Lippert Components Happijac Manual de usuario

Rev: 07.15.19 Page 1 CCD-0002704

HAPPIJAC®BED LIFT SUPPORT LEG AND BRACKET INSTALLATION

TI-322

POWER AND MOTION

Purpose

The purpose of this document is to provide instructions on:

• the installation of support legs (Fig. 1) on the sofa unit attached to the HappiJac Bedlift.

• the removal and installation of the HappiJac Bedlift support brackets (Fig. 2).

Fig. 1

Resources Required

• Cordless or electric drill or screw gun

• Appropriate drive bit

• Non-permanent marking method

• Sharp cutting instrument

• 1 ¼" self-tapping screws

Fig. 2

Rev: 07.15.19 Page 2 CCD-0002704

HAPPIJAC®BED LIFT SUPPORT LEG AND BRACKET INSTALLATION

TI-322

POWER AND MOTION

Support Leg Installation

1. Remove the sofa unit from the HappiJac Bedlift and lay it flat face-down in a clean area.

2. The support legs can be adjusted, if needed. The 14-inch legs are normally are installed on the seat

cushion and the backrest uses the 15-inch. The legs can be adjusted by removing the two nuts and bolts

(Fig. 3A) and sliding the bottom part of the leg (Fig. 3B) in or out. Replace nuts and bolts after adjustment.

3. Measure about 12 inches from the outside edge of the cushion portion of the unit (Fig. 4). Feel for

strapping under the fabric and make a small mark between two straps that is close to both the 12-inch

measurement and to the inside edge of the steel frame. Repeat for the other side.

Fig. 4

12"

4. Fold one of the cushion support legs flat by pressing the adjustment button (Fig. 5A) and moving the

leg to one of the side holes (Fig. 5B) in the bracket.

5. Place the tab on the bracket end of the leg (Fig. 5C) on the measurement mark (step 3) with the leg

pointing towards center.

12"

inside edge

of frame

Seatback

Cushion

Fig. 3

Fig. 5

Rev: 07.15.19 Page 3 CCD-0002704

HAPPIJAC®BED LIFT SUPPORT LEG AND BRACKET INSTALLATION

TI-322

POWER AND MOTION

6. Repeat steps 4 and 5 on the other side and make sure the end of the legs do not overlap one over the other.

7. Keeping the brackets in the same position, press the adjustment button (Fig. 5A) and rotate one of the

legs to make sure it does not stick out beyond the seat cushion hinge when in the stored position. Repeat

for the other leg.

8. Make a small cut into the fabric, just beyond the inside edge the frame. The hole should be large

enough to accommodate the bracket tab (Fig. 5C). Slide the tab into the cut slot so that support leg

bracket is upright and the arms of the bracket (Fig. 6A) are resting on the seat frame.

Fig. 6

9. Secure the bracket to the frame with two 1 1/4" self-tapping screws.

10. Repeat steps 8 and 9 for the other cushion leg.

11. Find a centerpoint on the seatback between the two cushion leg brackets (Fig. 7A). Make a mark at that

point that is between the straps under the fabric and is close to the inside edge of the frame.

Seatback

inside edge

of frame

Fig. 7

cushion leg

brackets

Rev: 07.15.19 Page 4 CCD-0002704

HAPPIJAC®BED LIFT SUPPORT LEG AND BRACKET INSTALLATION

TI-322

POWER AND MOTION

Fig. 8

12. Make a small cut into the fabric, just beyond the inside edge the frame. The hole should be large

enough to accommodate the bracket tab. Slide the tab into the cut slot so that support leg bracket is

upright and the arms of the bracket are resting on the seat frame.

13. Secure the bracket to the frame with two 1 1/4" self-tapping screws.

14. Fold all three legs down and reinstall the sofa on the HappiJac support brackets.

15. After the sofa is installed, lower the sofa until it is stopped by the microswitch. Make sure the legs gently

rest on the floor. Adjust the legs, if necessary.

Support Bracket Removal

1. Remove the sofa/dinette configuration or bed platform from the support brackets.

2. Remove the locking pin (Fig. 8A) from the bracket, then lower the bracket arm (Fig. 8B).

Rev: 07.15.19 Page 5 CCD-0002704

HAPPIJAC®BED LIFT SUPPORT LEG AND BRACKET INSTALLATION

TI-322

POWER AND MOTION

3. Remove the stop screw (Fig. 9A) from securing the support bracket, then remove the screw (Fig. 9B)

securing the trolley stop lock bracket (Fig. 9C) and remove the bracket. Set screws aside for later use.

