Billion BiPAC 7401V(G)P R4 Manual de usuario

BiPAC 7401V(G)P R4

VoIP/ (802.11g) ADSL2+

Firewall Router

Quick Start Guide

Billion BiPAC 7401V(G)P R4 VoIP/ (802.11g) ADSL2+ Firewall Router

PLEASE READ THE QUICK START GUIDE AND FOLLOW THE

STEPS CAREFULLY. THIS QUICK START GUIDE WILL HELP YOU

INSTALL THE DEVICE PROPERLY AND AVOID IMPROPER USAGE.

IF YOU NEED MORE INFORMATION ON THIS SOFTWARE

CONFIGURATION, PLEASE REFER TO THE USER MANUAL ON

CD-ROM.

BiPAC 7401V(G)P R4 ADSL2+ Router

CD (containing manual, utility, QSG)

RJ-11 ADSL/ telephone cable

Ethernet (RJ-45) cable

One 2dBi detachable antenna (Wireless model only)

Power adapter

RJ-45 to RS-232 Console Kit

Quick Start Guide

Splitter/ Micro-filter (Optional)

zDo not use the router in high humidity or high temperatures.

zDo not use the same power source for the router as other

equipment.

zDo not open or repair the case yourself. If the router is too hot,

turn off the power immediately and have it repaired at a qualified

service center.

zAvoid usin

this

roduct and all accessories outdoors.

Warning

zPlace the router on a stable surface.

zOnly use the power adapter that comes with the package. Using a

different voltage rating power adaptor may damage the router.

Attention

-1-

Quick Start Guide

The Front LEDs

The Rear Ports

Connect to the ADSL

telephone network with

RJ-11 cable (telephone).

Press the RESET button

for 6 seconds and abo

to restore the facto ve

default settings.

Connect to PC or an

office/home network of

10Mbps or 100Mbps with

UTP Ethernet cable. Port

4 can be either a LAN or

Console port at a time but

not both.

Connect with the

detachable antenna.

Lit orange when

power is ON. Lit red

means system is fai

Lit green when th l.

system is ready.

wall 1 cable.

Lit green when one of

LAN ports is connected to

an Ethernet device.

Blink when data is being

Connect to the

telephone jack on the

with RJ-1

Transmitted / Received. Lit Green when the device is

successfully connected to an

ADSL DSLAM. (“line sync”)

sending/receiving data.

Lit green when the

SIP Registration is

OK.

Lit green when a wireless

connection is

established. Flash green

when the device is

Power ON/OFF

witch

Lit green when the

inbound and outboun

calls are transm d

itted

through PSTN.

Connect to an

analog phone

set with RJ-11

cable.

Lit red when WAN port fails to

get IP address. Lit green w

WAN port gets IP address

successfully. Lit off when

device in bridged mode or

hen

WAN connection not present.

Lit green when the

phone is off hook.

Connect it with

the supplied

power adapter.

Push to trigger W

Protected Set i-Fi

function.

-2-

Billion BiPAC 7401V(G)P R4 VoIP/ (802.11g) ADSL2+ Firewall Router

* Note: For WPS configuration, please refer to th

e WPS section of User Manual.

1. Plug the supplied power adapter to the wall jack and the other side to the router.

Please note that the plug type may differ according to different countries.

Power Connection

LAN Connection2. Connect the supplied RJ-45 Ethernet cable to one of the Ethernet ports, and the

other side to the PC’s Ethernet interface.

-3-

Quick Start Guide

3. Phone Connection

Connect RJ-11 cable to the router’s phone port and the analog phone set.

4. Line Connection

a) Connect RJ-11 cable to the router Line port and the splitter phone port.

b) Connect RJ-11 cable to the router DSL port and the splitter ADSL port.

c) Connect RJ-11 cable to the splitter Line port and the phone jack on the wall.

5. EWAN Connection

Connect RJ-45 Ethernet cable to the Ethernet port # 1 (EWAN), and connect the

other side to another alternative broadband device, such as Cable Modem, VDSL,

Fibre Modem or PON optic lines. Please refer to User Manual for detail instruction.

-4-

Billion BiPAC 7401V(G)P R4 VoIP/ (802.11g) ADSL2+ Firewall Router

6. Splitter/ Micro-filter Connection

The Splitter / Micro-filter are important for ADSL installation, they help direct

high-frequency signals to the ADSL modem & low frequency signals to the

telephone or other analogue device to prevent inter-modulation distortion & get

good speed/stable ADSL sync rate.

a) Splitter connection

If the installation has only a single telephone and a single ADSL modem, then a

splitter can be employed.

b) Micro-filter connection

If the installation has several telephones or other analog devices, then an internal

micro-filter can be employed at each analog device.

