Nordcap SCU 1425 Manual de usuario

Bedienungsanweisung

Flaschenkühlschrank SCU 1425

[Art. 4358001425]

2021-07

Important Instructions:

The appliances mentioned in this document are only intended for preservation and cooling of

beverages in bottles and cans.

Read the manual In order to obtain full benefit of the appliance.

It is the user’s responsibility to utilize the appliance according to the instructions.

Contact the dealer immediately in case of any defects.

The appliance is only for indoor use.

The appliance should be placed in a dry sufficiently ventilated room.

The appliance should not be placed near a source of heat or direct sunlight.

The appliance should not be placed near a ventilation or air condition system.

Note that all electrical appliances can cause danger.

Do not store explosives such as gas, petrol, ether or similar substances in the appliance.

Asbestos nor CFC have been used in the production of the appliance.

The oil in the compressor does not contain PCB.

- THIS APPLIANCE MUST ALWAYS HAVE AN EARTHED PLUG!

- AT REPAIR ALWAYS UNPLUG THE APPLIANCE!

- ONLY FOR APPLIANCES WITH REFRIGERANT R290/R600a!

This appliance contains a flammable refrigerant, so make sure of good ventilation around the

appliance.

Do not use mechanical devices when defrosting, this can cause leakage of the cooling system.

Do not use electrical appliances inside the refrigerated storage compartment.

Any repair of the appliance should be carried out by a skilled technician (EN 60335-2-89: 2010).

Unpacking and Installation:

Remove the packing and check that the cabinet has no transport damage.

Any transport damages should be reported to the transport company and noted on the delivery note.



When building-in ensure a distance of at least 50 mm behind the appliance and above the

appliance.

Make sure that the air intake at the bottom panel is not blocked.

Place the appliance in a level position for correct functioning. This can be achieved by adjusting the

adjustable feet:

Electrical Connections

The appliance is intended for 220-240 V/50 Hz. The connection should be effected to an accessible

socket.

This appliance should have extra protection according to the power regulations. This is also the case

when replacing an existing appliance which does not have the extra protection.

Always use a 3 pin plug. The lead with green/yellow insulation should be earthed (marked ).

In all other cases an authorized electrician can tell you how to get the extra protection of the

appliance. In case there is no extra protection in the building, the Board of Electricity recommends

that an electrician installs a PFI or HPFI switch (contact breaker).

The appliance should be connected to an 13A

protected socket.

The appliance should not be connected to a

multipoled distribution socket.

Start-up the Appliance

Before taking the appliance into use it is recommended to clean it – see section regarding

maintenance.

Important!

In case the cabinet has been lying down during transport leave it standing up for 2 hours before

switching it on.

Thermostat (Also see page 137)

The thermostat setting has a scale 1-7, corresponding to approx. 2-12 ºC.

In most cases a setting of 3-4 will be optimum.

The cooling system can be switches off at 0.

Depending on model the thermostat can

be placed as follows:

1. In top panel

2. Under the canopy

3. On the cover of the internal fan

Thermometer

All appliances are fitted with a thermometer.

Depending on model the thermometer

can be placed as follows:

1. In top panel

2. Under the canopy

Defrosting

The appliance has automatic defrost. Discharge water is led to evaporation in a drip tray placed in the

compressor compartment.

Lock

The appliance with hinged door has a

lock. The lock is placed at the top of the

door.

Internal Light

Appliance with internal light has a light

switch. Depending on model this is

placed as follows:

1. In the top panel

2. Under the canopy

3. On the cover of the internal fan

Replacing the Light

REMEMBER to switch off the power before replacing the light!

Internal Light:

The internal fluorescent light is replaced

by demounting the light cover. Replace

the tube with an equivalent type.

The internal LED light should be

replaced by an equivalent type. Contact

your local supplier for original spare

parts.

Canopy Light:

The external fluorescent light in the

canopy is replaced by dismounting the

end piece of the canopy. Pull the

canopy plate to one side giving access

to the fluorescent light. Replace it with

an equivalent type.

The external LED light in the canopy is

replaced in the same way.

Contact your local supplier for original

spare parts.

Push carefully the canopy plate in place

and remount the end piece of the

canopy.

Door Reversal

Some models have reversible doors. Follow the below mentioned instructions for door reversal from right to

left and vice versa.

This operation is easily done by carefully lying down the cabinet at its back or on a sack truck.

1. Remove the bottom panel

2. Remove the bottom hinge and the

support fitting.

3. Remove the top panel/canopy.

4. Lift the door and pull it approx.10 cm

down.

5. Remove the top hinge pin.

6. Fit the hinge pin at the opposite

side without tightening it.

7. Lift the door in place in the top hinge.

8. Tighten the top hinge pin.

9. Remove the bottom hinge pin and

turn the bottom hinge 90 degrees.

