Planet FNSW-3200 Manual de usuario

Trademarks

Contentssubject to revision without prior notice.

PLANETisaregistered trademark ofPLANET Technology

Corp. All other trademarks belong to theirrespective owners.

Disclaimer

PLANETTechnologydoes not warrant that the hardwarewill

work properlyin all environmentsand applications,and

makesno warrantyand representation, either implied or ex-

pressed, with respectto the quality,performance,

merchantability, or fitness for a particular purpose.

PLANEThasmade everyeffort to ensurethat this Users

Manual is accurate; PLANET disclaimsliabilityfor anyinac-

curacies or omissionsthat mayhave occurred.

Information in thisUser sManual issubject to change without

notice and doesnot represent acommitment on the part of

PLANET.PLANET assumes no responsibilityforanyinac-

curacies that maybe contained in this UsersManual.

PLANETmakes no commitment to update or keep current

the information in this UsersManual, and reservesthe right to

makeimprovements to this User sManual and/or to the

productsdescribed in this UsersManual, at anytime without

notice.

Ifyou find information in this manual that is incorrect, mis-

leading, or incomplete, wewouldappreciate yourcomments

and suggestions.

- 3 -

FCCWarning

This equipment has been tested and found to comply with the

limits foraClassAdigital device, pursuant to Part 15 of the

FCC Rules. These limits aredesigned to provide reasonable

protection against harmfulinterference when the equipment

is operated in acommercial environment. This equipment

generates,uses, and can radiate radio frequency energyand,

if not installed and used in accordance with the Instruction

manual, maycause harmful interference to radiocommuni-

cations.Operation ofthis equipment in aresidential area is

likely to causeharmful interference in which case the userwill

be required to correct the interference at his own expense.

CEMark Warning

This isaClassAproduct. In adomestic environment, this

product maycause radio interference, in which case the user

maybe required to take adequate measures.

Revision

PLANETFast EthernetSwitch User's Manual

FOR MODEL: FNSW-3200

Part No.: EM-FNSW32V1

- 4 -

TABLE OF CONTENTS

1. UNPACKING INFORMATION.............................................1

2. PRODUCT INTRODUCTION...............................................3

2.1 KEY FEATURES.................................................................3

2.2 FRONT PANEL...................................................................3

2.2.1 Ports Speed.............................................................4

2.2.2 Cabling.....................................................................4

2.2.3 Auto-MDI/MDI-X.......................................................4

2.2.4 StatusLEDs.............................................................5

2.3 THE REAR PANEL.............................................................5

2.3.1 PowerConnector.....................................................5

3. INSTALLATION...................................................................7

3.1 RACK-MOUNT INSTALLATION.............................................7

3.2 DESKTOP INSTALLATION ...................................................7

4. OPTIMIZING CONFIGURATION.........................................9

4.1 PRIOR TO INSTALLATION ...................................................9

4.2 HALF- AND FULL-DUPLEX..................................................9

4.3 FAST ETHERNET.............................................................10

4.4 AUTO-NEGOTIATION .......................................................11

4.5 MAC ADDRESS TABLE....................................................11

4.6 SAMPLE APPLICATION.....................................................12

5. TROUBLESHOOTING.......................................................13

6. PRODUCT SPECIFICATIONS..........................................15

7. RJ-45 PIN ASSIGNMENT..................................................17

- 1 -

1. UNPACKING INFORMATION

Thankyou forpurchasing PLANETEthernet Switches.Before

continuing, pleasecheckthe contents ofthe productpack-

age. This product package should containthe following items:

One Ethernet Switch

One Power Cord

Two Rack-Mounting Bracketswith attachment screws

ThisUser s manual

Please inform yourlocal dealer/supplier immediatelyifany

itemis found to be defective, damaged or missing. Retain the

original packaging (carton), including the packing materials,

and usethemto re-pack the product in the unlikelyevent

there is a need to return it to usforrepairing.

- 2 -

Thispage intentionallyleft blank!

