Goldair GMH280 Manual de usuario

Operating Instructions

Model: GMH280

2400W Electronic Micathermic Heater

This page is intentionally left blank

CAUTION: In order to avoid a hazard due to inadvertent resetting of the

thermal cut-out, this appliance must not be supplied through an external

switching device, such as a timer, or connected to a circuit that is regularly

switched on and off by the utility.

•This appliance is not intended for use by persons (including children) with

reduced physical, sensory or mental capabilities or lack of experience and

knowledge, unless they are supervised or have been given instruction

concerning the use of the appliance by a person responsible for their safety.

•Children should be supervised to ensure that they do not play with the

appliance.

•If the supply cord is damaged, it must be replaced by the manufacturer, its

service agent or similarly qualified persons in order to avoid a hazard.

WARNING: You must not cover this appliance. Covering this appliance

presents fire risk and will activate the safety fuse; permanently disabling the

unit.

WARNING: Do not use this appliance in small rooms when they are

occupied by persons not capable of leaving the room on their own, unless

constant supervision is provided.

WARNING: To reduce the risk of fire, keep textiles, curtains, or any

flammable material a minimum distance of 1 metre from the air outlet.

General Care and Safety Guide

•Use only the voltage specified on the rating label of the appliance.

•Keep all objects at least 1 metre from the front, sides and rear of the

appliance.

•This appliance is intended for household use only and not for commercial or

industrial use.

•Indoor use only.

•Use this appliance only as described in this manual. Any other use is not

recommended by the manufacturer and may cause fire, electric shock or

injury.

•Do not use the appliance if it has been dropped or damaged.

•The common cause of overheating is deposits of dust or fluff in the appliance.

Ensure these deposits are removed regularly by unplugging the appliance and

vacuum cleaning the air vents and grills.

YOUR SAFETY IS IMPORTANT TO US. PLEASE ENSURE YOU TAKE NOTE OF THE

INSTRUCTIONS AND WARNINGS OUTLINED IN THIS MANUAL.

•Never use the appliance to dry clothes.

•Always unplug appliance when not in use.

•When the appliance has been unpacked, check it for transport damage and

ensure all parts have been delivered. If parts are missing or the appliance has

been damaged, contact the Customer Services Team.

•Do not use if there are visible signs of damage to the appliance.

•Do not connect the appliance to mains supply until completely assembled and

adjusted.

•Ensure hands are dry before handling the plug or main unit.

•Ensure appliance is on a flat, stable, heat-resistant surface.

•Do not operate with cord set coiled up as a heat build up is likely, which could

be sufficient to become a hazard.

•Carry out regular checks of the supply cord to ensure no damage is evident

•Do not operate this appliance with a damaged cord, plug or after the appliance

malfunctions or has been dropped or damaged in any manner. Take to a

qualified electrical person for examination, electrical service or repair.

•Do not twist, kink or wrap the cord around the appliance, as this may cause the

insulation to weaken and split. Always ensure that all cord has been removed

from any cord storage area and is unrolled before use.

•It is recommended that this appliance is plugged directly into the wall socket.

Power boards are not rated to supply power to high wattage appliances.

•A correctly specified, undamaged extension cord may be used with this

appliance provided it is used in a safe manner.

•Do not remove plug from power socket until the appliance has been switched

off.

•Do not remove plug from power socket by pulling cord; always grip plug.

•Do not place cord under carpet or cover with rugs or furniture. Arrange the cord

so it cannot be tripped over.

•Don’t place appliance on bedding or on thick & long carpet where the openings

may get blocked.

•Switch off and use handle provided when moving

•Do not place appliance close to radiant heat source.

•Do not insert or allow foreign objects to enter any ventilation or exhaust

opening, as this may cause an electric shock, fire or damage to the appliance.

•Do not sit on the appliance.

•Do not use abrasive cleaning products on this appliance. Clean with a damp

cloth (not wet) rinsed in hot soapy water only. Always remove plug from the

mains supply before cleaning.

•Do not operate in areas where petrol, paint or other flammable liquids are used

or stored.

•Do not use this appliance in the immediate surrounds of a bath, a shower, or a

swimming pool or other liquids.

General Care and Safety Guide

•The appliance must not be immersed in any liquids.

•There are no user serviceable parts installed in the unit.

•Do not place the unit in wardrobes or other enclosed spaces as this may cause

fire hazards.

