H3C PSR6000 Manual de usuario
H3C PSR6000-ACV Power Module
User Manual
New H3C Technologies Co., Ltd.
http://www.h3c.com
Document version: T2-08012K-20201205-C-1.02
Copyright © 2009-2020, New H3C Technologies Co., Ltd.
and its licensors
All rights reserved
No part of this manual may be reproduced or transmitted in any form
or by any means without prior written consent of New H3C
Technologies Co., Ltd.
Trademarks
Except for the trademarks of New H3C Technologies Co., Ltd., any
trademarks that may be mentioned in this document are the property
of their respective owners.
Notice
The information in this document is subject to change without notice.
All contents in this document, including statements, information, and
recommendations, are believed to be accurate, but they are
presented without warranty of any kind, express or implied. H3C shall
not be liable for technical or editorial errors or omissions contained
herein.
Environmental protection
This product has been designed to comply with the environmental
protection requirements. The storage, use, and disposal of this
product must meet the applicable national laws and regulations.
Documentation feedback
You can e-mail your comments about product documentation to
We appreciate your comments
i
Contents
Introduction························································1
Physical View ···········································································2
Technical Specifications ···························································4
LEDs·························································································5
Installing/Removing the PSR6000-ACV ·············8
Preparations ·············································································8
Installing the Power Module······················································8
Removing the Power Module···············································9
Connecting the Power Cord····················································10
Installing the Cable Retention Clip ····································· 10
Connecting the Power Cord··············································· 11
1
Introduction
The PSR6000-ACV is a built-in power module with AC input and DC
output. It provides the device with both system power and PoE power,
which can be controlled through separate switches.
Table 1 Features of the PSR6000-ACV
Item Description
Protection
functions
Support input under-/over-voltage protection,
output over-voltage protection, short-circuit
protection, over-current protection, and
overheat protection
Hot swapping Support hot swapping with the power switch
turned off while the device is in operation
Redundancy
backup Support 1 + 1 hot backup and current sharing
CAUTION:
PSR6000
-ACV cannot work with power modules of other
models on the same device.
2
Physical View
Figure 1 Physical view of the PSR6000-ACV
(1) Captive screws
(2) PoE power switch
(3) Status LEDs (4) Holes for installing a cable
retention clip
(5) System power socket
(6) System power switch
(7) Power module handle
(8) PoE input sockets
As shown in Figure 1, each PSR6000-ACV has four independent AC
input sockets, where,
•
Callout (5) is the system power input socket (SYS IN);
•
Callout (8) is the PoE power input sockets (PoE1, PoE2, and
PoE3).
The PSR6000-ACV is designed with two switches, of which,
•
Callout 6 is used to control the output of the entire power supply
system;
(2)
(4)
(3)
(6)
(7)
(1)
(5)
(8)
3
•
Callout (2) is used to control the PoE power output.
The PSR6000-ACV provides PoE power output on the premise that:
•
The system power switch is on and the system power output is
normal;
•
The PoE power switch is on and PoE input is available on at
least one of the three PoE sockets.
PoE output power of the PSR6000-ACV varies with number of PoE
power input lines. You can add or remove lines of PoE power
supplies as needed. For details, see Table 2.
In addition to providing dedicated PoE power supplies for devices
supporting PoE, PoE power output can also be used as
supplementary power supply for devices that do not support PoE:
•
With only the system power switch turned on, the maximum
power output of the system is 1150 W (110 VAC) or 1400 W (220
VAC).
•
If the power requirements of the entire system exceed the
maximum system power provided by the PSR6000-ACV, PoE
power output can be used as supplements. To do this, turn on
the PoE power switch and select lines of PoE power supplies as
needed. For details, refer to the installation manual of related
devices.
CAUTION:
•
Input voltage for the system power input, PoE 1, PoE 2, and
PoE 3 must be the same. It can be either 110 VAC or 220
VAC for power supplies of the power module.
•
Turn off the PoE power switch if PoE power supply is not
required by the device. For more information, see the
installation guide or hardware information and specifications
for the device.
