Interlogix UVP-N120P-36X(-P) Manual de usuario

UltraView IP PTZ 36X

Camera User Manual

P/N 1071693D-EN • ISS 05DEC12

2012 UTC Fire & Security Americas Corporation, Inc.

Interlogix is part of UTC Climate Controls & Security, a unit of United

Technologies Corporation. All

rights reserved.

Trademarks and patents

UltraView name and logo are trademarks of United Technologies.

Other trade names used in this document may be trademarks or

registered trademarks of the manufacturers or vendors of the

respective products.

Manufacturer

UTC Fire & Security Americas Corporation, Inc.

2955 Red Hill Avenue, Costa Mesa, CA 92626

-5923, USA.

Authorized EU manufacturing representative:

UTC Fire & Security B.V.

Kelvinstraat 7, 6003 DH Weert,

The Netherlands

Certification

N4131

FCC compliance

Class A

: This equipment has been tested and found to comply with

the limits for a Class A digital device, pursuant to part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in

commercial environment. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in

accordance with the instruction manual, may cause harmful

interference to radio communications. Operation of this equipment in

a residential area is likely to cause harmful interference in which

case the user will be required to correct the interference at his own

expense.

ACMA compliance

Notice!

This is a Class A product. In a domestic environment this

product may cause radi

o interference in which case the user may be

required to take adequate measures.

Canada

This Class A digital apparatus complies with Canadian ICES

-003.

Cet appareil numérique de la class A conforme à la norme NMB

003

du Canada.

European Union

directives

2004/108/EC (EMC directive)

: Hereby, UTC Fire & Security

declares that this device is in compliance with the essential

requirements and other relevant provisions of Directive 2004/108/EC

2002/96/EC (WEEE directive)

: Products marked with this symbol

cannot be disposed of as unsorted municipal waste in the European

Union. For proper recycling, return this product to your local supplier

upon the purchase of equivalent new equipment, or dispose of it at

designated collection points. For more

information see:

www.recyclethis.info.

Contact information

www.interlogix.com or

www.utcfssecurityproducts.eu

Customer support

w.interlogix.com/customer-support

UltraView IP PTZ 36X Camera User Manual i

Content

Chapter 1 Introduction 1

Product description 1

Features 1

Chapter 2 Installation 3

Installation environment 3

Before you begin 4

Camera description 4

Specifications 5

System requirements 5

Installing the camera 6

Accessing the SDHC card 10

Connections 11

Chapter 3 Using the Web browser 13

Checking your Web browser security level 13

Accessing the camera over the internet 14

Overview of the camera Web browser 15

Configuring the camera 17

Chapter 4 Camera setup 23

Camera information 23

DST time 23

Camera configuration 24

Display information 25

Video recording parameters 26

Camera tamper alarm 30

Adding extra text on-screen 32

Camera image settings 33

Reset camera settings 36

Restore camera settings to default 36

Chapter 5 Motion setup 37

PTZ channel 38

Park action 39

Home preset position 39

Preset position 40

Limit PTZ movement 41

Preset tour settings 43

Shadow Tour settings 46

Privacy masking 48

Time task 49

Clearing customized settings 51

ii UltraView IP PTZ 36X Camera User Manual

Chapter 6 Network setup 53

Chapter 7 Alarm setup 57

Motion detection 57

Event schedule for alarms 59

Alarm set up 60

Chapter 8 Camera management 63

User management 63

Format the SDHC card 66

Firmware upgrade 66

Restore default settings 66

Reboot the camera 67

Chapter 9 Camera operation 69

On-screen display 69

Live mode 69

Searching recorded video for playback 70

Playing back recorded files 72

Viewing logs 72

Searching for logs 73

Archiving recorded files 74

Using predefined presets 75

Appendix A Pin definitions 77

Index 79

UltraView IP PTZ 36X Camera User Manual 1

Chapter 1

Introduction

Product description

The UltraView IP PTZ 36X camera features integrated network remote

monitoring capability with the functions of a high speed dome. It is easy to install

and operate.

The dome camera is ideal for all surveillance requirements in a wide variety of

locations such as roads, airports, railway stations, harbors, stadiums, scenic

areas and parking lots.

This is the user manual for UltraView IP PTZ 36X camera models:

UVP-N120P-36X(-P)

UVP-N120S-36X(-P) (North America only)

UVP-N120F-36X(-P)

Features

This section describes the UltraView IP PTZ 36X camera features.

