Power Fist 8880940 Manual de usuario

V1.0 8880940

Please read and understand all instructions before use. Retain this manual for

future reference.

8880940 Hand Crank Air Hose Reel V1.0

2 For technical questions call 1-800-665-8685

SPECIFICATIONS

Type Hand Crank Air Hose Reel

Hose Capacity 100 ft x 3/8 in.(30.48 m x 9.52 mm) or

50 ft x 1/2 in. (15.24 m x 12.70 mm)

Max. Working Pressure 120 PSI

Mount Type Wall, Ceiling or Floor Mount

HAZARD DEFINITIONS

Please familiarize yourself with the hazard notices found in this manual. A

notice is an alert that there is a possibility of property damage, injury or death

if certain instructions are not followed.

DANGER! This notice indicates an immediate and specific hazard that will

result in severe personal injury or death if the proper

precautions are not taken.

WARNING! This notice indicates a specific hazard or unsafe practice that

could result in severe personal injury or death if the proper

precautions are not taken.

CAUTION! This notice indicates a potentially hazardous situation that may

result in minor or moderate injury if proper practices are not taken.

NOTICE! This notice indicates that a specific hazard or unsafe practice will

result in equipment or property damage, but not personal injury.

V1.0 Hand Crank Air Hose Reel 8880940

Visit www.princessauto.com for more information 3

INTRODUCTION

The Hand Crank Air Hose Reel provides convenient storage and protection for

your air hose. Air hose and mounting hardware are sold separately.

SAFETY

WARNING! Read and understand all instructions before using this tool. The

operator must follow basic precautions to reduce the risk of personal injury

and/or damage to the equipment.

Keep this manual for safety warnings, precautions, operating or inspection and

maintenance instructions.

WORK AREA

1. Operate in a safe work environment. Keep your work area clean, well-lit

and free of distractions.

2. Keep anyone not wearing the appropriate safety equipment away from the

work area.

3. Store unused tools properly in a safe and dry location to prevent rust or

damage. Lock tools away and keep out of the reach of children.

PERSONAL SAFETY

WARNING! Wear personal protective equipment approved by the Canadian

Standards Association (CSA) or American National Standards Institute (ANSI).

PERSONAL PROTECTIVE EQUIPMENT

1. Always wear impact safety goggles that provide front and side protection

for the eyes. Eye protection equipment should comply with CSA Z94.3-07

or ANSI Z87.1 standards based on the type of work performed.

2. Wear gloves that provide protection based on the work materials or to

reduce the effects of tool vibration.

3. Wear protective clothing designed for the work environment and tool.

4. Non-skid footwear is recommended to maintain footing and balance in the

work environment.

PERSONAL PRECAUTIONS

Control the tool, personal movement and the work environment to avoid

personal injury or damage to tool.

1. Do not operate any tool when tired or under the influence of drugs,

alcohol or medications.

8880940 Hand Crank Air Hose Reel V1.0

4 For technical questions call 1-800-665-8685

2. Avoid wearing clothes or jewelry that can become entangled with the

moving parts of a tool. Keep long hair covered or bound.

3. Do not overreach when operating a tool. Proper footing and balance

enables better control in unexpected situations.

SPECIFIC SAFETY PRECAUTIONS

WARNING! DO NOT let comfort or familiarity with product (gained from

repeated use) replace strict adherence to the tool safety rules. If you use this

tool unsafely or incorrectly, you can suffer serious personal injury.

1. Use the correct tool for the job. This tool was designed for a specific function.

Do not modify or alter this tool or use it for an unintended purpose.

2. Do not use the tool if any parts are damage broken or misplaced. Repair or

replace the parts.

3. Ensure that the reel is properly installed before connecting the input and

output air hoses.

4. Before connecting reel to supply line ensure that pressure does not exceed

maximum working pressure rating of the reel.

5. Remove system pressure immediately if a leak occurs in the hose or reel,

or if the reel ceases to wind and unwind.

6. Do not abruptly jerk on the hose as this can damage the hose or locking

mechanism.

