Cornelius VIPER 3 FLAVOR Manual de usuario

Viper 3 Flavor Plumbing Installation Instructions

INSTALLATION INSTRUCTIONS

SAFETY INSTRUCTIONS

WARNING:

Before starting installation, read and understand all safety label and warnings on the machine. Also review and

understand all safety instructions in the owners, installation and service manuals.

Failure to comply could result in serious injury, death or damage to the equipment.

QUALIFIED SERVICE PERSONNEL

WARNING:

Only trained and certified electrical, plumbing and refrigeration technicians should service this unit.

All wiring and plumbing must conform to national and local codes. Failure to comply

could result in serious injury, death or equipment damage.

SAFETY PRECAUTIONS

This unit has been specifically designed to provide protection against personal injury. To ensure continued

protection observe the following:

WARNING:

Disconnect power to the unit before servicing. Follow all lock out/tag out procedures established by the user. Verify

all power is off to the unit before performing any work.

Failure to comply could result in serious injury, death or damage to the equipment.

CAUTION:

Always be sure to keep area around the unit clean and free of clutter.

Failure to keep this area clean may result in injury or equipment damage.

Revision Date: August 23, 2017 www.cornelius.com Revision: H

Viper 3 Flavor Plumbing Installation Instructions

INSTRUCTIONS

VIPER 3 FLAVOR PLUMBING

The following instructions should be used for installation of the CO2, Water and Syrup plumbing for a Viper 3 Fla-

vor FCB unit at a maximum distance of 50 feet from the unit. Prior knowledge of the FCB Installation/Service

Manual is necessary before attempting the installation.

CART INFORMATION AND MOUNTING

The Viper unit may be mounted on a mobile cart (Cornelius part no. 620043075 for 2-barrel unit, 620053990 for

3-barrel unit and 620046556 for 4-barrel unit) which allows some movement of the unit for service and cleaning.

There are four captive nuts on the bottom of the Viper to accommodate four 3/8-16 bolts. These bolts must be

installed to secure the unit to the cart.

These carts are also designed with movable wheels that act as outriggers to provide stability to the unit when it is

being moved.

WARNING:

The above listed mounting bolts must be installed and the wheels extended and locked in the outboard position

prior to moving the unit.

Failure to comply could result in serious injury, death or equipment damage.

Parts List:

Table 1. Parts List

Sl. No. Part No. Description Quantity UOM

108859 Tie Cable, 11” Std. Dennison 10 EA

2174478000 Tubing Flexcor 265 X 465 500’/Ctn. 8FT

3178025100 Gasket, 1/4 Male Flare Fitting 5EA

4309852000 Clamp OETR 669 Open Stpls #17.0 10 EA

5312926000 Clamp OETR 484 Open Stpls #12.3 24 EA

677062000 Fitg C-Brb 3/8 (4) 1EA

7113375000 Tubing, Vinyl .375 X .625 Transparent 18 FT

850418 Bag, Plastic 1EA

9620807202 Bag, Plastic 10 X 13 Ziplock, 2 mil 1EA

10 629096928INS Manual Installation Kit, 3 Flavor

Plumbing 1EA

11 77010100 Nut, Swivel 7/16-20 BRNI 1EA

12 77010400 Fitting, NIPL 265 Tube 1/4FL Nut SS 1EA

13 77060200 Fitting, C-Barb 1/4 (4) SS 1EA

14 48114008 Clamp 779open Stpls #19.8 5EA

15 620058256 Tubg Uv Resist 510x740 50 FT

16 620717792 Tubg Sg 375id X 535 Taste Rite

Braided 250 FT

17 630900020 S-crtn Wrap I Series Evap 1EA

18 77046500 Fitg Swiv 7/16-20f 3/8brb 5EA

19 77060100 Fitg T-brb 1/4 (3) Ss 4EA

20 111353000 Clamp 571 Open Stpls #14.5 30 EA

21 620066599 Reg Flow Water 50 Psi Fixed 1EA

22 77040700 Splicer Barb 250 X 375 Stn Stl 3EA

Viper 3 Flavor Plumbing Installation Instructions

NOTE: Kit part number 629097278 includes additional components which are not listed in the table

above.