Built-in Web server

One channel of compressed video stream transmitted via network and

decoded for local display

Supports up to six connections via the network

Supports multiple network transmission protocols

Web access for WAN applications

Management of dome configuration and user permission administration via

Ethernet

IP address dynamic allocation

Built-in driver/receiver

Integrated design ensures high reliability

Chapter 1: Introduction

2 UltraView IP PTZ 36X Camera User Manual

256 presets and 8 tours programmable, each tour with a maximum of 32

configurable presets

Supports up to four shadow tours with a recording time of up to 10 minutes

Up to 24 programmable privacy mask areas (depending on camera models)

Built-in pan/tilt

High-precision motor drive, stable operation, sensitive reaction and precise

positioning

Integrated design with compact construction

360° continuous rotation

Low-speed movement ensures high image stability

Preset positioning tolerance less than 0.1°

Built-in zoom lens

High sensibility and high resolution

Auto focus

Automatic gain control

Auto white balance

Auto IR cut filter

UltraView IP PTZ 36X Camera User Manual 3

Chapter 2

Installation

This chapter provides information on how to install the dome camera.

Installation environment

When installing your product, consider these factors:

• Handling: Handle the camera carefully. Avoid striking, shaking, etc. Improper

handing or storage could damage the camera.

• Electrical: Install electrical wiring carefully. It should be done by qualified

service personnel. The input electricity to the unit has a tolerance of 24 VAC ±

10%. Do not overload the power cord or adapter.

• Ventilation: Ensure that the location planned for the installation of the

camera is well ventilated.

• Temperature: Do not operate the camera beyond the specified temperature,

humidity or power source ratings. The operating temperature of the indoor

camera is between -10°C to 50°C (14°F to 122°F) and that of the outdoor

camera is between -30°C to 60°C (-22°F to 140°F). Humidity is below 90%.

• Moisture: Do not expose the indoor camera to rain or moisture, or try to

operate it in wet areas. The indoor camera is designed for indoor use or

locations only where it is protected from rain and moisture. Turn the power off

immediately if the camera is wet and ask a qualified service person for

servicing. Moisture can damage the camera and also create the danger of

electric shock.

• Cleaning: Clean only with a dry cloth. If the dirt is difficult to remove, use a

mild liquid non-abrasive detergent and wipe gently.

• Protect from strong light: Never face the camera towards the sun. Do not

aim the camera at bright objects. Whether the camera is in use or not, never

aim it at the sun or other extremely bright objects. Otherwise, the camera may

be smeared or damaged.

• Servicing: Do not attempt to service this camera yourself. Any attempt to

dismantle or remove the covers from this product will invalidate the warranty

Chapter 2: Installation

4 UltraView IP PTZ 36X Camera User Manual

and may also result in serious injury. Refer all servicing to qualified service

personnel.

Before you begin

When you receive the product, check the package and contents for damage, and

verify that all items are included. If any of the items are damaged or missing,

please contact your local supplier. If you need to return the unit, you must ship it

in the original box.

The camera is shipped with the following items:

Dome camera

User manual

Quick Start Guide

Camera description

Figure 1: Camera dimensions

Pendant-mount camera

Flush-mount camera

Chapter 2: Installation

UltraView IP PTZ 36X Camera User Manual 5

Figure 2: Overview of the dome camera

1. Ethernet RJ-45 connector.

Connect to the network devices.

2. Video output.

Connect the BNC connector to a CCTV

monitor. Optional.

3. Power supply cord.

Connect +24 VAC power supply.

4. Housing.

5. PTZ module.

6. Bubble.

Specifications

Operating temperature

Pendant housing: -10 to +50 °C (-14 to +122 °F)

Flush housing: -30 to +65 °C (-22 to +149 °F)

Power supply

24 VAC +/- 4 VAC

Power

consumption 30 W (heater on), 15 W (heater off)

Dimensions (mm)

Pendant housing: Ø 220 × 261 mm (Ø 8.66 ×10.27 in.)

Flush housing: Ø 206 × 241 mm (Ø 8.11 × 9.49 in.)

Environmental

Pendant housing: IP66

Flush housing: IP54

Weight

5 kg (11 lb.)

System requirements

For proper operation, adhere to the following operational, cable, and power

requirements for the dome camera.

Cable requirements

Table 1 on page 6 lists the requirements for the cables that connect to the dome

camera.

