Oki MPS3537mc Series Manual de usuario

1 / 9

GN-1060 with GN-3010

for MC760/MC770/MC780/ES7460/ES7470/ES7480/MPS3537/MPS4242

SET-UP GUIDE

Warnings Points

• Theunpackingandsetupprocedureshallbedonebyaqualiedservicetechnician.

• Besuretounplugthepowercableoftheequipmentbeforeinstallingandsettinguptheproduct.

• Disconnectthegroundwireafterunpluggingthepowercable.Inaddition,besuretoconnectthegroundwire

beforepluggingthepowercable.

Cautionary Points

• Installtheequipmentnearanoutlet.Besuretowirethepowercablesecurelysoastounplugiteasilyandnot

totripoverit.

• Accordingtotheequipmentmodel,theseillustrationsmaydiffer.

• Thecoversofthisequipmenthavebeendesignedsoasnottobeeasilyremoved.Therefore,whenusing

tools,besurenottoputyourfaceandhandsinthedirectioninwhichforcewillbeapplied;otherwisethiscould

resultininjury.Inaddition,payattentionnottodeformpartsbyusingtoomuchforce.

• Whenunpackingandsettinguptheproduct,besuretowearglovestoavoidinjury.

 Accessories

GN-1060

GN-3010

J H

2 / 9

GN-1060 with GN-3010

 Setup

1. Take out the accessories.

2. Take off the cover.

*Youmustwearglovesforthisprocedure.

1) Remove[b]and[e].

 •b:1

 •e:1

2) Open[F].

3) Pushthelockingbuttontoopen[G].

4) Remove[b].

5) Remove[e].

3 / 9

GN-1060 with GN-3010

6) Openthecoversintheorderof(A)and(B).

7) Close[G].

8) Releasethelatches(A)ofthecover.

 •A:2

* Asshowninthegure,insertaathead

screwdriverintothegrooveandpushitin

thedirectionofthearrowtoreleasethe

latches.

When using tools, be sure not to put your

face and hands in the direction in which

force will be applied; otherwise this could

result in injury.

9) Releasethelatches(B)ofthecover.

 •B:2

* Asshowninthegure,insertaathead

screwdriverintothegrooveandpushitin

thedirectionofthearrowtoreleasethe

latches.

When using tools, be sure not to put your

face and hands in the direction in which

force will be applied; otherwise this could

result in injury.

4 / 9

GN-1060 with GN-3010

10)Releasethelatch(D)ofthecover.

 •D:1

* Asshowninthegure,insertaathead

screwdriverintothegrooveandpushitin

thedirectionofthearrowtoreleasethe

latches.

When using tools, be sure not to put your

face and hands in the direction in which

force will be applied; otherwise this could

result in injury.

11)Closer[F].

12)Takeofftheuppersideofthecover,release

thelatch(E)andthentakeoffthecover.

 •E:1place

3. Cut out the gray portion shown in the ﬁgure

and dispose of it.

5 / 9

GN-1060 with GN-3010

4. Loosen the screws and take off the cover.

•Screws:15places

5. Set [A] as shown in the ﬁgure.

* Makingsurethatitsterminalcontactsthatof

[A],fullyinserttheconnectorandpushitto

theboardsidetosetit.

6. Wire the cable of [D] as shown in the ﬁgure,

and then hook [D].

7. Secure [D] with [f].

•f:1

6 / 9

GN-1060 with GN-3010

8. Wire the cable of [D] inside the product as

shown in the ﬁgure.

9. Attach [E] and [H].

•E:1

•H:2

10. Set [J] to the position of the cable indicated

in the ﬁgure, and ﬁx it with [H].

•H:2

11. Loop the cable twice as shown in the ﬁgure,

and ﬁx it with [E].

•E:1

7 / 9

GN-1060 with GN-3010

12. Pass the cable through the hole as shown

in the ﬁgure, and connect it with [A].

13. Attach the cover and tighten the screws.

•Screws:15places

14. Insert its latch (E) and then the parts

indicated by the arrows as shown in the

ﬁgure.

Perform this operation with care to avoid

injury. In addition, be sure not to damage

the cover.

15. Insert the latches (A) and (B) of the cover.

•A:2places

•B:2places

8 / 9

GN-1060 with GN-3010

16. Open [F].

17. Insert the latch (D) of the cover.

18. Close the covers in the order of (A) and (B).

19. Push the locking button to open [G].

20. Attach [b].

•b:1

9 / 9

GN-1060 with GN-3010

21. Attach [b] and [e].

•b:1

•e:1

22. Attach [e].

•e:1

23. Close in the order of [G] and [F].

24. Afﬁx the label [B].

•B:1

25. The operation is now completed.

45564403EERev.1

1mm

Otros manuales para MPS3537mc Series

Este manual sirve para los siguientes modelos

Otros manuales de Accesorios de impresora de Oki

Manuales populares de Accesorios de impresora de otras marcas

Star Micronics

Star Micronics TSP800 Series Manual de usuario

REA

REA JET HR pro 2K Manual de usuario

HP Laserjet,Color Laserjet 4si Manual de usuario

oliser

oliser MS 45 Manual de usuario

Roland

Roland DU2-64 Instrucciones y recetas

Xerox

Xerox EFI EXP6000 Manual de usuario

Canon

Canon Finisher-T1 Manual de usuario

Sharp

Sharp FO-1MK Manual de usuario

Labelmate

Labelmate PM-300 Manual de usuario

Epson

Epson T6248 Manual de funcionamiento

Epson

Epson OT-BZ20 Manual de usuario

Canon

Canon TonerRobot EP-27 Manual de usuario

Ricoh

Ricoh LCIT RT5100 Guía de inicio rápido

GBC

GBC 16 Series Manual de usuario

Canon

Canon INNER 2-WAY TRAY-E1 Manual de operación y mantenimiento

Develop

Develop SD-509 Manual de usuario

Kyocera

Kyocera KM-6230 Manual

Triumph Adler

Triumph Adler DF-710 Manual