Perle MCR1900 Manual de usuario

MCR1900

Media Converter

19-Slot Chassis

Installation Guide

Part #5500304-10

This document must not be reproduced in any way whatsoever, either printed or electronically, without

the consent of:

Perle Systems Limited

60 Renfrew Drive

Markham, ON

Canada

L3R 0E1

Perle reserves the right to make changes without further notice, to any products to improve reliability,

function, or design.

Perle, the Perle logo, and MCR1900 are trademarks of Perle Systems Limited.

Perle Systems Limited, 2010.

FCC

This product has been found to comply with the limits for a Class A digital device, pursuant to Part 15 of

the FCC rules. These limits are designed to provide reasonable protection against harmful interference

when the equipment is operated in a commercial environment. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions in this

Guide, may cause harmful interference to radio communications. Operation of this equipment in a

residential area is likely to cause harmful interference, in which case the user will be required to correct

the interference at his/her own expense.

EN 55022, Class A,

WARNING: This is a Class A product. In a domestic environment this product may cause radio

interference in which case the user may be required to take adequate measures.

EN 55024, Class A,

Preface .................................................................................5

Chapter 1 Overview.............................................................7

Getting to Know the MCR1900.................................................... 7

Front and Rear Panel Components............................................ 7

Front View (with Media Converter Modules installed) .......................... 7

Rear View (with dual AC Power Supply Modules installed) ................. 8

Power Supply Module.................................................................. 8

Power Supply LED Status........................................................................ 9

Intelligent Alarm Relay ................................................................ 9

Media Converter Modules ......................................................... 10

Chapter 2 Installing the MCR1900 ...................................11

Site Preparation Requirements ................................................ 11

Grounding the MCR1900 Chassis ............................................ 12

Installing the Media Converter Modules .................................. 13

Connecting the Alarm Relays (optional).................................. 13

Powering On an AC Powered Chassis..................................... 14

Power Supply LED Status...................................................................... 14

Chapter 3 Media Converter Modules ...............................17

Installing or Replacing Media Converter Modules.................. 17

Removing Media Converter Modules ................................................... 17

Table of Contents

Installing or Replacing Media Converter Modules .............................. 17

Chapter 4 Power Supply Modules ...................................19

Installing or Replacing the Power Supply Module.................. 19

Removing the Power Supply Module ................................................... 19

Installing or Replacing the Power Supply Module .............................. 20

Appendix A Technical Specifications .............................22

Environmental Specifications................................................... 22

Physical Specifications ............................................................. 22

Power Specifications................................................................. 23

Appendix B Troubleshooting ...........................................24

Power Supply LED Status ......................................................... 24

Intelligent Alarm Relay .............................................................. 25

Preface

About This Guide

This guide provides the installation instructions for the Perle MCR1900

Media Converter Chassis.

This preface has the following sections.

zIntended Audience

zDocumentation

zWhere to find Web-based Guides

zWarranty/Registration

zContacting Perle

Intended Audience

This guide is for administrators who will be installing the MCR1900.

Documentation

The following documentation is included with the MCR1900.

zMCR1900 Media Converter 19-Slot Chassis Installation Guide

Where to find Web-based Guides

The installation and user guides (in PDF format) for all Perle products

can be found at http://www.perle.com/downloads

Warranty / Registration

Perle’s standard Lifetime Warranty provides customers with the return

to factory repairs for Perle products that fail under the conditions of the

warranty coverage. Details can be found at:

http://www.perle.com/support_services/warranty.shtml

Contacting Perle Systems

Technical support

Contact information for the Perle Technical Assistance Center

(PTAC) can be found at the link below. A Technical Support Query

may be made via this webpage.

http://www.perle.com/support_services_request.shtml

To chat live with a Technical Support Representative use the link

below.

http://www.perle.com/chattechsupp.shtml

Product Information

For more product details and information about Perle products use

the link below.

http://www.perle.com/products

Chat Live

To chat live with a Perle Sales Representative use the link below.

http://www.perle.com/chat.shtml

Address

Perle Systems Limited.

60 Renfrew Drive

Markham, Ontario

L3R 0E1

Toll Free North America

1-800-GO-PERLE (467-3753)

Phone 1-905-475-6070

Fax: 1-905-475-2377

Overview Chapter 1

Getting to Know the MCR1900

The MCR1900 is used to aggregate large numbers of geographically

separated Ethernet, Fast Ethernet and Gigabit Ethernet networks into a

central location, over fiber optic cables.

The MCR1900 Chassis features include:

zNineteen slots for Media Converter Modules.

zSupport for all Perle Media Converter Modules.

zMedia Converter Modules are individually secured and hot-

swappable for maximum connection reliability.

zDual hot-swappable power supplies with load sharing capabilities.

zPower Supply Module and Fan Status monitoring with builtin

Intelligent Alarm Relay technology.

Front and Rear Panel Components

Front View (with Media Converter Modules installed)

Vents

Captive retainer screw

Fiber ports

LEDs

Ethernet

Rear View

Power Connector

Power Switch

Grounding

Power LED

Fan

Second Power Supply

screw

Grounding

Intelligent

Captive retainer screws

Alarm Relay

(with dual AC Power Supply Modules installed)

Power Supply Module

The MCR9100 Chassis has two Bays for Power Supply Modules

located at the rear of the Chassis. Each Power Supply Module has a

cooling fan that draws air out of the Chassis through front air vents

on all face plates. The Perle MCR1900 Chassis also comes with an

Intelligent Alarm Relay feature that will monitor the Chassis, Fans

and Power Supply Modules for error conditions. The Chassis and the

Media Converter Modules power requirements can be met with one

Power Supply, however a second Power Supply can be added for

power redundancy and load- sharing. If the Chassis has two Power

Supply Modules, the modules will use a load-sharing arrangement in

which they both supply power to the Media Converter Modules and

Chassis. If either Power Supply Module should fail, the other Power

Supply Module will assume responsibility for powering the entire

Chassis, therefore preventing any interruption of service. The

backplane of the Chassis will continue to power both fans even if a

power supply is in a failed state or the power switch is in the Off

position. If either of the Power Supply Modules fail, both alarm

relays will be activated. Once the alarm has been set, the backplane

will continue to monitor the Power Supply Module to see if the

problem has been corrected and if so the alarms will be reset.

