Nordcap MG 185 Manual de usuario
GB Instructions for use
DE Bedienungsanleitung
FR
IT
Mode d’emploi
Manuale d’uso
Bedienungsanweisung
Glastürkühlschrank
MG 185
Art. 477850185
2018-02
2
GB
Warning
As the appliance contains a
ammable refrigerant, it is es-
sential to ensure that the refrig-
erant pipes are not damaged.
The quantity and type of the
refrigerant used in your appli-
ance is indicated on the rating
plate.
Standard EN378 species that
the room in which you install
your appliance must have a
volume of 1m³ per 8 g of hydro-
carbon refrigerant used in the
appliances. This is to avoid the
formation of ammable gas/air
mixtures in the room where the
appliance is located in the event
of a leak in the refrigerant circuit.
WARNING:
Keep ventilation openings in
the appliance’s cabinet or in the
built-in structure clear of obstruc-
tion.
WARNING:
Do not use other mechanical
devices or other means to ac-
celerate the defrosting process
than those recommended by the
manufacturer.
WARNING:
Do not damage the refrigerant
system.
WARNING:
Do not use electrical appli-
ances inside the refrigerated
storage compartment, unless
they are of a type recommended
by the manufacturer.
WARNING:
Do not expose the appliance to
rain.
WARNING:
This appliance is not intended
for use by children and persons
with reduced physical, sensory
or mental capabilities or lack of
experience and knowledge if
they have been given supervi-
sion or instruction concerning
use of the appliance in a safe
way and understand the hazards
involved.
WARNING:
Do not store explosives, such
as aerosol cans with ammable
propellants in the unit.
3
GB
WARNING:
Cleaning and user maintenance
shall not be made by children
without supervision.
WARNING:
Danger risk of re or explosion if
ammable refrigerant are used.
To be repaired only by trained
personnel.
●Always keep the keys in a sep-
arate place and out of reach of
children.
●Before servicing or clean-
ing the appliance, unplug the
appliance from the mains or
disconnect the electrical power
supply.
●Relevant for Australia: Sup-
ply cord tted with a plug com-
plies with AS/NZS 3112.
●Frost formation on the interior
evaporator wall and upper
parts is a natural phenom-
enon. Therefore, the appliance
should be defrosted during
normal cleaning or mainte-
nance.
●Please note that changes to
the appliance construction will
cancel all warranty and product
liability.
●If the supply cord is damaged,
it must be replaced by the
manufacturer, its service agent,
or similarly qualied persons
inorder to avoid a hazard.
●Do not use extension cords.
CLASS 1 LED PRODUCT
4
GB
Contents
Warning ..................................................2
ELectrical connection .............................4
Get to know your bottle cooler................5
Before use. .............................................6
Installation ..............................................6
Operation and function ...........................9
Fault nding..........................................10
Defrosting, cleaning and maintenance . 11
Warranty, sparepart and service...........12
Disposal................................................13
Wiring and connections in power supply
systems must been all applicable (local and
national) electrical codes. Consult these
codes lengths and sizes prior to cabinet
installation.
This device complies with relevant EU
directives including Low Voltage Directive
2014/35/EU and Electromagnetic Compat-
ibility Directive 2014/30/EU
The socket should be freely accessible.
Connect the appliance only to
220 / 240 V / 50Hz alternating current via a
correctly installed earthed socket.
The socket must be fused with a 10-13 A
fuse.
If the appliance is to be operated in a non-
European country, check on the rating plate
whether the indicated voltage and current
type correspond to the values of your mains
supply.
Information regarding voltage, current or
power are given on the rating plate
The power cord may be replaced by a
technician only.
The rating plate provides various techni-
cal information as well as type and serial
number.
Electrical connection
5
GB
Get to know your bottle cooler
*Transport protector
Top lighting
Control panel
Fan
Shelf
Door gasket
Name plate
Glass door
Kick plate
*Transport protector
Lock
Adjustable feet
g. 2
g. 1
6
GB
Before operating your new appliance,
please read the following instructions care-
fully as they contain important information
on safety, installation, operation and main-
tenance.
Keep the instructions for future reference.
On receipt, check to ensure that the ap-
pliance has not been damaged during
transport.
Transport damage should be reported
to the local distributor before the appliance
is put to use.
Remove the transport protector before the
appliance is put to use. ( g 1) Hang it on
one of the shelves as it can be used to
adjust the door.
If the appliance has to be moved, use the
protector
Remove the packaging. Clean the inside of
the cabinet using warm water with a mild
detergent. Rinse with clean water and dry
thoroughly (see cleaning instructions). Use
a soft cloth.
If during transport the appliance has been
laid down, or if it has been stored in cold
surroundings (colder than +5°C), it must be
allowed to stabilise in an upright position for
at least an hour before being switched on.