UNPACKING

WARNING! Do not operate the tool if any part is missing. Replace the missing

part before operating. Failure to do so could result in a malfunction and

personal injury.

Remove the parts and accessories from the packaging and inspect for damage.

Make sure that all items in the parts list are included.

Contents: • Air Hose Reel • Handle components (#1, 2, 3 and 4).

ASSEMBLY & INSTALLATION

Numbered references in parenthesis (#1) refer to the included Parts List.

The air hose reel is mostly preassembled. Mounting hardware is sold

separately. A 3/8 to 1/2 in. adaptor is required to connect a 1/2 in air hose to the

swivel valve.

1. Insert the handle (#3) into the handle sleeve (#4). Place the rubber sleeve (#2)

onto the end of the handle sleeve. Secure the rubber sleeve with a screw (#1).

V1.0 Hand Crank Air Hose Reel 8880940

Visit www.princessauto.com for more information 5

2. Insert the handle into the link lever opening (#5). Secure the handle with

the washer (#6) and nut (#7). Tighten the nut. Rotate the handle a few

times to ensure it is functioning correctly.

3. Mount the base (#9) on a structure capable of withstanding the weight of

the hose reel and air hose. Use the base as a template for marking the

screw locations.

4. Mount the air hose reel using 4 washers and 4 screws suitable for the

structural material.

5. Connect the swivel valve (#18) to the compressor’s air hose.

a. Wrap the external threads of the air hose. Wrap tape in a clockwise

direction so it will not unravel.

b. Do not tape all the threads. Leave several leading threads unwrapped

for easier alignment.

c. Screw the air supply hose into the swivel valve (#18) and tighten with

a wrench until snug. Use a second wrench on the swivel valve to hold

it still to prevent damage from twisting.

6. Wrap the air hose threads with sealant tape, as in step 5 a and b. Screw

the hose into the outlet valve (#15).

7. Wrap the air hose over the reel (#14) end and guide it on by hand as you

rotate the handle. Do not allow the air hose to cross-wrap.

CARE & MAINTENANCE

CAUTION! Bleed air pressure from the hose system before servicing the reel.

1. Maintain the tool with care. A tool in good condition is efficient, easier to

control and will have fewer problems.

2. Inspect the tool fittings, alignment, hoses and power supply cord

periodically. Have damaged or worn components repaired or replaced by an

authorized technician. Only use identical replacement parts when servicing.

3. Only use accessories intended for use with this tool.

4. Keep the tool handles clean, dry and free from oil/grease at all times.

5. Maintain the tool’s labels and name plates. These carry important information.

If unreadable or missing, contact Princess Auto Ltd. for replacements.

WARNING! Only qualified service personnel should repair the tool. An

improperly repaired tool may present a hazard to the user and/or others.

CLEANING

Wipe the surface with a clean, moist cloth.

8880940 Hand Crank Air Hose Reel V1.0

6 For technical questions call 1-800-665-8685

PARTS BREAKDOWN

V1.0 Hand Crank Air Hose Reel 8880940

Visit www.princessauto.com for more information 7

PARTS LIST

# DESCRIPTION QTY

1 Screw 1

2 Rubber Sleeve 1

3 Handle 1

4 Handle Sleeve 1

5 Link lever 1

6 Washer 1

7 Nut 1

8 Washer 1

9 Base 1

10 Washer 1

11 Spring 1

12 Washer 1

13 Axle 1

14 Reel 1

15 Outlet Valve 1

16 Washer 1

17 Spring Washer 1

18 Swivel Valve (includes 2

Valves, 2 O-rings)

19 Spring Washer 1

8880940 Hand Crank Air Hose Reel V1.0

8 For technical questions call 1-800-665-8685

V 1,0 8880940

Vous devez lire et comprendre toutes les instructions avant d'utiliser l'appareil.

Conservez ce manuel afin de pouvoir le consulter plus tard.

