Danfoss DEVIreg 330 Manual de usuario

www.DEVI.com

Installation Guide

DEVIreg™ 330 (+5 to +45°C)

Electronic Thermostat

DEVIreg™ 330 (+5 to +45°C)

3Installation Guide

1 Introduction

DEVIreg™ 330 is an electronic thermostat to be installed in

electric cabinets with DIN rail attachment. The thermostat

must be installed via an all-pole disconnection switch.

Either a ﬂoor sensor or an external room sensor must be

used to measure and control the desired temperature.

The thermostat has a button to adjust the temperature

setting with a scale from +5 to +45°C. An LED indicator

shows standby periods (green light) and heating periods

(red light).

More information on this product can also be found at:

devireg.devi.com

1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

1.1 Technical Speciﬁcations . . . . . . . . . . . . . . . . . . . . 4

1.2 Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . 5

2 Mounting Instructions . . . . . . . . . . . . . . . . . . . . . . . . 6

4 Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8

5 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9

6 Disposal Instruction . . . . . . . . . . . . . . . . . . . . . . . . . 11

Table of Contents

DEVIreg™ 330 (+5 to +45°C)

Installation Guide4

1.1 Technical Speciﬁcations

Operation voltage 220-240 V~, 50 Hz

Standby power consumption Max 0,25 W

Relay:

Resistive load

Inductive load Max 16 A / 3680 W @ 230 V

cos φ= 0,3 max1A

Sensing units NTC 15 kOhm at 25 °C

Sensing values:

0 °C

25 °C

50 °C

42 kOhm

15 kOhm

6 kOhm

Hysteresis ± 0,2 °C

Ambient temperature 10 °C to +50 °C

Lowering in economy periods -5 °C

Temperature range +5 °C to +45 °C

Cable speciﬁcation max 1x4 mm2or 2x2,5 mm2

Ball pressure temperature 75 °C

Pollution degree 2 (domestic use)

Type 1C

Storage temperature -20 °C to +65 °C

IP class 20

DEVIreg™ 330 (+5 to +45°C)

5Installation Guide

Protection class Class II

Dimensions 86 x 36 x 58 mm

Weight 83 g

The product complies with the EN/IEC Standard“Automatic

electrical controls for household and similar use”:

• EN/IEC 60730-1 (general)

• EN/IEC 60730-2-9 (thermostat)

1.2 Safety Instructions

Make sure the mains supply to the thermostat is turned oﬀ

before installation.

IMPORTANT: When the thermostat is used to control a

ﬂoor heating element in connection with a wooden ﬂoor or

similar material, always use a ﬂoor sensor and never set the

maximum ﬂoor temperature to more than 35°C.

Please also note the following:

• The installation of the thermostat must be done by an

authorized and qualiﬁed installer according to local

regulations.

• The thermostat must be connected to a power supply

via an all-pole disconnection switch.

• The sensor is to be considered as live voltage. Have this

in mind if the sensor must be extended.

DEVIreg™ 330 (+5 to +45°C)

Installation Guide6

• Always connect the thermostat to continuous power

supply.

• Do not expose the thermostat to moisture, water,

dust, and excessive heat.

2 Mounting Instructions

Please observe the following placement guidelines:

• Install the thermostat in an electric cabinet with DIN

rail attachment or a separate DIN attachment accord-

ing to local regulation on IP classes.

• Do not place the thermostat in a way that it will be

exposed to direct sunlight.

Follow the steps below to mount the thermostat:

1. Click the thermostat on to the DIN rail attachment.

2. Connect the thermostat according to the connection

diagram.

+5°C to

+45°C

DEVIreg™ 330 (+5 to +45°C)

7Installation Guide

The screen of the heating cable must be connected

to the earth conductor of the power supply cable by

using a separate connector.

Note: When you use the wire sensor for ﬂoor heating,

always install the sensor in a conduit.

3. Turn on the power supply.

DEVIreg™ 330 (+5 to +45°C)

Installation Guide8

4 Settings

If a ﬂoor sensor is used, please be aware of the following:

• The ﬂoor temperature is measured where the sensor is

placed.

• The temperature of the bottom of a wooden ﬂoor can

be up to 10 degrees higher than the top.

• Floor manufactures often specify the max temperature

on the top surface of the ﬂoor (usually 27-28˚C).

• Always use a ﬂoor sensor to control ﬂoor heating.

Without a ﬂoor sensor, the temperature control may be

less accurate and you risk overheating the ﬂoor.

Thermal

resist-

ance

[m²K/W]

Examples of

ooring

Details Approximate

setting for

25˚C oor

temperature

0,05 8 mm HDF based

laminate

> 800 kg/m³ 28˚C

0,10 14 mm beech

parquet

650 - 800 kg/m³

31˚C

0,13 22 mm solid oak

plank

> 800 kg/m³ 32˚C

< 0,17 Max. carpet

thickness suitable

for ﬂoor heating

acc. to EN 1307 34˚C

0,18 22 mm solid ﬁr

planks

450 - 650 kg/m³

35°C

DEVIreg™ 330 (+5 to +45°C)

9Installation Guide

5 Warranty

A 2-year product warranty is valid for:

• thermostats: DEVIreg™ 330 (+5 to +45° C).

