Billion BiPAC 7401V(G)PX Manual de usuario

BiPAC 7401V(G)PX

3G/ VoIP/ (802.11g) ADSL2+

Firewall Router

Quick Start Guide

Billion BiPAC 7401V(G)PX 3G/ VoIP/ (802.11g) ADSL2+ Firewall Router

-1-

Package Contents

BiPAC 7401V(G)PX ADSL2+ Router

CD containing the on-line manual

RJ-11 ADSL/telephone cable

Ethernet (RJ-45) cable

One 2dBi detachable antenna (Wireless model only)

Power adapter

RJ-45 to RS-232 Console Kit

This Quick Start Guide

Splitter/ Micro-filter (Option)

Warning

PLEASE READ THE QUICK START GUIDE AND FOLLOW THE

STEPS CAREFULLY. THIS QUICK START GUIDE WILL HELP YOU

INSTALL THE DEVICE PROPERLY AND AVOID IMPROPER USAGE.

IF YOU NEED MORE INFORMATION ON THIS SOFTWARE

CONFIGURATION, PLEASE REFER TO THE USER’S MANUAL ON

CD-ROM.

 Do not use the router in high humidity or high temperatures.

 Do not use the same power source for the router as other

equipment.

 Do not open or repair the case yourself. If the router is too hot,

turn off the power immediately and have it repaired at a qualified

service center.

 Avoid usin

this

roduct and all accessories outdoors.

 Place the router on a stable surface.

 Only use the power adapter that comes with the package. Using a

different voltage rating power adaptor may damage the router.

ttention

Quick Start Guide

-2-

Hardware Overview

The Front LEDs

The Rear Ports

Connect the

supplied power

adapter to this jack

Connect this port to the

ADSL/telephone network

with the RJ-11 cable

(

tele

hone

)

rovided.

Press it to reset

the device or

restore to factory

default settings

Connect a UTP Ethernet

cable (Cat-5 or Cat-5e) to

one ofthe LAN ports when

connecting to a PC or an

office/home network of

10Mbps or 100Mbps.

Connect the

detachable

antennato this port.

Lit when power is ON.

Lit red means system

failure.

Connect this port to

the telephone jack on

the wall with RJ-11

cable.

Lit when connected to an

Ethernet device.

Green for 100Mbps;

Orange for 10Mbps.

Blink when data is

Transmitted / Received.

Lit green when the

hone is of

hook.

Lit Green when the device is

successfully connected to an

ADSL

DSLAM. (

“

line sync

”

)

Lit green when a

wireless connection is

established. Flash

when the device is

sending/receiving data.

Power

ON/OFF

switch

Lit red when WAN port fails to

get IP address.

Lit green when WAN port gets

IP address successfully.

Lit when the inbound

and outbound calls

are transmitted

through PSTN.

Lit green when the

SIP Registration is

OK.

Push WPS button to

trigger Wi-Fi Protected

Setup function.

Connect this port to

an analog phone set

with RJ-11 cable.

Lit green when the

USB device is ready.

Flashes when

sending/ receiving

data.

3G/ HSDPA USB

modem backup for

Internet access

Billion BiPAC 7401V(G)PX 3G/ VoIP/ (802.11g) ADSL2+ Firewall Router

-3-

Hardware Connection

Hardware Installation

1. Power Connection

Plug the supplied power adapter to the wall jack and the other side to the router.

Please note that the plug type may differ according to different countries.

2. LAN Connection

Connect the supplied RJ-45 Ethernet cable to one of the Ethernet ports, and the

other side to the PC’s Ethernet interface.

Quick Start Guide

-4-

3. USB Connection

The USB 2.0 port supports 3G/HSDPA modem connectivity: users can

conveniently access Internet via 3G, eliminating the limitations of the wired

network. This solution also employs an auto fail-over feature to ensure always-on

connectivity for SOHO users.

4. Phone Connection

Connect RJ-11 cable to the router’s phone port and the analog phone set.

5. Line Connection

a) Connect RJ-11 cable to the router DSL port and the splitter ADSL port.

b) Connect RJ-11 cable to the router Line port and the splitter phone port.

c) Connect RJ-11 cable to the splitter Line port and the phone jack on the wall.

Billion BiPAC 7401V(G)PX 3G/ VoIP/ (802.11g) ADSL2+ Firewall Router

-5-

6. Splitter/ Micro-filter Connection

Splitter / Micro-filter are important for ADSL installation. It helps high-frequency

signals are directed to the ADSL modem, and low-frequency signals are directed

to the telephone or other analog voice-channel device to prevent inter-modulation

distortion and get good speed and stable ADSL sync rate.

a) Splitter connection

If the installation has only a single telephone and a single ADSL modem, then a

splitter can be employed.

b) Micro-filter connection

If the installation has several telephones or other analog devices, then an internal

micro-filter can be employed at each analog device.

