OHAUS Valor 2000 Manual de usuario

Quick Start Guide Valor™2000

Ohaus Corporation www.ohaus.com iValor

™

2000 Quick Start Guide

PREPARATION FOR USE

IMPORTANT: Unscrew the two rear leveling

feet slightly, to allow proper airflow inside the

scale, and relieve any internal pressure. Then

level the scale.

Before cleaning the scale, the rear leveling

feet must be screwed in tightly to avoid entry

of water inside the scale.

AC power may be used when battery power is

not available. Remove the rubber seal in the

back. Connect the AC adapter plug to the

input jack and plug it into a power outlet.

Note: To prevent water ingress during use,

insert rubber Seal into the input jack recess.

SELECTING THE LOCATION

Place on a firm, steady surface.

Avoid locations with excessive air current,

vibrations, heat sources, or rapid temperature

changes.

Level the scale: Adjust leveling feet so bubble

is centered.

SAFETY PRECAUTIONS

For safe and dependable operation of this product, please comply with the following

safety precautions:

•Verify that the input voltage printed on the power Adapter and the plug type matches

the local power supply.

•Make sure that the power cord does not pose an obstacle or tripping hazard.

•Disconnect the product from the power supply when cleaning.

•Do not operate this product in hazardous or unstable environments.

•Do not drop loads on the pan.

•Use only approved accessories and peripherals, as available.

•Operate the product only under ambient conditions specified in the Instruction Manual.

•Service should be performed by authorized personnel only.

Level

Bubble

Seal

Leveling

Feet

Valor™2000 Quick Start Guide

Valor

™

2000 Quick Start Guide ii Ohaus Corporation www.ohaus.com

CONTROLS

Front Display

Rear Display

Button

Primary Function

(Short Press)

ON/ >O/T<

Turns scale ON.

If scale is On: Sets zero.

Performs a tare operation.

UNITS

Changes the weighing Unit.

Secondary Function

(Long Press)

Off

Turns scale off.

Enter the User menu.

Menu Function

(Short Press)

Yes

Accepts the current setting

on the display.

Advances to the next menu

or menu item.

Rejects the current setting on

the display and advances to

the next available setting.

Quick Start Guide Valor™2000

Ohaus Corporation www.ohaus.com iii Valor

™

2000 Quick Start Guide

OPERATION

Turning Scale On/Off

Press ON. The scale performs a display test, displays the model/software

version, and then enters the active weighing mode.

To turn the scale off, press and hold Off until OFF is displayed.

Zero Operation

Press 0/T to zero the weight display. The scale must be stable to accept

zero operation.

Manual Tare

Place a container on the weighing pan and press 0/T.

The display shows a net value of “0”.

To clear the Tare value, press 0/T with the pan empty.

Changing Units of Measure

Press UNITS to display the next available measuring unit.

Choose from kg, g, lb, and oz.

Only measuring units enabled in the Unit Menu will be displayed.

(See back page.)

Verify the scale: place a known mass on it and check if the reading is accurate.

If not, calibrate, using the Calibration Guide.

Valor™2000 Quick Start Guide

Valor

™

2000 Quick Start Guide iv Ohaus Corporation www.ohaus.com

MENU NAVIGATION

Press and hold Menu until MENU is displayed, then release it.

Press Yes to enter the displayed menu or press No to advance to the next menu.

When viewing the menu setting, press Yes to accept the setting, or press No to change it, then

press Yes to accept the setting and move to the next menu.

When End is displayed, press Yes to exit the menu.

MENU STRUCTURE

Programmable features of the Valor 2000 scales are contained in menus which are accessed

through the Display Panel’s control switches. See the Instruction Manual for more details.

*When LFT is ON, the Calibration, Resolution, Unit, and AZT menus are inaccessible.

*80252980*

P/N 80252980

Otros manuales de Escala de OHAUS

OHAUS

OHAUS Scout STX Manual de usuario

OHAUS

OHAUS EX124 Manual de usuario

OHAUS

OHAUS Ranger 3000 Series Manual de usuario

OHAUS

OHAUS Ranger RD Manual de usuario

OHAUS

OHAUS Defender 3000 Series Manual de usuario

OHAUS

OHAUS Compass CX Series Manual de usuario

OHAUS

OHAUS Defender 3000 Series Manual de usuario

OHAUS

OHAUS DEFENDER SERIES Manual de usuario

OHAUS

OHAUS Defender 3000 Manual de usuario

OHAUS

OHAUS EXPLORER Manual de usuario

OHAUS

OHAUS Valor 1000 Manual de usuario

OHAUS

OHAUS FD Series Manual de usuario

OHAUS

OHAUS Ranger 3000 Series Manual de usuario

OHAUS

OHAUS Scout SPX Series Guía de instalación

OHAUS

OHAUS 1119D Manual de usuario

OHAUS

OHAUS adventurer+ Manual de usuario

OHAUS

OHAUS RA Series Manual de usuario

OHAUS

OHAUS Adventurer AR0640 Manual de usuario

OHAUS

OHAUS ES series Manual de usuario

OHAUS

OHAUS Navigator Balance Manual de usuario

OHAUS

OHAUS Catapult 1000 Manual de usuario

OHAUS

OHAUS D31P75SD Manual de usuario

OHAUS

OHAUS SB1200 Manual de usuario

OHAUS

OHAUS Explorer EX125D Manual de usuario

Manuales populares de Escala de otras marcas

AWS

AWS ZEO-50 Manual de usuario

Gima

Gima Glass Body Fat Analyzer Manual de lista de piezas

Seca

Seca 374 Manual de usuario

TEC

TEC TEC SL59 SERIES Manual de usuario

Axis

Axis B/E Series Manual de usuario

Alecto

Alecto ACW-40 Manual de usuario

Rice Lake

Rice Lake MSI-4260 IS Manual de usuario

IKA

IKA RCT basic safety control Manual de usuario

ADE

ADE M20011 Manual de usuario

Duronic

Duronic KS3000 Manual de usuario

Digi

Digi SM-720 Manual de usuario

Cardinal

Cardinal CS Series Manual de usuario

Korona

Korona Kastella Manual de usuario

A&D

A&D FC-50Ki Manual de usuario

BDA

BDA CAMARGUE Manual de usuario

Tanita

Tanita HD-357 Manual de usuario

Leifheit

Leifheit 03173 Manual de usuario

Lumme

Lumme LU-1340 Manual de usuario