- 3 -

2. PRODUCTINTRODUCTION

FNSW-3200 Ethernet Switchis multi-speed, versatile network

devicescombining both standard and "Big-Pipe" portsunderthe

same hood.

2.1Key Features

w Compliant with IEEE802.3 and 802.3u standards for

100Base-TX

w 32-port Fast Ethernet Switch, pure 10/100Base-TX

w Wire-speed "Store-and-Forward" filtering/forwarding

eliminatesbad data packetswith minimal delay

w 100Base-TX portsautomatically senseand set optimal

line speed from10/20, 100/200Mbps,All 100Base-TX

port support Auto-Negotiation function

w Shared buffermemoryand up to 4K FastEthernet

Switch-entryMAC sourceaddresstable makefor fast

handling of data packets

w Auto-MDI/MDI-Xdetection supports

w Flowcontrol to eliminate packets loss

w Internal, full-range power supplysuitable forworldwide

use

2.2Front Panel

Figure 1: Front View of theFNSW-3200

PWR

FNSW-3200

LNK/

ACT

100M

LNK/

ACT

100M

10/100Mbps Ethernet Switch

123456789

171819202122232425

- 4 -

2.2.1 Ports Speed

n100Base-TX

All 100Base-TX ports comewith auto-negotiation capability.

Theyautomaticallysupport 100Base-TXand 10Base-T

networks.Usersonlyneed to plug aworking network device

into one of the 100Base-TX ports,then turn on the switch.

The portwill automaticallyrunsin 10Mbps, 20Mbps,

100Mbps or 200Mbps after the negotiation with the con-

nected device.

2.2.2 Cabling

100Base-TX ports use RJ-45 sockets--similar to phone

jacks--forconnection of unshielded twisted-paircable(UTP).

The IEEE 802.3u Fast Ethernet standard requires Category 5

UTPfor 100Mbps 100Base-TX.10Base-Tnetworks can use

Cat.3, 4, or 5 UTP (see table A)

Port Type CableType Connector

10Base-TCat 3, 4, 5RJ-45

100Base-TX Cat.5/5eUTP RJ-45

Table A:Supported port list

2.2.3 Auto-MDI/MDI-X

Each numbered port ofFNSW-3200 is MDI/MDI-Xport.

Which automaticallydetectsstraight-through/ crossoverca-

ble types. You can directusestraight cable for the connection

to your workstation orother end nodes. Either straight or

cross-over cable can be used to connect switch, hub orend

nodes without anyhassle.

- 5 -

2.2.4 Status LEDs

One POWER LED to showpower On/Offis on the front panel

and each port hastwo statusLEDindicators, asshown below.

LABEL

STATUS /

COLOR MEANING

DESCRIPTION

Steady

orange 100MLit toindicatethat avalid physical

UTP/STP connection exists on

that port runs in 100Mbps

UPPER

ROW

OFF 10M Remains off and Link ON toin-

dicate theport runs in10Mbps

Steady

Green LinkLit toindicatethat avalid physical

UTP/STP connection isdetected

LOWER

ROW Blink

Green Activity Blink to indicate theport is re-

ceiving data packets

Table B:TheSwitch's Port-LED Functions

2.3The Rear Panel

Figure 2:Rear View for FNSW-3200

2.3.1 Power Connector

The Power Connectorisdesigned to be use with the powercord

included in the product package. Attachthe female end of the

cordto the powerconnector and the male end ofthe cordto a

grounded power outlet. The accepted power range isfrom

100VAC to 240VAC, 50/60Hz.

50-60 Hz

100-240V AC

- 6 -

Note:

The Switchisapower-required device, itmeans,the

Switchwill not work until it is powered. If your networked

PCs willneed to transmit data all the time, please con-

sideruse an UPS (Uninterrupted Power Supply) for your

Switch. It will prevent you fromnetworkdata loss.

