Danfoss Link FT Manual de usuario

MAKING MODERN LIVING POSSIBLE

Danfoss Heating Solutions

Danfoss Link™ FT Floor Thermostat

Installation Guide

2VISGZ45X © Danfoss 04/2011

Installation Guide Danfoss Link™ FT

VISGZ45X © Danfoss 04/2011

Installation Guide Danfoss Link™ FT

Installation Guide

Installationsanleitung

Guide d’installation

Installationsmanual

Installationshandbok

Asennusohje

Installatiehandleiding

Instrukcja instalacji

Instalační příručka

4VISGZ45X © Danfoss 04/2011

Introduction ............................................... 5

Installation................................................. 6

Adding device ............................................. 9

Perform network test....................................... 9

Factory reset.............................................. 10

Trouble shooting.......................................... 10

Disposal instructions...................................... 10

Technical speciﬁcations ................................... 11

Index

Installation Guide Danfoss Link™ FT

VISGZ45X © Danfoss 04/2011

The Danfoss Link™ FT (Floor Thermostat) is a device for

switching the heating element ON/OFF.

In connection with a floor sensor it can also measure the

temperature in the floor (FTS). Secondly you have the

possibility to use the FT as a on and off switch to other

equipments manually or by schedule.

LED

Install button

ON/OFF

safety switch

The Danfoss Link™ FT is powered by 230 V~ and shall

according to regulations be installed on a build in box or on

the wall box.

Introduction

Installation Guide Danfoss Link™ FT

6VISGZ45X © Danfoss 04/2011

Installation Guide Danfoss Link™ FT

Installation

The Danfoss Link™ wireless system’s transmission range is

suﬃcient for most applications; however each building has

diﬀerent obstacles aﬀecting communication and maximum

transmission distance.

If communication problems occur Danfoss suggests that

accessories would be required to support the system, such as

repeaters. In exceptional cases the wireless system may not be

suitable for your installation.

Please be aware of the following, when installing Danfoss

Link™ FT:

Installation and placement must be according to

local building regulations.

VISGZ45X © Danfoss 04/2011

Installation Guide Danfoss Link™ FT

Installation

Operation mode

Danfoss Link™ FT supports two types of operation modes:

1. ON/OFF switching: do not connect a ﬂoor sensor with

Danfoss Link™ FT in this modus.

2. Heating regulation: when installing the Danfoss Link™ FT

you have to consider the type of heating and thus which

sensors should be used.

There are three options:

1. Comfort heating: Constant temperature on the ﬂoor in

bathrooms and other rooms where a comfortable warm

surface is required. Install the Floor sensor and choose Floor

regulation for the room when doing the conﬁguration.

2. Total heating: Control of room temperature in living rooms

etc. Install the ﬂoor sensor and a Danfoss Link™ RS. Choose

Combined regulation when doing the conﬁguration on the

Danfoss Link™ CC.

3. No ﬂoor sensor: A ﬂoor sensor is not present, and cannot

be installed. You must install a Danfoss Link™ RS. Choose

Room regulation.

Be aware that temperature control is less accurate without a

ﬂoor sensor and that all Danfoss Link™ FT in a room need to

have the same sensor conﬁguration.

Danfoss recommends always installing a ﬂoor sensor.

Note! Do not install electric ﬂoor heating system without a ﬂoor

sensor, when the heating element is installed on or beneath

wooden surfaces and other surfaces sensitive to temperature!

8VISGZ45X © Danfoss 04/2011

Installation

1. To remove the front cover, gently press the release tabs un-

der the bottom of the thermostat with a screwdriver - then

remove the front.

2. Connect the thermostat according to the connection

diagram.

Installation Guide Danfoss Link™ FT

VISGZ45X © Danfoss 04/2011

Adding the Danfoss Link™ FT to a system is

made from the Danfoss Link™ CC Central

Controller.

When adding, press the install

button until the LED gives a

fast green ﬂash.

For further information,

see the Danfoss Link™ CC

instruction manual:

Conﬁguration 6:

Adding devices.