Should you, against all expectations, experience a problem with your DEVI product,

you will ﬁnd that Danfoss oﬀers DEVIwarranty valid from the date of purchase on

the following conditions: During the warranty period Danfoss shall oﬀer a new com-

parable product or repair the product if the product is found to be faulty by reason

of defective design, materials or workmanship.The repair or replacement.

The decision to either repair or replace will be solely at the discretion of Danfoss.

Danfoss shall not be liable for any consequential or incidental damages including,

but not limited to, damages to property or extra utility expenses. No extension of the

warranty period following repairs undertaken is granted.

The warranty shall be valid only if the WARRANTY CERTIFICATE is completed

correctly and in accordance with the instructions, the fault is submitted to the

installer or the seller without undue delay and proof of purchase is provided. Please

note that the WARRANTY CERTIFICATE must be ﬁlled in, stamped and signed by the

authorized installer performing the installation (Installation date must be indicated).

After the installation is performed, store and keep the WARRANTY CERTIFICATE and

purchase documents (invoice, receipt or similar) during the whole warranty period.

DEVIwarranty shall not cover any damage caused by incorrect conditions of use,

incorrect installation or if installation has been carried out by non-authorized electri-

cians. All work will be invoiced in full if Danfoss is required to inspect or repair faults

that have arisen as a result of any of the above. The DEVIwarranty shall not extend to

products which have not been paid in full. Danfoss will, at all times, provide a rapid

and eﬀective response to all complaints and inquiries from our customers.

The warranty explicitly excludes all claims exceeding the above conditions.

For full warranty text visit www.devi.com.

devi.danfoss.com/en/warranty/

DEVIreg™ 330 (+5 to +45°C)

Installation Guide10

WARRANTY CERTIFICATE

The DEVIwarranty is granted to:

Address Stamp

Purchase date

Serial number of the product

Product Art. No.

*Connected output [W]

Installation Date

& Signature

Connection Date

& Signature

*Not mandatory

Otros manuales para DEVIreg 330

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Termostato de Danfoss

Danfoss

Danfoss BasicPlus2 Manual de usuario

Danfoss

Danfoss RT51 Manual de usuario

Danfoss

Danfoss TP7000 Series Manual de usuario

Danfoss

Danfoss KP 61 Manual de usuario

Danfoss

Danfoss DEVIreg Opti Manual de usuario

Danfoss

Danfoss living connect Manual de usuario

Danfoss

Danfoss RET2000 B Manual de usuario

Danfoss

Danfoss TP5001 series Manual de usuario

Danfoss

Danfoss RET1000 B Manual de usuario

Danfoss

Danfoss ECtemp Next Plus Manual de usuario

Danfoss

Danfoss TP5001 series Manual de usuario

Danfoss

Danfoss TP6000M Manual de usuario

Danfoss

Danfoss Icon Master Controller 24 V Manual de usuario

Danfoss

Danfoss BasicPlus2 WT-D Manual de usuario

Danfoss

Danfoss DEVIreg Smart Manual de usuario

Danfoss

Danfoss HC75-3 Manual de funcionamiento

Danfoss

Danfoss 102E7 Instrucciones de montaje

Danfoss

Danfoss KP Series Manual de usuario

Danfoss

Danfoss ECtemp 610 Manual de usuario

Danfoss

Danfoss DEVIreg 610 Manual de usuario

Danfoss

Danfoss TP4 Instrucciones de funcionamiento

Danfoss

Danfoss FHV-R Manual de usuario

Danfoss

Danfoss TP5E Manual de usuario

Danfoss

Danfoss ECL Comfort 210 Manual de usuario

Manuales populares de Termostato de otras marcas

EWELLY

EWELLY EW-181 Manual de usuario

Prolon

Prolon T1100 Instrucciones de instalación

Computherm

Computherm Q20 Manual de usuario

Heatmiser

Heatmiser neoStat Manual de usuario

Aube Technologies

Aube Technologies TH111GFCI-NP 240 VCA Manual de usuario

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Manual de usuario

Saswell

Saswell SAS920XWHB-7-S-RF Guía

Aircalo

Aircalo TFP1-ET85P2 Manual de usuario

Honeywell

Honeywell CM721 Manual de usuario

Carrier

Carrier DEBONAIR 33CS Manual de usuario

Lennox

Lennox iHarmony Zone Thermostat Instrucciones de montaje

Gemtech

Gemtech GT7000 Manual de instrucciones

Rollei

Rollei Smartes 45000 Manual de usuario

Sinope

Sinope TH1300RF Manual de usuario

Honeywell

Honeywell RLV4305 Manual de usuario

Honeywell

Honeywell Prestige 2.0 THX9421 Manual de usuario

NuTone

NuTone NTBZ48 Instrucciones de funcionamiento originales

Stelpro

Stelpro MAESTRO ASMT402AD Manual de usuario