Note: If the appliance is to be laid down, the
door must face upwards and the appliance
must be enclosed in the original packaging1
Before use
g. 3
Placement
For safety and operational reasons, the ap-
pliance must not be installed outdoors.
The appliance should be placed on a level
surface in a dry, well ventilated room (max.
75% relative air humidity). Never place the
appliance close to sources of heat such as
cookers or radiators, and avoid placing it in
direct sunlight.
Ambient temperature
The climate class is stated on the name-
plate (see page 12). This species the op-
timum ambient temperature. Wine coolers
with winter position, however, function at
ambient temperatures as low as 5ºC.
6
Installation
7
GB
Installation
The surface on which the appliance is to be
placed must be level. Do not use a frame or
similar.
The appliance can be installed as a free-
standing unit against a wall, built into a
closet or lined up with other appliances.
It is important that the appliance be well
ventilated and that air can circulate unhin-
dered above, below and around it.
The gures below illustrate how the neces-
sary air circulation around the appliance
can be ensured (g 4-7).
g. 4
g. 6
g. 5
g. 7
8
GB
The distance pieces on the rear of the ap-
pliance ensure sucient air circulation. Fit
the two caps supplied with the appliance as
shown in g. 9
g. 9
g. 10
It is important that the appliance be abso-
lutely level. It can be levelled by screwing
the adjustable feet at the front of the appli-
ance up or down (g 10).
Use a spirit level to check that the appliance
is absolutely level sideways.
Setting up
g. 8
A “Side by Side” kit can be ordered (g 8)
g. 11
40
9
GB
Electronic controls
The electronic controls ensure that the set
temperature is maintained.
Following any power failure, the tempera-
ture settings are automatically recalled.
Operation and function
g. 12
Lighting on/o
To adjust temperature.
Push button in 2 sec.
Defrost
Temperature display
The display shows the actual temperature
in the cabinet, and indicates that power is
connected.
Temperature setting
Push the Set button on left side in 2 sec,
afterwards you can change the temperature
+/- with the buttons on right side.
Manual defrosting
If there is a need for manual defrosting,
push the Defrost botton for more than 2
second and a manual defrost will start.
After 30 min. the electronic control will
return to normal mode Beware
Pushing the Unit On/O button stops the
compressor and the light is switched o.
Pushing the Unit On/O button re-activates
the compressor, but the light remains turned
o. The light is switched on by pressing the
Light On/O button.
Temperature +/-
Unit on/o
10
GB
Fault nding
Fault Possible cause Remedy
The control lamp is
not lit.
The appliance is switched o.
Power failure; the fuse is blown;
the appliance is not plugged in
correctly.
Press the on/o switch.
Check that power is connected.
Reset the fuse.
Water collects on
the shelves.
The defrost water drain is
blocked.
Clean the defrost water channel
and the drain hole on the rear
wall of the cabinet.
Vibration or bother-
some noise.
The appliance is not level.
The appliance is resting against
other elements.
Level the appliance using a spirit
level.
Move the appliance away from
other elements or appliances it is
in contact with.
Compressor runs
continuously.
Temperature setting too low.
High room temperature.
Raise the temperature setting.
Ensure adequate ventilation.
Temperature in cabi-
net too high.
Temperature setting too high.
The cabinet has recently been
lled with unchilled bottles.
Lower the temperature setting.
Distribute items within the cabi-
net to improve air circulation.
Ice formation on
evaporator.
Door is open. Close the door
Otros manuales para MG 185
1
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Idiomas:
Otros manuales de Refrigerador de Nordcap
Nordcap
Nordcap VAR-PC12 Manual de usuario
Nordcap
Nordcap TM 33-G Manual de usuario
Nordcap
Nordcap LINUS 100 Guía de inicio rápido
Nordcap
Nordcap TM 32-V Manual de usuario
Nordcap
Nordcap KU 450 G Manual de usuario
Nordcap
Nordcap SCU 1425 Manual de usuario
Nordcap
Nordcap M5 Manual de usuario
Nordcap
Nordcap M180 Manual de usuario
Nordcap
Nordcap CLIO 2 L1 2065 Manual de usuario
Nordcap
Nordcap VAR-PM13 Manual de usuario
Nordcap
Nordcap TM 44-G Manual de usuario
Nordcap
Nordcap POS 080R Manual de usuario
Nordcap
Nordcap TKU 440 G-LED Manual de usuario
Nordcap
Nordcap EN1 Series Manual de usuario
Nordcap
Nordcap TM 52-V Manual de usuario
Nordcap
Nordcap 700l Refrigerator Manual de usuario
Nordcap
Nordcap KU 175 G-SP Manual de usuario
Nordcap
Nordcap ENTRY Guía de inicio rápido
Nordcap
Nordcap MF 180 Manual de usuario
Nordcap
Nordcap 477850180 Manual de usuario
