StarTech.com 8STVID2VGATV2 Manual de usuario

Manual Revision: 05/12/2011

For the most up-to-date information, please visit: www.startech.com

DE: Bedienungsanleitung - de.startech.com

FR: Guide de l'utilisateur - fr.startech.com

ES: Guía del usuario - es.startech.com

IT: Guida per l'uso - it.startech.com

NL: Gebruiksaanwijzing - nl.startech.com

PT: Guia do usuário - pt.startech.com

VID2VGATV2

Composite/S-Video to VGA Video Converter

*actual product may vary from photos

Instruction Manual

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there

is no guarantee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be determined by

turning the equipment o and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from that to which the receiver

is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Use of Trademarks, Registered Trademarks, and other Protected Names and

Symbols

This manual may make reference to trademarks, registered trademarks, and other

protected names and/or symbols of third-party companies not related in any way to

StarTech.com. Where they occur these references are for illustrative purposes only and do not

represent an endorsement of a product or service by StarTech.com, or an endorsement of the

product(s) to which this manual applies by the third-party company in question. Regardless

of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby

acknowledges that all trademarks, registered trademarks, service marks, and other protected

names and/or symbols contained in this manual and related documents are the property of

their respective holders.

Instruction Manual i

Table of Contents

Introduction ............................................................................................1

Packaging Contents .................................................................................................................................1

System Requirements .............................................................................................................................. 1

Front View ....................................................................................................................................................2

Rear View ...................................................................................................................................................... 2

Side View ...................................................................................................................................................... 3

Installation ..............................................................................................4

Hardware Installation .............................................................................................................................. 4

Driver Installation ...................................................................................................................................... 4

How to Use ..............................................................................................5

On Screen Display ..................................................................................................................................... 5

Specications ..........................................................................................6

Technical Support ..................................................................................7

Warranty Information ............................................................................7

Instruction Manual 1

Introduction

The VID2VGATV2 Composite and S-Video to VGA Video Scan Converter with Scaler

provides a simple way to convert Composite or S-Video signals to VGA (or Component

RCA) output for use with computer monitors, projectors or HDTV sets.

Equipped with an On Screen Display (OSD) menu and dip switches for simple

conguration and selection of your video output settings, this compact video scaler

installs quickly and easily for a true plug-and-play experience. An integrated scaler

circuit dynamically converts the input video signal, giving you multiple output

resolutions to choose from to ensure compatibility with your display or projector.

An included VGA to Component (RCA) breakout cable adds the ability to connect to TV

sets that are not equipped with a VGA port.

Packaging Contents

• 1 x Video Converter

• 1 x VGA to Component (RCA) breakout cable

• 1 x Universal Power Adapter

• 3 x Power Adapter plug (NA/UK/EU)

• 1 x Instruction Manual

System Requirements

• Composite or S-Video enabled video source (i.e. DVD player, PVR/DVR, etc.)

• Composite or S-Video cable

• VGA or component video enabled display device (e.g. monitor, projector, etc.)

• VGA cable (if connecting to VGA display device)

• Available AC electrical outlet

Instruction Manual 2

Front View

Rear View

Instruction Manual 3

Side View

Instruction Manual 4

Installation

Hardware Installation

1. Make sure all devices and components are powered o.

2. Connect the video source to the input side of the video converter using either an

S-Video or composite RCA cable (both sold separately).

3. Plug the power adapter into the video converter. The Input indicator LED will light

up steady.

4. If not already set to the correct input, press the Input selector button to change the

input source. The LED will light up green for composite and red for S-Video.

5. Connect the display to the converter using either the VGA to component RCA

breakout cable (included), or a male/male VGA cable (sold separately).

6. Set the Output Signal Mode selector switch along the side of the video converter to

the type of display you are using: “HD” for component and “PC” for VGA.

7. Select the output resolution using the slide switch next to the VGA output

connector. Make sure to select an output resolution that is supported by the display

device.

8. Power on the display device.

9. Power on the video source.

Driver Installation

The video converter is an external pure hardware converter, so no driver or software

installation is required.

Instruction Manual 5

How to Use

On Screen Display

The video converter has a built in on screen display (OSD) that will show the current

input and output signal properties on the connected display. If outputting a

component video signal (HD mode), the option to enable or disable 50Hz to 60Hz scan

rate conversion is available.

HD Output Mode

PC Output Mode

The OSD can be accessed by pressing and holding the Input Mode selection button

for 5 seconds. In HD mode, the scan rate conversion settings can be toggled between

by pressing the Input Mode button. The OSD will automatically close after several

seconds of inactivity.

