Dimplex DFR2551L Manual de usuario
7213950100R03
Owner’s Manual
Model
DFR2551L
DFR2551G
6908922359
6908922459
IMPORTANT SAFETY INFORMATION: Always read this manual rst
before attempting to install or use this replace. For your safety, always
comply with all warnings and safety instructions contained in this manual
to prevent personal injury or property damage.
To view the full line of Dimplex products, please visit
www.dimplex.com
2 www.dimplex.com
Table of Contents
Always use a qualied technician
or service agency to repair
this replace.
!NOTE: Procedures and
techniques that are considered
important enough to emphasize.
CAUTION: Procedures and
techniques which, if not carefully
followed, will result in damage to
the equipment.
WARNING: Procedures
and techniques which, if not
carefully followed, will expose
the user to the risk of re,
serious injury, or death.
Welcome & Congratulations ...................3
IMPORTANT INSTRUCTIONS .................4
Fireplace Installation ........................6
Operation ..................................9
Maintenance ...............................13
Warranty .................................14
Replacement Parts ..........................16
3
Welcome & Congratulations
Thank you and congratulations for purchasing an electric replace from
Dimplex. Please use our convenient online registration page to record
your model and serial numbers for future reference at
www.dimplex.com/register
NO NEED TO RETURN TO THE STORE
Questions with operation or assembly? Require Parts Information?
Product Under Manufacturer’s Warranty?
Contact us at: www.dimplex.com/customer_support
For Troubleshooting and Technical Support
OR Toll-Free 1-888-DIMPLEX (1-888-346-7539)
Monday to Friday 8:00 a.m. to 4:30 p.m. EST
In order to better serve you, please have your model and serial number
ready or register your product online before calling (See above)
Serial Number
Label
Rating Label with
Model Number
Please carefully read and save these instructions.
CAUTION: Read all instructions and warnings carefully before
starting installation. Failure to follow these instructions may result in
a possible electric shock, re hazard and will void the warranty.
4 www.dimplex.com
When using electrical appliances,
basic precautions should always
be followed to reduce the risk of
fire, electric shock, and injury to
persons, including the following:
① Read all instructions before
using this heater.
② This heater is hot when in use.
To avoid burns, do not let bare
skin touch hot surfaces. The trim
around the heater outlet becomes
hot during heater operation.
WARNING: High tempera-
tures may be generated under
certain abnormal conditions.
Do not partially or fully cover
or obstruct the front of this
heater.
③ Extreme caution is neces-
sary when any heater is used by
or near children or invalids and
whenever the unit is left operating
and unattended.
④ Always unplug the heater when
not in use.
⑤ Do not operate any heater with
a damaged cord or plug, or if the
heater has malfunctioned, or if it
has been dropped or damaged
in any manner, contact Dimplex
Technical Service at 1-888-346-
7539.
⑥ Do not use outdoors.
IMPORTANT INSTRUCTIONS
⑦ Never locate this heater where
it may fall into a bathtub or other
water container.
⑧ Do not run cord under carpet-
ing. Do not cover cord with throw
rugs, runners, or the like. Arrange
cord away from trafc area and
where it will not be tripped over.
⑨ To disconnect heater, turn
controls to off, then remove plug
from outlet.
⑩Do not insert or allow foreign
objects to enter any ventilation
or exhaust opening as this may
cause an electric shock or re, or
damage the heater.
⑪ To prevent a possible re, do
not block air intakes or exhaust in
any manner.
⑫ All electrical heaters have
hot and arcing or sparking parts
inside. Do not use in areas where
gasoline, paint, or ammable
liquids are used or stored.
⑬ Do not modify the heater.
Use it only as described in this
manual. Any other use not recom-
mended by the manufacturer may
cause re, electric shock, or injury
to persons.
⑭ To reduce the risk of electric
shock, this heater has a polarized
plug (one blade is wider than the
5
SAVE THESE INSTRUCTIONS
other). This plug will t in a polar-
ized outlet only one way. If the
plug does not t fully in the outlet,
reverse the plug. If it still does not
t, contact a qualied electrician
to install the proper outlet. Do
not change the plug in any way.
Always plug heaters directly into a
wall outlet/receptacle. Never use
with an extension cord or relo-
catable power tap (outlet/power
strip).
⑮ Do not burn wood or other
materials in the replace.
⑯ Do not strike the front glass.
⑰Always use a certied electri-
cian should new circuits or outlets
be required.
⑱ Always use properly grounded,
fused and polarized outlets.
