Olympia electronics GR-940/15L/MAR Manual de usuario

Thank you for purchasing this product of

O l y m p i a E l e c t r o n i c s . A E u r o p e a n

manufacturer.

GENERAL

These luminaires, according to Lloyd’s

s u i t a b l e f or m a r i ne a n d o ff sh o r e

applications for use in environmental

categories ENV1, ENV2, ENV3 and ENV4,

where ENV1 are controlled environments,

ENV2 are enclosed spaces subject to

temperature, humidity and vibration, ENV3

are enclosed spaces subject to generated

heat from other equipment and ENV4 are

mounted on reciprocating machinery.

Each luminaire must be permanently

connected to mains power supply. In

normal operation the led strip lights and

the battery is charging. In case of a mains

power supply failure the luminaire will light

the led strip automatically in emergency

mode. When the mains power supply is

restored the device turns to normal

operation.

INSTALLATION

To install the luminaire follow the

installation instructions on page 3.

OPERATION

Battery Charging

The battery charging is completely

controlled. In this case, is achieved the

perfect battery maintenance , as well as

the elongation of its duration. When the

battery has completely charged, it charges

with a maintenance current.

Battery Cut-off

The luminaire enters in this operation when

the mains power supply fails and battery

has lost its energy. During this operation

the luminaire enters the idle state and

battery consumption is negligible, in order

to be protected from deep discharge.

Manual Test

The manual test can be conducted only if

the main power supply and the battery is

connected. By pressing the TEST/RESET

button briefly (page 3) an operation test is

initiated. During this test period all

indication LEDs are OFF.

Automatic Test

This test includes all the operations that

provide the manual test and is conducted

automatically every 15 days. In order to be

performed, the main power supply and the

battery should be connected.

Automatic Autonomous Test

The Automatic Autonomous Test is

conducted and measures the luminaire`s

back up operation. This test is conducted

automatically every six months. In order to

be performed, the main power supply and

Page 1 from 2 923940002_09_003

High Quality European based Manufacturers

GR-940/15L/MAR WATERPROOF SELF TESTING EMERGENCY LUMINAIRES

220-240V AC/50-60Hz

Bayblend FR3010, transparent polycarbonate

TECHNICAL CHARACTERISTICS

OPERATION TEMPERATURE RANGE

RELATIVE HUMIDITY

EXTERNAL DIMENSIONS

CONSTRUCTION MATERIALS

TYPICAL WEIGHT

GUARANTEE

OPERATION VOLTAGE

MAXIMUM POWER CONSUMPTION

BATTERY (Ni-Cd)

CHARGING TIME

INDICATIONS

BATTERY PROTECTION

MINIMUM AUTONOMOUS DURATION

DEGREES OF COVER PROTECTION

PRODUCED IN ACCORDANCE WITH

ILLUMINATION (MAINS / EMERGENCY)

ILLUMINATION SOURCE

From overcharge and full discharge

IP 65

3.6V/3Ah

5 to 40 C

Up to 95%

3 years (1 year for the battery)

105lm / 105lm

480min

15 white LED’s

4W/7VA

945gr.

363 x 145 x 73 mm

Charge, lamp fault, battery fault indication LED

24h

EN 60598-1, EN 60598-2-22, ΕΝ 55015, ΕΝ 61547, ΕΝ 61000-3-2, ΕΝ 61000-3-3, IEC 60092-306, IEC 60533

Page 2 from 3

the battery should be connected (the

battery should be charged). If the battery

is not charged, the test is postponed until

the battery is completely charged. If during

the Automatic Autonomous Test the

luminaire’s duration is lower than the

no m i nal, th e n the bat t e r y must b e

replaced.

Back Up Operation

The autonomous duration of battery during

emergency mode is at least the one that is

stated in the technical characteristics.

During emergency mode, a LED strip test

is also performed.

Resetting Errors

Push the TEST/RESET button for 5

seconds, to extinguish all the indicated

LED errors (page 3). Then the luminaire

enters regular operation mode.

Indication LED status

(with connected mains power supply).

Charge

On: Good charge current.

Οff: No battery (No charging current or

disconnected battery).

Lamp Fault

Οn: Faulty LED strip.

Off: Good LED strip.

Battery Fault

Οff: Battery OK.

Blink (With Charge LED ON): Autonomy

or low battery problem

(the battery must be replaced).

Blink (With Charge LED Off):

No charging current or disconnected

battery.

ΑΤΤΕΝΤΙΟΝ!!!

1. Operations for installation, maintainance

or testing must be done by authorized

personel only.

2. The device must be connected to the

mains power supply through a fuse

dependent by the total amount of the line’s

power load.

3. In case of battery or lamp replacement,

these must be replaced by parts of the

same type, by the manufacturer or by a

competent person.

4. In case of inactive use for a period

greater than 2 months, disconnect the

battery by pulling out the battery’s

connector.

5. I s not allowed to discard batteries in t i

to common trash bins, they must be

discarded only in battery recycling

points. Do not incinerate.

NOTE: LED= Light Emitting Diode

LABELING EXPLANATION:

X: Self contained

1: Maintained (*)

A: Including test device

480: 8 hour duration

(*) Maintained operation: The luminaire

lights its illumination source, when it is

Non Maintained operation: The luminaire

lights its illumination source, only in power

supply’s failure.

