Goldair GPH150 Manual de usuario

Operating Instructions

Model: GPH150, GPH250, GPH350, GPH450

Mechanical Panel Heater

CAUTION: In order to avoid a hazard due to inadvertent resetting of the

thermal cut-out, this appliance must not be supplied through an external

switching device, such as a timer, or connected to a circuit that is regularly

switched on and off by the utility.

•This appliance is not intended for use by persons (including children) with

reduced physical, sensory or mental capabilities or lack of experience and

knowledge, unless they are supervised or have been given instruction

concerning the use of the appliance by a person responsible for their safety.

•Children should be supervised to ensure that they do not play with the

appliance.

•If the supply cord is damaged, it must be replaced by the manufacturer, its

service agent or similarly qualified persons in order to avoid a hazard.

WARNING: You must not cover this appliance. Covering this appliance

presents fire risk and will activate the safety fuse; permanently disabling the

unit.

WARNING: Do not use this appliance in small rooms when they are

occupied by persons not capable of leaving the room on their own, unless

constant supervision is provided.

WARNING: To reduce the risk of fire, keep textiles, curtains, or any

flammable material a minimum distance of 1 metre from the air outlet.

General Care and Safety Guide

•Use only the voltage specified on the rating label of the appliance.

•Keep all objects at least 1 metre from the front, sides and rear of the

appliance.

•This appliance is intended for household use only and not for commercial or

industrial use.

•Indoor use only.

•Use this appliance only as described in this manual. Any other use is not

recommended by the manufacturer and may cause fire, electric shock or

injury.

•Do not use the appliance if it has been dropped or damaged.

•The common cause of overheating is deposits of dust or fluff in the appliance.

Ensure these deposits are removed regularly by unplugging the appliance and

vacuum cleaning the air vents and grills.

YOUR SAFETY IS IMPORTANT TO US. PLEASE ENSURE YOU TAKE NOTE OF THE

INSTRUCTIONS AND WARNINGS OUTLINED IN THIS MANUAL.

•Never use the appliance to dry clothes.

•Always unplug appliance when not in use.

•When the appliance has been unpacked, check it for transport damage and

ensure all parts have been delivered. If parts are missing or the appliance has

been damaged, contact the Customer Services Team.

•Do not use if there are visible signs of damage to the appliance.

•Do not connect the appliance to mains supply until completely assembled and

adjusted.

•Ensure hands are dry before handling the plug or main unit.

•Ensure appliance is on a flat, stable, heat-resistant surface.

•Do not operate with cord set coiled up as a heat build up is likely, which could

be sufficient to become a hazard.

•Carry out regular checks of the supply cord to ensure no damage is evident

•Do not operate this appliance with a damaged cord, plug or after the appliance

malfunctions or has been dropped or damaged in any manner. Take to a

qualified electrical person for examination, electrical service or repair.

•Do not twist, kink or wrap the cord around the appliance, as this may cause the

insulation to weaken and split. Always ensure that all cord has been removed

from any cord storage area and is unrolled before use.

•It is recommended that this appliance is plugged directly into the wall socket.

Power boards are not rated to supply power to high wattage appliances.

•A correctly specified, undamaged extension cord may be used with this

appliance provided it is used in a safe manner.

•Do not remove plug from power socket until the appliance has been switched

off.

•Do not remove plug from power socket by pulling cord; always grip plug.

•Do not place cord under carpet or cover with rugs or furniture. Arrange the cord

so it cannot be tripped over.

•Don’t place appliance on bedding or on thick & long carpet where the openings

may get blocked.

•Switch off and use handle provided when moving

•Do not place appliance close to radiant heat source.

•Do not insert or allow foreign objects to enter any ventilation or exhaust

opening, as this may cause an electric shock, fire or damage to the appliance.

•Do not sit on the appliance.

•Do not use abrasive cleaning products on this appliance. Clean with a damp

cloth (not wet) rinsed in hot soapy water only. Always remove plug from the

mains supply before cleaning.

•Do not operate in areas where petrol, paint or other flammable liquids are used

or stored.

•Do not use this appliance in the immediate surrounds of a bath, a shower, or a

swimming pool or other liquids.

General Care and Safety Guide

•The appliance must not be immersed in any liquids.

•There are no user serviceable parts installed in the unit.

•Do not place the unit in wardrobes or other enclosed spaces as this may cause

fire hazards.

