Clarke CAX20S Manual de usuario

USER INSTRUCTIONS

ORIGINAL INSTRUCTIONS GC0422

20 TONNE SHORT AXLE STAND

MODEL NO: CAX20S

PART NO: 7600029

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

SAFETY WARNINGS

•Read these instructions carefully before

use.

• Do not exceed the axle stands maximum

load (20 tonne each stand), The vehicle

weight will be stated in the owners

manual.

• Use only as specified in this manual.

• NEVER let children play in or around a

vehicle that is on axle stands.

• ALWAYS make sure that before you work

below the vehicle, a responsible person is

aware in case of injury or accident.

• Do not use more than one pair of axle

stands.

• Replace the warning label if it becomes

unreadable.

• Use only on a hard, flat surface, for

example concrete.

• Make sure that you chock all the wheels

that remain on the ground.

• Make sure that the supported vehicle

cannot move.

• Set each axle stand below an

appropriate strong point on the vehicle -

See your vehicle owners manual for

advice.

• Take care when using the axle stands on

a three-wheeled vehicle or trailer.

• Use stands as a matched pair to support

one end of a vehicle only.

• For your safety, never attempt to modify

these axle stands.

WARNING: NEVER WORK UNDER A VEHICLE SUPPORTED ONLY BY A JACK.

WARNING: AFTER LIFTING THE VEHICLE, SUPPORT IMMEDIATELY WITH

PROPERLY RATED AXLE STANDS.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

USING THE AXLE STANDS

1. Refer to the vehicle handbook for

the correct jacking procedure and

location of support points.

2. Raise the vehicle using a suitable

lifting jack.

ADJUSTING THE AXLE STAND(S)

1. Raise the column to the required

height by rotating the handles while

hold the saddle to prevent it from

rotating.

• Turn the handles clockwise (looking

from above) to raise the saddle.

2. Position the axle stand under a

suitable supporting point. See your

vehicle manual for the location.

LOWERING THE VEHICLE

1. Slowly lower the vehicle onto the centre of the saddle.

REMOVING THE AXLE STANDS

1. Use a suitable jack to raise vehicle clear of the axle stands.

2. Remove stands.

3. Ensure that all tools, equipment and personnel are clear before carefully

lowering the vehicle to the ground.

WARNING: BEFORE USE, MAKE SURE THAT THERE IS NO DAMAGE TO ANY

PART OF THE AXLE STAND, IF THERE IS, DO NOT USE.

WARNING: DO NOT EXCEED THE RATED LOAD OF 20 TONNE PER STAND.

WARNING: IT MUST BE ENSURED THAT THE VEHICLE/LOAD IS CAREFULLY

LOCATED ONTO THE CENTRE OF THE AXLE STAND SADDLE. FAILURE TO DO

THIS CAN RESULT IN DAMAGE TO THE AXLE STANDS, LOSS OF SUPPORT TO

THE LOAD, SERIOUS PERSONAL INJURY OR LOSS OF LIFE.

WARNING: DO NOT LOAD THE STANDS OFF CENTRE. FAILURE TO HEED THIS

WARNING MAY CAUSE DAMAGE, INJURY OR LOSS OF LIFE.

SPECIFICATION

GUARANTEE

This product is guaranteed against faulty manufacture for a period of 12

months from the date of purchase. Please keep your receipt which will be

required as proof of purchase.

This guarantee is invalid if the product is found to have been abused or

tampered with in any way, or not used for the purpose for which it was

intended.

Faulty goods should be returned to their place of purchase, no product can

be returned to us without prior permission.

This guarantee does not effect your statutory rights.

Product Dimensions (HxWxD) 330 x 330 x 630 mm (fully extended)

Maximum Support Height 600 mm

Minimum Support Height 410 mm

Maximum Load 20 tonne (20,000 kg) per stand

Product Weight 26.1 kg per stand

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Rack y soporte de Clarke

Clarke

Clarke CUTS1 Manual de usuario

Clarke

Clarke CSR4200 Manual de usuario

Clarke

Clarke CWR1 Manual de usuario

Clarke

Clarke MCD1 Manual de instrucciones

Clarke

Clarke CBS3 Manual de usuario

Clarke

Clarke Strong-Arm CES450 Manual de usuario

Clarke

Clarke CHT399 Manual de instrucciones

Clarke

Clarke LB5S Manual de instrucciones

Clarke

Clarke CTS4000B Manual de usuario

Clarke

Clarke CSR4550BO Manual de usuario

Clarke

Clarke CAX3TBC Manual de usuario

Clarke

Clarke Metalworker CL430 Manual de usuario

Clarke

Clarke CARS1 Manual de instrucciones

Clarke

Clarke CMS1 Manual de usuario

Clarke

Clarke CWC80B Manual de usuario

Clarke

Clarke CSM5175 Series Manual de usuario

Clarke

Clarke CWR45B Manual de programación

Clarke

Clarke CSP420 Manual de usuario

Clarke

Clarke CMSS Manual de usuario

Clarke

Clarke Strong-Arm CES340 Manual de usuario

Clarke

Clarke LB7S Manual de instrucciones

Clarke

Clarke CWR45 Manual de programación

Clarke

Clarke CES680F Manual del propietario

Clarke

Clarke STRONG-ARM CAX3TPB Manual de usuario

Manuales populares de Rack y soporte de otras marcas

Salamander

Salamander Acadia AC/W/L400/WH Manual de usuario

Fohhn

Fohhn VAT-09 Guía del usuario

ricoo

ricoo FS0522 Manual de usuario

AMSOIL

AMSOIL BMK-22 Guía rápida

Kargo Master

Kargo Master 48220 Manual de usuario

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Manual de usuario

ricoo

ricoo S1222 Manual de usuario

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Manual de usuario

VidaBox

VidaBox VB MNT FFS2 Manual de usuario

Welch Allyn

Welch Allyn 48960 Manual de usuario

Arkon

Arkon CM035-ST-2 Manual de usuario

PROEL

PROEL PLWIN60C Manual de usuario

Agilent Technologies

Agilent Technologies E2609B Manual de usuario

Mustang

Mustang MV-ARM4 Manual de usuario

Mounting Solutions

Mounting Solutions WRM-320 Manual de usuario

Pyle

Pyle PMKSPAD1 Manual de usuario

ShelterIt

ShelterIt 21208 Manual de usuario

SPL

SPL RackPack?4 1040 Manual de usuario