Ubiquiti AirMAX PowerBridge M10 PBM10 Manual de usuario

10 GHz Carrier Class

airMAX BaseStation with

Dish Antenna

Model: PBM10

Introduction

Thank you for purchasing the Ubiquiti Networks™

PowerBridge™M. This Quick Start Guide is designed to guide

you through the installation, and show you how to access

the airOS™Configuration Interface. This Quick Start Guide

also includes the warranty terms and is for use with the

PowerBridgeM10, model PBM10.

Package Contents

Radio Dish Feed Mounting

Bracket

Pole Clamps

(Qty. 2)

Stabilizer Brackets

(Qty. 2)

Elevation

Rod

M10x150 Bolts

(Qty. 4)

M10x100 Bolts

(Qty. 2)

M10x25 Bolts

(Qty. 3)

O-Ring

(Installed on feed)

M4x12 Screw and

Washer Assembly

(Qty. 4)

M4x18 Screw and

Washer Assembly

(Qty. 4)

M10 Hex Nuts

(Qty. 9)

M16 Hex Nuts

(Qty. 2)

M10 Washers

(Qty. 9)

M16 Washers

(Qty. 2)

10GHz Carrier Class

airMAXBaseStation with

DishAntenna

Model:PBM 10

M10 Washers

(Qty. 9)

M16 Washers

(Qty. 2)

PoE Adapter

(24V, 1A)

Power Cord Quick Start

Guide

cable and earth grounding must be used as conditions of product warranty. TOUGHCable is

designed for outdoor installations. It is the customer’s responsibility to follow local country

regulations, including operation within legal frequency channels, output power, and Dynamic

Frequency Selection (DFS) requirements.

Installation Requirements

• Adjustable wrench or one 16 mm and one 24 mm wrench

• Phillips screwdriver

• Shielded Category 5 (or above) cabling should be used for

all wired Ethernet connections and should be grounded

through the AC ground of the PoE.

We recommend that you protect your networks from the

most brutal environments and devastating ESD attacks

with industrial-grade shielded Ethernet cable from Ubiquiti

Networks. For more details, visit www.ubnt.com/toughcable

Hardware Installation

To install the PowerBridgeM10, perform the following steps:

1. Align the Radio to the back of the Dish.

2. On the front of the Dish, use the four M4x18 Screw and

Washer Assemblies to secure the Radio to the Dish.

3. Connect the Elevation Rod to the back of the Dish using a

M10x25 Bolt, a M10 Washer, a M10 Spring Lock Washer, and

a M10 Hex Nut. Install a M16 Hex Nut about halfway down

on the Elevation Rod and then install a M16 Washer on the

Elevation Rod.

4. Insert the four M10x150 Carriage Bolts into the Mounting

Bracket.

*720-00062-01*

720-00062-01

5. Connect the Mounting Bracket to the Dish:

a. Insert two M10x25 Bolts through the bottom of the

Mounting Bracket and through the Dish. The bolts

should be on the inside facing outward.

b. Secure each bolt using a M10 Washer, a M10 Spring Lock

Washer, and a M10 Hex Nut.

c. Slide the Mounting Bracket onto the Elevation Rod.

d. Secure the Mounting Bracket to the Elevation Rod using

a M16 Washer, a M16 Spring Lock Washer, and a M16

HexNut.

6. Lift the cover on the Radio by pressing down and raising

it up. Connect an Ethernet cable to the Radio and place

the cover back on the Radio. There is an opening for the

Ethernet cable. Slide the cover over the cable.

7. Make sure the O-Ring is secure on the Feed.

O-Ring

8. On the front of the Dish, connect the Feed to the Radio and

Dish using the four M4x12 Screw and Washer Assemblies.

Note: DO NOT handle the assembled unit by the feed

at any time, especially during installation of the Dish

Dish or the brackets

while installing the product.

9. Attach the Stabilizer Brackets to the pole just beneath the

area where the Dish will be attached. Use two M10x100

Bolts, two M10 Washers, two M10 Spring Lock Washers,

and two M10 HexNuts. Tighten the nuts to approximately



Note: The mounting assembly can accommodate a

Ø 1.5" - 4.0" pole.

