Planet VC-23 Series Manual de usuario

Ethernet over VDSL2 Bridge

VC-231/VC-234

User’s Manual

Trademarks

Contents subject to revision without prior notice.

PLANET is a registered trademark of PLANET Technology Corp.

The information in this manual is subject to change without

notice. All other trademarks belong to their respective owners.

Disclaimer

PLANET Technology does not warrant that the hardware will

work properly in all environments and applications, and makes

no warranty and representation, either implied or expressed,

with respect to the quality, performance, merchantability, or

tness for a particular purpose.

PLANET has made every eort to ensure that this User’s Manual

is accurate; PLANET disclaims liability for any inaccuracies or

omissions that may have occurred.

Information in this User’s Manual is subject to change without

notice and does not represent a commitment on the part of

PLANET. PLANET assumes no responsibility for any inaccuracies

that may be contained in this User’s Manual. PLANET makes no

commitment to update or keep current the information in this

User’s Manual, and reserves the right to make improvements

to this User’s Manual and/or to the products described in this

User’s Manual, at any time without notice.

If you nd information in this manual that is incorrect,

misleading, or incomplete, we would appreciate your comments

and suggestions.

FCC Warning

This equipment has been tested and found to comply with the

regulations for a Class A digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment

is operated in a commercial environment. This equipment

generates, uses, and can radiate radio frequency energy and, if

not installed and used in accordance with this user’s guide, may

cause harmful interference to radio communications. Operation

of this equipment in a residential area is likely to cause harmful

interference, in which case the user will be required to correct

the interference at his own expense.

CE Mark Warning

This device is compliant with Class A of CISPR 32. In a

residential environment this equipment may cause radio

interference.

Energy Saving Note of the Device

This power required device does not support Standby mode

operation.

For energy saving, please remove the power cable to disconnect

the device from the power circuit.

Without removing power cable, the device will still consuming

power from the power source. In the view of Saving the Energy

and reduce the unnecessary power consuming, it is strongly

suggested to remove the power connection for the device if this

device is not intended to be active.

WEEE Warning

To avoid the potential eects on the environment and

human health as a result of the presence of hazardous

substances in electrical and electronic equipment, end

users of electrical and electronic equipment should

understand the meaning of the crossed-out wheeled bin symbol.

Do not dispose of WEEE as unsorted municipal waste and have

to collect such WEEE separately.

Revision

Ethernet over VDSL2 Bridge User's Manual

For Models: VC-231/VC-234

Rev 1.2 (Nov. 2019)

Part No.: 2350-AC0140-002

Table of Contents

1. Package Contents ............................................................. 5

2. Product Features............................................................... 6

3. Hardware Introduction ...................................................... 7

3.1 Front Panel................................................................ 7

3.2 LED Indicators ........................................................... 7

3.3 Rear Panel................................................................. 9

3.4 Mode DIP Switch...................................................... 10

3.5 Power Information.................................................... 13

4. Connecting and using the VDSL2 Bridge ........................... 14

4.1 Point-to-Point Application --

LAN to LAN Connection............................................. 15

4.2 Point-to-Multipoint Application --

Connect to IP DSLAM ............................................... 17

4.3 Chassis Installation and Rack Mounting (VC-231) ........... 19

5. Specications ................................................................. 20

6. Troubleshooting .............................................................. 23

7. FAQs ............................................................................. 24

8. Customer Support .......................................................... 26

1. Package Contents

Thank you for purchasing PLANET Fast Ethernet over VDSL2

Bridge Series, VC-231 and VC-234. In the following sections, the

term “VDSL2 Bridge” means the VC-23x series.

Open the box of the VDSL2 Bridge and carefully unpack it. The

box should contain the following items:

VDSL2 Bridge x 1 User’s Manual x 1

5V, 2A Power

Adapter x 1

Splitter x 1

(VC-231 only)

RJ11 Telephone

Wire x 1

If any of these are missing or damaged, please contact your

dealer immediately; if possible, retain the carton including the

original packing material, and use them again to repack the

product in case there is a need to return it to us for repair.

2. Product Features

Cost-eective VDSL2 CO/CPE bridge solution

One box design, CO/CPE selectable via DIP Switch

Denes prole 17a band plan for the long distance transmis-

sion of upstream and downstream signals

Denes prole 30a band plan for the short distance transmis-

sion of upstream and downstream signals

Complies with IEEE 802.3, IEEE 802.3u and IEEE 802.3x

standards

DMT (Discrete Multi-Tone) line coding

Half-duplex back pressure and IEEE 802.3x full-duplex pause

frame ow control

Built-in POTS splitter to share voice and data (VC-234 only)

Voice and data communication can be shared on the existing

telephone wire simultaneously

Hardware IGMP Snooping for multimedia service (VC-234)

Supports up to 1536 bytes packet size, 802.1Q VLAN tag

transparency

VDSL2 stand-alone transceiver for simple bridge modem

application

Selectable target prole and target SNR margin

Supports extensive LED indicators for network diagnostics

3. Hardware Introduction

3.1 Front Panel

VC-231 Front Panel

Figure 3-1: VC-231 front panel

VC-234 Front Panel

Power

VC-234 1234VDSL CPE

LNK/ACT

Ethernet over VDSL Bridge

Figure 3-2: VC-234 front panel

3.2 LED Indicators

System

LED Color Function

PWR Green

Lit Lights to indicate that the VDSL2 Bridge

has power.

