Johnson Controls M300CJ-R Manual de usuario

NOTE: All wiring must conform to applicable local codes, ordinances, and

regulations.

1. Install module wiring in accordance with the job drawings and appropri-

ate wiring diagrams.

2. Set the address on the module per job drawings.

3. Secure module to electrical box (supplied by installer), as shown in

Figure 2.

IMPORTANT: When using the M300CJ-REL for Class B applications, remove

Jumper (J1) and discard. The Jumper is located on the back as shown in

Figure 1B.

FIGURE 2. MODULE MOUNTING:

C1060-00

JC-460-008 1 I56-3368-000

M300CJ-REL Releasing Control Module

BEFORE INSTALLING

This information is included as a quick reference installation guide. Refer to

the control panel installation manual for detailed system information. If the

modules will be installed in an existing operational system, inform the opera-

tor and local authority that the system will be temporarily out of service. Dis-

connect power to the control panel before installing the modules.

NOTICE: This manual should be left with the owner/user of this equipment.

GENERAL DESCRIPTION

M300CJ-REL Releasing Control Modules are intended for use in intelligent, two-

wire systems, where the individual address of each module is selected using the

built-in rotary switches. This module is used to switch an external power sup-

ply, which can be a DC power supply to a solenoid. It also supervises the wiring

to the connected load and reports the status to the panel as NORMAL, OPEN, or

SHORT CIRCUIT. The M300CJ-REL has two pairs of output termination points

available for fault-tolerant wiring and a panel-controlled LED indicator.

COMPATIBILITY REQUIREMENTS

To ensure proper operation, this module shall be connected to a compati-

ble Johnson Controls system control panel only (list available from Johnson

Controls). In addition, please refer to Johnson Controls Device Compatibility

document for the list of compatible solenoids.

MOUNTING

The M300CJ-REL mounts directly to 4-inch square electrical boxes (see Figure

2). The box must have a minimum depth of 21/8inches. Surface mounted

electrical boxes (SMB500) are available (for indoor dry applications only).

FIGURE 1A. CONTROLS AND FIGURE 1B. JUMPER LOCATION:

I56-3368-000

SPECIFICATIONS

SLC

Normal Operating Voltage: 15 to 32 VDC Nominal

Average Operating Current: 700µA (LED flashing)

Maximum Activation Current: 9.0 mA (red LED on)

External Supply

Normal Operating Voltage: 24 VDC Nominal

Maximum Line Loss: 2.3 VDC (total allowable loss from power supply to module and from module to solenoid)

Minimum Operating Voltage to Activate Solenoid: 18 VDC (at solenoid)

Standby Current: 6.4 mA

Activation Current: 10 mA

Maximum Activation Current: 2 A

Solenoid

Supervisory Loop Voltage: 3.3 V

Supervisory Loop Current (Normal): 30 mA

Maximum Activation Current: 2 A

Temperature Range: 14°F to 140°F (-10°C to 60°C)

Humidity: 10% to 95% RH Non-condensing

Dimensions: 41/2˝ H × 4˝ W × 1

1/4˝ D; (106 mm H × 108 mm W × 31 mm D)

Accessories: Wall cover plate (included); SMB500 Surface Mount Electrical Box (for indoor dry applications only)

INSTALLATION AND MAINTENANCE INSTRUCTIONS

507 E. Michigan Street

Milwaukee, WI 53201

Phone: 414.524.4000

C1059-00 C0910-00

WIRING

INDICATORS:

FIGURE 3. TYPICAL CLASS B, SOLENOID CONFIGURATION:

(+)

(-)

(+)

(-)

(+)

(-) (-)

(+)

24 VDC CIRCUIT

DO NOT LOOP WIRE ON TERMINALS 10 & 11. BREAK WIRE

RUN TO PROVIDE SUPERVISION OF CONNECTIONS.

TO NEXT

MODULE

24 VDC POWER SUPPLY

ISOLATED, REGULATED,

POWER LIMITED PER NFPA

70. UL 864 LISTED FOR

RELEASING DEVICE

SERVICE USE WITH

BATTERY BACKUP.