10. Place the Pole Clamps on the other side of the pole that

the Dish will be mounted on and connect them to the

Mounting Bracket using M10 Washers, M10 Spring Lock

Washers, and M10 Hex Nuts.

11. Adjust the Azimuth and Elevation. Azimuth can be

adjusted by rotating the antenna while supported by the

stabilizer bracket. Elevation is adjusted by loosening the

Elevation Rod. Tighten all bolts and nuts to approximately



Elevation

Azimuth

12. Connect the other end of the Ethernet cable from the

Radio to the Ethernet port labeled POE on the PoE Adapter.

Tabla de contenidos

Otros manuales de Hardware de red de Ubiquiti

Ubiquiti

Ubiquiti UBB Manual de usuario

Ubiquiti

Ubiquiti R5AC-PTP Manual de usuario

Ubiquiti

Ubiquiti NanoBeam M Manual de usuario

Ubiquiti

Ubiquiti UniFi Dream Machine Pro Manual de usuario

Ubiquiti

Ubiquiti LiteBeam M5-23 Manual de usuario

Ubiquiti

Ubiquiti UBI-POWERBEAM-M5-300 Manual de usuario

Ubiquiti

Ubiquiti USW-48-POE Manual de usuario

Ubiquiti

Ubiquiti PowerBeam AC Gen2 Manual de usuario

Ubiquiti

Ubiquiti UF-AE Manual de usuario

Ubiquiti

Ubiquiti UF-LOCO Manual de usuario

Ubiquiti

Ubiquiti UniFi WiFi BaseStation XG Manual de usuario

Ubiquiti

Ubiquiti PowerBeam PBE-5AC-500 Manual de usuario

Ubiquiti

Ubiquiti USW-24 Manual de usuario

Ubiquiti

Ubiquiti ER-4 Manual de usuario

Ubiquiti

Ubiquiti PowerBeam PBE-5AC-Gen2 Manual de usuario

Ubiquiti

Ubiquiti PowerBeam M5 PBE-M5-400 Manual de usuario

Ubiquiti

Ubiquiti Loco5AC Manual de usuario

Ubiquiti

Ubiquiti airMAX NanoStationM2 Manual de usuario

Ubiquiti

Ubiquiti UBB Manual de usuario

Ubiquiti

Ubiquiti 0810354025402 Manual de usuario

Ubiquiti

Ubiquiti RD-3G26 Manual de usuario

Ubiquiti

Ubiquiti UniFi NVR Manual de usuario

Ubiquiti

Ubiquiti EdgeSwtch 5XP Manual de usuario

Ubiquiti

Ubiquiti UniFi Cloud Key Manual de usuario

Manuales populares de Hardware de red de otras marcas

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Manual de usuario

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Manual de usuario

Yudor

Yudor YDS-16 Manual de usuario

D-Link

D-Link ShareCenter DNS-320L Manual de usuario

Samsung

Samsung ES1642dc Instrucciones de uso

Honeywell Home

Honeywell Home LTEM-PV Instrucciones de montaje

evertz

evertz 7700 Series Manual de usuario

D-Link

D-Link ShareCenter DNS-343 Manual de usuario

Asante

Asante AsanteBridge 1012 Manual de usuario

FireBrick

FireBrick FB2700 Manual de usuario

Audiovox Electronics

Audiovox Electronics ARWH2T Manual de usuario

ADC

ADC DSX-1 Manual

NetComm

NetComm NF2 Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 5620 Manual de usuario

Dell EMC

Dell EMC XC6420 Series Manual de usuario

Lanner

Lanner NCA-1020A Manual de usuario

Allied Telesis

Allied Telesis AT-TN121-A Manual de usuario

Arista

Arista CCA-ETM-Q12 Manual de usuario

Ubiquiti airMAX PowerBridge M10 PBM10 Manual de usuario

Manuales populares de Hardware de red de otras marcas