Instruction Manual 6

Specications

Video Signal (Input) Composite

S-Video

Video Signal (Output) VGA (RGBHV)

YPbPr component

Connectors

1 x RCA Composite female

1 x S-Video 4-pin female

1 x DE-15 VGA female

1 x DC Power

LEDs 1 x Input Selection

Supported Video Systems NTSC, PAL

Supported Video Output

PC: XGA (1024x768), SXGA (1280x1024),

UXGA (1600x1200) @ 60 Hz

HD: 480p, 720p, 1080p @ 50/60 Hz

On Screen Display Yes

Power Adapter 5V DC, 1000mA, center positive

Enclosure Material Plastic

Operating Temperature 0°C ~ 40°C (32°F ~ 104°F)

Storage Temperature 0°C ~ 60°C (32°F ~ 140°F)

Humidity 0% ~ 60% RH

Dimensions (LxWxH) 112.0mm x 64.0mm x 26.0mm

Weight 90g

Instruction Manual 7

Technical Support

StarTech.com’s lifetime technical support is an integral part of our commitment to

provide industry-leading solutions. If you ever need help with your product, visit

www.startech.com/support and access our comprehensive selection of online tools,

documentation, and downloads.

For the latest drivers/software, please visit www.startech.com/downloads

Warranty Information

This product is backed by a one year warranty.

In addition, StarTech.com warrants its products against defects in materials

and workmanship for the periods noted, following the initial date of purchase.

During this period, the products may be returned for repair, or replacement with

equivalent products at our discretion. The warranty covers parts and labor costs only.

StarTech.com does not warrant its products from defects or damages arising from

misuse, abuse, alteration, or normal wear and tear.

Limitation of Liability

In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their

ocers, directors, employees or agents) for any damages (whether direct or indirect,

special, punitive, incidental, consequential, or otherwise), loss of prots, loss of business,

or any pecuniary loss, arising out of or related to the use of the product exceed the

actual price paid for the product. Some states do not allow the exclusion or limitation

of incidental or consequential damages. If such laws apply, the limitations or exclusions

contained in this statement may not apply to you.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Convertidor de medios de StarTech.com

StarTech.com

StarTech.com MCM110SC2 Manual de usuario

StarTech.com

StarTech.com HD2VID2 Manual de usuario

StarTech.com

StarTech.com MMC110MMST Manual de usuario

StarTech.com

StarTech.com 8STET91000SFP2C Manual de usuario

StarTech.com

StarTech.com VGA2DVII Manual de usuario

StarTech.com

StarTech.com SDI2HD Manual de usuario

StarTech.com

StarTech.com ICUSBAUDIO Manual del sistema

StarTech.com

StarTech.com 8STSDI2HD Manual de usuario

StarTech.com

StarTech.com ET91000SM20 Manual de usuario

StarTech.com

StarTech.com USB2DVIE Manual de usuario

StarTech.com

StarTech.com MCMGBSC055 Manual de usuario

StarTech.com

StarTech.com ST122LEA Manual de usuario

StarTech.com

StarTech.com VID2HDCON2 Manual de usuario

StarTech.com

StarTech.com ET1000S40LC2 Manual del sistema

StarTech.com

StarTech.com ET90110SC2 Manual de usuario

StarTech.com

StarTech.com VID2HDCON Manual de usuario

StarTech.com

StarTech.com ET9003SM Manual del sistema

StarTech.com

StarTech.com MCM110ST Manual de usuario

StarTech.com

StarTech.com ET91000SM10 Manual de usuario

StarTech.com

StarTech.com PIB2S31 Manual de usuario

StarTech.com

StarTech.com SLMPT2HD Manual de usuario

StarTech.com

StarTech.com ET1110PSE Manual de usuario

StarTech.com

StarTech.com SAT32MSAT257 Manual de usuario

StarTech.com

StarTech.com ET9003SC Manual

Manuales populares de Convertidor de medios de otras marcas

SoundTraxx

SoundTraxx Blunami BLU-2200 Manual de usuario

SPROLINK

SPROLINK VA1 Manual de usuario

Acclaim Lighting

Acclaim Lighting DDC-1-AC Manual de usuario

Nikon

Nikon AF-S TC-20E III Manual de usuario

Axis

Axis AXIS Q7406 Manual de usuario

Omega

Omega TAC80B-J Manual de usuario

Zoom

Zoom Thunderbolt TAC-2R Manual de usuario

OST

OST iConverter 10/100M Manual de usuario

Vertiv

Vertiv Netsure Manual de usuario

birddog

birddog MINI Manual de usuario

Roland

Roland GI-10 Manual de usuario

Wallenstein

Wallenstein WX310 Manual de usuario

Pace

Pace MSS 200-1 Manual de usuario

Solar Converters

Solar Converters EQ 12/24-50 Manual de usuario

CYP

CYP EL-7400V Manual de usuario

TIE

TIE MIDI 1i1o Manual de usuario

DCS

DCS Vivaldi Upsampler Manual de usuario

Westermo

Westermo MCW-211 SERIES Manual de usuario