Metra Electronics 99-3413 Manual de usuario

2-SHAFT HEAD UNITS: Slide the aftermarket head unit into the kit and secure with shaft

nuts. (see Fig. A)

DIN HEAD UNITS: Cut and remove the shaft supports. Slide the DIN cage into the Radio

Housing and secure by bending the metal locking tabs down. Slide the aftermarket head unit

into the cage until secure. (see Fig. B)

(If an equalizer will be included, slide the unit into the back of the Radio Housing and secure.

If an equalizer will NOT be included, snap the Equalizer Dummy Plate into the opening).

ALL VEHICLES

6 7

Locate the factory wiring harness in the

dash. Metra recommends using the

proper mating adaptor and making

connections as shown. (Isolate and

individually tape off the ends of any

unused wires to prevent electrical short

circuit).

COROLLA: Re-connect the battery terminal and

test the unit for proper operation. Mount the head

unit/kit assembly to the sub-dash with (4) Phillips

screws previously removed in step #1.

PRIZM: Re-connect the battery terminal and test

the unit for proper operation. Mount the head

unit/kit assembly to the sub-dash with (2) Phillips

screws previously removed in step #1 ("A") and

(2) Phillips Screws supplied ("B").

A) Strip wire ends back ½"

B) Twist ends together

C) Solder

D) Tape

99-3413

INSTALLATION

INSTRUCTIONS

APPLICATIONS

CAR PAGE

CHEVROLET

Prizm 1998-2003.........................................................1

TOYOTA

Corolla 1998-2002.....................................................2

KIT COMPONENTS

TOOLS REQUIRED

Cutting tool

Wrench

Phillips screwdriver

Prizm

Spacers

Equalizer

Dummy Plate

(2) Phillips

Screws

Fig. B

"B"

"A"

"B"

Fig. A

KIT FEATURES

Shaft and

DIN unit

provisions

Cupholder

provisions

Equalizer

provisions

Radio Housing

1-800-221-0932 www.metraonline.com

rev. 06-13-07

Disconnect the negative battery terminal to

prevent an accidental short circuit. Remove

the ashtray. Unclip the radio trim bezel and

disconnect the wiring. Remove (4) Phillips

screws se c u r i n g the factory he a d

unit/cupholder assembly, slide the assembly

out and disconnect the wiring.

Disconnect the negative battery terminal to

prevent an accidental short circuit. Unclip

the radio trim bezel (upper dash). Remove

(4) Phillips screws from the factory head

unit, slide the unit out and disconnect the

wiring. Remove the ashtray and unclip the

trim bezel (lower dash). Remove (4) Phillips

screws from the factory pocket/cupholder

assembly and remove the assembly. (Metra

recommends ordering the 88-00-8000 or

88-00-9000 to fill the space left in the upper

dash location).

Locate the faceplate supplied with the

aftermarket head unit. Place the faceplate

into the recessed opening in the Radio

Housing. If the faceplate fits easily into the

opening with no interference, leave the

Housing intact. If the faceplate does NOT fit

easily into the opening, trim away the ribs

located on the top and bottom of the opening

("A").

Locate the faceplate supplied with the

aftermarket head unit. Place the faceplate

into the recessed opening in the Radio

Housing. If the faceplate fits easily into the

opening with no interference, leave the

Housing intact. If the faceplate does NOT fit

easily into the opening, trim away the ribs

located on the top and bottom of the opening

("A").

Convert the Radio Housing by cutting and

removing the pins located under the

equalizer opening ("A"). Trim no less than

1/8" and no more than 1/4" from the bottom

of each upper mounting tab ("B"). Snap the

Prizm Spacers onto the back of the lower

mounting tabs ("C").

Remove the cupholder from the factory head

unit assembly. Slide the cupholder into the

bottom of the Radio Housing until the

locating pins engage the slots in the kit.

(Once the locating pins are engaged, PUSH

the cupholder into the Housing until it stops).

Skip to the Installation Instruction for ALL

VEHICLES on Page #3.

Remove the cupholder from the factory head

unit assembly. Slide the cupholder into the

bottom of the Radio Housing until the

locating pins engage the slots in the kit.

(Once the locating pins are engaged,

maneuver the cupholder until it is flush with

the face of the Housing). Skip to the

Installation Instruction for ALL VEHICLES on

Page #3.

CHEVROLET Prizm 1998-2003 TOYOTA Corolla 1998-2002

1 1

2 2

Locate the v-cut along the top lip of the

Radio Housing. Using the v-cut as a guide,

cut and remove the top portion of the

Housing as indicated above.

"A"

"C"

"A"

"B"

"C"

Tabla de contenidos

Otros manuales de Accesorios para automóviles de Metra Electronics

Metra Electronics

Metra Electronics 99-7506 Manual de usuario

Metra Electronics

Metra Electronics 107-HY1 Manual de usuario

Metra Electronics

Metra Electronics 70-5511 Manual de usuario

Metra Electronics

Metra Electronics 108-CH4 Manual de usuario

Metra Electronics

Metra Electronics 70-2054 Manual de usuario

Metra Electronics

Metra Electronics 99-7389B Manual de usuario

Metra Electronics

Metra Electronics 95-2009 Manual de usuario

Metra Electronics

Metra Electronics 99-2005 Manual de usuario

Metra Electronics

Metra Electronics 99-7860 Manual de usuario

Metra Electronics

Metra Electronics 99-5816 Manual de usuario

Metra Electronics

Metra Electronics 99-8216 Manual de usuario

Metra Electronics

Metra Electronics 95-9615B Manual de usuario

Metra Electronics

Metra Electronics XIAH-FD1 Manual de usuario

Metra Electronics

Metra Electronics 99-7579 Manual de usuario

Metra Electronics

Metra Electronics 95-8154 Manual de usuario

Metra Electronics

Metra Electronics 99-7308 Manual de usuario

Metra Electronics

Metra Electronics 99-6507 Manual de usuario

Metra Electronics

Metra Electronics 99-3030B Manual de usuario

Metra Electronics

Metra Electronics 95-3023HG Manual de usuario

Metra Electronics

Metra Electronics 95-3304 Manual de usuario

Metra Electronics

Metra Electronics 99-7423 Manual de usuario

Metra Electronics

Metra Electronics 99-6525 Manual de usuario

Metra Electronics

Metra Electronics 99-5806 Manual de usuario

Metra Electronics

Metra Electronics 99-6536 Manual de usuario

Manuales populares de Accesorios para automóviles de otras marcas

James Baroud

James Baroud Odyssey Manual de usuario

Motorola

Motorola i50sx Manual de usuario

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manual de usuario

Feniex

Feniex T3 Manual de usuario

Renault

Renault 77 11 423 180 Manual de usuario

Kia

Kia E8300-4D000 Manual de usuario

Brink

Brink 756843 Manual de usuario

Whispbar

Whispbar K085W Manual de usuario

v.link

v.link CI-VL2-PC-HSD Manual de usuario

Viking

Viking Stack-Rack Guía de configuración rápida

Aries

Aries 203015 Manual de usuario

Choetech

Choetech AT0005 Manual de usuario

ZZ2

ZZ2 ZZAIR-PRO Manual de usuario

Holman

Holman 4A80L Manual de usuario

Thule

Thule 2075 Manual de usuario

Motorola

Motorola T325 Manual de usuario

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guía de instalación

DV8

DV8 FBJL-02 Manual de usuario