POWER SUPPLY

SUPERVISION BY

MODULE

CONNECT MODULES TO LISTED

COMPATIBLE

CONTROL PANELS ONLY

SIGNAL LINE CIRCUIT (SLC)

32 VDC MAX.

TWISTED PAIR

IS RECOMMENDED

ALL WIRING SHOWN IS SUPERVISED

AND POWER LIMITED

RELEASING

CONTROL

MODULE

FROM

PANEL OR

DEVICE

TO NEXT

DEVICE

OUTPUT TO A UL LISTED FIRE

ALARM RELEASING SOLENOID

(REFER TO PANEL MANUFACTURER'S

INSTALLATION DOCUMENT)

C0996-02

FIGURE 4. TYPICAL CLASS A, SOLENOID CONFIGURATION:

(+)

(–)

(+)

(–)

(+)

(–)

(+)

(–)

ALL WIRING SHOWN IS SUPERVISED AND POWER LIMITED

POWER SUPPLY

SUPERVISION BY

MODULE

TO NEXT

MODULE

TO NEXT

DEVICE

SIGNAL LINE CIRCUIT (SLC)

32 VDC MAX.

TWISTED PAIR

IS RECOMMENDED

CONNECT MODULES TO

LISTED COMPATIBLE

CONTROL PANELS ONLY

FROM

PANEL OR

DEVICE

24 VDC CIRCUIT

DO NOT LOOP WIRE ON TERMINALS 10 & 11. BREAK WIRE

RUN TO PROVIDE SUPERVISION OF CONNECTIONS.

24 VDC POWER SUPPLY

ISOLATED, REGULATED,

POWER LIMITED PER

NFPA 70. UL 864 LISTED

FOR RELEASING DEVICE

SERVICE USE WITH

BATTERY BACKUP.

RELEASING

CONTROL

MODULE

OUTPUT TO A UL LISTED FIRE

ALARM RELEASING SOLENOID

(REFER TO PANEL MANUFACTURER'S

INSTALLATION DOCUMENT)

C0997-02

JC-460-008 2 I56-3368-000

Otros manuales de Unidad de control de Johnson Controls

Johnson Controls

Johnson Controls System 350 Manual de servicio

Johnson Controls

Johnson Controls Penn System 450 Series Manual de usuario

Johnson Controls

Johnson Controls V46SA Series Manual de usuario

Johnson Controls

Johnson Controls Autocall MX Indoor Isolated Callpoint Manual de usuario

Johnson Controls

Johnson Controls System 350 Y350R Manual de servicio

Johnson Controls

Johnson Controls PENN P470 Manual

Johnson Controls

Johnson Controls NIE39 Manual de usuario

Johnson Controls

Johnson Controls Digital Vision Network 5000 Series Guía de inicio rápido

Johnson Controls

Johnson Controls A19ZBC Series Manual de servicio

Johnson Controls

Johnson Controls M4-XPM Manual de usuario

Johnson Controls

Johnson Controls 300 Series Manual de usuario

Johnson Controls

Johnson Controls Tyco TJPX0500003 Manual de usuario

Johnson Controls

Johnson Controls A19 Series Manual de usuario

Johnson Controls

Johnson Controls Tyco CV-300B Manual de usuario

Johnson Controls

Johnson Controls MS-IOM2710-0U Manual de usuario

Johnson Controls

Johnson Controls System 450 Series Manual de usuario

Johnson Controls

Johnson Controls VG8000V Series Manual de usuario

Johnson Controls

Johnson Controls S1-TTSCC01 Manual de usuario

Johnson Controls

Johnson Controls GM 20 Series Manual de usuario

Johnson Controls

Johnson Controls Mercury P2000 CKM-MR16IN Manual

Johnson Controls

Johnson Controls TrueRH Series Guía

Johnson Controls

Johnson Controls Mercury 3 Series Manual

Johnson Controls

Johnson Controls F4-XPM Series Manual de usuario

Johnson Controls

Johnson Controls IOM3723 Manual de usuario

Manuales populares de Unidad de control de otras marcas

Festo

Festo Compact Performance CP-FB6-E Manual de lista de piezas

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manual de usuario

JS Automation

JS Automation MPC3034A Manual de usuario

JAUDT

JAUDT SW GII 6406 Series Guía rápida

Spektrum

Spektrum Air Module System Manual de usuario

BOC Edwards

BOC Edwards Q Series Manual de usuario

KHADAS

KHADAS BT Magic Manual de usuario

Etherma

Etherma eNEXHO-IL Manual de usuario

PMFoundations

PMFoundations Attenuverter Manual de usuario

GEA

GEA VARIVENT Manual de usuario

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manual de usuario

Altronix

Altronix LINQ8PD Instrucciones de montaje

Eaton

Eaton Powerware Series Manual de usuario

WAGO

WAGO 750-407/040-000 Manual de usuario

Sony

Sony CCU-590 Manual de usuario

Graco

Graco 25D614 Manual de usuario

Task Force Tips

Task Force Tips YE-RF-900 Manual de programación

Shini

Shini SPV-U Series Manual de usuario