StarTech.com SATDOCKU3SEF Manual de usuario
Manual Revision: 03/28/2011
For the most up-to-date information, please visit: www.startech.com
DE: Bedienungsanleitung - de.startech.com
FR: Guide de l'utilisateur - fr.startech.com
ES: Guía del usuario - es.startech.com
IT: Guida per l'uso - it.startech.com
NL: Gebruiksaanwijzing - nl.startech.com
PT: Guia do usuário - pt.startech.com
SATDOCKU3SEF / SATDOCKU3FGB / SATDOCKU3FEU
USB 3.0 eSATA to SATA Hard Drive Docking Station
with Fan
*actual product may vary from photo
Instruction Manual
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Use of Trademarks, Registered Trademarks, and other Protected Names and
Symbols
This manual may make reference to trademarks, registered trademarks, and other
protected names and/or symbols of third-party companies not related in any way to
StarTech.com. Where they occur these references are for illustrative purposes only and do not
represent an endorsement of a product or service by StarTech.com, or an endorsement of the
product(s) to which this manual applies by the third-party company in question. Regardless
of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby
acknowledges that all trademarks, registered trademarks, service marks, and other protected
names and/or symbols contained in this manual and related documents are the property of
their respective holders.
Instruction Manual i
Table of Contents
Introduction ............................................................................................1
Packaging Contents ................................................................................................................................. 1
System Requirements .............................................................................................................................. 1
Front View .................................................................................................................................................... 2
Rear View ...................................................................................................................................................... 2
Installation ..............................................................................................3
Hardware Installation .............................................................................................................................. 3
Driver Installation ...................................................................................................................................... 3
Using the Storage Device ......................................................................4
Specications ..........................................................................................6
Technical Support ..................................................................................7
Warranty Information ............................................................................7
Instruction Manual 1
Introduction
The SATDOCKU3SEF eSATA/USB 3.0 to SATA Hard Drive Docking Station with Fan
delivers quick and easy access to a 2.5in or 3.5in SATA hard disk drive (HDD) or solid
state drive (SSD) through either eSATA or USB connectivity, making it compatible
with almost any system. A built-in 80mm cooling fan provides increased reliability
and lifespan to HDDs, while also making them easier to handle when it comes time
to remove them from the dock. The variable fan speed control allows for on-the-y
adjustments for any type of HDD or to balance cooling with noise. eSATA provides
data transfer rates up to 3 Gbps, while USB 3.0 provides up to 5 Gbps while still being
backwards compatible with USB 2.0 systems at 480 Mbps. Extending the versatility
with the SATA to IDE hard drive adapter (SAT2IDEADP) allows for 2.5in or 3.5in IDE HDD
to be used in a SATA dock.
Packaging Contents
• 1x SATA Hard Drive Dock
• 1x USB 3.0 Cable
• 1x eSATA Cable
• 1x Power Adapter
• 1x Instruction Manual
System Requirements
• USB enabled computer system with available USB port
or
SATA enabled computer system with available eSATA port
• Available AC electrical outlet
• Microsoft® Windows® 2000/XP/Server 2003/Vista/Server 2008 R2/7 (32/64-bit), or
Apple® Mac OS® X, or Linux®
Instruction Manual 2
Front View
Rear View
Instruction Manual 3
Installation
WARNING! Hard drives and storage enclosures require careful handling, especially
when being transported. If you are not careful with your hard disk, lost data may
result. Always handle your hard drive and storage device with caution. Be sure that
you are properly grounded by wearing an anti-static strap when handling computer
components or discharge yourself of any static electricity build-up by touching a large
grounded metal surface (such as the computer case) for several seconds.
Hardware Installation
1. Connect the external power adapter from the hard drive dock to a power outlet.
2. Insert a 2.5” or 3.5” hard drive into the top loading slot. Make sure that the
connectors on the hard drive are facing the same corner of the slot that has a cutout
in the door. The label on the hard drive should face the front of the hard drive dock.
3. Connect the included USB 3.0 cable from the hard drive dock to an available USB 3.0
or 2.0 port on the computer system. The computer can be on or o.
NOTE: A USB 2.0 A-B cable could be used as a substitute on the hard drive dock but
will be restricted to USB 2.0 speeds.
or
Connect the included eSATA cable from the hard drive dock to an available eSATA
port on the computer system. The computer can be on or o.
NOTE: It is not recommended that both USB and eSATA be connected at the same
time, however eSATA will be the default connection if both are connected.
4. Press the power button on the top of the hard drive dock. The Power LED under the
power button should light up.
5. Adjust the fan speed control dial on the side of the docking station, to the desired
speed or turn it o completely.
6. To remove the hard drive, make sure it is currently not being accessed by the
computer then unmount or uninstall the disk drive from the operating system (see
documentation for your operating system). Press the power button to turn o
the hard drive dock and wait for the drive to power down. Press the drive ejection
button on the top of the hard drive dock to release the drive. Then pull the drive
from the slot.
