AWS SC-501 Manual de usuario
American Weigh Scales, Inc.
SC-501 (500x0.01g)
SC-2kg (2000x0.1g) User Manual
Digital Pocket Scale
ON/OFF MODE TARE
SC-Series
SC-Series Manual
Thank you for purchasing the American Weigh SC-
Series digital pocket scale. Please read all operating
instructions carefully before use. Scales are precision
instruments and should always be handled with proper
care. To ensure years of reliable service, keep these
simple tips in mind:
• Do not exceed the scales maximum capacity.
Overloading your scale can permanently damage it!
• Avoid exposure to extreme heat or cold. Scales
perform best at normal room temperature. If
temperatures have changed dramatically, recalibration
may be necessary.
• Allow your scale to warm up for 30-60 seconds
before performing calibration (if available).
• Store your scale in a clean, dry location. Dust, dirt,
and moisture can accumulate on the weighing sensors
and electronics causing innacuracy or malfunction.
• Avoid using your scale in close proximity to strong
radio wave emitting devices such as computers, cash
registers, and cordless phones.
• Always weigh on a at and level surface, free from
vibrations and drafts. The corner of a room is usually
the most stable.
• Gently apply all items to be weighed. Do not drop
items onto the weighing platform.
• Avoid dropping your scale. The warranty does not
cover damage due to rough treatment or overload.
I. SCALE OPERATION
Place the scale on a horizontal at surface.
1. Press [ ON/OFF ] key.
2. Wait until “0.0” or “0.00” is displayed.
3. Place the object(s) on the weighing platform.
4. By pressing the [ MODE ] key, you can switch
between weighing units.
5. The removable covers can also be used as
weighing trays.
II. TARE WEIGHING
1. Turn on the scale as described above.
2. Place a tray or container on the scale platform.
3. Press the [ TARE ] button. “0.0” will be displayed.
4. You can now add items to the container or tray to
obtain just the weight of the contents.
5. When the container is removed, a negative number
will be displayed. Press [ TARE ] again to zero the
scale.
III. CALIBRATION
This scale has come pre-calibrated at the factory. Only
re-calibrate if you are experiencing trouble weighing.
SC-501 uses a 100g and 2x 200g calibration weight
SC-2kg uses a 1kg and a 2kg calibration weight
1. Turn the scale OFF.
2. For model SC-2kg: While holding the [ MODE ]
key, tap the [ ON/OFF ] key to turn the scale on then
release both keys.
For model SC-501: While holding the [ TARE ] key,
tap the [ ON/OFF ] key to turn the scale on then
release both keys.
3. The display will show a random number.
4. Press the [ MODE ] key. The display will show the
rst required calibration weight.
5. Place the required weight on the scale and press
the [ MODE ] button.
6. The display will now show the second required
calibration weight.
7. Place the required weight on the scale and press
the [ MODE ] button.
8. [SC-501 only] The display will now show the third
required calibration weight.
9. [SC-501 only] Place the required weight on the
scale and press the [ MODE ] button.
10. The display will show “PASS”. Calibration is
complete
IV. TROUBLESHOOTING
The primary reasons for inaccuracy or malfunction
are low batteries, incorrect calibration, overload or
operating on an unstable surface. Please keep this in
mind and maintain and operate your scale properly.
This scale is a precise instrument and must be
handled with the utmost care and caution.
[Display] Elimination of errors
[Lo] Change the batteries.
[OUE2] Recalibrate the scale as shown above.
[O_Ld] You are overloading the scale. Remove the
excessive load immediately!
[UnST] Use the scale in a more stable position
Model SC-501 SC-2kg
Capacity 500g / 17.64oz / 2500ct / 7716 2000g / 70.55oz / 64.30ozt /
1286dwt
Resolution 0.01g /0.001oz / 0.05ct / 0.2gn 0.1g / 0.01oz / 0.01ozt / 0.1dwt
Weighing Units g, oz,ct, gn g, oz, ozt, dwt
Calibration Weight (not Included) 100g, and 2x 200g
(calibrates at 100g, 300g, and 500g) 1000g and 2000g
Platform Dimensions (inches) 4.0 x 4.0 “ Stainless Steel
Scale Dimensions (inches) 5.0 x 4.1 x 0.7”
Power 2 x AAA Batteries (included)
Warranty 10 Year Warranty
Specications
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Escala de AWS
AWS
AWS SR-1KG Manual de usuario
AWS
AWS AMW-440T Manual de usuario
AWS
AWS MDI-20 Manual de usuario
AWS
AWS H-11 Manual de usuario
AWS
AWS PS-25 Manual de usuario
AWS
AWS SC-501 Manual de usuario
AWS
AWS ZEO-50 Manual de usuario
AWS
AWS AMW-50 Manual de usuario
AWS
AWS 396LUMA Manual de usuario
AWS
AWS AMW-810 Manual de usuario
AWS
AWS CP5-100 Manual de usuario
AWS
AWS QUARTZ-5K Manual de usuario
AWS
AWS ME-5KG Manual de usuario
AWS
AWS SR-1 Manual de usuario
AWS
AWS AMW-500i Manual de usuario
AWS
AWS AMW-Card400 Manual de usuario
AWS
AWS GO-110 Manual de usuario
AWS
AWS 330LPW Instrucciones de montaje
AWS
AWS BLADE V2 BL2-50 Manual de usuario
AWS
AWS Chrome Manual de usuario
