Danfoss CF-RF Manual de usuario

088U0213

GB Instruction CF-RF Room Thermostat with Infrared Floor Sensor

DInstruktion CF-RF Raumthermostat mit Infrarot-Bodensensor

DK Vejledning CF-RF Rumtermostat med infrarød gulvsensor

FInstructionThermostat d’ambiance CF-RF avec Capteur au sol infrarouge

SE Bruksanvisning CF-RF rumstermostate med infraröd golvsensor

PL Instrukcja obsługi termostatu z czujnikiem podłogowym CF-RF

NL Handleiding voor CF-RF kamerthermostaat met infrarood vloersensor

IIstruzioni CF-RF con sensore a pavimento a raggi infrarossi

1VI.UH.R2.1C Produced by Danfoss Floor Heating Hydronics 03.2007

GB Instruction .......................3

DInstruktion ......................13

DK Vejledning ......................25

FInstruction ......................35

SE Bruksanvisning . . . . . . . . . . . . . . . . . . 45

PL Instrukcja obsługi. . . . . . . . . . . . . . . . 55

NL Handleiding.....................65

IIstruzioni........................75

2VI.UH.R2.1C Produced by Danfoss Floor Heating Hydronics 03.2007

3VI.UH.R2.1C Produced by Danfoss Floor Heating Hydronics 03.2007

Instruction CF-RF Room Thermostat with Infrared Floor Sensor

GB Index

1. Functional Overview ...............................................4

2. Installation ...................................................................4

3. Temperature Settings...............................................6

4. Transmission Test ......................................................9

5. Mounting .....................................................................9

6. Uninstallation .......................................................... 10

7. Specications........................................................... 11

8. Troubleshooting...................................................... 12

9. Figures and Illustrations................................ A1-A2

4VI.UH.R2.1C Produced by Danfoss Floor Heating Hydronics 03.2007

Instruction CF-RF Room Thermostat with Infrared Floor Sensor

1. Functional Overview

Front - g. 1

Up/down selector

Push button

Red LED (behind the cover)

InfraRed oor sensor

LED modes

Permanent light ON

No light OFF

Slow ashing Flashes

Fast ashing Flickers

Back - g. 2

Back plate

Back plate lock/unlock (turn 90°)

Screw hole for wall mounting

Battery placement

Screw and wall plug

Note: To activate batteries please remove enclosed strips

from batteries

2. Installation

Note:

• To activate batteries in the Room Thermostat, please

remove enclosed strips from the batteries.

• The assignment of the Room Thermostats to the Master

Controller should be within 1½ m distance

5VI.UH.R2.1C Produced by Danfoss Floor Heating Hydronics 03.2007

Instruction CF-RF Room Thermostat with Infrared Floor Sensor

Activate Install mode on Master Controller

- g. 1.

• Use the menu selection button to select the

Install mode. Install LED ashes

• Activate Install mode by pressing OK . Install

LED goes ON

Activate Install mode on Room Thermostat

• Press the push button . LED and icker

during communication

Select output on Master Controller

• All available output LEDs on Master Controller

light up, and the rst of them ashes

• Press output selection button , to select

desired output (ashes) and accept with OK

• All output LEDs go OFF. Selected output

stays ON shortly

Room Thermostat installation status

• Satisfactory - LED goes OFF

• Not satisfactory - LED ashes 5 times

Note: A Room Thermostat can be assigned to several

outputs if needed by repeating the installation process.

6VI.UH.R2.1C Produced by Danfoss Floor Heating Hydronics 03.2007

Instruction CF-RF Room Thermostat with Infrared Floor Sensor

3. Temperature Settings

Digital Display - g. 1

Set value adjustment

Minimum temperature limitation

Maximum temperature limitation

Lock icon (settings locked from Remote

Controller, CF-RC)

Transmission link icon

Low battery indicator

Alarm icon

Timer icon (time program is active from

Remote Controller, CF-RC)

Room temperature

Floor surface temperature

Changing default display temperature - g. 1.

1. The actual room temperature is shown in the

display as default

2. To change default display from actual room

temperature to actual oor surface tempera-

ture, press and hold the push button

until SET MAX is shown in the display

3. Press the button shortly and repeatedly

until or is ashing in the display

4. Press the up/down selector to select the

new default display temperature:

Room temperature

Floor surface temperature

7VI.UH.R2.1C Produced by Danfoss Floor Heating Hydronics 03.2007

Instruction CF-RF Room Thermostat with Infrared Floor Sensor

Setting of room temperature

1. Make sure actual room temperature is shown

in the display

2. Press the up/down selector to set the

desired room temperature value. SET is shown

in the display

3. When releasing the up/down selector the

display returns to actual temperature

Note: The thermostat regulates the oor heating system

according to room temperature set point, within the

maximum and minimum limitations dened for the oor

surface temperature

Room temperature limitation

1. Make sure actual room temperature is shown

in the display

2. Press the push button until SET MAX is

shown in the display

3. Press the up/down selector to set the

maximum room temperature limitation

4. Press the push button shortly, SET MIN is

shown in the display

5. Press the up/down selector to set the

minimum room temperature limitation

6. Press the push button shortly and the

actual oor surface temperature is shown in

the display

8VI.UH.R2.1C Produced by Danfoss Floor Heating Hydronics 03.2007

Instruction CF-RF Room Thermostat with Infrared Floor Sensor

Floor surface temperature limitation

1. Ensure actual oor surface temperature is

shown in the display illustrated by

2. Press and hold the push button until SET

MAX is also shown in the display

3. Press the up/down selector to set the

maximum oor surface temperature limitation

4. Press the push button shortly, SET MIN is

also shown in the display

5. Press the up/down selector to set the mini-

mum oor surface temperature limitation

IMPORTANT!