⑲ Disconnect all power supply
before performing any cleaning,
maintenance or relocation of the
heater.
⑳ When transporting or storing
the heater and cord, keep in a
dry place, free from excessive
vibration and store so as to avoid
damage.
WARNING: Remote control
contains a small battery. Keep
away from children. If swallowed,
seek medical attention immedi-
ately.
WARNING: Do not install bat-
tery backwards, charge, put in re
or mix with used or other battery
types - may explode or leak caus-
ing injury.
!NOTE: Changes or modica-
tions not expressly approved by
the party responsible for compli-
ance could void user's authority to
operate the equipment.
IMPORTANT INSTRUCTIONS
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
NO USER-SERVICEABLE PARTS INSIDE
6 www.dimplex.com
Fireplace Installation
WARNING: Ensure the power
cord is not installed so that it is
pinched or against a sharp edge
and ensure that the power cord is
stored or secured to avoid tripping
or snagging to reduce the risk of
re, electric shock or injury to per-
sons.
WARNING: Construction and
electrical outlet wiring must comply
with local building codes and other
applicable regulations to reduce the
risk of re, electric shock and injury
to persons.
WARNING: Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of re,
electric shock or injury to persons,
always use a licensed electrician.
WARNING: To reduce the risk
of re, do not store or use gaso-
line or other ammable vapors or
liquids in the vicinity of the heater.
Front Glass Installation
1. Unpack the glass assembly.
2. If applicable, carefully pour and
evenly distribute the supplied
media in the Media tray of the
rebox. (Figure 2)
3. Hang bottom bracket on screw
at the bottom of the rebox.
(Figure 1)
4. Secure the top bracket to re-
box using screws provided in
the hardware bag. (Figure 1)
Dimplex Mantel Installation
Depending on the available space
within the mantel cavity, the unit
can be secured to the mantel at the
bottom side or back. Remove the
screw on the bottom ange in the
most appropriate place for securing
and using the provided L-bracket
and the screw that was removed
attach the rebox to the mantel.
(Figure 3)
!NOTE: There are no guide
holes provided for the L-Brackets in
the mantel.
Figure 1
7
Figure 2
Media
Tray
Custom Installation
1. Mark the desired location on the
oor and store the replace in a
safe, dry and dust free location.
2. Frame an opening of 24.0 in.
(610 mm) wide x 18 ¾ in. (476
mm) high x 7 ⅞ in. (200 mm)
deep (Figure 4).
Option #1 - The power cord can
be lead from behind the trim and
along the wall to an outlet near the
replace.
Option #2 - A new outlet can be
installed inside the new frame con-
struction. Plug the unit directly into
a 15 A, 120 V outlet.
!NOTE: A 15 Amp, 120 Volt
circuit is required. A dedicated
circuit is preferred but not essential
in all cases. A dedicated circuit will
be required if, after installation, the
circuit breaker trips or fuse blows
on a regular basis when the heater
is operating. Additional appliances
on the same circuit may exceed the
current rating of the circuit breaker.
3. Install the provided plastic feet
to the unit as shown in Figure 5.
CAUTION: Clearance for air
circulation beneath the replace
insert is provided by feet.
Do not install the replace
Fireplace Installation
Figure 3
Figure 4
24.0 in.
(610 mm)
18 ¾ in.
(476 mm)
7 ⅞ in.
(200 mm)
8 www.dimplex.com
Fireplace Installation
insert directly on carpet or
similar surfaces which may
restrict air circulation.
CAUTION: If installing the re-
place in a carpeted area, place a
one-piece, solid, at surface under
the replace. Ensure that all of the
feet rest securely on this surface.
4. The rebox is to be installed
from the front of the mantel and
inserted so that the anges are
ush against the front surface of
the mantel.
N
L
LOGSET ASSEMBLY
MEDIA BED RGB LED STRIP
MEDIA BED LED ASSEMBLY
~
120V / 12V
AC / DC
CUTOUT
FLICKER
MOTOR
BLOWER
MOTOR
DISPLAY-CONTROL BOARD
M
+T°
M
ELEMENT
AC/DC
ADAPTER
SWITCHBOARD
RELAY BOARD
THERMISTOR
LOGSET LED ASSEMBLY
LED LIGHT ASSEMBLY
Wiring Diagram
Bathroom Installation
This rebox must be protected by
a GFI receptacle or circuit. If a re-
ceptacle is used it must be readily
accessible.
