Speco INTENSIFIER CVC6246IHR Manual de usuario
Please read this manual thoroughly before operation and keep
it handy for further reference.
CVC-6246iHR
540 Line Color Dome Camera
Intensifier Series
Wall & Ceiling Mounta le
WARNING & CA TION
The lighting flash with an arrowhead symbol, within an equilateral triangle is
Intended to alert the user to the presence of un-insulated “dangerous voltage”
within the product’s enclosure that may be of sufficient magnitude to constitute
a risk of electric shock to persons
The exclamation point within an equilateral triangle is intended to alert the user
to the presence of important operating and maintenance (serving) instructions
in the literature accompanying the appliance
INFORMATION -This equipment has been tested and found to company with
limits for a class a digital device Pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful
Interference When the equipments operated in a commercial environment.
This equipment generates, uses, and Can Radiate radio frequency energy and
if not installed and used in accordance with the instruction manual, may Cause
Harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which
Case the user will be required to correct the interference at his own expense.
WARNING – Change or modification not expressly approved by the manufacturer could void
the user’s authority to operate the equipment
CA TION : To prevent electric shock and risk of fire hazards.
DO NOT use power sources other than that specified.
DO NOT expose this appliance to rain or moisture.000
This installation should be made by a qualified service person and should conform to all local codes.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CA TION : TO REDUCE THE RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER (OR BACK).
NO USER SERVICEABLE PARTS INSIDE
REFER SERVICINGTO QUALIFIED
SERVICE PERSONNEL.
CAUTION
Package Contents
Features
1
3
Contents
Precautions 4
Camera Installation 5
Internal Components 7
9
Operating Your Camera
Troubleshooting
SET UP
SET UP LENS
SHUTTER SPEED CONTROL
BACK LIGHT
AUTO GAIN (AGC)
WHITE BALANCE
REDUCE NOISE
INTENSIFIER
CAMERA TITLE
DAY/NIGHT/SYNC
MOTION DETECTION
PRIVACY
REVERSE
DETAIL
DEFAULT/RETURN
13
14
15
19
20
21
23
24
25
27
29
31
32
33
11
35
2
34
Specifications / Dimensions 37
arranty 39
PACKAGE CONTENTS
•Please make sure that the following items are included
in the package:
1 CVC-6246iHR Camera
2 Mounting Screws
1 Video test Connector
1 Power Adaptor Lead
Please leave this manual with the end-user for future
reference.
3
PRECA TIONS
•THIS DOME CAMERA SHO LD BE ONLY INSTALLED BY
Q ALIFIED PERSONNEL
•TO PREVENT A FIRE OR ELECTRICAL HAZARD PLEASE SE
PROPER POWER CABLE
•THE DOME COVER SHO LD BE TREATED WITH CARE. DO
NOT CELAN THE COVER WITH AN ABRAISIVE CLEANING
MATERIAL - PLEASE SE A SOFT CLOTH OR TISS E TO
CLEAN THE DOME COVER
•THERE ARE NO SER-SERVICEABLE PARTS INSIDE. PLEASE
DO NOT DISASSEMBLE THIS CAMERA OTHER THAN TO
MAKE INITIAL ADJ STMENTS
•PLEASE SE A L APPROVED REG LATED 24 VOLT AC OR
12 VOLT DC POWER S PPLY
•PLEASE SE APPROPRIATE LOW VOLTAGE POWER CABLE
TO PREVENT FIRE OR ELECTRICAL SHOCK
•PLEASE INS RE THAT YO R INSTALLATION AREA CAN
S PPORT THE WEIGHT OF THE CAMERA
•PLEASE HANDLE THIS CAMERA CAREF LLY:
- DON’T SE A STRONG OR ABRASIVE DETERGENT WHEN
CLEANING THE CAMERA.
- DO NOT EXPOSE THE CAMERA TO DIRECT S N
4
CAMERA INSTALLATION
CONNECT POWER CABLE
1. WHEN SING 12 VOLTS DC (constant voltage 600 mA)
2. WHEN SING 24 VOLTS AC (40 Volt Amps)
-CONNECT ACCESSORY CABLE TO THE POWER JACK
AND CONNECT 24V AC TO THE LEAD
3. CONNECT VIDEO CABLE
-CONNECT BNC CABLE TO THE BNC JACK.
5
PO ER SUPPLY
CONNECT
YELLO :VIDEO OUT
PO ER INPUT:RED
CENTER:(+)
CONNECT
BLACK:(-)
PO ER RED(+)
PO ER SUPPLY
AC 24V
INTERNAL COMPONENTS
7
1. Mechanical
(1) DC A TO-IRIS LENS
Adjust between TW (TELE WIDE) to set the
angle (focal length) Set the focus by adjusting ∞N
NOTE: BOTH OF THE ABOVE ADJ STMENTS GET LOCKED
INTO POSITION THRO GH THE SE OF "LOCKING HANDLES".
(2) JOY STICK
TO SET THE OSD (ON SCREEN DISPLAY) , PRESS THE JOY
STICK FOR ONE SECOND AND SET AS DESCRIBED
IN THE MANUAL
(2) Joy Stick
Controller
(1) DC Auto iris Lens
(2.8~11mm)
8
2. Joy Stick
Video Test
Terminal
LEFT
DOWN
UP
RIGHT
SET
Push the Joy stick for one second, and the OSD appears
on the screen. Move the Joy Stick up, down, left & right to
control the OSD functions.
Otros manuales para INTENSIFIER CVC6246IHR
2
Tabla de contenidos
Otros manuales de Cámara de seguridad de Speco
Speco
Speco O4FT2W Manual de usuario
Speco
Speco ProVideo CVC-7WMTD Manual de usuario
Speco
Speco PROVIDEO CVC-620WP Manual de usuario
Speco
Speco VLEDT1HG/W Series Manual de usuario
Speco
Speco O4D9M Manual de usuario
Speco
Speco VL7038IRVF Manual de usuario
Speco
Speco CVC6146SCSFF Manual de usuario
Speco
Speco O8VB3 Manual de usuario
Speco
Speco O8VT3M Manual de usuario
Speco
Speco WDR-B1 Manual de usuario
Speco
Speco O4VLD5 Manual de usuario
Speco
Speco O8D8 Manual de usuario
Speco
Speco O2VLB7 Manual de usuario
Speco
Speco CVC-105CM Manual de usuario
Speco
Speco VL5700BPVF Manual de usuario
Speco
Speco CVC-3805 Manual de usuario
Speco
Speco O2B6M Manual de usuario
Speco
Speco O4VD2 Manual de usuario
Speco
Speco CVC-105CM Manual de usuario
Speco
Speco CLPR67H Manual de usuario