Driver Installation
No driver installation is required for the supported operating systems, as the hard drive
docking station is natively supported, so the drivers are already installed.
Instruction Manual 4
Using the Storage Device
Windows 2000/XP/Vista/7
If you are using a brand new hard drive that does not contain any data, then you will
rst need to prepare the hard drive for use. From the main desktop, right-click on
“My Computer” (“Computer” in Vista/7), then select Manage. In the new Computer
Management window, select Disk Management from the left window panel.
Locate the Disk that says it is “Unallocated” (check hard drive capacity to conrm it’s the
correct hard drive) and then right-click in the section that says “Unallocated” and select
“New Partition”.
Instruction Manual 5
The New Partition Wizard will appear. Follow the instructions in the wizard to
complete setting up the drive. Once complete, the Disk should show up as “Healthy”
with a drive letter assigned (i.e. E:). This drive letter should now appear within My
Computer.
If you are installing a hard drive that already has data on it, then after plugging it in, the
drive should automatically show up with a drive letter assigned within My Computer.
Instruction Manual 6
Specications
Host Interface SuperSpeed USB 3.0
SATA revsion 2.x
Chipset ID JMicron JMS551
Connectors
1 x USB 3.0 type B female
1 x eSATA female
1 x DC Power
LEDs 1 x Power/Activity
1 x Power
Fans 1 x 80mm
Maximum Data Transfer Rate USB 3.0: 5 Gbps
eSATA: 3 Gbps
Compatible Hard Drives 2.5in/3.5in SATA hard drives or solid
state drives
Power Adapter 12VDC, 2000mA, center positive,
type M plug
Operating Temperature 5°C ~ 80°C (41°F ~ 176°F)
Storage Temperature -40°C ~ 70°C (-40°F ~ 158°F)
Humidity 8 ~ 90% RH
Dimensions 130.0mm x 92.0mm x 127.0mm
Weight 505g
Compatible Operating Systems
Windows 2000/XP/Server 2003/Vista/
Server 2008 R2/7 (32/64-bit), Mac OS X,
Linux
Instruction Manual 7
Technical Support
StarTech.com’s lifetime technical support is an integral part of our commitment to
provide industry-leading solutions. If you ever need help with your product, visit
www.startech.com/support and access our comprehensive selection of online tools,
documentation, and downloads.
Warranty Information
This product is backed by a one year warranty.
In addition, StarTech.com warrants its products against defects in materials
and workmanship for the periods noted, following the initial date of purchase.
During this period, the products may be returned for repair, or replacement with
equivalent products at our discretion. The warranty covers parts and labor costs only.
StarTech.com does not warrant its products from defects or damages arising from
misuse, abuse, alteration, or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their
ocers, directors, employees or agents) for any damages (whether direct or indirect,
special, punitive, incidental, consequential, or otherwise), loss of prots, loss of business,
or any pecuniary loss, arising out of or related to the use of the product exceed the
actual price paid for the product. Some states do not allow the exclusion or limitation
of incidental or consequential damages. If such laws apply, the limitations or exclusions
contained in this statement may not apply to you.
Este manual sirve para los siguientes modelos
2
Tabla de contenidos
Otros manuales de Estación de acoplamiento de StarTech.com
StarTech.com
StarTech.com SATDOCK4U2E Manual de usuario
StarTech.com
StarTech.com SDOCKU33EF Manual de usuario
StarTech.com
StarTech.com SDOCKU33EBV Manual de usuario
StarTech.com
StarTech.com SATADOCK525 Manual del sistema
StarTech.com
StarTech.com 8STUSB3DDOCKFT Manual de usuario
StarTech.com
StarTech.com SATADOCK22UE Manual de usuario
StarTech.com
StarTech.com DKWG30DPHPD Manual de usuario
StarTech.com
StarTech.com TBDOCKHDPBC Manual de usuario
StarTech.com
StarTech.com UNIDUPDOCK Manual de usuario
StarTech.com
StarTech.com USBVGADOCK2 Manual de usuario
StarTech.com
StarTech.com Thunderbolt 3 TB3DKM2DPL Manual de usuario
StarTech.com
StarTech.com USBDOCK2 Manual de usuario
StarTech.com
StarTech.com SATDOCK22RE Manual de usuario
StarTech.com
StarTech.com USB3DOCKH2DP Manual de usuario
StarTech.com
StarTech.com DK30BACDD Manual de usuario
StarTech.com
StarTech.com DK30CHDDPPD Manual de usuario
StarTech.com
StarTech.com USB3SMDOCKV Manual de usuario
StarTech.com
StarTech.com SATDOCKCRH Manual de usuario
StarTech.com
StarTech.com 116E-USBC-DOCK Manual de usuario
StarTech.com
StarTech.com USB3SDOCKHD Manual del sistema