To prevent electrical shock this unit
is an electrical appliance that is not
watertight and must be installed
as to prevent water from entering
the unit. This unit must be installed
away from showers, tubs, etc.
Never locate replace where it may
fall into a bathtub or other water
containers.
Holes for plastic
feet
Figure 5
9
Operation
WARNING: This electric
rebox must be properly installed
before it is used.
The unit can be controlled by
either the manual controls which
are located on the upper right of
the replace or the remote (Figure
6 & 7).
The replace is supplied with an
IR multifunction remote control.
This remote control has a range
of approximately 16 ft (5 m). To
operate correctly, the remote con-
trol must be pointed towards the
Floating DisplayTM.
!NOTE: Before attempting any
operation with the remote, pull
the plastic insulator strip out from
between the remote casing and
battery cover.
A. Standby
Turns the unit On and Off.
→ Activated by pressing the
Standby button on the remote
or the unit.
• The unit will turn on with the
same functions that it was set
to when it was turned Off and
the intake temperature will be
indicated on the On Screen
Display.
!NOTE: When any button is
pressed the intake tempera-
ture will be displayed on the On
Screen Display for 5 seconds.
B. Flame Effects
Turns the ame effect On and Off.
→ Activated by pressing the
button on the remote.
Figure 7Figure 6
A C D E A
D
B C
E
G
F
Floating DisplayTM H
F
10 www.dimplex.com
Operation
C. Heat ON/OFF
Cycles the unit sequentially
through the 3 settings: Low Heat,
High Heat and Off.
→ Activated by pressing the
button on the unit or the remote.
• Indicated by the (low heat) or
the (high heat) icon and the
intake temperature being dis-
played on the On Screen Display,
for 5 seconds before turning off.
!NOTE: After the heater is
switched off, there is a 60 second
fan delay, where the fan will con-
tinue running before turning off.
!NOTE: The unit can be oper-
ated in Heat Only Mode. When
the unit is only running with the
heater, the (low heat) or the
(high heat) icon and the in-
take temperature will continuously
be displayed on the On Screen
Display.
!NOTE: The heater may emit
a slight, harmless odor when rst
used. This odor is a normal condi-
tion caused by initial heating of
internal heater.
D & E. Thermostat Controls
Adjusts the temperature set point
to your individual requirements.
Once the desired set temperature
is reached the heater will turn off.
The heater will cycle on and off
to maintain the desired set tem-
perature. The default temperature
setting is 72°F (22°C).
→ Adjusted by pressing the
to decrease the setpoint and
the to increase the setpoint
on the remote.
• The On Screen Display will in-
dicate the temperature setpoint
as it is adjusted.
!NOTE: Holding the button
down, then press on the unit,
will change the temperature from
°C to °F, or vice versa.
Disable Heat
If desired, depending on the sea-
son, the heater on the unit can be
disabled. The unit will operate in
the same fashion, with remainder
of the controls.
Pressing the and buttons
on the unit at the same time and
holding for 2 seconds will disable
Este manual sirve para los siguientes modelos
3
Tabla de contenidos
Otros manuales de Chimenea de interior de Dimplex
Dimplex
Dimplex COMPACT FIREPLACE Manual de usuario
Dimplex
Dimplex CASTILLO CS3540 Guía de inicio rápido
Dimplex
Dimplex CAS500R Manual de usuario
Dimplex
Dimplex LEE 20RC Manual de usuario
Dimplex
Dimplex SP16 Manual de usuario
Dimplex
Dimplex ELECTRALOG DF203A Manual de usuario
Dimplex
Dimplex ASP20 Manual de usuario
Dimplex
Dimplex EWMC-CC-SS Manual de usuario
Dimplex
Dimplex Crestmore CRS20 Manual de instrucciones
Dimplex
Dimplex DWF1203 Manual de usuario
Dimplex
Dimplex ELECTRALOG CFP3913 Manual de usuario
Dimplex
Dimplex CDFI1000-PRO Manual de usuario
Dimplex
Dimplex MULTIFIRE DF3015 Guía de inicio rápido
Dimplex
Dimplex BF39STP/DXP Manual de usuario
Dimplex
Dimplex BF9000 Manual de usuario
Dimplex
Dimplex 26" Guía de inicio rápido
Dimplex
Dimplex THWG XLF74 Manual de usuario
Dimplex
Dimplex BLF5051-AU/PRISM 50" Manual de usuario
Dimplex
Dimplex BF33ST Manual de usuario
Dimplex
Dimplex DWF1215B Manual de usuario