•This unit is not supposed to be used in or around locations where foodstuffs,

works of art or delicate articles of science, etc. are stored.

•If your appliance does not work, or is not working properly, contact the place of

purchase or the Customer Services Team.

General Care and Safety Guide

PICTURE A PICTURE B

ASSEMBLY INSTRUCTIONS

1. Carefully turn the Main Body upside-down on a scratch-free and stable surface.

Be careful to prevent damage to the cosmetic finish or your floor surfacing.

2. Slide the wheel set fully into the grooves in the base of the heater nearest to the

back of the heater as shown in Picture A.

3. Slide the foot set fully into the grooves at the control panel/power cord end of the

heater as shown in Picture B.

4. Turn the heater the right way up.

Before using this appliance, it must have the castor plates with castors fitted. The

screw pack to attach the feet to your appliance will be taped to either one of the feet

for your appliance, or taped to the plug.

WARNING: Heater must not be used without the feet, castors, wheels

fitted.

This appliance has been supplied with ‘1 way screws’ for permanent installation of the

feet. This is a safety requirement for the New Zealand and Australian market.

Assembly Instructions

WARNING: Operate the appliance in normal upright position only with

wheel assemblies attached to the bottom. Any other position could create a

hazardous situation.

Operating Your Heater

Always choose a safe location for the heater, keeping in mind the safety precautions

outlined. Ensure all packaging has been removed from the unit before use. Please

follow the below instructions.

WARNING: In order to avoid overheating or fire, do not cover the heater.

WARNING: Keep all objects at least 1 metre from the front, sides and rear

of the appliance.

WARNING: Do not use this heater with a programmer, separate timer,

remote-control system or any other device that switches the heater on

automatically, since a fire risk exists if the heater is covered or positioned

incorrectly.

WARNING:Never leave this heater unattended when in use.

Ensure heater is on a flat, stable, heat-resistant surface.

Once the heater is in a safe operating position and all switches are in the off

position, insert the power plug into the mains outlet and switch on.

CAUTION: Ensure the power cord is not tight because if pulled it may

partially pull the plug from the socket. A partially inserted plug will overheat

the plug and socket and could result in fire.

Note: When the appliance is turned on for the first time, it may release a

slight odour or smoke. This odour or smoke is a normal occurrence caused by

the initial heating of the heating elements and should not occur again.

HEATER POWER SWITCH

•Check that the heat control switch at the back of the heater is set to Off position

before plugging the heater in and turning on the mains supply.

•Turn the Power Switch at the back of the heater to the “I” position.

CONTROL PANEL

HEAT CONTROLS

•Press the Power button to switch the appliance ON.

•The LED will display the current room temperature.

•The “▲”and “▼”buttons can be used to select High Heat (2400W) or Low Heat

(1200W). This is indicated by the segments to the right of the flame symbol.

THERMOSTATIC CONTROL

•Press the TEMPERATURE button, then use the “▲”and “▼”buttons to set the

target temperature.

•The thermometer symbol will illuminate, and the digital display will flash, showing

the target temperature.

•After 5 seconds the display will stop flashing and return to displaying the room

temperature.

NOTE: the temperature is read from a thermostat in the heater, for a more accurate

reading, position a separate thermometer in another part of the room.

To find your preferred comfort level, Set the thermostat to the maximum setting.

When the room reaches a comfortable temperature for you, look at the temperature

reading on the heater and then set the heater to this temperature. The heater will

now cycle on and off to maintain the set temperature.

TEMPERATURE

TIMER

POWER INDICATOR

HIGH HEAT (2400W)

LOW HEAT (1200W)

POWER BUTTON

DECREASE AMOUNT (DOWN)

INCREASE AMOUNT (UP)

TIMER INDICATOR

TEMPERATURE INDICATOR

DIGITAL DISPLAY

Operating Your Heater

TIMER

•Press the Timer button then use the “▲”and “▼”buttons to adjust the length of

time from 1–18 hours that you would like the heater to run for before turning off

automatically.

•Each press of the “▲”and “▼”buttons will adjust the length of time by an hour.

•Once the timer has been set, the timer will count down the hours, hour by hour

until the heater turns itself off.

•To turn off the Timer function, press the “▼”button back down to “0”hours or

simply turn the unit off.

REMOTE CONTROL

The remote will operate all of the controls the same as the control panel. This remote

requires 2 x AAA batteries which are not included in the box.

