3D production system ►Make a better world
10
3 Operate your 3D printer –Software
Please refer to MiiUtility User Manual, all-in-one software for Mii raft printers.
4 After Print
4.1 Remove Model
Lift the handle→Remove the Picker and printed model→Use air gun and ethanol to clean the printed
model →Post curing (Additional post curing unit is required)→ arefully remove the printed model from the
picker. → Use putty knife to help separate the printed model and picker
* Do not expose the resin tank to direct light source because the resin will solidify under UV light. Use tray
to cover the resin tank to prevent solidify.
4.2 lean Picker
Use putty knife or similar object to scrape away the excess printed model on the picker. If any greasy
residue persists, use a soft cloth dipped in alcohol to rub the surface until the grease is removed.
4.3 lean Resin Tank
Pour resin out of tank→ Pour ethanol into tank and soak in a while→ Use Ɵssue or lens Ɵssue soŌly wipe
the boƩom of tank→ Finished cleaning. Or let the projector help cleaning Tank, please refer to MiiUtility
user manual, the cleaning Tank Process on Page 19 form
Notifications:
- Do not shut down the power during curing
- Do not interrupt the firmware upgrade process. Any interruptions during the firmware upgrade process
may cause your printer to malfunction.
- Update the firmware frequently for better user experience, please refer to page8, page14 for upgrade
- Before printing, please check the surface of picker and tank is clean, no residual, or may affect printing
quality.
- Tank and Picker are consumables, suggest replace for a period, or may affect printing quality.
- Tank has lifespan around 1,000 hours. Evenly arrange the printing model can protect the tank, do not
print on one single point repeatedly.
