Usually, the long press of 5 seconds is used to enter a programming or pairing mode.
This procedure prevents that important settings are changed accidentally.
Using the Alarm unit
The alarm unit can be operated both through the remote control as well as by pressing the
buttons on the side.
Switch On: Long press the On/Off Button [ ] to switch the unit on. The lights on the front
will light up one by one from top to bottom when the unit is switched on and a beep will
be heard.
Switch Off: Long press the On/Off Button [ ] to switch the unit off. The lights on the front
will dim one by one from bottom to top when switching off. A beep will be heard.
Arm/Disarm: Make sure the Alarm unit is switched On. Now, short press the SET button [
] once. A beep will be heard and the visual indicator will light up once when the unit
is armed, and 2 beeps will be heard and the visual indicator will light up twice if the unit is
disarmed.
IMPORTANT: Your Alarm unit is equipped with a memory function. This means that the
Alarm unit will always come back to its last settings when switched On. If it was armed
when it was switched off, it will be armed when it is switched On again. However, if it
was disarmed when it was switched Off, it will be disarmed when switched On again. In
this case, to arm the Alarm unit just short press the SET button [ ] .
Change the sound: Make sure the Alarm unit is switched On. Change the sounds by short
pressing the On/Off Button [ ] . A short confirmation sound will be heard if the sound is
changed.
Entering the Pairing mode: Make sure the Alarm unit is switched On. Long press the SET
button [ ]. All the lights on the front of the Alarm unit are now lit.
Select a zone in pairing mode:
In Pairing mode, short press the SET button [ ] to switch between zones.
See the Chapter “Pairing with sensors and remote controls” for further instructions on
how to pair devices with the Alarm unit.
When a sensor is triggered:
-The sound will be heard, Chime or Siren.
-If the Siren is selected as a notification sound, the LED lights will indicate which zone
triggered the alarm (one of the four LEDs will light up).
-If the Chime sound was selected as a notification sound, all 4 LEDs will light to
indicate a sensor was triggered but the zone will not be indicated.