Chapter 2: Installation

6 UltraView IP PTZ 36X Camera User Manual

Table 1: Recommended cable requirements

Operation

Cable requirement Max. length

feet meters

Data (RS

-485) Not used

Video

75 ohm RG-59 coaxial cable with BNC ends. 750 228

Alarm

Cat 5 cable (recommended) 1250 381

Network

Cat 5 cable (recommended) 492 150

Power

24 VAC cable. To determine the size of cable needed for individual

applications, see “Power cable size and length requirements” below.

Power cable size and length requirements

Use the proper gauge of power cable to ensure proper operation and to avoid

voltage drops. See Table 2 below for the recommended cable gauge for varying

maximum cable lengths and power draws.

Table 2: Recommended power cable gauges based on maximum lengths for an operating

voltage of 24 VAC (±10%)

Wire gauge

mm (diameter) Power

30 W 40 W

Distance

(feet) Distance

(m) Distance

(feet) Distance

(m)

0.80 94 28 70 21

1.00 150 45 112 34

1.25 238 72 179 54

2.00 603 183 452 137

Installing the camera

For basic operation, you need to connect Ethernet, power and video output

cables to the components in the dome shown in Figure 2 on page 5. For

advanced operation, you can also connect any combination of alarm, relay, or

audio cables to the dome.

A qualified service person, complying with all applicable codes, should perform

all required hardware installation.

Note: After removing the protective foil, it is recommended to clean the bubble in

order to ensure a clear view at all times.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Cámara de seguridad de Interlogix

Interlogix

Interlogix TruVision TVB-2401 Manual de usuario

Interlogix

Interlogix UVC-XP4DN-HR Manual de usuario

Interlogix

Interlogix TruVision TVP-5201 Hoja de instrucciones

Interlogix

Interlogix UltraView PTZ Manual de usuario

Interlogix

Interlogix TVW-6101 Manual de usuario

Interlogix

Interlogix TruVision Line Manual

Interlogix

Interlogix TruVision TVB-2401 Manual de usuario

Interlogix

Interlogix TruVision Series Manual de usuario

Interlogix

Interlogix UVP-M1120P-18X-N Manual de usuario

Interlogix

Interlogix 36X Manual de usuario

Interlogix

Interlogix UVD-XP4DNR Manual de usuario

Interlogix

Interlogix TruVision TVD-2402 Manual de usuario

Interlogix

Interlogix TruVision Line Manual de usuario

Interlogix

Interlogix TruVision TVD-2401 Manual de usuario

Interlogix

Interlogix TruVision TVB-2402 Hoja de instrucciones

Interlogix

Interlogix TruVision TVA-1101 Manual de usuario

Interlogix

Interlogix TVB-2201 Manual de usuario

Interlogix

Interlogix UVC-XP4DN-HR-P Manual de usuario

Interlogix

Interlogix UVC-XP4DN-HR Manual de usuario

Interlogix

Interlogix TruVision TVB-2402 Manual de usuario

Interlogix

Interlogix TVP-6102 Manual de usuario

Interlogix

Interlogix UVC-XP4DN-HR Manual de usuario

Interlogix

Interlogix TruVision TVW-2401 Manual de usuario

Interlogix

Interlogix TruVision 4 IP Series Hoja de instrucciones

Manuales populares de Cámara de seguridad de otras marcas

Okina USA

Okina USA SIR36-870VF650LP Manual de usuario

Divio

Divio NDR155PA Manual de usuario

Canon

Canon VB-C500D Manual de usuario

Easy Access

Easy Access EasyGuard Manual de usuario

Vivotek

Vivotek FD9389-EHV-v2 Manual de usuario

TUYA

TUYA COSMO W2 Manual de usuario

Eusso

Eusso UNC7500-IR Guía de configuración

urmet domus

urmet domus 1096/204 Manual de usuario

VC VC20 series Manual de usuario

Axis

Axis Q1614 Manual de usuario

ieGeek

ieGeek DD201 Manual de usuario

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Manual de usuario

Vicon

Vicon V662-D-1 Instrucciones de funcionamiento

Grundig

Grundig GCH-K0274P Manual de usuario

Lorex

Lorex VANTAGE LBC7032 Manual de usuario

4xem

4xem WPT Manual de usuario

Samsung

Samsung SCV-3082 Manual de usuario

Vitek

Vitek VTC-C544 Manual de usuario