HIK VISION DS-2CD2412F-I Guía del usuario
UD.6L0201B1191A01
Network Camera
Quick Operation Guide
Network Camera·Quick Operation Guide
1
1
Thank you for purchasing our product. If there are any questions,
or requests, please do not hesitate to contact the dealer.
About This Document:
This manual applies to DS-2CD2412F-I(W); DS-2CD2432F-I(W)
series cameras.
This manual may contain several technical incorrect places or
printing errors, and the content is subject to change without notice.
The updates will be added to the new version of this manual. We
will readily improve or update the products or procedures
described in the manual.
DISCLAIMER STATEMENT
“Underwriters Laboratories Inc. (“UL”) has not tested the
performance or reliability of the security or signaling aspects of
this product. UL has only tested for fire, shock or casualty hazards
as outlined in UL’s Standard(s) for Safety, UL60950-1. UL
Certification does not cover the performance or reliability of the
security or signaling aspects of this product. UL MAKES NO
REPRESENTATIONS, WARRANTIES OR CERTIFICATIONS
WHATSOEVER REGARDING THE PERFORMANCE OR RELIABILITY
OF ANY SECURITY OR SIGNALING RELATED FUNCTIONS OF THIS
PRODUCT.
0500051030809
Network Camera·Quick Operation Guide
2
2
Regulatory Information
FCC Information
FCC compliance: This equipment has been tested and found to
comply with the limits for a digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the
interference at his own expense.
FCC Conditions
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation
EU Conformity Statement
This product and - if applicable - the supplied
accessories too are marked with "CE" and comply
therefore with the applicable harmonized
European standards listed under the Low Voltage Directive
2006/95/EC, the EMC Directive 2004/108/EC.
Network Camera·Quick Operation Guide
3
3
2002/96/EC (WEEE directive): Products marked
with this symbol cannot be disposed of as unsorted
municipal waste in the European Union. For proper
recycling, return this product to your local supplier
upon the purchase of equivalent new equipment, or dispose of it at
designated collection points. For more information see:
www.recyclethis.info.
Network Camera·Quick Operation Guide
4
4
Contents
1 Appearance Description ................................................ 5
2 Notice............................................................................ 8
3 Installation ................................................................. 10
4 Setting the Network Camera over the LAN .................. 15
5 Accessing via WEB browser......................................... 20
Network Camera·Quick Operation Guide
5
5
1Appearance Description
1
2
3
4
5
6
7
8
9
10
11
12
Figure 1-1 Overview
Table 1-1 Description
No.
Description
1
Lens
2
PIR(Passive Infrared) sensor
3
Microphone
4
Indicators
Alarm:
Solid red when the camera is armed;
Solid blue when the camera is
unarmed.
Network Camera·Quick Operation Guide
6
6
No.
Description
Status: Reserved
Link:
Flashing amber when network
connection is functioning properly;
Unlit when no network connection;
5
Infrared Light
6
SD Card Slot
7
10M / 100M self-adaptive Ethernet interface & PoE
8
WPS (Wi-Fi Protected Setup)/Reset Button
9
Alarm Input Interface
10
Ground
11
Alarm Output Interface
12
Power supply interface; (DC 12V)
To reset the default parameters to the camera, you need to
press and hold the RESET button and power on the camera.
After the power on of the camera, you must still press and hold
the Reset button for about 10 seconds.
The WPS button is an easy configuration protocol of Wi-Fi
settings. Press the WPS button on the camera and press the
Network Camera·Quick Operation Guide
7
7
WPS button on the wireless router, the camera can be easily
connected on line.
Network Camera·Quick Operation Guide
8
8
2Notice
Do not install the camera
in the extreme whether
condition.
Do not touch the lens with
your figure.
Do not install the camera
towards the strong light
or in the unstable
lightening condition.
Do not subject the
camera to vibration,
shock or heavy pressure.
Network Camera·Quick Operation Guide
9
9
High humidity may
damage the camera
hardware; put it in dry
and well-ventilated place.
Under no circumstances
should you submerge the
camera in any type of
liquid.
Electromagnetic radiation may affect the video data
transmission and the image quality. Do not install the
camera near
Otros manuales para DS-2CD2412F-I
1
Este manual sirve para los siguientes modelos
3
Tabla de contenidos
Otros manuales de Cámara de seguridad de HIK VISION
HIK VISION
HIK VISION HiWatch HWI-B140H-M Manual de usuario
HIK VISION
HIK VISION DS-2CE12DFT-PIRXOF28 Manual de usuario
HIK VISION
HIK VISION DS-2AE7232TI-A Manual de usuario
HIK VISION
HIK VISION 26 series Manual de usuario
HIK VISION
HIK VISION DS-2DF1-77XY Manual de usuario
HIK VISION
HIK VISION DS-2CE16C5T-AVFIR3 TURBO HD Manual de usuario
HIK VISION
HIK VISION DS-2CE16H0T-ITF Manual de usuario
HIK VISION
HIK VISION DS-2CE56D5T-IR3Z Manual de usuario
HIK VISION
HIK VISION DS-2AE4223TI-A Manual de usuario
HIK VISION
HIK VISION DS-2DF7C445IXR-AEL(T5) Manual de usuario
HIK VISION
HIK VISION iDS-TCM403-A Manual de usuario
HIK VISION
HIK VISION ECI-D64Z2 Manual de usuario
HIK VISION
HIK VISION DS-2CE16C0T-IRPF Manual de usuario
HIK VISION
HIK VISION DS-2TD2628-7/QA/GLT Manual de usuario
HIK VISION
HIK VISION DS-2CE11D0T-PIRL Manual de usuario
HIK VISION
HIK VISION DS-2TD1228T-2/QA Manual de usuario
HIK VISION
HIK VISION DS-2CD2146G1-IS Manual de usuario
HIK VISION
HIK VISION DS-2CE71H0T-PIRL Manual de usuario
HIK VISION
HIK VISION DS-2XS6A25G0-I/CH20S40/K Instrucciones de funcionamiento
HIK VISION
HIK VISION iDS-TCV500-B(I)/IM Manual de usuario