NOTE!! After finishing the installation

you must power the luminaire at least

for 24 hours for battery charging to

perform the nominal autonomy.

Battery replacement

1. Unfasten the 4 retaining screws (step 10

of the installation instructions) and remove

the diffusor.

2. Unfasten the 2 retaining screws step 9 of

the installation instructions and remove the

reflector.

3. Remove the old battery and place a new

on of the same type and characteristics.

4. Replace the removed parts (previous

steps 1,2).

923940002_09_003

Page 3 from 3

Manual TEST or Resetting Errors

In order to test or reset the device you

must carefully remove the diffusor by

unfastening the 4 mounting screws.

Then push the button as described in

the according paragraphs on page 1.

L1 L N N

L1 L N

External

switch

Controlled operation of the lamp

Link

Permanent maintained operation

1 Remove the diffusor. Place simultaneously 2 flat blade screwdrivers and pull up gently the

reflector.

2 Install the included plastic cover in to the unused hole and install the base plastic (with the

included mounting screws and plugs).

3 Always use in any case round mains cable, with external diameter of 6-9mm (H05RN-F

type 2x1mm² or any other type, at least equal to it’s mechanical and electrical properties).

ATTENTION!! The cable must not be deformed in any way (This requirement is important

to ensure the tightness isolation IP 65). Install the cable gland, pass the round cable through

and tighten it all the way.

4 Place the battery’s connector to the corresponding connector on the P.C.B.

5 Connect the mains cables to the respective terminal block (connect the ground wire if required).

6 Ν for neutral, L for live wire and L1 for the maintained operation. The L1 wire can be connected

to an external switch to control the maintained or non maintained operation of the luminaire.

7 For permanent maintained operation use two wires to power the luminaire, Ν for neutral and L for

live wire, and link the L and L1.

8 Install the included tie (if needed) to fasten securely the power cables.

9 Refit the reflector and fasten the two small screws (included).

10 Finaly place the diffusor by using the 4 included screws (tightening torque 1.2 Nm).

INSTALLATION INSTRUCTIONS

234

923940002_09_003

Otros manuales de Linterna de olympia electronics

olympia electronics

olympia electronics GR-900/30L/SC Manual de usuario

olympia electronics

olympia electronics EASY LIGHT Series Manual de usuario

olympia electronics

olympia electronics GR-270 Manual de usuario

olympia electronics

olympia electronics GR-796/ST/DUO/ADR Manual de usuario

olympia electronics

olympia electronics GR-579/L/90/WP Manual de usuario

olympia electronics

olympia electronics GR-8/leds Manual de usuario

olympia electronics

olympia electronics GR-2100/ST Manual de usuario

olympia electronics

olympia electronics GR-427/12L Manual de usuario

olympia electronics

olympia electronics POWER LIGHT Series Manual de usuario

olympia electronics

olympia electronics OLY-1004 Manual de usuario

olympia electronics

olympia electronics KLIN-20/ST Manual de usuario

olympia electronics

olympia electronics POWER LIGHT Series Manual de usuario

olympia electronics

olympia electronics GRL-38/90/M Manual de usuario

olympia electronics

olympia electronics GRL-37/90/WP Manual de usuario

olympia electronics

olympia electronics Classic Light Series Manual de usuario

olympia electronics

olympia electronics GR-290/WP/M Manual de usuario

olympia electronics

olympia electronics OLY-500 Manual de usuario

olympia electronics

olympia electronics GR-220/DUO/M Manual de usuario

olympia electronics

olympia electronics GR-290 Manual de usuario

olympia electronics

olympia electronics GR-939/30L/LT Manual de usuario

olympia electronics

olympia electronics WATERPROOF POWER LIGHT Series Manual de usuario

olympia electronics

olympia electronics GRL-29 WP Manual de usuario

olympia electronics

olympia electronics GR-108/12L/90 Manual de usuario

olympia electronics

olympia electronics OLY-1004/WP/ADR Manual de usuario

Manuales populares de Linterna de otras marcas

KYOWA

KYOWA KW-9114 Manual de usuario

Stahl

Stahl ECOLUX 6610 Series Manual de usuario

SNOWJOE

SNOWJOE SUNJOE 24V-LGT500-CT Manual de usuario

PRG

PRG VARI LITE VL5 Manual de usuario

Raytec

Raytec VARIO2 series Manual de usuario

ENSA

ENSA LEDBT18WS2 Manual de usuario

LUG

LUG OFFICE LB LED N/T Manual de usuario

GE Wallighter 250 Manual de usuario

Draper

Draper RLEDL19/B Manual de usuario

Green Lighting

Green Lighting TRI-SENSOR GL4612LU Manual de usuario

Panasonic

Panasonic EY3741B57 Manual de usuario

Clas Ohlson

Clas Ohlson LCC8T Manual de usuario

Coolon

Coolon WDN-140 Manual de usuario

Holiday Travel

Holiday Travel 834873 Manual de usuario

BEGA

BEGA 84 036 Manual de usuario

BEGA

BEGA 33 596 Manual de usuario

Dale Tiffany

Dale Tiffany GT701162 Manual de usuario

Wagan

Wagan Brite Nite Pop-Up USB Lantern Manual de usuario

olympia electronics GR-940/15L/MAR Manual de usuario

Manuales populares de Linterna de otras marcas