Speco H2AB2 Manual de usuario

User Manual

Thank you for purchasing our product. Speco Technologies is constantly developing and

improving products. We reserve the right to modify product design and specifications

without notice and without incurring any obligation.

H2AB2/H2AT2

Warnings

■

Speco Technologies is not responsible for any problems caused by improper operation or repair.

If the product does not work properly, please contact the dealer or where the product was purchased.

■

Do not expose the unit to heavy stress, violent vibration or long-term exposure to water and humidity

during transportation, storage, and/or installation.

Do not install near sources of heat.

Only install the product in environments inside the specification operating temperature and humidity

range.

Do not install the camera near power lines, radar equipment or other electromagnetic radiation.

Do not block any ventilation openings if any.

Use all the weatherproofing hardware requirement to minimize weather intrusion.

sensitivity, low noise and distortion and supports HD video transmission with the common coaxial cable,

ensuring the requirement of the HD monitoring in the traditional surveillance system.

This camera series is the latest technology and advanced circuit design, which features high definition and

Introduction

● High Resolution

Adopt high performance sensor, providing high definition and clear image.

● High Transmission Performance

Real-time transmission with high speed and long distance.

● DNR

Reduce noise from brightness and color signal.

● OSD

Access the camera settings which can be clearly displayed through the main menu.

● White Balance

Adjust the color temperature according to the environment automatically.

● AGC

Adjust the gain of amplifier, enabling the camera to output the standard video signal in different

lighting condition.

● Backlight Compensation (BLC)

When the back of the captured object is too much bright, you can set BLC for the captured object to

make it clearer.

● Coaxial audio transmission

Cables

Power Cable

Video Output

Video Switch Cable

Video Switch: Four video output modes can be optional--AHD, TVI, CVI and CVBS

(a) remove the cover of the video switch cable; (b) hold and press the button in the video

switch cable for 5 seconds to switch the current video output.

Before you start, please make sure that the wall or ceiling is strong e nough to withstand three times

the weight of the camera. Please install and use the camera in the dry environment.

You’d better install back the lens cover or lower dome less than 4 hours after removing it.

The mounting types of cameras are only for reference.

Installation

►Mounting for H2AB2

1. Drill the screw holes and the cable hole on the wall according to the drill template.

2. Route and connect the cables .

3. Secure the mounting base with camera to the wall with screws as shown below.

∅4.6

∅25.1

∅82.0

∅72.2

120°

62.5mm

18.1mm

36.1mm

4. Bracket adjustment. Before adjustment, preview the image of the camera on a monitor and then loosen the

fixed ring to adjust the view angle of the camera. Tighten the fixed ring after the adjustment.

►Mounting for H2AT2

1.Drill the screw holeson the wall according to the drill template.

PA 4×25mm

3×

Fixed Ring

Pan 360°

Tilt 80°

∅4.4mm

∅107mm

∅118.5mm 120° 120°

② Loosen the fixed screw to disassemble the camera.

Fixed Screw

Mounting Base

Enclosure

Camera Unit

③ Route and connect the cables. T

ceiling or wall with the screws provided.

hen secure the mounting base to the

PA 4×25mm

3×

④

adjust if necessary to obtain an optimum view angle. Finally, fasten the

camera with the fixed screw.

Install the camera unit and enclosure to the mounting base and then

Specifications

Camera

Image Sensor

Resolution

Image size

Video Output

Audio

Image System

Electronic Shutter

White Light Range (feet)

Frame Rate

Min. Illumination

Lens

Lens Mount

S/N Ratio

Ingress Protection

Functions

Function Control

Smart LED

WDR

Digital NR

AGC

Auto White Balance

HLC

BLC

Front Light Compensation

Defog

Contrast

Sharpness

Image Setting

Defect Correction

Others

Power Supply

1/2.8" CM S

2MP

1920×1080

AHD/TVI/CVI/CVBS (*camera comes defaulted to HD-TVI)

1CH built-in microphone

PAL/NTSC

Auto

65~98

30fps(60Hz); 25fps(50Hz)

0 lux (LED ON)

M12

2.8 mm

≥ 52dB(AGC OFF)

IP67

OSD (UTC control)

Manual or auto mode

Digital WDR

Yes

Auto

DC12V (± 15%)

LED OFF: < 1W;

Specifications

Models H2AB2

6.52 2.71× × 2.71

Power Consumption

Dimensions (inch)

Working Environment

LED ON : < 4W

-22 °F ~ 122 °F, 10 % ~ 90 %(relative humidity)

H2AT2

Ф3.72 3.25×

Model:

Federal Communications Commission (FCC) Statements

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2)

This device must accept any interference received, including interference that may

cause undesired operation.

FCC Responsible Party:

Speco Technologies

200 New Highway

Amityville, NY 11701

www.specotech.com

H2AT2/H2AB2

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Cámara de seguridad de Speco

Speco

Speco BULLET HT7816DNV Manual de usuario

Speco

Speco CVC-1705 Manual de usuario

Speco

Speco HT61iLHB Manual de usuario

Speco

Speco VL-183 Manual de usuario

Speco

Speco O4FD5M Manual de usuario

Speco

Speco CVC-605CM Manual de usuario

Speco

Speco PROVIDEO CVC-190 Manual de usuario

Speco

Speco VL-66 Manual de usuario

Speco

Speco HT7040H Manual de usuario

Speco

Speco INTENSIFIER CVC6246IHR Manual de usuario

Speco

Speco HT-INTD8 Manual de usuario

Speco

Speco CVC-607EXCM25 Manual de usuario

Speco

Speco O5T2 Manual de usuario

Speco

Speco O2iD5M Manual de usuario

Speco

Speco HT-7247IHR Manual de usuario

Speco

Speco ONSIP O2D4 Manual de usuario

Speco

Speco Intensifier O2iBD3 Manual de usuario

Speco

Speco OINT56B Manual de usuario

Speco

Speco CVC6146SCS Series Manual de usuario

Speco

Speco HTINT70T Manual de usuario

Speco

Speco O2iBD4 Manual de usuario

Speco

Speco CVC-680CD Manual de usuario

Speco

Speco O4FB2M Manual de usuario

Speco

Speco VIP2D2M Manual de usuario

Manuales populares de Cámara de seguridad de otras marcas

Okina USA

Okina USA SIR36-870VF650LP Manual de usuario

Divio

Divio NDR155PA Manual de usuario

Canon

Canon VB-C500D Manual de usuario

Easy Access

Easy Access EasyGuard Manual de usuario

Vivotek

Vivotek FD9389-EHV-v2 Manual de usuario

TUYA

TUYA COSMO W2 Manual de usuario

Eusso

Eusso UNC7500-IR Guía de configuración

urmet domus

urmet domus 1096/204 Manual de usuario

VC VC20 series Manual de usuario

Axis

Axis Q1614 Manual de usuario

ieGeek

ieGeek DD201 Manual de usuario

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Manual de usuario

Vicon

Vicon V662-D-1 Instrucciones de funcionamiento

Grundig

Grundig GCH-K0274P Manual de usuario

Lorex

Lorex VANTAGE LBC7032 Manual de usuario

4xem

4xem WPT Manual de usuario

Samsung

Samsung SCV-3082 Manual de usuario

Vitek

Vitek VTC-C544 Manual de usuario