Setup Utility

Quick Start Guide

-6-

After you complete the hardware installation, insert the CD-ROM to the CD-ROM drive to

perform Setup Utility for network configuration. The Setup Utility will auto-run. Follow the

step-by-step configuration wizard, the utility will guide you complete the basic network

configuration.

Troubleshooting

1. None of the LEDs are on when you turn on the router.

Check the connection between the adapter and the router. If the error persists, you may have

a hardware problem. In this case you should contact technical support.

2. You have forgotten your router login and/or password.

Try the default login and password, please refer to the user manual. If this fails, you can

restore your router to its factory settings by holding the Reset button on the back of your

router for 6 seconds or more.

3. Can’t ping any PCs on the LAN.

Check the Ethernet LEDs on the front panel. The LED should be on for a port that has a PC

connected. If it is off, check the cables between your router and the PC. Make sure you have

uninstalled any software firewall for troubleshooting. Verify that the IP address and the subnet

mask are consistent between the router and the workstations.

4. Frequent loss of ADSL linesync (disconnections).

Ensure that all other devices connected to the same telephone line as your router (e.g.

telephones, fax machines, analogue modems) have a line filter connected between them and

the wall socket (unless you are using a Central Splitter or Central Filter installed by a qualified

and licensed electrician), and ensure that all line filters are correctly installed and the right

way around. Missing line filters or line filters installed the wrong way around can cause

problems with your ADSL connection, including causing frequent disconnections. If you have

a back-to-base alarm system you should contact your security provider for a technician to

make any necessary changes.

Product Support and Contact Information

Most problems can be solved by referring to the Troubleshooting section in the User’s Manual.

If you cannot resolve the problem with the Troubleshooting chapter, please contact the dealer

where you purchased this product.

Contact Billion

WORLDWIDE

http://www.billion.com

Billion Product Registration

Billion is committed to before and after sales customer services. You will get the most out of your Billion's products

after registration. Please register online at www.billion.com/register to receive valuable services and support from

us.

7401V

(

)

PX: V1.00EN

Otros manuales para BiPAC 7401V(G)PX

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Enrutador de red de Billion

Billion

Billion BiPAC 7404V(G)OX/V(G)PX Manual de usuario

Billion

Billion BiPAC 7100SG Manual de usuario

Billion

Billion BiPAC 7402GL R4 Manual de usuario

Billion

Billion VoIP/(802.11g) ADSL2+ Router BiPAC 7300VGP Manual de usuario

Billion

Billion BiPAC 710C2 Manual de usuario

Billion

Billion BiPAC 6404VGP R3 Manual de usuario

Billion

Billion BiPAC 7300 G Manual de usuario

Billion

Billion BiPAC VGL Manual de usuario

Billion

Billion Router Manual de usuario

Billion

Billion BiPAC 7402VGO Manual de usuario

Billion

Billion myGuard 7202 Manual de usuario

Billion

Billion BiPAC 8900X R3 Manual de usuario

Billion

Billion BiPAC 7401VGP R3 Manual de usuario

Billion

Billion BiPAC 5200S Series Manual de usuario

Billion

Billion BIPAC-7402 Manual de usuario

Billion

Billion BiPAC 7800(N) Manual de usuario

Billion

Billion BiPAC 5200N Manual de usuario

Billion

Billion 400G Instrucciones de uso

Billion

Billion BiPAC 5200 Manual de usuario

Billion

Billion myGuard 7500GL Manual de usuario

Billion

Billion 7560 Manual de usuario

Billion

Billion BiPAC 6300VNP Manual de usuario

Billion

Billion (802.11g) ADSL2+ Modem/Router BIPAC 5102G Manual de usuario

Billion

Billion BiPAC 5100S Manual de usuario

Manuales populares de Enrutador de red de otras marcas

Allnet

Allnet ALL0333AU Manual de usuario

HomeSeer

HomeSeer HT-SEL Manual de usuario

Sercomm

Sercomm Genesis OC3505D Manual de usuario

TP-Link

TP-Link TD-8817 Manual de usuario

Motorola

Motorola MR1900 Manual de usuario

Digi

Digi IX14 Manual de usuario

Cisco

Cisco NCS 540 Manual

XAVi

XAVi X8821e Manual de usuario

BEC

BEC 6200WZL Manual de usuario

MikroTik

MikroTik hAP ac3 Series Manual de usuario

Korenix

Korenix JetNet 5428G Series Manual de usuario

NETGEAR

NETGEAR FS526T - Switch Manual de usuario

Korenix

Korenix JetNet 5710G Series Manual de usuario

Automated Logic

Automated Logic ZN551 Manual del propietario

Cisco

Cisco ASR 1000 Series Manual del operador

EnGenius

EnGenius ESR-9710 Manual de usuario

Cisco

Cisco 805 Series Instrucciones de funcionamiento y seguridad

LevelOne

LevelOne FBR-1416 Manual de usuario