•This unit is not supposed to be used in or around locations where foodstuffs,

works of art or delicate articles of science, etc. are stored.

•If your appliance does not work, or is not working properly, contact the place of

purchase or the Customer Services Team.

General Care and Safety Guide

CONTROL PANEL

HEAT OUTLET

AIR INLET

Components

CASTOR WHEELS

CASTOR WHEEL

BRACKET

WALL MOUNTING

BRACKET

Before using this appliance, it must either be wall mounted or have the castor plates

and castors fitted.

This appliance has been supplied with ‘1 way screws’ for permanent installation of the

feet. This is a safety requirement for the New Zealand and Australian market.

Assembly Instructions

FREE STANDING

1. Ensure the appliance is unplugged and power switches are off.

2. Carefully turn the main body upside-down on a scratch-free and stable surface. Be

careful to prevent damage to the cosmetic finish or your floor surfacing.

3. Align the screw hole on the Castor Wheel Bracket with the screw hole on the base

of the appliance.

4. Attach Castor Wheel Bracket with the ‘1 way screws’ provided and ensure the

bracket sits firmly in place (do not over tighten). Firmly press Castor Wheels into

the slots provided on the Castor Wheel Bracket until they click into place. Some

force may be required.

5. Set appliance upright.

NOTE: The wall bracket edges may be sharp. It is recommended that if using as a free

standing appliance please remove the wall bracket from the back of the heater.

Installation Instructions

The appliance must not be located immediately below a socket outlet.

NOTE: Your Panel Heater should be installed with at least 150mm clearance from the

floor and any other surrounding parts including other appliances and side walls.

At least 300mm clearance from ceilings, shelves and soft furnishings.

Note: Do not run the power cord behind the heater.

WALL MOUNTED HEATERS ARE

ONLY TO BE MOUNTED ON HEAT

RESISTANT WALLS THAT COMPLY

WITH CURRENT AS/NZS

SPECIFICATIONS & BUILDING

REGULATIONS

150mm

300mm

150mm

WALL MOUNTED

1. Make sure the appliance is unplugged and power switches are off.

2. Position the panel appliance within one metre of a wall socket. Do not mount in front of or

below the wall socket. Ensure there is at least 150mm clearance on all sides of the

appliance.

3. Detach the mounting bracket from the back of the panel appliance by unscrewing the two

locking screws (located on the top of the mounting bracket).

4. Position the mounting bracket on the wall and mark the hole positions with a pen or pencil

and check they are horizontal with a spirit level. Ensure the two bottom mount holes are at

least 150mm from the floor and drill holes as required.

5. Secure the mounting bracket to the wall with the mounting screws. (For masonry walls use

the plastic sheaths).

6. Slot the back of the appliance onto the mounting bracket locating the bottom plugs first

and secure with two locking screws.

7. Plug appliance into a standard 240 volt AC electrical outlet.

Operating Your Heater

CONTROL PANEL

O - Off

I–Low Heat

II –High Heat

Ensure the switch is in the Off position before plugging into the mains supply.

Use the 2 way switch to select your desired heat setting. When you are finished, return the switch

to the Off position.

Always choose a safe location for the heater, keeping in mind the safety precautions

outlined. Ensure all packaging has been removed from the unit before use. Please

follow the below instructions.

WARNING: In order to avoid overheating or fire, do not cover the heater.

WARNING: Keep all objects at least 1 metre from the front and 150mm

from the sides of the appliance.

WARNING: Do not use this heater with a programmer, separate timer,

remote-control system or any other device that switches the heater on

automatically, since a fire risk exists if the heater is covered or positioned

incorrectly.

WARNING:Never leave this heater unattended when in use.

If mounted on castors, ensure heater is on a flat, stable, heat-resistant

surface.

Once the heater is in a safe operating position and all switches are in the off

position, insert the power plug into the mains outlet and switch on.

CAUTION: Ensure the power cord is not tight because if pulled it may

partially pull the plug from the socket. A partially inserted plug will overheat

the plug and socket and could result in fire.

THERMOSTATIC CONTROL

1. Rotate thermostat knob clockwise until you reach the

maximum position.

2. When the room reaches a temperature that is comfortable

for you, slowly turn the knob anti-clockwise until the heater

just turns off (you will hear a click).

3. The heater will now cycle on and off to maintain the comfort

level you have set.

