StarTech.com HSB2535SATBK Manual de usuario

Manual Revision: 09/20/2013

For the most up-to-date information, please visit: www.startech.com

DE: Bedienungsanleitung - de.startech.com

FR: Guide de l'utilisateur - fr.startech.com

ES: Guía del usuario - es.startech.com

IT: Guida per l'uso - it.startech.com

NL: Gebruiksaanwijzing - nl.startech.com

PT: Guia do usuário - pt.startech.com

HSB2535SATBK

5.25in Dual 2.5/3.5in HDD/SSD SAS SATA

Trayless Mobile Rack

*actual product may vary from photos

Instruction Manual

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation.This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there

is no guarantee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be determined by

turning the equipment o and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from that to which the receiver

is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols

This manual may make reference to trademarks, registered trademarks, and other

protected names and/or symbols of third-party companies not related in any way to

StarTech.com. Where they occur these references are for illustrative purposes only and do not

represent an endorsement of a product or service by StarTech.com, or an endorsement of the

product(s) to which this manual applies by the third-party company in question. Regardless

of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby

acknowledges that all trademarks, registered trademarks, service marks, and other protected

names and/or symbols contained in this manual and related documents are the property of

their respective holders.

Instruction Manual

Table of Contents

Product Diagram ....................................................................................1

Front View .................................................................................................................................................... 1

Rear View...................................................................................................................................................... 1

Introduction............................................................................................2

Packaging Contents ................................................................................................................................. 2

System Requirements.............................................................................................................................. 2

Hardware Installation............................................................................3

2.5/3.5in Hard Drive Installation.......................................................................................................... 4

2.5/3.5in Hard Drive Removal............................................................................................................... 5

How to Use ..............................................................................................6

Connecting the Hard Drive.................................................................................................................... 6

LED Indicator .............................................................................................................................................. 6

Initializing the Hard Drive.....................................................................6

Technical Support ..................................................................................8

Warranty Information............................................................................8

Instruction Manual

Product Diagram

Front View

1. 2.5” Drive bay

2. 2.5” Drive bay key hole

3. 3.5” Drive bay

4. 3.5” Drive bay key hole

5. 2.5/3.5in LED indicators

Rear View

1. 2.5” Drive SATA port

2. 3.5” Drive SATA/SAS Port

3. LP4 Power Connector

Instruction Manual

Introduction

Packaging Contents

• 1 x 2.5/3.5in SATA HDD Backplane

• 2 x 18” SATA Cable

• 1 x Molex LP4 to SATA Power Adapter Cable

• 2 x Bay Key

• 1 x Installation Screw kit

• 1 x Instruction Manual

System Requirements

• 1 x Computer System with SATA connectivity and an available 5.25” bay

• 1 x Available SATA or LP4 Power Connection

• 1 x 2.5” SATA Hard Drive and/or 1 x 3.5” SATA/SAS Hard Drive

WARNING! Hard drives and storage docks require careful handling, especially when

being transported. If you are not careful with your hard disk, lost data may result.

Always handle your hard drive and storage device with caution. Be sure that you

are properly grounded by wearing an anti-static strap when handling computer

components or discharge yourself of any static electricity build-up by touching a large

grounded metal surface (such as the computer case) for several seconds.

Instruction Manual

Hardware Installation

1. Ensure your computer system is powered down, and the power cable has been

disconnected from the Power Supply.

2. Open your computer case (refer to the computer user manual for details), and place

the 2.5/3.5in SATA HDD Backplane into an available 5.25” slot, lining up the side

installation holes on the HSB2535SATBK (pictured below), with installation holes on

the 5.25” slot inside the computer.

3. Hold the HSB2535SATBK into place, and x 4 of the included screws through

the installation holes on the 5.25” slot, into the side installation holes on the

HSB2535SATBK.

4. Connect one of the included “18in SATA cables”from an available SATA host port on

your motherboard to the“2.5” Drive SATA port” on the back of the HSB2535SATBK.

5. Connect one of the included “18in SATA cables”from an available SATA host port on

your motherboard to the“3.5” Drive SATA port” on the back of the HSB2535SATBK.

6. Connect a Molex LP4 Power header from your power supply to the“LP4 Power

Connector” on the back of the HSB2535SATBK. If you do not have an LP4 connector

available, use the included“Molex LP4 to SATA Power Adapter Cable”with an

available SATA Power Header from your power supply.

Instruction Manual

2.5/3.5in Hard Drive Installation

1. Insert either of the included bay keys into the “2.5in/3.5in Drive bay key holes

depending on which type of drive you intend to install. And Turn the key clockwise

into the unlock position.

2. Pull the drive door handle to open the drive bay.

3. Insert your desired drive.

4. Close the drive door.

Instruction Manual

2.5/3.5in Hard Drive Removal

1. Insert either of the included bay keys into the “2.5in/3.5in Drive bay key holes

depending on which type of drive you intend to install. And Turn the key clockwise

into the unlock position.