Tools Required

• Adjustable Wrench

• Oetiker Pliers

• Tube Cutters for Beverage Tubing

Additional Items Required

• BIB Disconnects

• BIB Pumps

• BIB Rack

• CO2Regulators

• Water Filter

Refer to 620043090INS for Cornelius part numbers of Additional Items in list above.

Requirements

Table 2. Requirements

CO275±1 psig at the unit

Water

25 psig minimum flowing pressure at the unit with 2.5 gallons

per minute flow rate (150gph) per 3 barrels. If the flowing

pressure and flow rate are less than specified, a water pres-

sure booster is required. See note below.

Syrup 70-75 psig CO2to pumps.

Clearances Refer to Installation/Service Manual

Water Requirement Note: When testing the water supply to the FCB machine the installer must take into consid-

eration the total potential water demand that may be placed on the store water supply by all equipment within the

store.

Equipment such as fountain dispensers, icemakers, coffee brewers, and juice dispensers typically draw water

from a common source/filter system. The FCB machine must be supplied with water to the specification above at

all times, even when any of the other equipment is drawing water. If the operation of the other appliances reduces

the flow rate of water to this FCB unit below 2.5gpm (150gph), add the required water booster.

WARNING:

Secure the CO2cylinder in an upright position with a safety chain to prevent it from falling over and causing per-

sonal injury and property damage.

WARNING:

CO2displaces oxygen. Persons exposed to high concentrations of CO2will experience tremors, followed by loss

of consciousness and death. It is very important to prevent CO2leaks, especially in small, unventilated areas. If a

CO2leak occurs ventilate the area before fixing the leak.

23 77060900 Fitg T-brb 3/8 (3) SS 4EA

24 283012111 Reg CO2S 1X100 1 1/4FL 2EA

Table 1. Parts List

Sl. No. Part No. Description Quantity UOM

Viper 3 Flavor Plumbing Installation Instructions

NOTE: Tubing, hoses, and cabling may be routed from beneath or in back of the Viper FCB unit. It

may be necessary to make a penetration in the counter or wall to accommodate the desired

installation.

NOTE: If the syrup lines will be routed in an area that will see temperatures less than 55°F the lines

must be insulated.

FCB Unit

BIB Syr u p

BIB Pu m p

Wat er Fi lt er

Connections

Tubing

½ Inch Beverage Tubing

3/8 Inch Beverage Tubing

¼ Inch Beverage Tubing

3/8 Inch Tygon Tubing

utlet on S

rup Pum

&25HJXODWRU6HFRQGDU\

¼ Inch Female Flare Nut

Direct Connection to Syrup

Outlet on Syrup Pump

Direct Connection to CO2

Inlet on Syrup Pump

irect Connection to S

rup

Direct Connection to Syrup

Inlet on Syrup Pump

Wat er I n l et

Sy r u p Li n e 1

CO2 I n l e t

BIB Syr u p

BIB Syr u p BIB Pu m p

BIB Pu m p

Sy r u p Li n e 2

Sy r u p Li n e 3

1/2 to3/8 Inch Fitting reducer

¼ Inch Cross Barb

CO2 Regulator - Primary

3/8 Inch Tee Barb

3/8 Inch Flare Nut and Barb (3/8)

3/8 to 1/4 Inch Fitting Reducer

1/4 Inch Tee barb

ylppuS2OC

J H

115 Psig

Max 3 Feet

75 Psig

3 Feet Typical

Figure 1. Plumbing diagram Viper 3 Flavor

CO2

Cylinder

75±1 psig

70-75 psig

Viper Unit

Bag in Box

3/8" Line

NOTE:

Each unit requires a dedicated 3/8" CO2

line with a regulator located at the unit.

