Interlogix TVB-WBS Manual de usuario

Interlogix is part of UTC Climate, Controls & Security, a unit of United Technologies Corporation.

TVB-WBS Stainless Steel Bullet (Box Camera

Housing) Wall Mount Installation Instructions

Specifications

Dimensions

: 412.5 × 140 × 228 mm

(16.24 × 5.51 × 8.98 in.)

412.5 mm (16.24 in.)

140 mm (5.51 in.)

228 mm

(8.98 in.)

200 mm

(7.87 in.)

145 mm

5.71 in.)

Weight:

3.80 kg (8.38 lb.)

ccessories:

Expansion anchors: 4

pcs

Used to

install the TVB-WBS stainless steel wall mount to the

mounting surface.

Screw

A: 4 pcs

Used to install the

stainless steel bullet camera to the TVB-WBS

wall mount

Supported cameras

The stainless steel wall mount can be used with following

cameras:

Stainless Steel Bullet (Box

Camera Housing) Camera:

TVB-5801, TVB-5802

Installation

To install the stainless steel bullet (box camera housing)

camera to the TVB-WBS:

1. Mark and drill the mounting holes for the expansion

anchors in the mounting surface. Hammer the supplied M8

expansion anchors into the mounting holes.

2. The wall mount allows you to adjust the position of the

camera by using the pan (2) and tilt (1) adjust brackets.

You may not need to use all the screws provided to lock

the camera into position, depending on the amount of

range required.

Note: If preferred mount the bullet (box camera housing)

on the wall mount without removing the universal joint

base (2). Use screw A as shown in step 5.

3. Remove the eight screws that attach the tilt bracket (1) to

the pan bracket (2)

2 / 2 P/N 1073411-EN • REV B • ISS 23APR18

4. Route the cable harness through the cable access hole in

the wall mount.

5. Secure the housing base (1) to the tilt bracket (2) using

screw A (3), as shown below.

6. Loosen the three pan adjustment screws (1) and rotate the

camera housing to the proper location).

7. Once the camera is pointing towards the targeted scene,

tighten the pan adjustment screws. Install the camera

housing on the wall mount by matching up the pan and tilt

brackets, as shown. Use two of the screws to attach the

brackets together, using the non-slotted screw holes. The

other screws are used to set the tilt angle. Depending on

the tilt angle required, all the screws may not be needed.

Once the tilt angle is set, tighten the tilt adjustment screws

to lock the position in place.

Legal and regulatory information

Trademarks and

patents

The trade names used in this document may be

trademarks or registered trademarks of the

manufacturers or vendors of the respective

products.

Manufacturer

Interlogix.

2955 Red Hill Avenue, Costa Mesa, CA 92626

5923, USA

Authorized EU manufacturing representative:

UTC Fire & Security B.V.

Kelvinstraat 7, 6003 DH Weert, The Netherlands

Certification

Product warnings

and disclaimers

THESE PRODUCTS ARE INTENDED FOR

SALE TO AND INSTALLATION BY QUALIFIED

PROFESSIONALS. UTC FIRE & SECURITY

CANNOT PROVIDE ANY ASSURANCE THAT

ANY PERSON OR ENTITY BUYING ITS

PRODUCTS, INCLUDING ANY “AUTHORIZED

DEALER” OR “AUTHORIZED RESELLER”, IS

PROPERLY TRAINED OR EXPERIENCED TO

CORRECTLY INSTALL FIRE AND SECURITY

RELATED PRODUCTS.

For more information on warranty disclaimers and

product safety information, please check

www.firesecurityproducts.com/policy/product-

warning/ or scan the following code:

Contact

information and

manuals

For contact information go to: www.interlogix.com

or www.firesecurityproducts.com

To get translations for this and other product

manuals go to: www.firesecurityproducts.com

Tabla de contenidos

Otros manuales de Cámara de seguridad de Interlogix

Interlogix

Interlogix TruVision TVD-6120VE-2 Manual de usuario

Interlogix

Interlogix PIR Manual de usuario

Interlogix

Interlogix TruVision 5 Series Hoja de instrucciones

Interlogix

Interlogix UVD-XP4DNR Manual de usuario

Interlogix

Interlogix TruVision 4 IP Series Hoja de instrucciones

Interlogix

Interlogix TruVision TVC-6110-1 Instrucciones de funcionamiento y mantenimiento

Interlogix

Interlogix TruVision Series Manual de usuario

Interlogix

Interlogix UVD-XP3DNR Instrucciones de montaje

Interlogix

Interlogix UVC-XP4DN-HR Manual de usuario

Interlogix

Interlogix TruVision TVB-2402 Instrucciones de funcionamiento y mantenimiento

Interlogix

Interlogix TruVision TVT-2103 Manual de usuario

Interlogix

Interlogix TruVision Line Manual de usuario

Interlogix

Interlogix TruVision TVD-2401 Manual de usuario

Interlogix

Interlogix TruVision 4 Series Manual de usuario

Interlogix

Interlogix TVF-1101 Manual de usuario

Interlogix

Interlogix TVW-6101 Manual de usuario

Interlogix

Interlogix TruVision TVD-2402 Manual de usuario

Interlogix

Interlogix TruVision TVP-5201 Hoja de instrucciones

Interlogix

Interlogix TruVision TVW-2401 Manual de usuario

Interlogix

Interlogix TVB-5501 Manual de usuario

Interlogix

Interlogix UltraView UVD-6130VE-2-P Manual de usuario

Interlogix

Interlogix TruVision HD-TVI 3MPX Hoja de instrucciones

Interlogix

Interlogix 36X Manual de usuario

Interlogix

Interlogix TruVision TVT-2101 Manual de usuario

Manuales populares de Cámara de seguridad de otras marcas

Okina USA

Okina USA SIR36-870VF650LP Manual de usuario

Divio

Divio NDR155PA Manual de usuario

Canon

Canon VB-C500D Manual de usuario

Easy Access

Easy Access EasyGuard Manual de usuario

Vivotek

Vivotek FD9389-EHV-v2 Manual de usuario

TUYA

TUYA COSMO W2 Manual de usuario

Eusso

Eusso UNC7500-IR Guía de configuración

urmet domus

urmet domus 1096/204 Manual de usuario

VC VC20 series Manual de usuario

Axis

Axis Q1614 Manual de usuario

ieGeek

ieGeek DD201 Manual de usuario

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Manual de usuario

Vicon

Vicon V662-D-1 Instrucciones de funcionamiento

Grundig

Grundig GCH-K0274P Manual de usuario

Lorex

Lorex VANTAGE LBC7032 Manual de usuario

4xem

4xem WPT Manual de usuario

Samsung

Samsung SCV-3082 Manual de usuario

Vitek

Vitek VTC-C544 Manual de usuario