Advantech ICR-3831 Guía

Start Guide

ICR-3831

Start Guide

Safety Instructions

Please take care to following instructions:

•Use the router in compliance with national and international law and in compliance with

any special or additional restrictions regulating the use of the router in the various appli-

cations and environments.

•To avoid possible injury and/or damage to the device, observe the relevant provisions

and standards. Use only the original accessories as recommended. Unauthorized de-

vice or accessory modiﬁcation, or using accessories that have not been approved can

result in router damage and/or violation of the regulations.

•Unauthorized device or accessory modiﬁcation or using the accessories that have not

been approved can result in warranty termination.

•Do not open the router.

•Caution! The SIM card can be swallowed by small children.

•When connecting the device to a power supply do not exceed the deﬁned voltage.

•Do not expose the router to extreme ambient conditions. Protect the router against dust,

moisture, and high temperature.

•It is recommended that you do not use the router at petrol ﬁlling stations. We recommend

observing local restrictions concerning the use of radio-based devices while working with

explosive material for example, at petrol ﬁlling stations, or in chemical plants.

•While using the router close to personal medical devices, such as cardiac pacemakers

or hearing aids, proceed with heightened caution.

•Operating the router too close to TV sets, radio receivers, personal computers, or tele-

phones can cause interference.

•It is recommended that you create a copy or backup of the important settings stored in

the memory of the router.

QSG-0007-EN, April 29, 2020 1 Released in the Czech Republic

Start Guide

Product Disposal Instructions

The WEEE (Waste Electrical and Electronic Equipment: 2012/19/EU) direc-

tive was introduced to ensure that electrical/electronic products are recycled us-

ing the best available recovery techniques in order to minimize impact on the en-

vironment. This product contains high-quality materials and components which

can be recycled. At the end of it’s life this product MUST NOT be mixed with

other commercial waste for disposal. The device contains the battery. Remove

the battery from the device before disposal. The battery in the device needs to be disposed

apart accordingly. Check the terms and conditions of your supplier for disposal information.

Open Source Software License

The software in this device uses various pieces of open-source software governed by the

following licenses:

•GPL versions 2 and 3

•LGPL version 2

•BSD-style licences

•MIT-style licences

The list of components together with complete license texts can be found on the device

itself. See Licenses link at the bottom of the router’s main Web page (General Status) or point

your browser to this address (replace the DEVICE_IP string with real router’s IP address):

https://DEVICE_IP/licenses.cgi

This is a written offer valid for 3 years since the device purchase offering any third party

for a charge no more than the cost of physically performing source distribution, a complete

machine-readable copy of the corresponding source code on a ﬂash drive medium. If you are

interested in obtaining the source, please contact us at:

[email protected]

Modiﬁcations and debugging of LGPL-linked executables:

The manufacturer of the device hereby grants the right to use debugging techniques (e.g.

decompilation) and making customer modiﬁcations of any executable linked with an LGPL

library for own purposes. Note these rights are limited to the customer’s own usage. No further

distribution of such modiﬁed executables and no transmission of the information obtained

during these actions may be done.

QSG-0007-EN, April 29, 2020 2 Released in the Czech Republic

Start Guide

First Use

Before applying power to the router, connect the components that you required for your

applications. You cannot operate the router without a connected antenna, inserted SIM card,

nor a connected power supply. Cross-shaped screwdriver is necessary to insert a SIM card.

If you do not have connected the main antenna during operation of the router, the router

can be damaged!

1. Antenna

Use TNC connectors to connect the antennas to the router. The main antenna is connected

to the router by screwing on the ANT connector (see the ﬁgure below). The second diversity

antenna can also be connected to the DIV connector to improve performance.

QSG-0007-EN, April 29, 2020 3 Released in the Czech Republic

Start Guide

2. SIM Card

The SIM card readers for Mini SIM (2FF) type of 3 V and 1.8 V SIM cards (25.0 x 15.0 x

0.76 mm.) are located on the front panel of the router under the cover. If you intend to use this

device to communicate over a cellular network, please place an activated data-provisioned

SIM card with an unblocked PIN into the SIM card reader. Unscrew the cover and push your

SIM card into the SIM1 or SIM2 slot until it clicks in place.

Disconnect the router from power supply before handling of the SIM card!

QSG-0007-EN, April 29, 2020 4 Released in the Czech Republic

Start Guide

3. Power

The router requires an external DC power supply. The DC voltage required is between

+12 to +48 V DC. The router has built-in protection against reverse polarity without signaling.

Connect the power supply cable to the PWR connector on the rear panel of the router (see the

ﬁgure below).

4. Ethernet

An Ethernet cable may be connected to the ETH0 connector on the rear panel of the router

(see the ﬁgure above). By default, the Ethernet port is conﬁgured as follows:

Connector Purpose Default Setting

ETH0 LAN port (default)

Connect your laptop or PC to this port to

get a local web-server for device conﬁgu-

ration and diagnostics.

