Cornelius 6 Flavor Guía

Este manual sirve para los siguientes modelos

1

Tabla de contenidos

Otros manuales de Dispensador de bebidas de Cornelius

Cornelius

Cornelius 2 Flavor Post-Mix Cold Coffee Dispenser Quest... Manual de usuario

Cornelius

Cornelius Nueva Style Manual

Cornelius

Cornelius VIPER 3 FLAVOR Manual de usuario

Cornelius

Cornelius Enduro 300 BC Guía de configuración

Cornelius

Cornelius TRIAD-150 Manual de usuario

Cornelius

Cornelius FCB PINNACLE 2 Flavour Manual de usuario

Cornelius

Cornelius Agitator Gear Motor Capacitor ED/DF Manual de usuario

Cornelius

Cornelius VANTAGE Manual de usuario

Cornelius

Cornelius IDC 255 Manual de usuario

Cornelius

Cornelius C10 Manual de usuario

Cornelius

Cornelius R-404A REFRIGERANT Manual de usuario

Cornelius

Cornelius R-404A REFRIGERANT Manual de usuario

Cornelius

Cornelius 15 Gallon Single-Flavor Visual Display Dispenser... Guía de instalación

Cornelius

Cornelius ED-300 Guía de configuración

Cornelius

Cornelius Agitator Motor Universal 750 Manual de usuario

Cornelius

Cornelius IDC Pro Guía

Cornelius

Cornelius ED 300 BC Manual de usuario

Cornelius

Cornelius JetSpray JT30-W25 Manual de usuario

Cornelius

Cornelius ENDURO-150 6 VALVE Manual de usuario

Cornelius

Cornelius FCB VIPER Manual de usuario

Cornelius

Cornelius FCB - 2 Flavor Manual de usuario

Cornelius

Cornelius 1522 Manual de usuario

Cornelius

Cornelius MILLENNIUM MJ30-4 PB Manual

Cornelius

Cornelius Jet Spray EJ1 Manual de usuario

Manuales populares de Dispensador de bebidas de otras marcas

PEGAS

PEGAS Evolution Manual de usuario

Ugolini

Ugolini MT micro Manual de usuario

Bunn

Bunn SLCA-7 Instrucciones de instalación

Gekkeikan

Gekkeikan Sake Machine Manual de usuario

Olympia

Olympia DH709 Manual de usuario

Marco

Marco ECOSMART PB10 Manual de usuario

Marvel

Marvel ML24BN Series Manual

Cecilware

Cecilware 2K-GB-LD Manual

Sure Vend

Sure Vend 673 Manual de usuario

Nostalgia Electrics

Nostalgia Electrics KEG7000SS Manual de usuario

Bunn

Bunn LCR-3 HV Guía de solución de problemas

Servend

Servend SV-200 Manual de usuario

EdgeStar

EdgeStar VBR440 Manual de usuario

CDS AUTOMATEN

CDS AUTOMATEN ML-16C2-C Manual de usuario

Siemens

Siemens GA 3000 Manual de instrucciones y seguridad

Selbach

Selbach Fruit Juice dispenser Manual de usuario

Taylor

Taylor C302NP Manual de usuario

Vinotemp

Vinotemp VT-WINEDISP2 Manual de usuario

Mellennium II - Water Inlet Replacement

© 2002, IMI Cornelius Inc. - 1 - Publication Number: 620919561

MILLENNIUM II

WATER INLET REPLACEMENT

This instruction sheet details the procedure for replacing the water inlet fitting at the valve.

All necessary material to make the change, along with this bulletin, is included in a kit. The

kit contents are listed below. Note that this kit will work for all models, regardless of volt-

age.

Procedure

1. Turn off the water supply to the dispenser. Disconnect power from the dispenser.

Remove the top panel and merchandiser. Note that there are two harnesses from the top

panel and one from the merchandiser that must be disconnected. Make sure to mark the

harnesses so as not to incorrectly wire them during re-assembly. Next remove both side

panels by sliding them towards the front of the dispenser.

2. Remove the hitch pins that secure the refrigeration deck to the waterbath housing.

Carefully lift the refrigeration deck out of the waterbath to access the manifold.

3. Remove the water inlet fittings from the back of the valve (Figure 1). These are the fit-

tings attached to the 3-inch piece of tubing that runs from the manifold. Also remove this

tubing from the manifold. Discard both the fitting and the tubing for all valves.

4. If not already done, install the new o-ring to the new fitting. Attach this fitting to a 3-inch

piece of tubing with a clamp, and then attach this assembly to the manifold (clamps, tubing

and fittings supplied in kit). Install the fitting into the valve. Repeat for remaining valves.

5. Turn on the water supply to the dispenser and check for leaks. If any leaks are discov-

ered, turn off supply and re-install the fitting into the valve.

6. Install and secure the refrigeration deck into the waterbath, and install the side panels,

top panel and merchandiser. Making sure to properly connect the harnesses and interlock

all cladding pieces. Do not force any panels together. During proper assembly, the panels

will slide together easily and remain interlocked. Connect power to the dispenser.

Millennium II - Kit No. 629087501

Fitting (Qty. 6) 77050300

O-Ring (Qty. 6) 31525003

Clamp (Qty. 12) 40502

Tubing (Qty. 18 in.) 50299

Instruction Sheet 620919561

FIGURE 1

Release Date: February 2, 2002 Revision: A

Mellennium II - Water Inlet Replacement

Publication Number: 620919561 - 2 - © 2002, IMI Cornelius Inc.