O Indicate that the VDSL2 Bridge has no

power.

VDSL

LED Color Function

VDSL Green

Lit Indicates that the VDSL link is

established.

Fast

Blink

Indicates that the VDSL link is in training

status (about 10 seconds).

Slow

Blink

Indicates that the VDSL link is in idle

status.

CO Green Lit Indicates the VDSL2 Bridge is running in

CO mode.

CPE Green Lit Indicates the VDSL2 Bridge is running in

CPE mode.

10/100BASE-TX Port for VC-231

LED Color Function

LNK/

ACT Green

Lit Indicates that the port is linked up.

Blink

Indicates that the VDSL2 Bridge is

actively sending or receiving data over

that port.

O Indicates that the port is linked down.

100 Green

Lit Indicates that the port is operating at

100Mbps.

O Indicate that the port is linked down or

10Mbps.

10/100BASE-TX Port for VC-234

LED Color Function

LNK/

ACT Green

Lit Indicates that the port is linked up at

10/100Mbps.

Blink Indicates that the VDSL Bridge is actively

sending or receiving data over that port.

O Indicates that the port is linked down.

3.3 Rear Panel

The rear panel of the VDSL2 Bridge is shown below.

VC-231 Rear Panel

Figure 3-3: VC-231 rear panel

¾DIP switch

¾DC jack (DC input) for power adapter

VC-234 Rear Panel

LAN

4 3 2 1VDSLPhone

lnter

17a

9dB

CPE

Fast

30a

6dB

OFF

, 2A max.

Figure 3-4: VC-234 rear panel

¾Four 10/100BASE-TX RJ45 connectors for Ethernet

¾One RJ11 connector for VDSL2; connect to IP DSLAM or

another VDSL2 Bridge

¾One RJ11 connector for telephone or PBX POTS

¾DIP switch

¾DC jack (DC input) for power adapter

3.4 Mode DIP Switch

The Ethernet over VDSL2 Bridge provides 4 selective

transmission modes. By switching the transmission modes,

you can obtain a best transmission mode to suit with phone

line quality or distance of connectivity. The following is the

summary table of transmission setting, bandwidth and distance

extensibility tested for AWG 24 (0.5mm) twisted-pair without

noise and cross talk.

DIP-1 DIP-2 DIP-3 DIP-4

Mode Channel Prole SNR

OFF CO Interleave 17A 9dB

ON (default) CPE Fast 30A 6dB

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Enrutador de red de Planet

Planet

Planet WDRT-1202AC Manual de usuario

Planet

Planet ADE-4400 Manual de usuario

Planet

Planet SW-804 Manual de usuario

Planet

Planet IGS-620TF Manual de usuario

Planet

Planet ISW-621 Series Manual de usuario

Planet

Planet FGSW-2624SF Series Manual de usuario

Planet

Planet FNSW-3200 Manual de usuario

Planet

Planet XRT-401F Manual de usuario

Planet

Planet VC-230 Manual de usuario

Planet

Planet WNAP-7335 Manual de usuario

Planet

Planet FGSW-2620VM Series Manual de usuario

Planet

Planet G.SHDSL.bis Bridge Router GRT-504 Manual de usuario

Planet

Planet SW-504 Manual de usuario

Planet

Planet IGS-5227-6T Manual de usuario

Planet

Planet SW-502 Manual de usuario

Planet

Planet WGSW-404 Manual de usuario

Planet

Planet FGSD-1022VHP Manual de usuario

Planet

Planet IGS-6325 DIN rail Series Manual de usuario

Planet

Planet FNSW-1600P Manual de usuario

Planet

Planet XRT-401D Manual de usuario

Planet

Planet GPN-400ACV Manual de usuario

Planet

Planet XRT-401F Manual de usuario

Planet

Planet ADW-4300B Manual de usuario

Planet

Planet ADE-4100 Manual de usuario

Manuales populares de Enrutador de red de otras marcas

Allnet

Allnet ALL0333AU Manual de usuario

HomeSeer

HomeSeer HT-SEL Manual de usuario

Sercomm

Sercomm Genesis OC3505D Manual de usuario

Billion

Billion BIPAC 5102 Series Manual de usuario

TP-Link

TP-Link TD-8817 Manual de usuario

Motorola

Motorola MR1900 Manual de usuario

Digi

Digi IX14 Manual de usuario

Cisco

Cisco NCS 540 Manual

XAVi

XAVi X8821e Manual de usuario

BEC

BEC 6200WZL Manual de usuario

MikroTik

MikroTik hAP ac3 Series Manual de usuario

Korenix

Korenix JetNet 5428G Series Manual de usuario

NETGEAR

NETGEAR FS526T - Switch Manual de usuario

Korenix

Korenix JetNet 5710G Series Manual de usuario

Automated Logic

Automated Logic ZN551 Manual del propietario

Cisco

Cisco ASR 1000 Series Manual del operador

EnGenius

EnGenius ESR-9710 Manual de usuario

Cisco

Cisco 805 Series Instrucciones de funcionamiento y seguridad