Milwaukee MW500 Manual de usuario

USER MANUAL

MW500

PRO ORP Meter

milwaukeeinstruments.com (USA & CAN)

milwaukeeinst.com

CERTIFICATION

Milwaukee Instruments conform to the

CEEuropean Directives.

Disposal of Electrical & Electronic

Equipment. Do not treat this product as

household waste. Hand it over to the

appropriate collection point for the recycling of

electrical and electronic equipment.

Disposal of waste batteries. This product

contains batteries. Do not dispose of them

with other household waste. Hand them

over to the appropriate collection point for recycling.

Please note: proper product and battery disposal

prevents potential negative consequences for human

health and the environment. For detailed information,

contact your local household waste disposal service

or go to www.milwaukeeinstruments.com (USA &

CAN) or www.milwaukeeinst.com.

RECOMMENDATION

Before using this product, make sure it is entirely

suitable for your specific application and for the

environment in which it is used. Any modification

introduced by the user to the supplied equipment

may compromise the meter’s performance. For your

and the meter’s safety do not use or store the meter in

hazardous environment. To avoid damage or burn, do

not perform any measurement in microwave ovens.

WARRANTY

This instrument is warranted against defects in

materials and manufacturing for a period of 2 years

from the date of purchase.

Probe is warranted for

6 months.

This warranty is limited to repair or free

of charge replacement if the instrument cannot be

repaired. Damage due to accidents, misuse, tampering

or lack of prescribed maintenance is not covered by

warranty. If service is required, contact your local

Milwaukee Instruments Technical Service. If the repair

is not covered by the warranty, you will be notified of the

charges incurred. When shipping any meter, make sure

it is properly packaged for complete protection.

Milwaukee Instruments reserves the right to make

improvements in design, construction and appearance

of its products without advance notice.

SATISFACTION

GUARANTEED

ISTMW500 07/20

OPERATION

yThe meter is supplied complete with a 9V battery.

Slide o the battery compartment cover located

on the back of the meter. Install the battery into the

battery clip connector while observing polarity.

yAlways remove the electrode protective cap before

taking any measurement. If the electrode has been

left dry, soak the tip in storage solution for a few

minutes to reactivate it.

yConnect the ORP electrode to the BNC socket on the

top of the meter.

yImmerse the tip (2.5 cm) of the ORP electrode into the

sample.

yTurn the instrument on by pressing the ON/OFF key.

yAllow the reading to stabilize before taking

measurements.

yAfter use, switch the meter o and store the

electrode with a few drops of storage solution in the

protective cap.

yThe meter is factory calibrated. ORP electrodes are

interchangeable and no mV calibration is needed

when they are replaced.

MAINTENANCE:

yThe surface of the ORP electrode must always be

clean. Use M10000B rinse solution for this purpose.

If needed, clean the Platinum tip with very fine

abrasive paper.

yWhen not in use, the tip (reference junction) of the

electrode should always be kept moist and safe

from any mechanical stress.

BATTERY REPLACEMENT

When the battery becomes weak the meter will

display “ “, the low battery indicator. The battery

has about 50 hours of working time left. A low battery

will result in unreliable measurements. Prompt battery

replacement is required.

Battery replacement must only take place in a non

hazardous area using an alkaline 9V battery.

Turn the meter o, slide the battery compartment

cover located at the rear of the meter o and replace

the 9V battery with a new one. Make sure the battery

contacts are fully engaged in the connector, seat the

battery in its compartment and replace the cover.

SPECIFICATIONS

RANGE ±1000 mV

RESOLUTION 1 mV

ACCURACY (@25 °C) ±5 mV

TYPICAL EMC

DEVIATION ±5 mV

ORP ELECTRODE SE-300 (included)

ENVIRONMENT 0 to 50 °C; 95% RH max.

BATTERY TYPE 9V alkaline (included)

BATTERY LIFE approx. 300 hours of use

DIMENSIONS 143 x 80 x 32 mm

WEIGHT 220 g (with battery)

meter only

OPTIONAL ACCESSORIES

M10000B Electrode rinse solution, 20 ml sachet,

25 pcs.

MA9015 Electrode storage solution, 220 mL

bottle

SE-300 Platinum ORP electrode with 1 m cable

Otros manuales de Instrumento de medición de Milwaukee

Milwaukee

Milwaukee M12 CLLP-301C Manual de usuario

Milwaukee

Milwaukee MW13 Manual de usuario

Milwaukee

Milwaukee MW806 MAX Manual de usuario

Milwaukee

Milwaukee MW14 Manual de usuario

Milwaukee

Milwaukee MR32ATC Manual de usuario

Milwaukee

Milwaukee MW150 Manual de usuario

Milwaukee

Milwaukee SM101 Manual de usuario

Milwaukee

Milwaukee MI405 Manual de usuario

Milwaukee

Milwaukee MC310 Manual de usuario

Milwaukee

Milwaukee MW301 Manual de usuario

Milwaukee

Milwaukee pH54 Manual de usuario

Milwaukee

Milwaukee MW12 Manual de usuario

Milwaukee

Milwaukee HEAVY DUTY M12 PL Manual de usuario

Milwaukee

Milwaukee MW11 Manual de usuario

Milwaukee

Milwaukee MW105 MAX Manual de usuario

Milwaukee

Milwaukee CALIBRATION 2238-20 Manual de usuario

Milwaukee

Milwaukee MW14 Manual de usuario

Milwaukee

Milwaukee PRO MI414 Manual de usuario

Milwaukee

Milwaukee 2280-20 Manual de usuario

Milwaukee

Milwaukee MI 404 Manual de usuario

Milwaukee

Milwaukee 2237-20 Manual de usuario

Milwaukee

Milwaukee M12 3632-20 Manual de usuario

Milwaukee

Milwaukee M12 CLLP Manual de usuario

Milwaukee

Milwaukee 3421 Manual de usuario

Manuales populares de Instrumento de medición de otras marcas

Suaoki

Suaoki D40 Manual de usuario

Elster

Elster BK-G1.6 Manual de usuario

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manual

Duratool

Duratool D03128 Manual de usuario

Vega

Vega VEGAPULS 65 Manual de usuario

Tonghui

Tonghui TH2618B Manual de usuario

Tenmars

Tenmars TM-801 Manual de usuario

MSR

MSR 145 Manual de usuario

TPS

TPS WP-82 Manual de usuario

ELMETRON

ELMETRON CP-511 Manual de usuario

PCB Piezotronics

PCB Piezotronics 003C30 Manual de usuario

Tenma

Tenma 72-10465 Manual de usuario

Endress+Hauser

Endress+Hauser Proline Promag 50 Especificaciones técnicas

Siemens

Siemens SITRANS F Coriolis FCT030 Manual de lista de piezas

KLINGER

KLINGER CMF V Series Manual de usuario

EXFO

EXFO FTB-2 Manual de operación y mantenimiento

Keysight

Keysight M8290A Manual de usuario

ADTEK

ADTEK MW-5 Manual de usuario