4. Grasp the base of the sofa bracket (Fig. 10A) and pull up until the hooks are even with travel trolley

slots (Fig. 10B), then pull the sofa bracket away from the travel trolley.

5. Repeat for other brackets, if necessary.

Support Bracket Installation

1. Line up the hooks (Fig. 11A) on the end edge of the support bracket with the slots in the lower trolley

(Fig. 11B) then insert the bracket in to the trolley slots.

Fig. 10

Fig. 9

Fig. 11

Rev: 07.15.19 Page 6 CCD-0002704

As a supplier of components to the RV industry, safety, education and customer satisfaction are our primary concerns. Should you

have any questions, please do not hesitate to contact us at (574) 537-8900 or by email at [email protected]. Self-help tips,

technical documents, product videos and a training class schedule are available at lci1.com or by downloading the MyLCI app.

HAPPIJAC®BED LIFT SUPPORT LEG AND BRACKET INSTALLATION

TI-322

POWER AND MOTION

2. Pull down on the bracket to secure it in the trolley.

3. Line up the holes in the trolley stop lock bracket (Fig. 12A) with the top two holes in the lower trolley

(Fig. 12B). Secure the trolley stop lock bracket with the previously removed screw (Fig. 12C).

4. Secure the support bracket with the previously removed stop screw (Fig. 12D).

5. Repeat steps 2-4 for other support brackets, if necessary.

Fig. 12

Otros manuales para Happijac

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Accesorios para automóviles de Lippert Components

Lippert Components

Lippert Components SolidStep XF Manual de usuario

Lippert Components

Lippert Components Alumi-Tread series Manual de usuario

Lippert Components

Lippert Components In-Wall Slide-Out Manual de usuario

Lippert Components

Lippert Components Jack-It Manual de usuario

Lippert Components

Lippert Components Solera Manual de usuario

Lippert Components

Lippert Components In-Wall Slide-Out Winnebago Instrucciones de funcionamiento

Lippert Components

Lippert Components Ground Control 2.0 Manual de usuario

Lippert Components

Lippert Components PSX1 Manual de uso y cuidado

Lippert Components

Lippert Components Levelegs Manual del propietario

Lippert Components

Lippert Components Edge Manual de usuario

Lippert Components

Lippert Components In-Wall Slide-Out Manual de usuario

Lippert Components

Lippert Components Sliding Swivel Seat Base Manual de usuario

Lippert Components

Lippert Components 432223 Manual de usuario

Lippert Components

Lippert Components ground control TT Instrucciones de instalación

Lippert Components

Lippert Components Solera Power Awning Regal Head Manual de uso y cuidado

Lippert Components

Lippert Components Vela Manual de usuario

Lippert Components

Lippert Components Solera Instrucciones de instalación

Lippert Components

Lippert Components Curt Rota-Flex Pin Box Manual de usuario

Lippert Components

Lippert Components ground control 3.0 Manual de usuario

Lippert Components

Lippert Components SURESHADE POWER BIMINI Manual de usuario

Lippert Components

Lippert Components Kwikee Manual de usuario

Lippert Components

Lippert Components Solera Slide Topper Manual de usuario

Lippert Components

Lippert Components Solera Power Awning Manual de uso y cuidado

Lippert Components

Lippert Components Happijack FT-DR2 Manual de usuario

Manuales populares de Accesorios para automóviles de otras marcas

James Baroud

James Baroud Odyssey Manual de usuario

Motorola

Motorola i50sx Manual de usuario

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manual de usuario

Feniex

Feniex T3 Manual de usuario

Renault

Renault 77 11 423 180 Manual de usuario

Kia

Kia E8300-4D000 Manual de usuario

Brink

Brink 756843 Manual de usuario

Whispbar

Whispbar K085W Manual de usuario

v.link

v.link CI-VL2-PC-HSD Manual de usuario

Viking

Viking Stack-Rack Guía de configuración rápida

Aries

Aries 203015 Manual de usuario

Choetech

Choetech AT0005 Manual de usuario

ZZ2

ZZ2 ZZAIR-PRO Manual de usuario

Holman

Holman 4A80L Manual de usuario

Thule

Thule 2075 Manual de usuario

Motorola

Motorola T325 Manual de usuario

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guía de instalación

DV8

DV8 FBJL-02 Manual de usuario