An additional dedicated 3/8" CO2line is

required with a regulator located at the

BIB rack.

Viper 3 Flavor Plumbing Installation Instructions

Viper CO2 setup Single unit

Figure 2. Viper CO2 setup - single unit

Bag in Box

Cylinder

Viper Unit

Bag in Box

75±1 psig

70-75 psig

Viper UnitViper Unit

Bag in Box

3/8" Lines

75±1 psig 75±1 psig

NOTE:

Each unit requires a dedicated 3/8" CO

line with a regulator located at the unit.

An additional dedicated 3/8" CO

line is

required with a regulator located at the

BIB rack.

Viper 3 Flavor Plumbing Installation Instructions

Viper CO2 setup Multiple unit

Figure 3. Viper CO2 setup - multiple unit

Otros manuales para VIPER 3 FLAVOR

Tabla de contenidos

Otros manuales de Dispensador de bebidas de Cornelius

Cornelius

Cornelius IDC215 Manual de usuario

Cornelius

Cornelius CHD22 Guía

Cornelius

Cornelius JetSpray JT30-W25 Manual de usuario

Cornelius

Cornelius 440000902 Manual de usuario

Cornelius

Cornelius A8530 Guía de configuración

Cornelius

Cornelius ED-250 Manual de usuario

Cornelius

Cornelius ENDURO-150 6 VALVE Manual de usuario

Cornelius

Cornelius JetSpray JS7 Guía de configuración

Cornelius

Cornelius ED2XX 29677 Manual de usuario

Cornelius

Cornelius REMCOR R-134A Suplemento

Cornelius

Cornelius A.B.S. Unit Manual de usuario

Cornelius

Cornelius ED 300 BN Manual de usuario

Cornelius

Cornelius Enduro 150 8 Valve Manual de usuario

Cornelius

Cornelius VIPER 4 FLAVOR Manual de usuario

Cornelius

Cornelius 300026000 Manual de usuario

Cornelius

Cornelius Drop-In and Free-Standing Ice Cooled... Manual de usuario

Cornelius

Cornelius MillenniumII 4000 Manual de usuario

Cornelius

Cornelius C10 Manual de usuario

Cornelius

Cornelius IDC 255 PROGATE DRIVE THRU UNIT Manual de usuario

Cornelius

Cornelius Impulse Juice Dispenser 851000109 Guía de configuración

Cornelius

Cornelius MILLENNIUM MJ30-4 PB Manual

Cornelius

Cornelius JetSpray JS7C Manual de usuario

Cornelius

Cornelius IDC 2 Series Manual de usuario

Cornelius

Cornelius V4 Instrucciones de funcionamiento

Manuales populares de Dispensador de bebidas de otras marcas

PEGAS

PEGAS Evolution Manual de usuario

Ugolini

Ugolini MT micro Manual de usuario

Bunn

Bunn SLCA-7 Instrucciones de instalación

Gekkeikan

Gekkeikan Sake Machine Manual de usuario

Olympia

Olympia DH709 Manual de usuario

Marco

Marco ECOSMART PB10 Manual de usuario

Marvel

Marvel ML24BN Series Manual

Cecilware

Cecilware 2K-GB-LD Manual

Sure Vend

Sure Vend 673 Manual de usuario

Nostalgia Electrics

Nostalgia Electrics KEG7000SS Manual de usuario

Bunn

Bunn LCR-3 HV Guía de solución de problemas

Servend

Servend SV-200 Manual de usuario

EdgeStar

EdgeStar VBR440 Manual de usuario

CDS AUTOMATEN

CDS AUTOMATEN ML-16C2-C Manual de usuario

Siemens

Siemens GA 3000 Manual de instrucciones y seguridad

Selbach

Selbach Fruit Juice dispenser Manual de usuario

Taylor

Taylor C302NP Manual de usuario

Vinotemp

Vinotemp VT-WINEDISP2 Manual de usuario