4
Technical Specifications
Table 2 Technical specifications
Item Description
Rated voltage range 100 VAC to 240 VAC;
50 Hz or 60 Hz
Maximum input current per line 16 A
Maximum output current 117 A
Maximum PoE output current 100 A
Max system power output 1150 W (110 VAC)
1400 W (220 VAC)
Max PoE
power output
One line of PoE
input 1200 W (110 VAC)
1800 W (220 VAC)
Two lines of
PoE input 2400 W (110 VAC)
3600 W (220 VAC)
Three lines of
PoE input 3600 W (110 VAC)
5300 W (220 VAC)
Physical dimensions
(H × W × D) 128 × 196 × 380 mm
(5.04 × 7.72 × 14.96 in.)
Temperature
requirements
Operating
temperature 0°C to 45°C (32°F to 113°F)
Storage
temperature –40°C to +70°C (–40°F to
+158°F)
5
LEDs
Each PSR6000-ACV provides eight red/green bi-color LEDs. Table 3
describes the LEDs of the power module.
Table 3 Description of the LEDs
LED State Description
System
power
input (SYS
IN)
Off No system power input is present.
Green The system power input is normal.
Red The system power input is abnormal.
System
power
output
(SYS
OUT)
Off No system power input is present.
Green The system power output is normal.
Red
The power switch is in the off position.
Power alarm (output short circuit,
output over-current, output
over-voltage, or overheat occurs on the
power module, and the power module
takes a self-protection action)
System fan
(SYS FAN)
Off No system power input is present.
Green The power module fan works normally.
Red
The system switch is in the off position.
The power module fan is faulty (the
power module takes a self-protection
action and stops power output two
seconds after the fan fails.)
6
LED State Description
PoE power
input (PoE
IN1*)
Off No PoE power input is present.
Green The PoE power input is normal.
Red The PoE power input is abnormal.
PoE power
output
(PoE OUT)
Off No PoE power input is present.
Green The power output is normal.
Red
The power switch is in the OFF
position.
Power alarm (output short circuit,
output over-current, output
over-voltage, or overheat occurs to the
power module, and the power module
takes a self-protection action).
PoE fan
(PoE FAN)
Off No PoE power input is present.
Green The PoE fan works normally.
Red
The PoE switch is in the off position.
The PoE fan is faulty (the PoE module
takes a self-protection action and stops
power output two seconds after the fan
fails.)
Note*: Description for PoE IN1, PoE IN2, and PoE IN3 is the
same.
7
CAUTION:
•
The power module provides PoE power output only if the
system power output is normal.
•
It would be normal that the power LED remains on for a
period of time after you turn off the power switch.
•
Avoid turning on and off the power switch frequently.After
turning off the power switch, wait at least 30 seconds before
turning it on again.
Tabla de contenidos
Otros manuales de Unidad de control de H3C
H3C
H3C PSR1800-56A Manual de usuario
H3C
H3C SecPath PSR300-12A2 Manual de usuario
H3C
H3C LSQM1TGT24FD0 Manual de usuario
H3C
H3C LSWM116FC Manual de usuario
H3C
H3C Campus SeerEngine LSXM1SEERBXC2 Manual de usuario
H3C
H3C PSR300-12A Series Manual de usuario
H3C
H3C SecPath M9000-AI NSQM5MBSHA1 Manual de usuario
H3C
H3C SecBlade Manual de usuario
H3C
H3C LSQM1SDNB0 Manual de usuario
H3C
H3C SR6600 SPE-FWM-200 Manual de usuario
H3C
H3C PSR650B-12A2-F Manual de usuario
H3C
H3C S9500E Series Manual de lista de piezas
H3C
H3C SecPath NSQM2GP24TSSC0 Manual de usuario
H3C
H3C LSUM1TGT24FD0 Manual de usuario
H3C
H3C LSVM1S9800FAN Manual de usuario
H3C
H3C SecPath NSQ1FAB08D0 Manual de usuario
H3C
H3C S12500 LST1LB1A1 Manual de usuario
H3C
H3C R6900-FAN Manual de usuario
H3C
H3C PSR2400-54D Manual de usuario
H3C
H3C SecPath NSQM2AC1400 Manual de usuario
Manuales populares de Unidad de control de otras marcas
Festo
Festo Compact Performance CP-FB6-E Manual de lista de piezas
Elo TouchSystems
Elo TouchSystems DMS-SA19P-EXTME Manual de usuario
JS Automation
JS Automation MPC3034A Manual de usuario
JAUDT
JAUDT SW GII 6406 Series Guía rápida
Spektrum
Spektrum Air Module System Manual de usuario
BOC Edwards
BOC Edwards Q Series Manual de usuario