2. Pull the drive door handle to open the drive bay.

3. Remove your drive.

4. Close the drive door.

Note: It is important to eject or unmount the hard drive from your computer system

before physically removing the drive. See How to Use - Disconnecting the Hard Drive

section for instructions.

Instruction Manual

How to Use

Connecting the Hard Drive

Once the drive has been installed in the drive bay, the drivers will install automatically,

and the inserted drive will be accessible as though it were installed within the system.

Prior to using the drive, it will need to be formatted according to your operating

system requirements.

Refer to Initializing the Hard Drive

LED Indicator

The HSB2535SATBK oers 2.5/3.5in LED indicators, to enable you to monitor drive

activity. The LED will ash while the hard drive is being accessed. Do not remove the

enclosure from the host computer while the LED is ashing, as it could damage the

drive or the enclosure, resulting in data loss.

Initializing the Hard Drive

1. If the SATA Hard Drive is blank it may need to be initialized and formatted before

use. From the main Windows desktop, right-click on “My Computer” (“Computer” in

Vista/ 7 / 8), then select Manage. In the new Computer Management window, select

Disk Management from the left window panel.

Instruction Manual

2. A dialog window should automatically appear, asking you to initialize the drive.

Depending on the version of Windows, it will give you the option of either creating

an “MBR” or “GPT”disk. GPT (GUID partition) is required for drives larger than 2TB but

is not compatible with some older operating systems, while MBR is supported by

newer and older operating systems.

3. Once initialized, locate the Disk that says it is “Unallocated” (check the listed hard

drive capacity to conrm it’s the correct hard drive) and then right-click in the

section that says “Unallocated” and select“New Partition”.

4. Several on screen prompts will follow walking you through the steps to create the

partition. Follow these prompts to complete partition creation.

Tabla de contenidos

Otros manuales de Recinto de StarTech.com

StarTech.com

StarTech.com S251BPU31C3 Manual de usuario

StarTech.com

StarTech.com SAT35401U Manual del sistema

StarTech.com

StarTech.com S3510SMU33 Manual del sistema

StarTech.com

StarTech.com SAT3540U3ER Manual de usuario

StarTech.com

StarTech.com RK2536BKF Manual de usuario

StarTech.com

StarTech.com RK1219WALL Manual de usuario

StarTech.com

StarTech.com SMS1BMU313 Manual de usuario

StarTech.com

StarTech.com S3540BU33E Manual de usuario

StarTech.com

StarTech.com SAT3510U2V Manual de usuario

StarTech.com

StarTech.com INFOSAFE IDE2510U2 Manual de usuario

StarTech.com

StarTech.com SAT3540U3ER Manual del sistema

StarTech.com

StarTech.com 2636CABINET Manual de usuario

StarTech.com

StarTech.com S352BU313R Manual de usuario

StarTech.com

StarTech.com DRW110ATA Manual

StarTech.com

StarTech.com SM2NGFFMBU33 Manual de usuario

StarTech.com

StarTech.com SAT3510U3VP Manual de usuario

StarTech.com

StarTech.com S2510BMU33 Manual del sistema

StarTech.com

StarTech.com RK2537BKM Manual de usuario

StarTech.com

StarTech.com S251BRU31C3 Manual de usuario

StarTech.com

StarTech.com S351BU313 Manual de usuario

StarTech.com

StarTech.com INFOSAFE IDE2510U2 Manual de usuario

StarTech.com

StarTech.com USB2SLSATINT Manual de usuario

StarTech.com

StarTech.com SAT2510U2E Manual de usuario

StarTech.com

StarTech.com InfoSafe IDECASE25OTG Manual de usuario

Manuales populares de Recinto de otras marcas

SilentiumPC

SilentiumPC Armis AR5 Manual

Pulsar

Pulsar 17/TRP80/DSPR Manual de usuario

Thermaltake

Thermaltake V150 TG Manual de usuario

MSI

MSI MPG SEKIRA 500X Manual de usuario

Antec

Antec Dark fleet DF-10 Manual de usuario

Nexans

Nexans WTC05 Manual de usuario

Peavey

Peavey DS 1502 Manual de usuario

D-Link

D-Link ShareCenter Pro DNS-1550-04 Manual de usuario

Rosewill

Rosewill RX82-U(JBOD) Manual de usuario

QNAP

QNAP SAS JBOD CLI 1.0 Manual de usuario

GAMDIAS

GAMDIAS Talos P1 Manual de usuario

Auvs

Auvs KR615 Manual de usuario

Digitus

Digitus DA-71114 Manual de usuario

CommScope

CommScope FDH 3000 Manual de usuario

FS FHD-FWME4 Manual de usuario

JBL

JBL CS1215T Manual de usuario

Pulsar

Pulsar ARAD-S4 Manual de usuario

Pulsar

Pulsar AWO454 Manual de usuario