Siemens MPS-6 Manual de usuario

Installation Instructions

Model MPS-6

Power Supply Module

P/N 315-090334-8

OPERATION

The Model MPS-6 from Siemens Industry, Inc. is a

fully supervised power supply that provides the MXL

System with primary 24 VDC power. It is rated at 6.5

amps and is unfiltered and unregulated. The MPS-6

supplies the MXL Control Panel or PSR-1 and its

expansion modules with the power required for

normal operation. The module incorporates a 2 amp

resettable circuitbreaker on the primary input and

includes a built-in AC line filter for surge and noise

suppression. The MPS-6 mounts in an MXL enclo-

sure backbox.

INSTALLATION

Always remove power before installation.

The installation kit for the MPS-6 includes the

following:

Four #10 nuts

Two #10 lockwashers

Two #10 flat washers

Two ¼" nuts

One 14 gauge green ground strap

The MPS-6 is designed to operate from a 120 VAC,

60 Hz power source. Use a separate or dedicated

circuitbreaker. Wire in accordance with local codes

and Article 760 of the NEC, NFPA 70, latest edition.

Run the earth ground from a suitable source to the

MPS-6. Check local requirements. Conduit is not

an acceptable conductor.

1. Make sure that the dedicated circuitbreaker

for the MPS-6 is turned off at the mains.

2. Place the mounting bracket for the MPS-6 over

the two studs provided in the enclosure. (Refer to

Figure 1.)

3. Secure the MPS-6 to the enclosure by slipping the

flat washers, then the lockwashers, and finally the

nuts over the two studs. Tighten them securely.

4. Connect the AC mains to the MPS-6:

Terminal

Black (hot) 1

White (neutral) 2

Green (earth ground) 3

5. Install the 14 gauge green ground strap spade lug

side to Terminal 3 (green, earth ground) of the

MPS-6. Secure the ring lug side of the ground

strap to the nearest available stud in the enclo-

sure. The stud size may vary depending on the

actual system modules and enclosure used.

Because the stud may be either a #10 thread or

¼" thread, nuts for both have been provided. The

ground strap provided is long enough for all

applications and the ring lug is good for both #10

and ¼" studs. If possible, install the ring lug under

one of the lock-washers and nuts which secure

the MPS-6 itself.

6. When used with a PSR-1:

Connect the 3-wire cable coming from the MPS-6

to the PSR at P12.

When used with an MMB-1/-2/-3 or SMB-1/2:

Connect the 3-wire cable coming from the MPS-6

to the MMB-1/-2/-3 or the SMB-1/2 at P1.

Siemens Industry, Inc.

Building Technologies Division

Florham Park, NJ

Siemens Building Technologies, Ltd.

Fire Safety & Security Products

2 Kenview Boulevard

Brampton, Ontario

L6T 5E4 Canada

P/N 315-090334-8

Figure 2

Front of MPS-6

Figure 1

MPS-6 in MXL Enclosure

POWER CABLE TO:

MMB-1/-2/-3, P1

SMB-1/-2, P1

PSR-1, P12

Otros manuales de Unidad de control de Siemens

Siemens

Siemens FN2013-U1 Manual de usuario

Siemens

Siemens SITRANS F M MAGFLO series Manual de usuario

Siemens

Siemens DMS8000 MP4 Series Instrucciones de funcionamiento y mantenimiento

Siemens

Siemens 7153 Manual de usuario

Siemens

Siemens SINAMICS G120P Instrucciones de montaje

Siemens

Siemens CM 1542-5 Manual de usuario

Siemens

Siemens SPCW110 Manual de usuario

Siemens

Siemens Simatic S7-400 Manual de usuario

Siemens

Siemens SINUMERIK 808D Manual de lista de piezas

Siemens

Siemens LMO14 Series Manual de usuario

Siemens

Siemens Add 7 AddFEM Manual de usuario

Siemens

Siemens SIRIUS PROFINET Manual de usuario

Siemens

Siemens SCALANCE W788C-2 Manual de usuario

Siemens

Siemens Flowrite 599 Series Manual del propietario

Siemens

Siemens SR-35 Manual de usuario

Siemens

Siemens ST950 Manual de usuario

Siemens

Siemens SINUMERIK 808D Manual de usuario

Siemens

Siemens SITRANS PCS 7 Manual de lista de piezas

Siemens

Siemens SIMATIC S7-300 FM 350-1 Manual de usuario

Siemens

Siemens SIMOTICS CONNECT 400 Manual de usuario

Siemens

Siemens SINUMERIK 840DE SL Guía de inicio rápido

Siemens

Siemens SIPROTEC PROFINET IO Manual de usuario

Siemens

Siemens SINUMERIK 840Di sl Guía de inicio rápido

Siemens

Siemens Simatic S5 IP 240 Documento técnico

Manuales populares de Unidad de control de otras marcas

Festo

Festo Compact Performance CP-FB6-E Manual de lista de piezas

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manual de usuario

JS Automation

JS Automation MPC3034A Manual de usuario

JAUDT

JAUDT SW GII 6406 Series Guía rápida

Spektrum

Spektrum Air Module System Manual de usuario

BOC Edwards

BOC Edwards Q Series Manual de usuario

KHADAS

KHADAS BT Magic Manual de usuario

Etherma

Etherma eNEXHO-IL Manual de usuario

PMFoundations

PMFoundations Attenuverter Manual de usuario

GEA

GEA VARIVENT Manual de usuario

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manual de usuario

Altronix

Altronix LINQ8PD Instrucciones de montaje

Eaton

Eaton Powerware Series Manual de usuario

WAGO

WAGO 750-407/040-000 Manual de usuario

Sony

Sony CCU-590 Manual de usuario

Graco

Graco 25D614 Manual de usuario

Task Force Tips

Task Force Tips YE-RF-900 Manual de programación

Shini

Shini SPV-U Series Manual de usuario