In some area, installing asurge suppression devicemay

also help to protect yourSwitch from being damaged by

unregulated surge or current to the Switchorthe power

adapter.

- 7 -

3. INSTALLATION

The Switchdo NOTrequire software configuration. Users can

immediately useanyof the features of this product simplyby

attaching the cables and turning on the power.

Toget the best use oftheseSwitchmodels, manythings need

to be considered first. See Section 4. OPTIMIZING

CONFIGURATION fordetails.

3.1Rack-Mount Installation

Most userspreferto attachthe power cord to the hub before

installation inanetwork rack.Do not plug the other end of the

cord into a poweroutlet until after the hub is installed.

For mounting the Switch in anetworkrack,firstattach the

rack-mount bracketsto the side of the hub with screws.(Both

bracketsand screwsare included in the product package.) Slide

the hub into the rack and align the holes in the bracket with the

corresponding holesin the networkrack.Attach the bracket to

the rackwith the enclosed screws.

3.2Desktop Installation

Tolocate the Switchon adesktop, first attach the four rubber

feet to the bottomof the hub, one in each corner. Place the hub

on aclean, flat desk or tabletop close to apower outlet. Make

sure there is no hindrance behind the fan ofthe hub

Plug in all networkconnections, and then turn the switch on via

plug in the power cord.

Tabla de contenidos

Otros manuales de Enrutador de red de Planet

Planet

Planet ADE-4400 Manual de usuario

Planet

Planet GS-4210-24P2S Manual de usuario

Planet

Planet IGS-6325 DIN rail Series Manual de usuario

Planet

Planet ADE-3410 Manual de usuario

Planet

Planet GSW-1601 Manual de usuario

Planet

Planet ADE-3400 Manual de usuario

Planet

Planet XRT-401C Manual de usuario

Planet

Planet gsd-1002vhp Manual de usuario

Planet

Planet XRT-101A Manual de usuario

Planet

Planet FGSW-2402VS Manual de usuario

Planet

Planet 802.11g Wireless Access Point / Bridge... Manual de usuario

Planet

Planet SGSW-2620 Manual de usuario

Planet

Planet FGSD-1022VHP Manual de usuario

Planet

Planet VC-200S Manual de usuario

Planet

Planet PL-510W Manual de usuario

Planet

Planet ADSL VPN/Firewall Router ADW-4200 Manual de usuario

Planet

Planet WGR-500-4P Manual de usuario

Planet

Planet WNRT-625G Manual de usuario

Planet

Planet ERT-805 Manual de usuario

Planet

Planet FSD-805 Manual de usuario

Planet

Planet VC-23 Series Manual de usuario

Planet

Planet PL-501-EU Manual de usuario

Planet

Planet ADW-4401 A/B Manual de usuario

Planet

Planet GSW-2416 Manual de usuario

Manuales populares de Enrutador de red de otras marcas

Allnet

Allnet ALL0333AU Manual de usuario

HomeSeer

HomeSeer HT-SEL Manual de usuario

Sercomm

Sercomm Genesis OC3505D Manual de usuario

Billion

Billion BIPAC 5102 Series Manual de usuario

TP-Link

TP-Link TD-8817 Manual de usuario

Motorola

Motorola MR1900 Manual de usuario

Digi

Digi IX14 Manual de usuario

Cisco

Cisco NCS 540 Manual

XAVi

XAVi X8821e Manual de usuario

BEC

BEC 6200WZL Manual de usuario

MikroTik

MikroTik hAP ac3 Series Manual de usuario

Korenix

Korenix JetNet 5428G Series Manual de usuario

NETGEAR

NETGEAR FS526T - Switch Manual de usuario

Korenix

Korenix JetNet 5710G Series Manual de usuario

Automated Logic

Automated Logic ZN551 Manual del propietario

Cisco

Cisco ASR 1000 Series Manual del operador

EnGenius

EnGenius ESR-9710 Manual de usuario

Cisco

Cisco 805 Series Instrucciones de funcionamiento y seguridad