Kargo Master 4081M Manual de usuario
Installation Guide
4081M
Kargo Master
Rancho Cordova, CA 95742
800-343-7486
CustomerService@KargoMaster.com
20210224R2 DATE: ______________
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 1
Instructions –4081M
*PLEASE READ ALL INSTRUCTIONS AND WARNINGS PRIOR TO ASSEMBLING,
INSTALLING, AND USING THIS PRODUCT.*
Warning
Always check for wires, fuel tanks and lines, brake lines, and other important
vehicle functionality items prior to drilling and installing all products.
Tools Needed
9/16” Socket and Wrench
1/2” Socket and Wrench
10mm Socket and Wrench
Table of Contents
Parts List ..............................................................................................................................2
Hardware List .......................................................................................................................3
Step 1 –Front Foot ...............................................................................................................4
Step 2 –Rear Foot Mount ....................................................................................................5
Step 3 –Rear Foot to Mount.................................................................................................6
Step 4 –Installing Bows ........................................................................................................7
Before You Begin
Read all instructions prior to assembling or installing any Kargo Master product.
Follow ladder rack instructions after installing mount feet.
These instructions are for mount feet only.
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 2
Instructions –4081M
Parts
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 3
Instructions –4081M
Hardware
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 4
Instructions –4081M
Step 1 –Front Foot
Locate front mount locations as shown above.
Remove front most plastic cap in these locations to expose threads in the roof.
Place front rail pad over the front most hole. Place small foot (D) on top of pad.
Mount small foot (D) through the front rail pad into the roof using a M6 x 22mm hex bolt,
a 1/4” lock washer and a 1/4” flat washer. Repeat on other side.
**Be sure to put sealant in and around the threads to ensure the roof will not
leak in wet applications**
Snug tighten, but allow movement.
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 5
Instructions –4081M
Step 2 –Rear Foot Mount
In the rear of the van, locate the two rear most mounting locations from picture on
page 4.
Remove plastic to expose both threads in the roof.
Place small angle bracket (C) with flange to the center of van. Offset bracket to the front.
Bolt into roof using two M6 x 22mm hex bolts, two 1/4” lock washers and two 1/4” flat
washers. (Driver Side Shown)
**Be sure to put sealant in and around the threads to ensure the roof will not
leak in wet applications.**
Snug tighten, but allow movement.
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 6
Instructions –4081M
Step 3 –Rear Foot to Mount
The distance between the front and rear foot should be approximately 71.5”.
Place the correct large foot (A or B) on top of the angle bracket. The drivers side is shown
below. The slope on the large foot will make the top of the foot flat.
Use the foot that contours best with the slope of the van roof.
The opening in the large foot assembly will open to the outside of the van.
Mount large foot (A or B) to angle bracket using two 5/16” carriage bolts, two 5/16” flat
washers and two 5/16” lock nuts.
Snug tighten, but allow movement.
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 7
Instructions –4081M
Step 4 –Installing Ladder Bows
Place correct ladder bow on the previously mounted front and rear feet. Be sure to have
equal distance along the bow as shown below.
Bolt in place using 3/8” x 3/4” hex head, a 3/8” lock washer and a 3/8” flat washer.
Follow ladder rack instructions from this point.
ONCE LADDER RACK IS FULLY INSTALLED, BE SURE TO GO BACK AND
ENSURE ALL HARDWARE IS TIGHT
YOUR INSTALLATION IS NOW COMPLETE.
Tabla de contenidos
Otros manuales de Accesorios para automóviles de Kargo Master
Kargo Master
Kargo Master 48132 Manual
Kargo Master
Kargo Master 4A95L Manual de usuario
Kargo Master
Kargo Master 48152 Manual de usuario
Kargo Master
Kargo Master 408TC Manual de usuario
Kargo Master
Kargo Master 4081SF Manual
Kargo Master
Kargo Master 406GM Manual
Kargo Master
Kargo Master 40890 Manual de usuario
Kargo Master
Kargo Master 40053 Manual
Kargo Master
Kargo Master 40131 Manual de usuario
Kargo Master
Kargo Master 406GMF-P Manual
Kargo Master
Kargo Master 80070 Hoja de datos
Kargo Master
Kargo Master 4A873 Manual
Kargo Master
Kargo Master 40933 Manual
Kargo Master
Kargo Master 4A92L Manual de usuario
Kargo Master
Kargo Master 4089P Manual
Kargo Master
Kargo Master 31010 Manual de usuario
Kargo Master
Kargo Master 40670 Manual de usuario
Kargo Master
Kargo Master 81002 Manual
Kargo Master
Kargo Master 40816 Manual
Kargo Master
Kargo Master 8006A Manual