DHCP Server enabled

IP Address: 192.168.1.1

NetMask: 255.255.255.0

QSG-0007-EN, April 29, 2020 5 Released in the Czech Republic

Start Guide

Conﬁguration

1. Conﬁguring the Device Using the Web Browser

You can access the router for status monitoring, conﬁguration, and administration after en-

tering the IP address of the router into a Web browser. The default IP address is 192.168.1.1

(netmask 255.255.255.0). Conﬁguration access is allowed for the user root. The default pass-

word is printed on the router’s label.1Attention, it is necessary to use HTTPS protocol for

secure communication over a network! For a detailed description and examples of the router

conﬁgurations, see the Conﬁguration Manual.

Important Notes

After logging on to the device for the ﬁrst time, we strongly recommend changing the

default password due to security reasons.

For security reasons, it is highly recommended to update the ﬁrmware of the router to the

latest version regularly. Downgrading the ﬁrmware to an older version than the production

version or uploading a ﬁrmware intended for a different device may cause the malfunction

of the device.

2. Conﬁguration Settings via WebAccess/DMP

Your router has been pre-installed with the WebAccess/DMP client. If you enable it in

the router’s web interface, you may conﬁgure the router from WebAccess/DMP. Navigate your

browser to:

https://www.wadmp.com

If this is your ﬁrst time, please self-sign-up with the site. If not, please login with your

username and password. Once logged in, further assistance can be found here:

https://docs.wadmp.com

3. Restoring and Backing up the Router Conﬁguration

After you reset the router, the current conﬁguration is overwritten by the default settings.

We recommend that you back up the router conﬁguration before resetting the device. Refer to

the Conﬁguration Manual for more information.

When the PWR LED starts blinking, it is possible to restore the default conﬁguration of

the router by pressing the RST button on the front panel of the router. Note that the RST

button is located under the cover – unscrew the cover. After pressing this button, the default

conﬁguration is restored and then the router reboots (green LED will be on).

1If the router’s label does not contain a unique password, use the password "root".

QSG-0007-EN, April 29, 2020 6 Released in the Czech Republic

Start Guide

Documentation

User’s Manual, Conﬁguration Manual and other manuals can be found and downloaded

on this web site: www.advantech-bb.cz/download

Hereby, Advantech Czech s.r.o. declares that the radio equipment type

ICR-3831 is in compliance with Directive 2014/53/EU.

The full text of the EU Declaration of Conformity is available at the following internet address:

www.advantech-bb.cz/eudoc

QSG-0007-EN, April 29, 2020 7 Released in the Czech Republic

Tabla de contenidos

Otros manuales de Enrutador de red de Advantech

Advantech

Advantech ICR-2441 Manual de usuario

Advantech

Advantech ICR-2031 Manual de usuario

Advantech

Advantech EKI-4524I Manual de usuario

Advantech

Advantech ICR-3211 Manual de usuario

Advantech

Advantech B&B SmartWorx ESWGP506-2SFP-T Manual de usuario

Advantech

Advantech ICR-4401 Manual de usuario

Advantech

Advantech EKI-7626C Manual de usuario

Advantech

Advantech Libratum ICR-2834 Manual de usuario

Advantech

Advantech EKI-2726FHPI Series Manual de instalación y operación

Advantech

Advantech ICR-3211 Guía

Advantech

Advantech ICR-2734P Manual de usuario

Advantech

Advantech SmartStart SL304 Manual de usuario

Advantech

Advantech EKI-6538 Manual de usuario

Advantech

Advantech ICR-3232 Manual de usuario

Advantech

Advantech ICR-3241 Manual de usuario

Advantech

Advantech ICR-4461 Manual de usuario

Advantech

Advantech ICR-2412 Manual de usuario

Advantech

Advantech ICR-3201 Series Manual de usuario

Advantech

Advantech ICR-2701 Manual de usuario

Advantech

Advantech CR10 v2 Manual de usuario

Advantech

Advantech ICR-4401 Manual de usuario

Advantech

Advantech SmartMotion ST352 Manual de usuario

Advantech

Advantech ICR-1601G Hoja de instrucciones

Advantech

Advantech ICR-2431 Manual de usuario

Manuales populares de Enrutador de red de otras marcas

Allnet

Allnet ALL0333AU Manual de usuario

HomeSeer

HomeSeer HT-SEL Manual de usuario

Sercomm

Sercomm Genesis OC3505D Manual de usuario

Billion

Billion BIPAC 5102 Series Manual de usuario

TP-Link

TP-Link TD-8817 Manual de usuario

Motorola

Motorola MR1900 Manual de usuario

Digi

Digi IX14 Manual de usuario

Cisco

Cisco NCS 540 Manual

XAVi

XAVi X8821e Manual de usuario

BEC

BEC 6200WZL Manual de usuario

MikroTik

MikroTik hAP ac3 Series Manual de usuario

Korenix

Korenix JetNet 5428G Series Manual de usuario

NETGEAR

NETGEAR FS526T - Switch Manual de usuario

Korenix

Korenix JetNet 5710G Series Manual de usuario

Automated Logic

Automated Logic ZN551 Manual del propietario

Cisco

Cisco ASR 1000 Series Manual del operador

EnGenius

EnGenius ESR-9710 Manual de usuario

Cisco

Cisco 805 Series Instrucciones de funcionamiento y seguridad