Operating Your Heater

SUPPORT AND TECHNICAL ADVICE

Goldair –New Zealand

Monday –Friday 8am-5pm

Phone +64 (0)9 917 4000

Phone 0800 232 633

[email protected]

Goldair –Australia

Monday –Friday 8am-5pm

Phone +61 (0)3 9365 5100

Phone 1300 465 324

[email protected]

Operating Your Heater

TECHNICAL SPECIFICATION

Model No:GMH280

Supply: 240VAC 50/60Hz

Wattage: 2400W

SAFETY DEVICES

This appliance has three protection devices:

•Resettable thermal link - this will automatically disconnect the power to the

appliance at a pre-set overheat temperature. After cooling down it will reset and

power on again. If this occurs, investigate what is causing the appliance to

overheat.

•Thermal fuse - this disconnects the appliance permanently in case of overheating.

(It is non resettable).

CAUTION: The appliance generates heat during use. Precautions must be

taken to prevent the risk of burns, scalds, fires or other damage to persons.

CARE AND CLEANING

The heater requires regular cleaning to ensure trouble free operation:

•Unplug the heater from the mains supply before cleaning.

•Ensure that the heater has been allowed to cool down completely before cleaning.

•The common cause of overheating is deposits of dust or fluff in the appliance.

Ensure these deposits are removed regularly by unplugging the appliance and

vacuum cleaning the air vents and grills.

•Use a damp cloth (not wet) to wipe the exterior of the heater to remove dust and

dirt.

•Never use solutions such as petrol, thinners or polishing agents.

•Ensure the heater is dry before plugging back into the mains supply.

•Do not attempt to dismantle the appliance.

•There are no user serviceable parts. For service or repair, contact an authorised

electrical service technician.

PROOF OF PURCHASE

To receive warranty retain receipt as proof of purchase.

Tabla de contenidos

Otros manuales de Calentador de Goldair

Goldair

Goldair GSMH120 Instrucciones de instalación

Goldair

Goldair GCV325 Manual de usuario

Goldair

Goldair GCV290B Manual de usuario

Goldair

Goldair PLATINUM GPOC4115 Manual de usuario

Goldair

Goldair GCH240 Manual de usuario

Goldair

Goldair GCV280 Manual de usuario

Goldair

Goldair GCT250 Manual de usuario

Goldair

Goldair GSCV280 Manual de usuario

Goldair

Goldair GFP213 Manual de usuario

Goldair

Goldair GPH150 Manual de usuario

Goldair

Goldair GCT360 Manual de usuario

Goldair

Goldair Select GSCT100 Manual de usuario

Goldair

Goldair GMH325 Manual de usuario

Goldair

Goldair GCT250 Manual de usuario

Goldair

Goldair Platinum Series Manual de usuario

Goldair

Goldair GCT255 Manual de usuario

Goldair

Goldair GBH450 Manual de usuario

Goldair

Goldair Select GSCH250R Manual de usuario

Goldair

Goldair GPH110 Manual de usuario

Goldair

Goldair GMH230 Manual de usuario

Goldair

Goldair GFE320 Manual de usuario

Goldair

Goldair GECO255 Manual de usuario

Goldair

Goldair Platinum Series Manual de usuario

Goldair

Goldair GCV340 Manual de usuario

Manuales populares de Calentador de otras marcas

oventrop

oventrop Regucor Series Manual de usuario

Blaze King

Blaze King CLARITY CL2118.IPI.1 Manual de usuario

ELMEKO

ELMEKO ML 150 Manual de usuario

BN Thermic

BN Thermic 830T Manual de usuario

KING

KING K Series Guía

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Guía de inicio rápido

Well Straler

Well Straler RC-16B Manual de usuario

EUROM

EUROM 333299 Manual de usuario

Heylo

Heylo K 170 Manual de usuario

Eterna

Eterna TR70W Manual de usuario

Clarke

Clarke GRH15 Manual de instrucciones

IRSAP

IRSAP The Radiator Company Ovali Manual de usuario

Empire Heating Systems

Empire Heating Systems WCC65 Manual de usuario

Wetekom

Wetekom 92 86 43 Manual de usuario

Desa

Desa SPC170-F Manual de usuario

Watlow

Watlow Watrod Electric Tubular Heaters Manual de usuario

Haverland

Haverland ECO-DRY GPS Series Manual de lista de piezas

Stelpro

Stelpro ASILVC2060 Series Manual de usuario