H3C PSR1800-56A Manual de usuario
H3C PSR1800-56A Power Module
User Manual
New H3C Technologies Co., Ltd.
http://www.h3c.com
Document version: 6PW103-20181128
Copyright © 2013-2018, New H3C Technologies Co., Ltd.
and its licensors
All rights reserved
No part of this manual may be reproduced or transmitted in any form
or by any means without prior written consent of New H3C
Technologies Co., Ltd.
Trademarks
Except for the trademarks of New H3C Technologies Co., Ltd., any
trademarks that may be mentioned in this document are the property
of their respective owners.
Notice
The information in this document is subject to change without notice.
All contents in this document, including statements, information, and
recommendations, are believed to be accurate, but they are
presented without warranty of any kind, express or implied. H3C shall
not be liable for technical or editorial errors or omissions contained
herein.
Environmental protection
This product has been designed to comply with the environmental
protection requirements. The storage, use, and disposal of this
product must meet the applicable national laws and regulations.
Documentation feedback
You can e-mail your comments about product documentation to
We appreciate your comments
i
Contents
Power module overview······························· 1
Technical specifications ··················································· 1
Appearance ··································································· 3
LEDs············································································ 4
Installing and removing a power module·········· 5
Safety precautions ·························································· 5
Tools············································································ 5
Installing and removing a power module······························ 5
Installing the power module ·········································· 6
Connecting the AC power cord······································ 9
Removing the power module········································11
1
Power module overview
The PSR1800-56Ais an AC/DC-input and DC-output power module.
It provides a maximum output of 1800 W and delivers the following
features:
Feature Description
Protection
Protection against over-current input,
undervoltage input, overvoltage output,
overcurrent output, output short circuit, and
overtemperature.
Redundancy The power modules can operate in redundant
mode, and support load sharing.
Hot swapping You can replace a power module when the
switch is operating.
Technical specifications
Item Specifications
Rated input voltage
•100 VAC to 240 VAC @ 50 Hz or 60
Hz (AC input)
•240 VDC (high voltage DC input)
Maximum input current •13 A (AC input)
•10.5 A (high voltage DC input)
Output voltage –56 V
2
Item Specifications
Output current
•32.2 A (201 VAC to 240 VAC input
voltage)
•19.6 A (100 VAC to 200 VAC input
voltage)
•32.2 A (240 VDC input voltage)
Maximum output
power
•1800 W (201 VAC to 240 VAC input
voltage)
•1100 W (100 VAC to 200 VAC input
voltage)
•1800 W (240 VDC input voltage)
Dimensions (H × W ×
D) 40.1 × 82.6 × 297.7 mm (1.58 × 3.25 ×
11.72 in)
Operating temperature –10°C to +55°C (14°F to 131°F)
Relative humidity 5% to 95%
NOTE:
When the input voltage is in the range of 100 VAC to 200 VAC,
the output power of the power module decreases to 1100 W.
You need to determine whether the output power meets the
requirements for the device operation. If not, take necessary
measures. For more information, see device installation manuals.
3
Appearance
Figure 1 PSR1800-56A
(1) Input status LED (AC OK) (2) AC input socket
(3) Latch
(4) Handle (The handle is in red, indicating the air ventilation is
performed by exhausting air from the inside to the outside.)
(5) Output status LED (DC OK)
4
LEDs
APSR1800-56Ahas two status LEDs on its front panel. The following
table lists the LED status and description.
LED Status Description
Input status
LED (AC OK)
Steady green The power input is normal.
Off No power input or the power
input is abnormal.
Output status
LED (DC OK)
Steady green The power output is normal.
Steady red The power output is abnormal.
Off No power output.
5
Installing and removing a power
module
Safety precautions
To avoid possible bodily injury and power module and device
damage, follow these safety precautions:
•When you install and remove a power module, always wear an
ESD wrist strap and make sure it makes good skin contact and
is well grounded.
•Before you install the power module, make sure the voltage of
the power source is the same as the rated voltage of the power
module, and the output voltage of the power module is the same
as the required voltage.
•Do not touch any naked cable or terminal of the power module.
•Do not place the power module in a wet area, and prevent liquid
from flowing into the power module.
•To avoid power module damage, do not open the power module.
When the internal circuits or components of the power module
fail, contact the maintainer for examining and repairing.
Tools
Prepare an ESD wrist strap and a flat-blade screwdriver yourself.
Installing and removing a power module
6
IMPORTANT:
Before installation, make sure the power module model is as
required. For more information about the device requirements,
see the installation guide of the device.
Installing the power module
To avoid bodily injury or device damage, follow the steps in Figure 2
to install the power module.
Figure 2 Installation procedure
1. Wear an ESD wrist strap and make sure the strap makes good
skin contact and is reliably grounded.
2. Unpack the power module and verify that the power module
model is as required.
7
3. As shown in Figure 3, with the upside of the power module up,
hold the handle of the power module with one hand and the
bottom of the power module with the other, and then slide the
power module slowly along the guide rails into the slot. When
the power module is completely inserted into the slot, you can
hear that the latch of the power module clicks into the slot.
Figure 3 Installing the power module
Tabla de contenidos
Otros manuales de Unidad de control de H3C
H3C
H3C SecPath NSQ1FAB04B0 Manual de usuario
H3C
H3C S9500E Series Manual de lista de piezas
H3C
H3C SR6600 SPE-FWM Manual de usuario
H3C
H3C SecPath NSQM2AC1400 Manual de usuario
H3C
H3C LSVM2106SFAN Manual de usuario
H3C
H3C SIC-4G-LTE-M Instrucciones de funcionamiento y mantenimiento
H3C
H3C R6900-FAN Manual de usuario
H3C
H3C SecPath M9000-AI NSQM5AIASKA1 Manual de usuario
H3C
H3C NSQ1TGS32SF0 Manual de usuario
H3C
H3C S12500 LST1LB1A1 Manual de usuario
H3C
H3C PSR2400-54D Manual de usuario
H3C
H3C PSR300-12A Series Manual de usuario
H3C
H3C LSXM1SEERBXD2 Manual de usuario
H3C
H3C EWPA1PCID Manual de usuario
H3C
H3C PSR650C-12A Manual de usuario
H3C
H3C PSR750-A Manual de usuario
H3C
H3C PSR2400-12AHAH-B Manual de usuario
H3C
H3C NSQM1FWDFGC1 Manual de usuario
H3C
H3C PSR450-12A Manual de usuario
H3C
H3C SIC-4G-CAT6 Manual de usuario
Manuales populares de Unidad de control de otras marcas
Festo
Festo Compact Performance CP-FB6-E Manual de lista de piezas
Elo TouchSystems
Elo TouchSystems DMS-SA19P-EXTME Manual de usuario
JS Automation
JS Automation MPC3034A Manual de usuario
JAUDT
JAUDT SW GII 6406 Series Guía rápida
Spektrum
Spektrum Air Module System Manual de usuario
BOC Edwards
BOC Edwards Q Series Manual de usuario
