Cornelius FCB Cord Kit Manual de usuario

FCB Cord Kit for V-Series 4 Flavor Installation Instructions

INSTALLATION INSTRUCTIONS

FCB CORD KIT FOR V-SERIES 4 FLAVOR

The following instructions should be used for installation of a power cord for a V-Series 4 Flavor unit.

Each kit will supply power to 1 unit.

Parts List

Tools Required

Phillips Screwdriver

Flat Screwdriver

Pliers

CAUTION – Only trained and certified electrical technicians should service this unit. ALL WIRING

MUST CONFORM TO NATIONAL AND LOCAL CODES.

DANGER – To avoid possible serious injury or death the ELCB (earth leakage circuit breaker) must

be installed in the electrical circuit of all units.

WARNING – To avoid possible electrical shock make sure the unit is properly grounded by con-

necting the earth ground cable, in the power cord to any connection in the machine marked with a

ground symbol.

CAUTION – The wiring must be properly grounded and connected through a disconnect switch

(slow-blow fuse or equivalent HVAC/R circuit breaker).

Electrical Requirements

Refer to the nameplate to determine the power requirements before connecting electrical power to the

unit. Voltage across contactor terminals L1 and L2, with the compressor running, must be within voltage

limits described in Table 1.

If the line voltage does not meet these requirements see the possible corrective actions in Table 2.

Item

Number Description Qty

150 Amp Power Cord 1

2Strain Relief 2

Table 1

Unit Requirements

V-Series 4 Flavor Integral Condense 208-230V, 60Hz, 50 Amp

V-Series 4 Flavor Water Condense 208-230V, 60Hz, 50 Amp

Table 2

Voltage Corrective Action

Below 180 VAC Do Not Connect Unit

180-190 VAC Boost voltage by +32 V

191-207 VAC Boost voltage by +16 V

208-230 VAC Use line voltage

231-246 VAC Reduce voltage by –16 V

247-262 VAC Reduce voltage by –32 V

Above 262 VAC Do Not Connect Unit

Revision Date: March 24, 2014 www.cornelius.com Revision: B

FCB Cord Kit for V-Series 4 Flavor Installation Instructions

Installation Steps

1. Switch the power to the unit off or remove the fuse to the electrical power circuit breaker.

2. Remove the back panel and the right side panel to gain access to the electrical area in the back of

the unit.

3. Remove the cover of the contactor box.

4. On both strain relief parts, loosen the screws until no threads show through the bottom.

5. Install the first strain relief to the bottom of the unit.

6. Install the second strain relief to the side of the con-

tactor box.

7. Feed the power cord through the first strain relief,

lead end first, from the outside of the unit to the

inside of the unit.

8. Pull the power cord to the second strain relief.

FCB Cord Kit for V-Series 4 Flavor Installation Instructions

9. Feed the power cord through the second strain

relief from the side into the contactor box.

10. Attach the two outside leads from the power cord to

the right side of the compressor contactor.

11. Remove the top ground nut from the ground stud.

Slip the ring of the middle ground lead over the

ground stud and secure it by tightening the ground

nut.

12. Pull the slack out of the power cord through the side

of the contactor box and tighten the strain relief on

the contactor box.

13. Pull the slack out of the power cord through the

back of the unit and tighten the strain relief on the

outside of the unit.

14. Replace the cover to the contactor box.

15. Replace the back panel and left side panel.

Tabla de contenidos

Otros manuales de Dispensador de bebidas de Cornelius

Cornelius

Cornelius Impulse Non-Carbonated Post-Mix Beverage... Manual de usuario

Cornelius

Cornelius SPIRIT 414384-XXX Guía de configuración

Cornelius

Cornelius V4 Instrucciones de funcionamiento

Cornelius

Cornelius Enduro 150 8 Valve Manual de usuario

Cornelius

Cornelius 15 Gallon Single-Flavor Visual Display Dispenser... Guía de instalación

Cornelius

Cornelius JetSpray JT30-W25 Manual de usuario

Cornelius

Cornelius IDC Pro Guía de instalación y uso

Cornelius

Cornelius UC-20 Guía de configuración

Cornelius

Cornelius IntelliCarb Cold Beverage Dispenser Guía de instalación

Cornelius

Cornelius CTP-20 Guía de configuración

Cornelius

Cornelius A8661 Guía de configuración

Cornelius

Cornelius remcor DB275--BCP Manual de usuario

Cornelius

Cornelius Impulse XL Manual de usuario

Cornelius

Cornelius VANTAGE Manual de usuario

Cornelius

Cornelius Enduro 200 Manual de usuario

Cornelius

Cornelius A.B.S. Unit Manual de usuario

Cornelius

Cornelius The Profile PR150 BC Manual de usuario

Cornelius

Cornelius Remcor TJ45-A Manual de usuario

Cornelius

Cornelius Agitator Motor 569000207 Manual de usuario

Cornelius

Cornelius Liquid Base Beverage Dispenser Manual de usuario

Cornelius

Cornelius ENDURO-150 Manual de usuario

Cornelius

Cornelius CHD22 Guía

Cornelius

Cornelius Millennium II 6000 Manual de usuario

Cornelius

Cornelius QUEST ELITE 4000 Manual de usuario

Manuales populares de Dispensador de bebidas de otras marcas

PEGAS

PEGAS Evolution Manual de usuario

Ugolini

Ugolini MT micro Manual de usuario

Bunn

Bunn SLCA-7 Instrucciones de instalación

Gekkeikan

Gekkeikan Sake Machine Manual de usuario

Olympia

Olympia DH709 Manual de usuario

Marco

Marco ECOSMART PB10 Manual de usuario

Marvel

Marvel ML24BN Series Manual

Cecilware

Cecilware 2K-GB-LD Manual

Sure Vend

Sure Vend 673 Manual de usuario

Nostalgia Electrics

Nostalgia Electrics KEG7000SS Manual de usuario

Bunn

Bunn LCR-3 HV Guía de solución de problemas

Servend

Servend SV-200 Manual de usuario

EdgeStar

EdgeStar VBR440 Manual de usuario

CDS AUTOMATEN

CDS AUTOMATEN ML-16C2-C Manual de usuario

Siemens

Siemens GA 3000 Manual de instrucciones y seguridad

Selbach

Selbach Fruit Juice dispenser Manual de usuario

Taylor

Taylor C302NP Manual de usuario

Vinotemp

Vinotemp VT-WINEDISP2 Manual de usuario