When the Danfoss Link™ FT

has been added to the Danfoss

Link™ CC Central Controller,

a network test should be

performed.

For more information on

network tests, see the Danfoss

Link™ CC instruction manual:

Conﬁguration 8: Perform

network test.

devireg™550

Installation Guide Danfoss Link™ FT

Adding device

Max. 1 m

Perform network test

10 VISGZ45X © Danfoss 04/2011

Installation Guide Danfoss Link™ FT

Green LED ON Standby

Red LED ON Heating

Green LED fast ﬂash Inclusion or link test

Red LED short ﬂash Inclusion not OK, goes to not

included.

Linktest not OK, goes to

missing link

RED LED slow ﬂash Sensor failure

Trouble shooting

1. Turn oﬀ power on the safety switch

on the front.

2. Hold the install button in while

pushing ON the safety switch and

keep the install button pressed

until the LED gives a red ﬂash (ap-

prox. 5 sec.)

Factory reset

Disposal instructions

Otros manuales para Link FT

Tabla de contenidos

Idiomas:

Otros manuales de Termostato de Danfoss

Danfoss

Danfoss TP6000M Manual de usuario

Danfoss

Danfoss KP 61 Manual de usuario

Danfoss

Danfoss ECtemp Next Plus Manual de usuario

Danfoss

Danfoss TS715 Si Manual de usuario

Danfoss

Danfoss FP975 Manual de usuario

Danfoss

Danfoss DEVIreg Smart Manual de usuario

Danfoss

Danfoss ECL Comfort 210 Manual de usuario

Danfoss

Danfoss ECtemp 330 Manual de usuario

Danfoss

Danfoss CF-RP 088U0211 Manual de usuario

Danfoss

Danfoss TPONE-RF Manual de usuario

Danfoss

Danfoss TP9000 Manual de usuario

Danfoss

Danfoss ST-D1 Manual de usuario

Danfoss

Danfoss ECL Comfort 310 Manual de usuario

Danfoss

Danfoss DEVI DEVIreg 530 Manual de usuario

Danfoss

Danfoss TP75H Manual de funcionamiento

Danfoss

Danfoss GreenCon RC-C2 Manual de usuario

Danfoss

Danfoss RET1001M Manual de usuario

Danfoss

Danfoss ECL Comfort 310, P318 Manual de usuario

Danfoss

Danfoss ECtemp 530 Manual de usuario

Danfoss

Danfoss TP5001RF Manual de usuario

Danfoss

Danfoss REP24CO Manual de usuario

Danfoss

Danfoss RET-B Manual de usuario

Danfoss

Danfoss FH-CWP Manual de usuario

Danfoss

Danfoss TP9 Manual de usuario

Manuales populares de Termostato de otras marcas

EWELLY

EWELLY EW-181 Manual de usuario

Prolon

Prolon T1100 Instrucciones de instalación

Computherm

Computherm Q20 Manual de usuario

Heatmiser

Heatmiser neoStat Manual de usuario

Aube Technologies

Aube Technologies TH111GFCI-NP 240 VCA Manual de usuario

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Manual de usuario

Saswell

Saswell SAS920XWHB-7-S-RF Guía

Aircalo

Aircalo TFP1-ET85P2 Manual de usuario

Honeywell

Honeywell CM721 Manual de usuario

Carrier

Carrier DEBONAIR 33CS Manual de usuario

Lennox

Lennox iHarmony Zone Thermostat Instrucciones de montaje

Gemtech

Gemtech GT7000 Manual de instrucciones

Rollei

Rollei Smartes 45000 Manual de usuario

Sinope

Sinope TH1300RF Manual de usuario

Honeywell

Honeywell RLV4305 Manual de usuario

Honeywell

Honeywell Prestige 2.0 THX9421 Manual de usuario

NuTone

NuTone NTBZ48 Instrucciones de funcionamiento originales

Stelpro

Stelpro MAESTRO ASMT402AD Manual de usuario