8880940 Enrouleur pour tuyau à air à manivelle V 1,0

2 En cas de questions techniques, appelez le 1-800-665-8685

SPÉCIFICATIONS

Type Enrouleur pour tuyau à air à manivelle

Capacité du tuyau 30,48 m x 9,52 mm (100 pi x 3/8 po) ou

15,24 m x 12,70 mm (50 pi x 1/2 po)

Pression max. de fonctionnement 120 lb/po carré

Type de montage Installation sur le mur, le plafond ou le

plancher

DÉFINITIONS DE DANGER

Veuillez-vous familiariser avec les avis de danger qui sont présentés dans ce

manuel. Un avis est une alerte indiquant quil existe un risque de dommage à la

propriété, de blessure ou de décès si on ne respecte pas certaines instructions.

DANGER ! Cet avis indique un risque immédiat et particulier qui

entraînera des blessures corporelles graves ou même la

mort si on omet de prendre les précautions nécessaires.

AVERTISSEMENT ! Cet avis indique un risque particulier ou une pratique non

sécuritaire qui pourrait entraîner des blessures

corporelles graves ou même la mort si on omet de

prendre les précautions nécessaires.

ATTENTION ! Cet avis indique une situation possiblement dangereuse

qui peut entraîner des blessures mineures ou modérées si

on ne procède pas de la façon recommandée.

AVIS ! Cet avis indique un risque particulier ou une pratique non

sécuritaire qui entraînera des dommages au niveau de

léquipement ou des biens, mais non des blessures corporelles.

Tabla de contenidos

Idiomas:

Otros manuales de Herramientas de Power Fist

Power Fist

Power Fist 8655888 Manual de usuario

Power Fist

Power Fist Metal Punch Kit Manual de usuario

Power Fist

Power Fist 8843583 Manual de usuario

Power Fist

Power Fist 8623159 Manual de usuario

Power Fist

Power Fist 8685042 Manual de usuario

Power Fist

Power Fist 8549024 Manual de usuario

Power Fist

Power Fist 8665549 Manual de usuario

Power Fist

Power Fist 1/2 in. Air Ratchet and Socket Set Manual de usuario

Power Fist

Power Fist 8662330 Manual de usuario

Power Fist

Power Fist 8873358 Manual de usuario

Power Fist

Power Fist 8843799 Manual de usuario

Power Fist

Power Fist 9166695 Manual de usuario

Power Fist

Power Fist 8957425 Manual de usuario

Power Fist

Power Fist 8063927 Manual de usuario

Power Fist

Power Fist 8916793 Manual de usuario

Power Fist

Power Fist 8663783 Manual de usuario

Power Fist

Power Fist 9081415 Manual de usuario

Power Fist

Power Fist 9011438 Manual de usuario

Power Fist

Power Fist 8887408 Manual de usuario

Power Fist

Power Fist 8089591 Manual de usuario

Power Fist

Power Fist 8843773 Manual de usuario

Power Fist

Power Fist 8668402 Manual de usuario

Power Fist

Power Fist 8517393 Manual de usuario

Power Fist

Power Fist 8074668 Manual de usuario

Manuales populares de Herramientas de otras marcas

Martor

Martor SECUNORM 175 Manual de usuario

ERKCO

ERKCO 1000 Manual de usuario

jbc

jbc N4473 Manual de usuario

FEINMETALL

FEINMETALL FZWZ-SET-001 Manual de usuario

Worx Professional

Worx Professional Sonicrafter WU676 Manual de usuario

Gage Bilt

Gage Bilt GB713SH Manual de usuario

Hilti

Hilti DX 9-ENP Manual de usuario

norbar

norbar NORTRONIC 34399 Manual de usuario

BGS technic

BGS technic 8578 Manual de usuario

Makita

Makita DHR241 Manual de usuario

Motor Guard

Motor Guard JMB-1250 Manual de usuario

Power Adhesives

Power Adhesives 805-12 Manual de usuario

Clemco

Clemco 24189 Manual de usuario

VVG

VVG VNG 903 Series Manual de usuario

Hilti

Hilti FX 3-A Manual de usuario

Grizzly

Grizzly H6472 Manual de usuario

axing

axing BWZ 5-02 Manual de usuario

Dh-Robotics

Dh-Robotics RGI-100 Cómo utilizar