.

Snap the pocket into the radio housing.

(Figure C)

Contin e to final assembly.

*Note: Refer also to the instructions included with the aftermarket radio.

99-5816 KIT ASSEMBLY

ISO MOUNT RADIO PROVISION ITH POCKET

Mount the ISO Brackets to the radio

using the screws supplied with the

radio.

(Figure A)

Slide the radio into the radio housing

until it snaps into place.

(Figure B)

Snap the trim plate onto the front of

the adio Housing.

(Figure B)

Snap the Pocket into the radio

housing.

(Figure C)

Contin e to final assembly.

*Note: Refer also to the instructions included with the aftermarket radio.

99-5816 KIT ASSEMBLY

DOUBLE DIN/STACKED ISO MOUNT

UNITS RADIO PROVISION

Cut and remove the center bar from

the radio housing.

(Figure A)

Snap the Double DIN brackets to the

inside edge of the radio housing.

(Figure B)

Slide the Double DIN or stacked ISO

mount unit(s) into the bracket/radio

housing assembly and secure the

unit(s) to the assembly using the

screws supplied with the unit(s).

(Figure C)

Snap the double DIN trim plate onto

the front of the radio housing.

(Figure C)

Contin e to final assembly.

*Note: Refer also to the instructions included with the aftermarket radio.

99-5816 FINAL ASSEMBLY

FINAL ASSEMBLY

(A) Strip wire en s back 1/2"

B) Twist en s together

C) Sol er

D) Tape

Locate the factory wiring harness in the dash. Metra recommends using the

proper mating adapter and making connections as shown. (Isolate and individ-

ually tape off the ends of any unused wires to prevent electrical short circuit.)

e-connect the negative battery terminal and test the unit for proper operation.

eassemble radio and dash assemblies in reverse order of disassembly.

FINAL WIRING CONNECTIONS

Make wiring onne tions using the EIA olor ode hart shown below and the instru tions in luded with the

head unit. Metra re ommends making onne tions as shown below; Strip, Spli e, Solder, Tape. Isolate and

individually tape off ends of any unused wires to prevent ele tri al short ir uit.

METRA / EIA WIRING CODE

12V Ignition / A . . . . . . . . . . Red

12V Batt / Memory. . . . . . . . . Yellow

Ground. . . . . . . . . . . . . . . . . . Bla k*

Power Antenna. . . . . . . . . . . . Blue

Amp Turn-On . . . . . . . . . . . . . Blue / White

Amp Ground. . . . . . . . . . . . . . Bla k / White

Illumination . . . . . . . . . . . . . . Orange

Dimmer . . . . . . . . . . . . . . . . . Orange / White

Right Front (+) . . . . . . . . . . . . Gray

Right Front (-). . . . . . . . . . . . . Gray/ Bla k

Left Front (+) . . . . . . . . . . . . . White

Left Front (-). . . . . . . . . . . . . . White / Bla k

Right Rear (+) . . . . . . . . . . . . Violet

Right Rear (-) . . . . . . . . . . . . . Violet / Bla k

Left Rear (+) . . . . . . . . . . . . . Green

Left Rear (-) . . . . . . . . . . . . . . Green / Bla k

*NOTE: When a Bla k wire is not present, ground radio to vehi le hassis.

All olors may not be present on all leads due to manufa turer’s spe ifi ations.

NOTES

99-5816

Otros manuales para 99-5816

Tabla de contenidos

Otros manuales de Accesorios para automóviles de Metra Electronics

Metra Electronics

Metra Electronics 99-8903B Manual de usuario

Metra Electronics

Metra Electronics 95-7417 Manual de usuario

Metra Electronics

Metra Electronics 95-7330 Manual de usuario

Metra Electronics

Metra Electronics 99-9001 Manual de usuario

Metra Electronics

Metra Electronics 99-7804B Manual de usuario

Metra Electronics

Metra Electronics 108-TO7HG Manual de usuario

Metra Electronics

Metra Electronics 99-3307G Manual de usuario

Metra Electronics

Metra Electronics 99-3308G Manual de usuario

Metra Electronics

Metra Electronics 99-7954 Manual de usuario

Metra Electronics

Metra Electronics 107-FD1B Manual de usuario

Metra Electronics

Metra Electronics 99-7356B Manual de usuario

Metra Electronics

Metra Electronics 99-3303 Manual de usuario

Metra Electronics

Metra Electronics 99-3107S Manual de usuario

Metra Electronics

Metra Electronics 95-7863 Manual de usuario

Metra Electronics

Metra Electronics 95-8727 Manual de usuario

Metra Electronics

Metra Electronics 95-7324 Manual de usuario

Metra Electronics

Metra Electronics 99-3411 Manual de usuario

Metra Electronics

Metra Electronics 99-8201 Manual de usuario

Metra Electronics

Metra Electronics 95-9607B Manual de usuario

Metra Electronics

Metra Electronics XSVI-2004 Manual de usuario

Metra Electronics

Metra Electronics 99-7314 Manual de usuario

Metra Electronics

Metra Electronics 99-7509 Manual de usuario

Metra Electronics

Metra Electronics 95-7427B Manual de usuario

Metra Electronics

Metra Electronics 99-8715 Manual de usuario

Manuales populares de Accesorios para automóviles de otras marcas

James Baroud

James Baroud Odyssey Manual de usuario

Motorola

Motorola i50sx Manual de usuario

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manual de usuario

Feniex

Feniex T3 Manual de usuario

Renault

Renault 77 11 423 180 Manual de usuario

Kia

Kia E8300-4D000 Manual de usuario

Brink

Brink 756843 Manual de usuario

Whispbar

Whispbar K085W Manual de usuario

v.link

v.link CI-VL2-PC-HSD Manual de usuario

Viking

Viking Stack-Rack Guía de configuración rápida

Aries

Aries 203015 Manual de usuario

Choetech

Choetech AT0005 Manual de usuario

ZZ2

ZZ2 ZZAIR-PRO Manual de usuario

Holman

Holman 4A80L Manual de usuario

Thule

Thule 2075 Manual de usuario

Motorola

Motorola T325 Manual de usuario

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guía de instalación

DV8

DV8 FBJL-02 Manual de usuario