10.Refit the bottom hinge pin to the

bottom hinge which was turned.

11. Fit the bottom hinge on the

opposite side.

12. Refit the bottom panel.

13. Move the handle to the opposite

hinge side.

Wall Fitting

Some models are prepared for wall fitting. See below.

Max. Load:

FS60CP

345

20 kgs.

FS80CP

360

30 kgs.

FSC100

527

30 kgs.

Drill 2 holes with a diameter of 8 mm and a depth of 40 mm and

a distance as shown on the drawing (A).

Insert 8 mm plugs.

Use 4.8 x 38 mm screws, DIN NO.7981.

Make sure the distance between the screw head and the wall is

2-3 mm.

Make sure the screws fit perfectly into the wall fitting.

Maintenance

The appliance has a closed cooling system, which normally does not require any maintenance.

REMEMBER to switch off the power before cleaning the appliance!

However, it is recommended to clean the condenser 2-4 times a year by means of a brush or a

vacuum cleaner. This can influence the energy consumption and the lifetime of the cabinet.

The appliance has automatic defrost. Discharge water is led to evaporation in a drip tray placed in the

compressor compartment.

Service

In case of no cooling check failure in the power supply.

In case you are unable to find any failure, please contact your dealer.

You need to inform your dealer of the model number and serial number stated on the rating label

normally placed inside on the right side of the cabinet.

Always use authorized technicians and original spare parts.

This device complies with the following EU Directives:

Low Voltage Directive (LVD) 2014/35/EU,

Electromagnetic Compatibility Directive (EMC) 2014/30/EU,

Restriction of Hazardous Substances (RoHS) Directive 2011/65/EC

Disposal

The disposal of old appliances should be done correctly in order to protect the environment.

Please observe the national regulations for disposal of old appliances.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Idiomas:

Otros manuales de Refrigerador de Nordcap

Nordcap

Nordcap TKU 440 G-LED Manual de usuario

Nordcap

Nordcap KU 400 CHR Manual de usuario

Nordcap

Nordcap KU 407 Manual de usuario

Nordcap

Nordcap KU 710 GL-Plus Manual de usuario

Nordcap

Nordcap CLIO 2 L1 2065 Manual de usuario

Nordcap

Nordcap TM32 Manual de usuario

Nordcap

Nordcap TM 33-G Manual de usuario

Nordcap

Nordcap TK 400 CHR Manual de usuario

Nordcap

Nordcap POS 080R Manual de usuario

Nordcap

Nordcap MG 185 Manual de usuario

Nordcap

Nordcap KU 175 G-SP Manual de usuario

Nordcap

Nordcap VAR-PM12 Manual de usuario

Nordcap

Nordcap VAR-PM13 Manual de usuario

Nordcap

Nordcap EN1 Series Manual de usuario

Nordcap

Nordcap VAR-PC13 Manual de usuario

Nordcap

Nordcap 477850180 Manual de usuario

Nordcap

Nordcap TM 32-V Manual de usuario

Nordcap

Nordcap COOL-LINE KT 13 3T Manual de usuario

Nordcap

Nordcap TM 44-G Manual de usuario

Nordcap

Nordcap MG 185 Manual de usuario

Nordcap

Nordcap KU 450 G Manual de usuario

Nordcap

Nordcap KU 1000 G-SD Manual de usuario

Nordcap

Nordcap V160 Semiprofessional Series Instrucciones de montaje

Nordcap

Nordcap M180 Manual de usuario

Manuales populares de Refrigerador de otras marcas

Bonnet Neve

Bonnet Neve SKYVIEW PLUS Manual de usuario

Zanussi Electrolux

Zanussi Electrolux ZERB 8441 Manual de usuario

Sharp

Sharp SJ-BA31IEXW2-EU Manual de usuario

CORBERO

CORBERO CC2300MCW Manual de usuario

KitchenAid

KitchenAid 2205264 Manual de usuario

Stengel

Stengel KU 1101 A++ Manual de usuario

NEFF

NEFF KI181 Series Manual de usuario

Hoshizaki

Hoshizaki Reach-In Manual de usuario

Amana

Amana ASD2524VES00 Manual de usuario

BOMANN

BOMANN KGC 213 Manual de usuario

Danby

Danby DAR044A1SLDD Instrucciones de montaje

Samsung

Samsung RF323TE Manual de usuario

Beko

Beko CSA31022 Manual de usuario

IKEA

IKEA FROSTIG C 185 E Manual de usuario

Electrolux

Electrolux ER 6821 D Manual de usuario

True

True TS-28 Manual de usuario

Frigidaire

Frigidaire FSC23R5DW9 Manual de usuario

Beko

Beko LSP4579W Manual de usuario