Power Supply LED Status

Description LED

Intelligent Alarm Relay

The Perle MCR1900 Chassis is fashioned with an Intelligent Alarm

Relay. This relay is engaged after the unit is powered up and the

backplane has been initialized. Should a failure occur, the relay will

be disengaged, therefore setting the alarm until the unit returns to a

normal state of operation.

A failure can be one of the following:

On (solid) Indicates that the power has been

switched On and the Power Supply

Module is supplying power to the

Chassis.

Off zThe Power Supply Module has been

switched Off.

zThe power plug has been removed.

zNo power at power source.

zThe Power Supply Module has failed.

Slow Blinking (Only applies to a Dual Power Supply

Chassis). The Power Supply Modules are

establishing load sharing parameters.

NOTE: This state will activate the alarm

relays.

Fast Blinking zThe Power Supply Module is not seated

in the Chassis correctly.

zA Power Supply Module has been

removed from the Chassis without

disconnecting the power cable from the

power connector and the power switch

is in the ON position.

zNOTE: This is an indication of a

potential hazard. The power switch

should be immediately turned off and

the power disconnected.

zLoss of power to the Power Supply Module(s).

zFan failure.

zOver temperature heat protection.

zOver voltage protection.

The relay is accessible via a set of three contact connections. These

contacts are known as "Normally Closed", “Common” and

"Normally Open", and are electrically isolated to the relay. The

contacts are rated for voltages up to 30 V DC/AC with a maximum

current of 3 A.

For terminals # 1 through 3, strip insulation from wire (7 mm - 8

mm) 9/32-5/16 using stranded wire size 18-12 AWG. Tighten screw

to a torque of 4.5 lb per inch (0.51 Nm).

Media Converter Modules

For information regarding Media Converter Installation, see the

appropriate Installation Guide for that product.

Terminal Description Usage

1 Normally

Closed

Use this with the Common terminal

to act as switch contacts that remain

closed when the unit is powered off

or in a failed state.

2 Common Use this terminal in conjunction with

the Normally Open or Normally

Closed terminals.

3 Normally

Open

Use this with the Common terminal

to act as switch contacts that remain

open when the unit is powered off or

in a failed state.

Otros manuales para MCR1900

Tabla de contenidos

Otros manuales de Convertidor de medios de Perle

Perle

Perle C-1110 Series Manual de usuario

Perle

Perle C-110-M2ST2 Manual de usuario

Perle

Perle S-10G-XTXH Manual de usuario

Perle

Perle C-1000MM-XXXXXX Manual de usuario

Perle

Perle S-1110HP Manual de usuario

Perle

Perle S-100-XXXXX Manual de usuario

Perle

Perle C-100-XXXXX Manual de usuario

Perle

Perle SMI Media Converter Manual de usuario

Perle

Perle S-1110-XT 10 Manual de usuario

Perle

Perle S-1110-XT Manual de usuario

Perle

Perle S-10GR-STS Manual de usuario

Perle

Perle C-10GT-SFP Manual de usuario

Perle

Perle S-10GRT-SFP Manual de usuario

Perle

Perle SMI Media Converter Manual de usuario

Perle

Perle S-1110P Manual de usuario

Perle

Perle C-1000MM Series Manual de usuario

Perle

Perle SMI-10GT Manual de usuario

Perle

Perle S-1000-SFP Manual de usuario

Perle

Perle S-110-P Manual de usuario

Perle

Perle CM-10G-STS Manual de usuario

Perle

Perle MCR1900 Manual de usuario

Perle

Perle C-110-XXXXX Manual de usuario

Perle

Perle S-1110P Manual de usuario

Perle

Perle S-10GT-SFP Manual de usuario

Manuales populares de Convertidor de medios de otras marcas

SoundTraxx

SoundTraxx Blunami BLU-2200 Manual de usuario

SPROLINK

SPROLINK VA1 Manual de usuario

Acclaim Lighting

Acclaim Lighting DDC-1-AC Manual de usuario

Nikon

Nikon AF-S TC-20E III Manual de usuario

Axis

Axis AXIS Q7406 Manual de usuario

Omega

Omega TAC80B-J Manual de usuario

Zoom

Zoom Thunderbolt TAC-2R Manual de usuario

OST

OST iConverter 10/100M Manual de usuario

Vertiv

Vertiv Netsure Manual de usuario

birddog

birddog MINI Manual de usuario

Roland

Roland GI-10 Manual de usuario

Wallenstein

Wallenstein WX310 Manual de usuario

Pace

Pace MSS 200-1 Manual de usuario

Solar Converters

Solar Converters EQ 12/24-50 Manual de usuario

CYP

CYP EL-7400V Manual de usuario

TIE

TIE MIDI 1i1o Manual de usuario

DCS

DCS Vivaldi Upsampler Manual de usuario

Westermo

Westermo MCW-211 SERIES Manual de usuario