After you complete the hardware installation insert CD into the CD Drive to run the setup utility.

The setup utility will auto-run. Follow the step-by-step configuration wizard & it will guide you to

setting up the basic network configuration.

-5-

Quick Start Guide

1. Open the web browser and type http://192.168.1.254 in the browser's address box. This

number is the default IP address for this router. Press Enter.

2. A username and password window will appear. The default username is “admin”, and

password is “admin”. Press OK to proceed.

3. You will get a status report web page and main menu screen.

Please see the relevant sections of user manual for detailed instructions on how to

configure your router.

1. None of the LEDs are on when you turn on the router.

Check the connection between the adapter and the router. If the error persists, you may have

a hardware problem. In this case you should contact technical support.

2. Can’t ping any PCs on the LAN.

Check the Ethernet LEDs on the front panel. The LED should be on for a port that has a PC

connected. If it is off, check the cables between your router and the PC. Make sure you have

uninstalled any software firewall for troubleshooting. Verify that the IP address and the subnet

mask are consistent between the router and the workstations.

3. Frequent loss of ADSL line sync (disconnections).

Ensure that all other devices connected to the same telephone line as your router (e.g.

telephones, fax machines, analogue modems) have a line filter connected between them and

the wall socket (unless you are using a Central Splitter or Central Filter installed by a qualified

and licensed electrician), and ensure that all line filters are correctly installed and the right

way around. Missing line filters or line filters installed the wrong way around can cause

problems with your ADSL connection, including causing frequent disconnections. If you have

a back-to-base alarm system you should contact your security provider for a technician to

make any necessary changes.

Most problems can be solved by referring to the Troubleshooting section in the User Manual.If

you cannot resolve the problem with the Troubleshooting chapter, please contact the dealer

where you purchased this product.

WORLDWIDE

http://www.billion.com

BiPAC 7401V

(

)

P R4: V1.01EN

-6-

Tabla de contenidos

Otros manuales de Enrutador de red de Billion

Billion

Billion BiPAC 7402(G)X(L) Series Manual de usuario

Billion

Billion BIPAC-74x GE Series Manual de usuario

Billion

Billion BiPAC 8700VAX(L)-1600 Manual de usuario

Billion

Billion 400G Instrucciones de uso

Billion

Billion BiPAC 2070 (P) Manual de usuario

Billion

Billion BiPAC 6300VNP Manual de usuario

Billion

Billion BiPAC 5210S Manual de usuario

Billion

Billion BiPAC 7404V series Manual de usuario

Billion

Billion BiPAC 7300M Manual de usuario

Billion

Billion BiPAC 7402NXL Manual de usuario

Billion

Billion BiPAC 5200 Manual de usuario

Billion

Billion BiPAC 5200G Series Manual de usuario

Billion

Billion BIPAC-7402 Manual de usuario

Billion

Billion BiPAC 7404VGOX Manual de usuario

Billion

Billion BiPAC VGL Manual de usuario

Billion

Billion BIPAC 7100G Manual de usuario

Billion

Billion BiPAC 7800(N) Manual de usuario

Billion

Billion BiPAC 8700AX-1600 Manual de usuario

Billion

Billion BiPAC 7100 Manual de usuario

Billion

Billion BiPAC 7800VDPX Manual de usuario

Billion

Billion BiPAC 7800(N) Manual de usuario

Billion

Billion BiPAC 4700ZUL Manual de usuario

Billion

Billion myGuard 7202 Manual de usuario

Billion

Billion BiPAC 7402VGO Manual de usuario

Manuales populares de Enrutador de red de otras marcas

Allnet

Allnet ALL0333AU Manual de usuario

HomeSeer

HomeSeer HT-SEL Manual de usuario

Sercomm

Sercomm Genesis OC3505D Manual de usuario

TP-Link

TP-Link TD-8817 Manual de usuario

Motorola

Motorola MR1900 Manual de usuario

Digi

Digi IX14 Manual de usuario

Cisco

Cisco NCS 540 Manual

XAVi

XAVi X8821e Manual de usuario

BEC

BEC 6200WZL Manual de usuario

MikroTik

MikroTik hAP ac3 Series Manual de usuario

Korenix

Korenix JetNet 5428G Series Manual de usuario

NETGEAR

NETGEAR FS526T - Switch Manual de usuario

Korenix

Korenix JetNet 5710G Series Manual de usuario

Automated Logic

Automated Logic ZN551 Manual del propietario

Cisco

Cisco ASR 1000 Series Manual del operador

EnGenius

EnGenius ESR-9710 Manual de usuario

Cisco

Cisco 805 Series Instrucciones de funcionamiento y seguridad

LevelOne

LevelOne FBR-1416 Manual de usuario