4. Take note of this setting position for future use.

TECHNICAL SPECIFICATION

Model No: GPH150, GPH250, GPH350, GPH450

Supply: 220-240VAC 50Hz

Wattage: 500W, 900-1000W, 1350-1500W, 1800-2000W

SUPPORT AND TECHNICAL ADVICE

Goldair –New Zealand

Monday –Friday 8am-5pm

Phone +64 (0)9 917 4000

Phone 0800 232 633

[email protected]

Goldair –Australia

Monday –Friday 8am-5pm

Phone +61 (0)3 9365 5100

Phone 1300 465 324

[email protected]

PROOF OF PURCHASE

To receive warranty retain receipt as proof of purchase.

Operating Your Heater

SAFETY DEVICES

This appliance has two protection devices:

•Tilt Switch - this will automatically turn the appliance off if the appliance is not in

the correct operating position.

•Thermal Fuse - this disconnects the appliance permanently in case of overheating.

(It is non resettable).

CAUTION: The appliance generates heat during use. Precautions must be

taken to prevent the risk of burns, scalds, fires or other damage to persons.

CARE AND CLEANING

The heater requires regular cleaning to ensure trouble free operation:

•Unplug the heater from the mains supply before cleaning.

•Ensure that the heater has been allowed to cool down completely before cleaning.

•The common cause of overheating is deposits of dust or fluff in the appliance.

Ensure these deposits are removed regularly by unplugging the appliance and

vacuum cleaning the air vents and grills.

•Use a damp cloth (not wet) to wipe the exterior of the heater to remove dust and

dirt.

•Never use solutions such as petrol, thinners or polishing agents.

•Ensure the heater is dry before plugging back into the mains supply.

•Do not attempt to dismantle the heater.

•There are no user serviceable parts. For service or repair, contact an authorised

electrical service technician.

Otros manuales para GPH150

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Calentador de Goldair

Goldair

Goldair GFH220 Manual de usuario

Goldair

Goldair GFH240 Manual de usuario

Goldair

Goldair GSCV120 Manual de usuario

Goldair

Goldair GCT270 Manual de usuario

Goldair

Goldair GCH500 Manual de usuario

Goldair

Goldair Select GSOC117T Manual de usuario

Goldair

Goldair GFH267 Manual de usuario

Goldair

Goldair GOC177C Instrucciones de instalación

Goldair

Goldair GPH110 Manual de usuario

Goldair

Goldair Select GSCT100 Manual de usuario

Goldair

Goldair GCT110 Manual de usuario

Goldair

Goldair GPH100-2PK Manual de usuario

Goldair

Goldair GOC167T Manual de usuario

Goldair

Goldair Platinum GPPH610 Manual de usuario

Goldair

Goldair GSCV18 Manual de usuario

Goldair

Goldair GCT260 Manual de usuario

Goldair

Goldair Platinum GPPH620 Manual de usuario

Goldair

Goldair GCH320 Manual de usuario

Goldair

Goldair Platinum GPPH610 Manual de usuario

Goldair

Goldair GCT420 Manual de usuario

Goldair

Goldair GCT330 Manual de usuario

Goldair

Goldair GCV125 Manual de usuario

Goldair

Goldair GMH210 Manual de usuario

Goldair

Goldair GMH240 Manual de usuario

Manuales populares de Calentador de otras marcas

oventrop

oventrop Regucor Series Manual de usuario

Blaze King

Blaze King CLARITY CL2118.IPI.1 Manual de usuario

ELMEKO

ELMEKO ML 150 Manual de usuario

BN Thermic

BN Thermic 830T Manual de usuario

KING

KING K Series Guía

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Guía de inicio rápido

Well Straler

Well Straler RC-16B Manual de usuario

EUROM

EUROM 333299 Manual de usuario

Heylo

Heylo K 170 Manual de usuario

Eterna

Eterna TR70W Manual de usuario

Clarke

Clarke GRH15 Manual de instrucciones

IRSAP

IRSAP The Radiator Company Ovali Manual de usuario

Empire Heating Systems

Empire Heating Systems WCC65 Manual de usuario

Wetekom

Wetekom 92 86 43 Manual de usuario

Desa

Desa SPC170-F Manual de usuario

Watlow

Watlow Watrod Electric Tubular Heaters Manual de usuario

Haverland

Haverland ECO-DRY GPS Series Manual de lista de piezas

Stelpro

Stelpro ASILVC2060 Series Manual de usuario