As heat emission from the oor may vary slightly

depending on oor covering - and thereby cause

inaccurate temperature measurement - it may be

necessary to adjust the setting of max. and min.

oor surface temperatures accordingly.

! It is important always to follow recommendations

from the oor manufacturer regarding max. oor

surface temperature.

! It is recommended always to include mixing shunt

for oor heating circuits in order to ensure optimal

ow temperature. - In addition to minimised energy

consumption, correct setting of the ow tempera-

ture will eliminate the risk of excessive heat transfer

to the oor.

9VI.UH.R2.1C Produced by Danfoss Floor Heating Hydronics 03.2007

Instruction CF-RF Room Thermostat with Infrared Floor Sensor

4. Transmission Test

Initiate transmission test on Room Thermostat

- g. 1

• Press the push button

• LED goes ON

Link test is satisfactory

• LED goes OFF

Link test is unsatisfactory

• LED ashes 5 times

No link connection to RoomThermostat

• Try to relocate Room Thermostat in the room

• Or install Repeater Unit (CF-RU) and locate

between Master Controller and Room

Thermostat

Note: Master Controller output LED(s) connected to the

Room thermostat, ash(es) during link test

5. Mounting

Placing the Room Thermostat - g. 3

• The Room Thermostat should be placed in

accordance with g. 3

IMPORTANT!

Wherever possible, the room thermostat should

be installed at a place where the eect of sunlight,

Tabla de contenidos

Idiomas:

Otros manuales de Termostato de Danfoss

Danfoss

Danfoss ECL Comfort 310, P314 Manual de usuario

Danfoss

Danfoss living connect Manual de usuario

Danfoss

Danfoss Icon Master Manual de usuario

Danfoss

Danfoss TP5001 series Instrucciones de uso

Danfoss

Danfoss TP4 Instrucciones de funcionamiento

Danfoss

Danfoss ECA 30 Manual de usuario

Danfoss

Danfoss RT1 Instrucciones de montaje

Danfoss

Danfoss RET 230 HCW-3 Manual de usuario

Danfoss

Danfoss TPONE-RF Manual de usuario

Danfoss

Danfoss DEVIreg Opti Manual de usuario

Danfoss

Danfoss RT 115 Manual de usuario

Danfoss

Danfoss TP5001 series Manual de usuario

Danfoss

Danfoss FP735Si Manual de usuario

Danfoss

Danfoss RT 14L Manual de usuario

Danfoss

Danfoss living connect Z Manual de usuario

Danfoss

Danfoss RET2001 Manual de usuario

Danfoss

Danfoss Eco Manual de usuario

Danfoss

Danfoss 3020P Instrucciones de montaje

Danfoss

Danfoss Living Eco Manual de usuario

Danfoss

Danfoss Type CFR Manual de usuario

Danfoss

Danfoss TP5000 RF Si Manual de usuario

Danfoss

Danfoss ST-D1 Manual de usuario

Danfoss

Danfoss RTW-RA Manual de usuario

Danfoss

Danfoss TP7000 Series Manual de usuario

Manuales populares de Termostato de otras marcas

EWELLY

EWELLY EW-181 Manual de usuario

Prolon

Prolon T1100 Instrucciones de instalación

Computherm

Computherm Q20 Manual de usuario

Heatmiser

Heatmiser neoStat Manual de usuario

Aube Technologies

Aube Technologies TH111GFCI-NP 240 VCA Manual de usuario

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Manual de usuario

Saswell

Saswell SAS920XWHB-7-S-RF Guía

Aircalo

Aircalo TFP1-ET85P2 Manual de usuario

Honeywell

Honeywell CM721 Manual de usuario

Carrier

Carrier DEBONAIR 33CS Manual de usuario

Lennox

Lennox iHarmony Zone Thermostat Instrucciones de montaje

Gemtech

Gemtech GT7000 Manual de instrucciones

Rollei

Rollei Smartes 45000 Manual de usuario

Sinope

Sinope TH1300RF Manual de usuario

Honeywell

Honeywell RLV4305 Manual de usuario

Honeywell

Honeywell Prestige 2.0 THX9421 Manual de usuario

NuTone

NuTone NTBZ48 Instrucciones de funcionamiento originales

Stelpro

Stelpro MAESTRO ASMT402AD Manual de usuario